Details, datasheet, quote on part number: M28C16
PartM28C16
Category
Description
CompanyN.A.
DatasheetDownload M28C16 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

FAST ACCESS TIME: at 3V SINGLE SUPPLY VOLTAGE: 10% for M28C16A and to 3.6V for M28C16-xxW LOW POWER CONSUMPTION FAST WRITE CYCLE 32 Bytes Page Write Operation Byte or Page Write Cycle: 5ms ENHANCED END OF WRITE DETECTION Ready/Busy Open Drain Output Data Polling Toggle Bit PAGE LOAD TIMER STATUS BIT HIGH RELIABILITY SINGLE POLYSILICON, CMOS TECHNOLOGY Endurance >100,000 Erase/Write Cycles Data Retention >40 Years JEDEC APPROVED BYTEWIDE PIN OUT DESCRIPTION The M28C16A and 2K x8 low power Parallel EEPROM fabricatedwith STMicroelectronics proprietarysingle polysilicon CMOS technology. The device offers fast access time with low power dissipation and requires or 3V power supply. Table 1. Signal Names

G RB VCC VSS Address Input Data Input / Output Write Enable Chip Enable Output Enable Ready / Busy Supply Voltage Ground

Warning: NC = Not Connected, DU = Don't Use. Note: 1. Pin 2 is either RB for or NC for M28C16A.

Symbol TA T STG VCC IO VI VESD Parameter Ambient Operating Temperature Storage Temperature Range Supply Voltage Input/Output Voltage Input Voltage Electrostatic Discharge Voltage (Human Body model)

Notes: 1. Except for the rating "Operating Temperature Range", stresses above those listed in the Table "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the Operating sections of this specification is not i mplied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. Refer also to the STMicroelectronics SURE Program and other relevant quality documents. 2. Depends on range.

Mode Read Write Standby / Write Inhibit Write Inhibit Write Inhibit Output Disable
- DQ7 Data Out Data In Hi-Z Data Out or Hi-Z Data Out or Hi-Z

DESCRIPTION (cont'd) The circuit has been designed to offer a flexible microcontroller interface featuring both hardware and software handshakingmode with Ready/Busy, Data Polling and Toggle Bit. The M28C16A/17A supports 32 byte page write operation. PIN DESCRITPION Addresses (A0-A10). The address inputs select an 8-bit memory location during a read or write operation. Chip Enable (E). The chip enable input must be low to enable all read/write operations. When Chip Enable is high, power consumption is reduced. Output Enable (G). The Output Enable input controls the data output buffers and is used to initiate read operations. Data In/ Out - DQ7). Data is written to or read from the M28C16A/17A through the I/O pins.

Write Enable (W). The Write Enable input controls the writing of data to the M28C16A/17A. Ready/Busy (RB). Ready/Busy is an open drain output that can be used to detect the end of the internal write cycle. Ready/Busy is available for the M28C17A in PDIP, PLCC and SO packages, and for the M28C16A in TSOP only. OPERATION In order to prevent data corruption and inadvertent write operations during power-up, a Power On Reset (POR) circuit resets all internal programming cicuitry. Access to the memory in write mode is allowed after a power-up as specified in Table 7. Read The M28C16A/17Ais accessed like a static RAM. When E and G are low with W high, the data addressed is presented on the I/O pins. The I/O pins are high impedancewhen either E is high.


 

Some Part number from the same manufacture
M28C16-150K6 Ic-sm-16k CMOS EePROM
M28C16-17
M28C16-17A
M28C64-120K1 Ic-sm-64k CMOS EePROM
M28C64-15
M28C64-150P1 Ic-sm-64k CMOS EePROM
M28C64-A12BS6
M28C64C-150K1 Ic-sm-64k CMOS EePROM
M28C64N
M28F101-120K1 Ic-sm-1m Flash Memory
M28F101-70
M28F102
M28F201
M28F201-120K1 Ic-sm-2m Flash Memory
M28F220
M28F256-12X
M28F410
M28F411
M28F420
M28F420-80X
M28F512-12X
Same catergory

HD14518B : Dual BCD up Counter, Dual Binary up Counter.

