Details, datasheet, quote on part number: SWA400H
PartSWA400H
Category
DescriptionAqueous FC 400ml Aerosol
CompanyN.A.
DatasheetDownload SWA400H datasheet
  

 

Features, Applications

SWA400H, SWA400S ELECTROLUBE H.K. Wentworth Ltd., Wentworth House, Blakes Road, Wargrave, Berkshire, RG10 8AW, United Kingdom. Fax No:

Identification of the preparation Chemical Name ETHANOLAMINE METHOXYPROPOXYPROPANOL BUTANE Non hazardous material CAS-No 34590-94-8 106-97-8 EEC-No 603-030-00-8 203-448-7 Class Xn; R20 Xi; R36/37/38 R10 F+; R12 Weight

Most important hazards: Specific hazards Non hazardous. Aerosol dispensers, compressed liquefied gas. High concentration of vapours may induce unconsciousness / narcosis. May cause skin irritation and/or dermatitis.

General advice: Inhalation: Skin contact: Eye contact: Ingestion: Remove from exposure, lie down. Move to fresh air Wash off immediately with soap and plenty of water. Treat frostbitten areas as needed Flush eye(s) immediately with plenty of water. If eye irritation persists, consult a specialist. Clean mouth with water and drink afterwards plenty of water. Consult a physician if necessary.

Suitable extinguishing media: Extinguish with carbon dioxide, dry chemical, foam or waterspray. Extinguishing media which must not be used for safety reasons: Not applicable. Specific hazards: Not applicable. Special protective equipment for firefighters: Wear self contained breathing apparatus for fire fighting if necessary

Personal precautions: Environmental precautions: Wear suitable gloves and eye/face protection No special environmental precautions required.

SWA400H, SWA400S Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Keep in suitable, closed containers for disposal.

Handling: Storage: Use only in well-ventilated areas. Avoid contact with the skin and the eyes.Do not breath vapours or spray mist. When using, do not eat, drink or smoke. Keep containers tightly closed in a cool, well-ventilated place < 45c

Chemical Name: ETHANOLAMINE METHOXYPROPOXYPROPANOL BUTANE Non hazardous material National occupational exposure limits: Long term (8 hrs) = 100 ppm Long term (8 hrs) = 600 ppm Short term (15 min) = 750 ppm -

Engineering measures Ensure adequate ventilation, especially in confined areas. Personal protection equipment: - Respiratory protection: No special precautions required. - Hand protection: Latex gloves. - Eye protection: No special precautions required. - Skin and body protection: No special precautions required Hygiene measures: In accordance with local and national regulations.

Form: Colour: Odour: pH: Boiling point/range: Flash point: Vapour pressure: Relative density: Solubility: Water solubility Viscosity: liquid green characteristic ( 20 C) does not flash < 1.3 (MELA) 0.99 1.10 completely miscible 10 C hPa

Stability: Conditions to avoid: Materials to avoid: Hazardous decomposition products: Stable. Incompatible with strong acids and oxidizing agents. strong acids and oxidizing agents No decomposition if stored and applied as directed

Acute toxicity: Local effects: Sensitization: Long term toxicity: Chronic toxicity: Ethanolamine: - 2.7g/kg Prolonged skin contact may cause skin irritation and/or dermatitis. Contact with eyes may cause irritation Not applicable Did not show carcinogenic, teratogenic or mutagenic effects in animal experiments Not applicable

Mobility: Persistence and degradability: Bioaccumulation: Ecotoxicity effects: Soluble in water. Readily biodegradable, according to appropriate OECD test Not applicable Not applicable

Waste from residues / unused products: Contaminated packaging: In accordance with local and national regulations. Do not pierce or burn even when empty

UN-No: ADR/RID Class: 1950 2 Marine pollutant: Item: HI/UN No: 5A 1950

Proper shipping name: Aerosol dispensers IMO Class: EmS: Proper shipping name: ICAO Class: Proper shipping name Aerosol dispensers 2.2 UN/ID No: Aerosols, non flammable, n.o.s., 1950 IMDG Page: MFAG: -

Classification according to European directive on classification of hazardous preparations 90/492/EEC - Contains: - Symbol(s):

S2 - Keep out of reach of children. S3 - Keep in a cool place..

