Details, datasheet, quote on part number: AK6480A
PartAK6480A
Category
Description
CompanyN.A.
DatasheetDownload AK6480A datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Features

ADVANCED CMOS EEPROM TECHNOLOGY Wide Vcc (1.8V 5.5V) operation AK6420A 2048 bits: 16 organization AK6440A 4096 bits: 16 organization AK6480A 8192 bits: 16 organization ONE CHIP MICROCOMPUTER INTERFACE - Interface with one chip microcomputer's serial communication port directly LOW POWER CONSUMPTION - 0.75mA Max (Read operation) - 0.8A Max (Standby mode) HIGH RELIABILITY -Endurance -Data Retention : 100K cycles : 10 years

SPECIAL FEATURES - High speed operation ) - Automatic write cycle time-out with auto-ERASE - Automatic address increment (READ) - Ready/Busy status signal - Software and Hardware controlled write protection IDEAL FOR LOW DENSITY DATA STORAGE - Low cost, space saving, 8-pin package (SOP , SSOP)

General Description The a 2048/4096/8192bit, serial, read/write, non-volatile memory device fabricated using an advanced CMOS EEPROM technology. The AK6420A has 2048bits of memory organized into 128 registers of 16 bits each. The AK6440A has 4096bits of memory organized into 256 registers of 16 bits each. The AK6480A has 8192bits of memory organized into 512 registers of 16 bits each. The AK6420A/40A/80A can operate full function under wide operating voltage range from to 5.5V. The charge up circuit is integrated for high voltage generation that is used for write operation. The AK6420A/40A/80A can connect to the serial communication port of popular one chip microcomputer directly (3 line negative clock synchronous interface). At write operation, AK6420A/40A/80A takes in the write data from data input pin (DI) to a register synchronously with rising edge of input pulse of serial clock pin (SK). And at read operation, AK6420A/40A/80A takes out the read data from a register to data output pin (DO) synchronously with falling edge of SK. The AK6420A/40A/80A has 4 instructions such as READ, WRITE, WREN (write enable) and WRDS (write disable). Each instruction is organized by op-code block (8bits), address block (8bits) and data 2). When input level of SK pin is high level and input level of chip select (CS) pin is changed from high level to low level, AK6420A/40A/80A can receive the instructions. Special features of the AK6420A/40A/80A include : automatic write time-out with auto-ERASE, Ready/Busy status signal output and ultra-low standby power mode when deselected (CS=high). Software and Hardware controlled write protection The AK6420A/40A/80A has 2 (hardware and software) write protection functions. After power on or after execution of WRDS (write disable) instruction, execution of WRITE instruction will be disabled. This write protection condition continues until WREN instruction is executed or Vcc is removed from the part. Execution of READ instruction is independent of both WREN and WRDS instructions. Reset pin should be low level when WRITE instruction is executed. When the Reset pin is high level, the WRITE instruction is not executed. Ready/Busy status signal During the automatic write time-out period (BUSY status), the AK6420A/40A/80A can't accept the other instructions. The AK6420A/40A/80A has 2 functions to know the Busy status from exterior. The RDY/BUSY pin indicates the Busy status regardless of the CS pin status. The RDY/BUSY pin outputs the low level regardless of the CS pin status during Busy status. Except the above status, this pin outputs high level. Also the DO pin indicates the Busy status. When input level of SK pin is low level and input level of CS pin is changed from high level to low level, the is in the status output mode and the DO pin indicates the Ready/Busy status. The Ready/Busy status outputs on DO pin until CS pin is changed from low level to high level, or first bit ("1") of op-code of next instruction is given to the part. Except when the device is in the status output mode or outputs data, the DO pin is in the high impedance state. Type of Products Model AK6480AF AK6480AM

Package 8pin Plastic SOP 8pin Plastic SSOP 8pin Plastic SOP 8pin Plastic SSOP 8pin Plastic SOP 8pin Plastic SSOP


 

Some Part number from the same manufacture
AK6480AF
AK6480AM
AK6480AM-E2
AK6480HF
AK6510A
AK6510A32KBIT
AK6512A
AK6512A64KBIT
AK93C10
AK93C10A
AK93C41A
AK93C41AV
AK93C45A
AK93C45AF
AK93C45ANF
AK93C45AV
AK93C45B
AK93C46
AK93C47
AK93C51A
AK93C51AV
Same catergory

MC14544BCL : Bcd-to-seven Segment Latch/decoder/driver For Liquid Crystals. The MC14544B BCDtoseven segment latch/decoder/driver is designed for use with liquid crystal readouts, and is constructed with complementary MOS (CMOS) enhancement mode devices. The circuit provides the functions a 4bit storage latch and an 8421 BCDtoseven segment decoder and driver. The device has the capability to invert the logic levels of the output.

XFUY20D2C : Material (Color) = GaAsP/GaP(Yellow);; Lens = Yellow Diffused;; Peak Wave Length = 590;; Iv(ucd) If@10mA Min.= 12;; Iv(ucd) If@10mA Typ.= 30.9.

VI-JTLCM : Dc-dc Converters 25 to 100 Watts. to 50W/Cubic Inch UL, CSA, TV, VDE, BABT CE Marked to 90% Efficiency Size: x 12,7) Remote Sense and Current Limit Logic Disable Wide Range Output Adjust ZCS Power Architecture Low Noise FM Control Nominal The VI-J00 MiniMod family establishes a new standard in component-level DC-DC converters. This "junior" size complement to the higher power VI-200.