NJM2380AD : Adjustable High Precision Shunt Regulator.

SY10/100E416 : . s Differential D and Q s Extended 100E VEE range to 5.5V VBB output for single-ended use 600ps max. propagation delay High frequency outputs 2 stages of gain Internal 75K input pull-down resistors Fully compatible with Motorola 10E/100E416 Available in 28-pin PLCC package The SY10/100E416 are 5-bit differential line receiving devices. The 2.0GHz of bandwidth.

2STA1962 : Transistors, Power Bipolar High power PNP epitaxial planar bipolar transistor.

SV01JA223JAA : High Voltage MLC Radials (SV Style).

84134230 : SIMM Series Input Modules. SIMM Series Input Modules 6.2 mm wide and 65 mm deep * DIN Rail mounted * LED input status indicator * Bridges enable quick linking of common voltage * Identification zone on front face * IP20 Nominal voltage Operating voltage range Max input current Operating temperature range Storage temperature range Turn-On time Turn-Off time Switching frequency.

KK4541B : Programmable Timer High-performance Silicon-gate CMOS. The KK4541B programmable timer consists a 16-stage binary counter, an oscillator that is controlled by external R-C components (2 resistors and a capacitor), an automatic power-on reset circuit, and output control logic. The counter increments on positive-edge clock transitons and can also be reset via the MASTER RESET input. The output from this timer.

UPC8106TB-EV09 : RF Development Tools For UPC8106TB-A at 900 MHz. s: Manufacturer: CEL ; Product Category: RF Development Tools ; RoHS: No.

AD9641-155KITZ : Eval Board - Analog To Digital Converter (adcs) Programmers, Development System; KIT EVAL FOR AD9641. s: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

ISL6228EVAL3Z : Eval Board - Dc/dc & Ac/dc (off-line) Smp Programmers, Development System; EVALUATION BOARD FOR ISL6228. s: Board Type: Fully Populated ; Main Purpose: DC/DC, Step Down ; Regulator Topology: Buck ; Outputs and Type: 2, Non-Isolated ; Voltage - Output: 1.5V or 1.8V, 1.8V ; Current - Output: 8A, 8A ; Voltage - Input: 3.3 ~ 25 V ; Frequency - Switching:.

AS3911-BQFT-1K : Tape & Reel. s: Family: RFID ICs ; Series: - ; RF Type: Read / Write ; Frequency: 13.56MHz ; : ISO14443-A, ISO14443-B ; Package / Case: 32-VFQFN Exposed Pad ; Supplier Device Package: 32-QFN (5x5) ; Packaging: Tape & Reel (TR) ; Dynamic Catalog: AS3911.

063YXM10MFA5X11 : CAPACITOR, ALUMINUM ELECTROLYTIC, NON SOLID, POLARIZED, 63 V, 10 uF, THROUGH HOLE MOUNT. s: Configuration / Form Factor: Leaded Capacitor ; RoHS Compliant: Yes ; : Polarized ; Capacitance Range: 10 microF ; Capacitance Tolerance: 20 (+/- %) ; WVDC: 63 volts ; Leakage Current: 6.3 microamps ; Mounting Style: Through Hole ; Operating Temperature: -25 to 105 C (-13.

A112R0F0.07 : RES NET,THICK FILM,2 OHMS,200WV,1% +/-TOL,-250,250PPM TC,7612 CASE. s: Configuration: Chip Array ; Category / Application: General Use.

MPN4-02001800-23P : 2000 MHz - 18000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER. s: Amplifier Type: Power Amplifier ; Applications: RF Microwave ; Frequency Range: 2000 to 18000 MHz ; Minimum Gain: 24 dB ; Input VSWR: 2.2 1 ; Output VSWR: 2.2 1 ; Package Type: Connectorized ; Operating Temperature: -54 to 70 C (-65 to 158 F).

UM6001C : PIN DIODE. These series of PIN diodes are designed for applications requiring small package size and moderate average power handling capability. The low capacitance of the UM6000 and UM6600 allows them to be used as series switching elements to 1 GHz. The low resistance of the UM6200 is useful in applications where forward bias current must be minimized. Because.

 
0-C     D-L     M-R     S-Z