|Category||Interface and Interconnect|
|Company||Allegro Micro Systems, Inc.|
|Datasheet||Download UDN2580 datasheet|
|Quote||Find where to buy UDN2580|
This versatile family of integrated circuits will work with many combinations of logic- and load-voltage levels, meeting interface requirements beyond the capabilities of standard logic buffers. Series UDN2580A and A2580SLW source drivers can drive incandescent, LED, or vacuum fluorescent displays. Internal transient-suppression diodes permit the drivers to be used with inductive loads such as relays, solenoids, dc and stepping motors, and magnetic print hammers. The Types UDN2580A and A2580SLW are high-current source drivers used to switch the ground ends of loads that are directly connected -50 V supply. Typical loads are telephone relays, PIN diodes, and LEDs. The UDN2585A and A2585SLW are drivers designed for applications requiring low output saturation voltages. Typical loads are low-voltage LEDs and incandescent displays. The eight non-Darlington, 25 V outputs will simultaneously sustain continuous load currents mA at ambient temperatures to +70°C. The UDN2588A and A2588SLW have separate logic and driver supply lines. Their eight drivers can serve as an interface between positive logic (TTL, CMOS, PMOS) or negative logic (NMOS) and either negative or splitload supplies -80 V. These drivers are packaged in plastic DlPs (suffix A) or surface-mountable wide-body SOlCs (suffix LW), and are rated for operation over the temperature range to +85°C.FEATURES
TTL, CMOS, PMOS, NMOS Compatible High Output-Current Rating Internal Transient Suppression Efficient Input /Output Structure Through-Hole and Surface-Mount PackagesAlways order by complete part number, e.g., UDN2580A.
at 25°C Free-Air Temperature for any one driver (unless otherwise noted).
UDN2580A A2580SLW Output Voltage, VCE Supply Voltage, VS (ref. sub.) Supply Voltage, VCC (ref. sub.) Input Voltage, VIN (ref. VS) Total Output Current, (lC + IS) Substrate Current ISUB 3.0 A
Package Power Dissipation, PD (single output). 1.0 W (total package). See Graph Operating Temperature Range, TA. to +85°C Storage Temperature Range, to +150°C
115 Northeast Cutoff, Box 15036 Worcester, Massachusetts 853-5000 W Copyright 1981, 2002 Allegro MicroSystems, Inc.
For simplification, these devices are characterized on the following pages with specific voltages for inputs, logic supply (VS), load supply (VEE), and collector supply (VCC). Typical use of the UDN2580A and A2580SLW is with negativereferenced logic. The more common application of the A2585SLW, UDN2588A and A2588SLW are with positive-referenced logic supplies. In application, the devices are capable of operation over a wide range of logic and supply voltage levels:
NOTE: The substrate must be tied to the most negative point in the external circuit to maintain isolation between drivers and to provide for normal circuit operation.
|Related products with the same datasheet|
|Some Part number from the same manufacture Allegro Micro Systems, Inc.|
|UDN2580A 8-channel Source Drivers|
|UDN2588A 8-channel Source Drivers|
|UDN2595A 8-channel Saturated Sink Driver|
|UDN2596A 8-channel Saturated Sink Drivers|
|UDN2878W Quad High-current Darlington Switches|
|UDN2879W Quad Darlington Power Driver|
|UDN2916B Dual Full-bridge PWM Motor Driver|
|UDN2936W 3-phase Brushless DC Motor Controller/driver|
|UDN2943Z Bipolar Half-bridge Motor Drivers|
|UDN2944W Protected Quad Power Driver|
|UDN2953B Bipolar Half-bridge Motor Drivers|