ELM9830AA : Voltage Regulator. ELM98xxxA Series is a CMOS Voltage Regulator. It consists of reference voltage, error amplifier, shortprotected control transistor, output voltage setting resistor, and so on. Output voltage is fixed internally with high accuracy. Two package types are available, SOT-89 and SOT-23. High accuracy Load stability Input stability Output voltage temperature.

ICL7104-16CPL : 3 Digit, Lcd/led Display, A/D Converters. The Intersil ICL7106 and ICL7107 are high performance, low power, 31/2 digit A/D converters. Included are seven segment decoders, display drivers, a reference, and a clock. The ICL7106 is designed to interface with a liquid crystal display (LCD) and includes a multiplexed backplane drive; the ICL7107 will directly drive an instrument size light emitting.

1825SXXX : High Voltage MLC Chip.

1-1318114-4 : Panel Mount, Snap-In Rectangular - Housing Connectors, Interconnect Male Pin; CONN HOUSING TAB 8POS KEY-X PNL. s: Color: Black ; Contact Termination: Crimp ; Contact Type: Male Pin ; Mounting Type: Panel Mount, Snap-In ; Number of Rows: 2 ; Pitch: 0.098" (2.50mm) ; Packaging: Bulk ; Connector Type: Plug ; Fastening Type: - ; : Polarizing Key ; Number.

74HCT241PW,112 : Logic - Buffers, Drivers, Receivers, Transceiver Integrated Circuit (ics) Buffer/Line Driver, Non-Inverting Tube 6mA, 6mA 4.5 V ~ 5.5 V; IC BUFF/DVR TRI-ST DUAL 20TSSOP. s: Logic Type: Buffer/Line Driver, Non-Inverting ; Package / Case: 20-TSSOP (0.173", 4.40mm Width) ; Packaging: Tube ; Mounting Type: Surface Mount ; Number of Bits per Element: 4 ; Number.

1-827745-4 : Gold or Gold-Palladium Through Hole Rectangular - Headers, Male Pin Connectors, Interconnect Header, Shrouded; LATCH PIN HEADER VERTICAL 14W. s: Color: Black ; Connector Type: Header, Shrouded ; Contact Finish: Gold or Gold-Palladium ; Contact Mating Length: - ; : - ; Mounting Type: Through Hole ; Number of Positions Loaded: All ; Number of Rows: 2 ; Pitch:.

LTC1451IS8#TRPBF : Data Acquisition - Digital To Analog Converter (dac) Integrated Circuit (ics) Tape & Reel (TR) Single Supply; IC D/A CONV 12BIT R-R 8-SOIC. s: Data Interface: Serial ; Number of Bits: 12 ; Operating Temperature: -40C ~ 85C ; Package / Case: 8-SOIC (0.154", 3.90mm Width) ; Packaging: Tape & Reel (TR) ; Voltage Supply Source: Single Supply ; Settling.

1-640440-2 : Tin-Lead Free Hanging (In-Line) Rectangular - Free Hanging, Panel Mount Connectors, Interconnect Receptacle; CONN RECEPT 12POS 22AWG MTA100. s: Color: Red ; Connector Type: Receptacle ; Contact Finish: Tin-Lead ; : Closed End ; Mounting Type: Free Hanging (In-Line) ; Number of Rows: 1 ; Pitch: 0.100" (2.54mm) ; Row Spacing: - ; Packaging: Bulk ; Fastening.

152657 : Nickel Free Hanging (In-Line) Terminal - Ring Connectors, Interconnect Free Hanging (In-Line); CONN RING STR 20AWG #10 PIDG. s: Color: Gray ; : High Temperature, Serrated Termination ; Wire Gauge: 20 AWG ; Insulation: Insulated ; Length - Overall: 0.787" (20.00mm) ; Mounting Type: Free Hanging (In-Line) ; Packaging: Bulk ; Stud/Tab Size: 10 Stud ; Terminal.

4-1879213-6 : 78.7 Ohm 0.063W, 1/16W Chip Resistor - Surface Mount; RES 78.7 OHM 1/16W 0.1% 0402. s: Resistance (Ohms): 78.7 ; Power (Watts): 0.063W, 1/16W ; Tolerance: 0.1% ; Packaging: Tape & Reel (TR) ; Composition: Thin Film ; Temperature Coefficient: 25ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

RNF14BAC4K22 : 4.22K Ohm 0.25W, 1/4W Through Hole Resistors; RES 4.22K OHM 1/4W .1% AXIAL. s: Resistance (Ohms): 4.22K ; Power (Watts): 0.25W, 1/4W ; Tolerance: 0.1% ; Packaging: Tape & Box (TB) ; Composition: Metal Film ; Temperature Coefficient: 50ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

ED800/2 : Through Hole Terminal Block - Wire To Board Connectors, Interconnect Through Hole; TERMINAL BLOCK 10MM 2POS PCB. s: Color: Green ; Current: 15A ; : - ; Mating Orientation: Horizontal with Board ; Mounting Type: Through Hole ; Pitch: 0.394" (10.00mm) ; Voltage: 250V ; Wire Gauge: 14-22 AWG ; Number of Levels: 1 ; Positions Per Level: 2 ; Packaging: Bulk.

79434-006 : 6 CONTACT(S), FEMALE, TWO PART EURO CONNECTOR, IDC. s: Connector Type: TWO PART EURO CONNECTOR ; Gender: Female ; Termination Types: IDC ; Number of Contacts: 6.

 
0-C     D-L     M-R     S-Z