|
Details, datasheet, quote on part number:9SPOP2
| |
Datasheet text preview:
Documentation Number 9SPOP23401 pg. 1/1
9-Pin RS-232 to RS-232 Port-Powered Optical Isolator CE
Model 9SPOP2 The Model 9SPOP2 optically isolates both the RS-232 transmit and receive lines. The isolator has a DB9S female connector on the DTE side and a DB9P male connector on the DCE side. Signals pass through the isolator as shown below. When connecting the Model 9SPOP2, it is recommended that all signals that are outputs be connected. The Model 9SPOP2 derives power from these signals, even if they are not used by your system. On a DTE device with a DB9 pin connector, the following lines are outputs: 3-TX (Transmit) 4 DTR (Data Terminal Ready) 7 RTS (Request To Send) On a DCE device with a DB9 pin connector, the following lines are outputs 1 DCD (Data Carrier Detect) 2 RX (Receive) 6 DSR (Data Set Ready) 8 CTS (Clear To Send)
T O DTE DB9S 3 TX 2 RX 4 DTR
Po we r C onv er s io C ir c uits
T O DCE DB9P 3 TX 2500 Volt Optical Isolation Zone 2 RX 1 DCD
P ow e r C onv e rs io C ir c uits
7 RTS 5 GND
6 DSR 8 CTS 5 GND
Typical DTE devices include PCs, terminals, and printers. Typical DCE devices include modems and multiplexers. Most DTE ports are male and most DCE ports are female. If the 9SPOP2 is inserted into a working system, it will only pass signals if inserted correctly. If the devices communicate with each other without the 9SPOP2 inline, but not when it is installed, simply reverse the isolator. If your port meets the low voltage requirements of RS-562, you will not be able to use this isolator. An RS-562 port will only produce about 3.7 volts, which is not adequate to power the isolator. Typically the only devices that have this type of port are palmtop or very low power laptop computers. NOTE: Connecting an external power supply to the handshake lines may damage the isolator. Contact technical support for more information on connecting an external power supply to the handshake lines. Specifications: Transmission Mode: Interface: Signals Supported: Data Rates: Power Requirements: Isolation: Dimensions: Asynchronous, half or full duplex, point-to-point RS-232 Transmit Data, Receive Data DECLARATION OF CONFORMITY 0 to 115.2K bps Manufacturer's Name: B&B Electronics Manufacturing Company Manufacturer's Address: P.O. Box 1040 Port-powered from RS-232 data 707 Dayton Road and handshake lines. Ottawa, IL 61350 USA Model Number: 9SPOP2 2500V RMS isolation for 1 minute Description: 2-Channel RS-232 Optical Isolator 2.4"L x 1.3"W x 0.66"H Type: Light industrial ITE equipment (6.1L x 3.3W x 1.7H cm) Application of Council Directive: 89/336/EEC
Standards: EN 50082-1:1998 EN 50082-1:1992 IEC 801(-2, -3, -4) EN 61000 (-4-2, -4-3, -4-4, -4-6)
Michael J. Fahrion, Director of Engineering
© B&B Electronics Revised September 2001
This product designed and manufactured in USA of domestic and imported parts by
|
|