Recommended use: Recommended restrictions: Revision number: Further information: The level of Ethanolamine is below levels at which it produces irritant/harmful effects. 7 CN no: 34029090. Flammable composition = 10%


 

Some Part number from the same manufacture
SWE05-05FC Psu L Frame 5v 1a
SX-10M Solar Panel 10watt
SX-30M Solar Panel 32watt
SX-5M Solar Panel 4.5watt
SX01DD4 Pressure Sensor
SX18AC75DP Ic-8-bit MCU
SX30DD4 Pressure Sensor
SXT2222A
SXT6234 E-rate Multiplexer
SY100-68-A-30 Lead 3 Metre
SY41PR110AC Relay 4 Dpco 110vac
SYM53C720
SYM53CF92A-64QFP
SYM53CF96-2
SYS32256ZK-20 Module-8mb SRAM
T0-1-102/EA/SVB ISOlator Flush 20a 2 Pole
T0505H
T0505MH-1AA2 Triac 5a 600v
T0505XH
T0510
T0605
Same catergory

AD7829-1 : The AD7829-1 is a high speed 8-channel, microprocessor-compatible, 8-bit analog-to-digital converter with a maximum throughput of 2 MSPS. The AD7829-1 contains an on-chip reference of 2.5 V (2% tolerance); a track/hold amplifier; a 420 ns, 8-bit half-flash ADC; and a high speed parallel interface. The converter can operate from a single 3 V 10% and 5 V 10% supply.

MLL5541B : Low Voltage Surface Mount 500 mW Avalanche Diodes. The 1N5518BUR thru 1N5546BUR series of 0.5 watt glass surface mount Zener voltage regulators provides a selection from to 33 volts in standard 5% tolerances as well as tighter tolerances identified by different suffix letters on the part number. These are also available with an internalmetallurgical-bond option by adding a "-1" suffix (see separate.

EL8186ISZ : Micropower Single Supply Rail-to-rail Input-output Precision Op Amp. The is a micropower operational amplifier optimized for single supply operation at 5V and can operate down to 2.4V. The EL8186 draws minimal supply current while meeting excellent DC-accuracy noise and output drive s. Competing devices seriously degrade these parameters to achieve micropower supply current. Offset current, voltage and current noise,.

S30S40 : Schottky Barrier Rectifiers. SWITCHMODE POWER RECTIFIERS D2 PAK SURFACE MOUNT POWER PACKAGE The D2 PAK Power rectifier employs the Schottky Barrier principle with a Molybdenum barrier metal. These state-of-the-art geometry epitaxial construction with oxide passivation and metal overlay contact. Ideally suited for low voltage, high frequency rectification, or as free wheeling and polarity.

ASJ-7 : 3.5mm Audio Jacks Stereo & MONO Earphone Jacks.

UPS1C330MDD : Aluminum Electrolytic Capacitors. Miniature Sized, Low Impedance, For Switching Power Supplies Wide temperature range type, miniature sized. Adapted to the RoHS directive (2002/95/EC). s Item Category Temperature Range Rated Voltage Range Rated Capacitance Range Capacitance Tolerance Rated voltage (V) ~ 100 After 1 minute's application of rated voltage, leakage current is not more than.

SBP1660 : Current 16.0amperes Voltage 20 to 100 Volts. Plastic Package has Underwriters Laboratory Flammability Classification 94V-0 Metal silicon junction, majority carrier conduction Guard ring for overvoltage protection Low power loss, high efficiency High current capability, Low forward voltage drop High surge capability For use in low voltage, high frequency inverters, free wheeling, and polarity protection.

G2992F1U : 3A DDR Bus Termination Regulator. The is a linear regulator designed to meet the JEDEC SSTL-18, SSTL-2 and SSTL-3 (Series Stub Termination Logic) s for termination of DDR / II -SDRAM. It contains a high-speed operational amplifier that provides excellent response to the load transients. This device can deliver 3A continuous current in the application such as required for DDR I/ II SDRAM.

TDA04H0SB1 : Ultra-miniature Surface Mount Half-pitch DIP Switches. C&K TDA Series Ultra-miniature Surface Mount Half-pitch DIP Switches electrical reliability Tin-lead plated terminals for reliable solder coverage Process sealed for surface mount soldering and washable processing RoHS compliant - options available How To Order Complete part numbers for TDA Series are shown below. All switches supplied in "OFF" position.

