Details, datasheet, quote on part number: AAT3223IJS-2.8-T1
CategoryPower Management => Regulators => Linear Regulators => LDO (Low Drop Out)
Description250mA Nanopower LDO Linear Regulator With Power ok
CompanyAnadigics, Inc.
DatasheetDownload AAT3223IJS-2.8-T1 datasheet


Features, Applications
250mA NanoPowerTM LDO Linear Regulator with Power OK General Description

The AAT3223 PowerLinearTM NanoPower Low Dropout Linear Regulator is ideal for portable applications where extended battery life is critical. This device features extremely low quiescent current which is typically 1.1A. Dropout voltage is also very low, typically at 100mA. The AAT3223 has an Enable pin feature, which when pulled low will put the LDO regulator into a shutdown mode removing power from its load and offering extended power conservation capabilities for portable battery powered applications. The AAT3223 also has a Power OK (POK) feature. The POK function monitors the LDO output voltage and will alert the system if the output falls out of regulation. The AAT3223 has output short circuit and over current protection. In addition, the device also has an over temperature protection circuit, which will shutdown the LDO regulator during extended over current event events. The AAT3223 is available in a space saving 8-pin SC70JW package. The device is rated over to 85C temperature range. The AAT3223 is similar to the AAT3221 with the exception that it offers the additional Power OK function through the POK pin.


1.1 A Quiescent Current 250 mA Output Current Low Dropout: 190 mV (typical) High accuracy: 2% Current limit protection Over-Temperature protection Extremely Low power shutdown mode Low Temperature Coefficient Factory programmed output voltages Stable operation with virtually any output capacitor type Power OK signal output Active high Enable pin 8-pin SC70JW package 4kV ESD


Cellular Phones Notebook Computers Portable Communication Devices Handheld Electronics Remote Controls Digital Cameras PDAs

250mA NanoPowerTM LDO Linear Regulator with Power OK Pin Descriptions

Input pin. It is recommended to bypass this pin with a 1F capacitor Ground connection pin Output pin. This pin should be decoupled with 1F or larger capacitor. Not connected Enable input. Active high, logic level compatible. Power OK output pin. This pin pulled to ground during a power failure, it is normally high impedance and should have a 100k pull-up resistor connected to OUT.

250mA NanoPowerTM LDO Linear Regulator with Power OK Absolute Maximum Ratings

Input Voltage EN to GND Voltage Maximum EN to Input Voltage Maximum DC Output Current Operating Junction Temperature Range Maximum Soldering Temperature (at leads, 10 sec)

Note: Stresses above those listed in Absolute Maximum Ratings may cause permanent damage to the device. Functional operation at conditions other than the operating conditions specified is not implied. Only one Absolute Maximum rating should be applied at any one time.

Note 1: Mounted on a demo board. Note 2: Derate 6.7mW/C above 25C.

Note 3: To calculate minimum input voltage, use the following equation: VIN(MIN) = VOUT(MAX) + VDO(MAX) as long as VIN 2.5V.


Related products with the same datasheet
Some Part number from the same manufacture Anadigics, Inc.
AAT3239 500mA Micropower LDO<<<>>>the AAT3239 Micropower Low Dropout Linear<<<>>>regulator is Ideally Suited For Portable Applications<<<>>>where Very Fast Transient Response, Extended Battery<<<>>>life And Small
AAT3242 300mA/150mA Dual CMOS LDO Linear Regulator<<<>>>the AAT3242 is a Dual Low Dropout Linear<<<>>>regulator With Power ok Outputs. Two Integrated<<<>>>regulators Provide a High Power 300mA Output And<<<>>>a
AAT3510 Micropower P Reset With Watchdog Timer<<<>>>the AAT351x Powermanager Products Are<<<>>>members of Analogictech 's Total Power<<<>>>management ic Product Family. This Family Of<<<>>>microprocessor Reset
AAT4290 I/o Expander Load Switches With Serial Control<<<>>>the AAT4290 And AAT4291 Smartswitch Products<<<>>>are Members of Aati's Application Specific<<<>>>power MOSFET (ASPM ) Product Family With<<<>>>five
AAT7551 20V P-channel Power MOSFET<<<>>>the AAT7551 is a Dual Low Threshold MOSFET<<<>>>designed For The Battery, Cell Phone, And Pda Markets.<<<>>>using Analogictech 's Ultra High Density<<<>>>mosFET Process
AAT8303 20V P-channel Power MOSFET
ABA3100 Balanced Low Noise Amplifier
ACA0861 750/860 MHZ Catv Line Amplifier Mmic
ACA0861A 750/860 MHZ Catv Line Amplifier
ACA0861AS7C 750/860 MHZ Catv Line Amplifier Mmic
ACA0861B 750/860 MHZ Catv Line Amplifier
ACA0861BS7C 750/860 MHZ Catv Line Amplifier Mmic
ACA0861C 750/860 MHZ Catv Line Amplifier
ACA0861CS7C 750/860 MHZ Catv Line Amplifier Mmic
ACA0861D 750/860 MHZ Catv Line Amplifier
ACA0861DS7C 750/860 MHZ Catv Line Amplifier Mmic
ACA1205 750/870 MHZ Catv Line Amplifier Mmic

AAT3242ITP-WN-T1 : 300mA/150mA Dual CMOS LDO Linear Regulatorthe AAT3242 is a Dual Low Dropout Linearregulator With Power ok Outputs. Two Integratedregulators Provide a High Power 300mA Output Anda Lower Power 150mA Output, Making This Deviceideal For Use With Microprocessors And DSP Core

AAT3510 : Micropower P Reset With Watchdog Timerthe AAT351x Powermanager Products Aremembers of Analogictech 's Total Powermanagement ic Product Family. This Family Ofmicroprocessor Reset Circuits Provides The Ultimatein Versatility, Allowing System Designers Fullcustomiza

AWT906DS6 :

AWM6430 : WiMAX 802.16 Power Amplifiers The ANADIGICS AWM6430 WiMAX Power Amplifier is a high performance device that delivers exceptional linearity and efficiency at high levels of output power. Designed to operate in the 3.5 GHz band, it supports the IEEE 802.16-2004 and ETSI EN301-021 wireless standards.

AWL9924 : WLAN 802.11 Power Amplifiers The ANADIGICS AWL9924 dual band power amplifier is a high performance InGaP HBT IC designed for transmit applications in the 2.4-2.5 GHz and 4.9-5.9 GHz band. Matched to 50 Ω at all RF inputs and outputs, the part requires no additional RF matching components of

APS3623 : 1 GHz Three-way Active Power Splitter Optimized for Moca-enabled Subscriber Equipment

EVA9224RS28 : 2.4 GHz 802.11b/g WLAN Power Amplifier

AWU6608RM45Q7 : 880 MHz - 915 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER Specifications: Amplifier Type: Power Amplifier ; Applications: RF Microwave ; Frequency Range: 880 to 915 MHz ; Minimum Gain: 13 dB ; Package Type: 4 X 4 MM, 1 MM HEIGHT, ROHS COMPLIANT, MINIATURE, M49 PACKAGE-10 ; Nominal Impedance: 50 ; Operating Temperature: -30 to 90 C (-22 to 194 F)

0-C     D-L     M-R     S-Z