Details, datasheet, quote on part number: XJ109
DescriptionN-channel JFET Switch
CompanyCalogic, LLC
DatasheetDownload XJ109 datasheet
Find where to buy


Features, Applications

FEATURES Low Cost Automated Insertion Package Low Insertion Loss No Offset or Error Voltages Generated by Closed Switch Purely Resistive High Isolation Resistance from Driver Fast Switching Low Noise

APPLICATIONS Analog Switches Choppers Commutators Low-Noise Audio Amplifiers

ABSOLUTE MAXIMUM RATINGS (TA = 25oC unless otherwise specified) Gate-Drain or Gate-Source Voltage. -25V Gate Current. 50mA Storage Temperature Range. to +150oC Operating Temperature Range. to +135oC Lead Temperature (Soldering, 10sec). +300oC Power Dissipation. 360mW Derate above 3.3mW/ oC

NOTE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions above those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

ORDERING INFORMATION Part Package J108-110 Plastic TO-92 XJ108-110 Sorted Chips in Carriers SST109-110 Plastic SOT-23

SYMBOL IGSS VGS(off) BVGSS IDSS ID(off) rDS(on) Cdg(off) Csg(off) Cdg(on) + Csg(on) td(on) tr td(off) tf PARAMETER Gate Reverse Current (Note 1) Gate-Source Cutoff Voltage Gate-Source Breakdown Voltage Drain Saturation Current (Note 2) Drain Cutoff Current (Note 1) Drain-Source ON Resistance Drain-Gate OFF Capacitance Source-Gate OFF Capacitance Drain-Gate Plus Source-Gate ON Capacitance Turn On Delay Time Rise Time Turn OFF Delay Time Fall Time

TEST CONDITIONS VDS = 0V, VGS = -15V VDS 1 A VDS = -1A VDS = 15V, VGS = 0V VDS = 5V, VGS = -10V VDS 0.1V, VGS = 0V VDS = 0, VGS = -10V (Note = 1MHz VDS = VGS = 0 (Note 3) Switching Time Test Conditions (Note J109 J110 VDD 1.5V VGS(off) RL 150

NOTES: 1. Approximately doubles for every 10 C increase in TA. 2. Pulse test duration = 300s; duty cycle 3%. 3. For design reference only, not 100% tested.


Related products with the same datasheet
Some Part number from the same manufacture Calogic, LLC
XJ110 N-channel JFET Switch
XM116 Diode Protected N-channel Enhancement Mode MOSFET General Purpose Amplifier
XPAD1-100 Low Leakage Pico Amp Diodes
XSD200 High-speed Analog N-channel Enhancement-mode DmosFETs
XSD2100 N-channel Depletion Mode Lateral DmosFET
XSD212 High-speed Analog N-channel DmosFETs
XSD215 High-speed Analo N-channel DmosFETs
XSD310 High-speed Analog N-channel DmosFETs Improved on -resistance
XSD400 High-speed Analog N-channel/enhancement-mode DmosFETs
XSD403 High Speed Dmos N-channel Switch
XSD411 N-channel Enhancement Mode Dual DmosFET
XSD5000 High-speed Dmos Quad Fet Analog Switch Arrays
XSD5300 Quad Dmos Analog Switch Driver Improved Performance Over Sd5000n And Sd5400cy
XSD5400 High-speed Dmos Quad Fet Analog Switch Arrays

CL432BD : 1.25vprecision Adjustable Shunt Reference / Amplifier

CLM2930A-4 : 150ma Low Dropout Voltage Regulators

LP2950ACN-3 : 3 V, 10 ma Low Dropout Voltage Regulator

TL431LP : Precision Adjustable Shunt Reference

X2N5485 : 25 V, N-channel JFET High Frequency Amplifier

CVA2456T : CRT Driver Amplifiers

OP-01Z : Inverting High-speed Operational Amplifier

CA506TR1 : 1.4 mA, SILICON, CURRENT REGULATOR DIODE Specifications: Configuration: Single ; Package: PLASTIC PACKAGE-2 ; Pin Count: 2 ; Number of Diodes: 1 ; PD: 360 milliwatts

CLM4041DNTR1 : 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PBCY3 Specifications: Package Type: TO-92, Other, TO-92, 3 PIN ; VREF: 1.2 to 1.25 volts ; TC: 150 ppm/C ; Operating Temperature: -40 to 85 C (-40 to 185 F)

0-C     D-L     M-R     S-Z