ME21XAX : 14 pin DIP, 5.0 Volt, ECL, Pecl, Clock Oscillator. 14 pin DIP, 5.0 Volt, ECL, PECL, Clock Oscillator ME Series ECL/PECL Clock Oscillators, 10 KH Compatible with Optional Complementary Outputs MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete.

DCMC514U010CD2B : 85 C High Capacitance, Screw Terminal, Aluminum. Type DCMC 85 C High Capacitance, Screw Terminal, Aluminum Highest Capacitance Screw Terminal Type With more capacitance and often more ripple-current capabilty than the best-value Type 3186 capacitor, the Type DCMC capacitor is the better choice for high-capacitance, power supply filters and energy storage applications such as welding equipment,UPS.

UH8JT-E3/45 : High Voltage Ultrafast Rectifier. Oxide planar chip junction Ultrafast recovery time Soft recovery characteristics Low switching losses, high efficiency High forward surge capability Solder Dip 260 C, 40 seconds Component in accordance to RoHS 2002/95/EC and WEEE 2002/96/EC TYPICAL APPLICATIONS For use in high voltage continuous mode power factor correctors (CCM PFC), switching mode.

SLP331M220A5P3 : 330F Aluminum Capacitor Radial, Can - Snap-In 220V; CAP ALUM 330UF 220V 20% SNAP. s: Capacitance: 330F ; ESR (Equivalent Series Resistance): 603.0 mOhm ; : General Purpose ; Lifetime @ Temp.: 3000 Hrs @ 105C ; Size / Dimension: 0.866" Dia (22.00mm) ; Lead Spacing: 0.394" (10.00mm) ; Surface Mount Land Size: - ; Mounting Type: Through Hole ; Package.

1546937-1 : Through Hole Terminal Block - Barrier Block Connectors, Interconnect Through Hole; CONN BARRIER BLOCK 5CIRC 8.26MM. s: Color: Black ; Mounting Type: Through Hole ; Number of Rows: 1 ; Pitch: 0.325" (8.255mm) ; Terminal Block Type: Barrier Block ; Number of Circuits: 5 ; : - ; Current: 20A ; Voltage: 150V ; Wire Gauge: 14-22 AWG ; Top Termination: Screws.

5-1761182-6 : Gold Through Hole, Right Angle Sdl, Semconn Connectors, Interconnect Receptacle; CONN RCPT 16POS SDL R/A. s: Connector Type: Receptacle ; Contact Finish: Gold ; : Keyed, Shielded ; Mounting Type: Through Hole, Right Angle ; Number of Positions: 16 ; Plating - Thickness: 50in (1.27m) ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

1060327080 : Fiber Optic Connectors, Interconnect; CONN SC TUNABLE 3MM RED. s: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

MX1N6507 : UNIDIRECTIONAL, 8 ELEMENT, SILICON, TVS DIODE. s: Arrangement: Common Anode ; Diode Type: Transient Voltage Suppressor Diodes ; VBR: 60 volts ; Package: HERMETIC SEALED, CERAMIC, DIP-14 ; Pin Count: 14 ; Number of Diodes: 8.

S0547143 : SHIELDED, VARIABLE INDUCTOR, SMD. s: Mounting Option: Surface Mount Technology ; Devices in Package: 1 ; Lead Style: Gull ; Standards and Certifications: RoHS ; Molded / Shielded: Shielded ; Configuration: Variable ; Application: RF Choke ; Inductance Range: 195 microH.

9-177609-1 : 64 CONTACT(S), MALE, COMBINATION LINE CONNECTOR, SOLDER. s: Connector Type: COMBINATION LINE CONNECTOR ; Gender: Male ; Termination Types: SOLDER ; Number of Contacts: 64.

9112BM-17LF-T : 9112 SERIES, LOW SKEW CLOCK DRIVER, 8 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16. s: Device Type: Clock Driver ; Package Type: Surface Mount, SOIC, 0.150 INCH, ROHS COMPLIANT, MS-012, SOIC-16 ; Supply Voltage: 2.97 to 3.63 volts ; Skew: 250 ps ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; / Standards: RoHS, Lead-Free.

 
0-C     D-L     M-R     S-Z