Stability R/R 1 % for ° C Pure tin solder contacts on Ni barrier layer provides compatibility with lead (Pb)-free and lead containing soldering processes Metal glaze on high quality ceramic Compliant to RoHS Directive 2002/95/EC Halogen-free according to IEC 61249-2-21 definition AEC-Q200 qualified
SIZE MODEL INCH METRIC RATED DISSIPATION W 0.063 LIMITING RESISTANCE TEMPERATURE ELEMENT RANGE COEFFICIENT TOLERANCE % VOLTAGE ppm/K Umax. AC/DC to 10M SERIES E96 E24
Zero-Ohm-Resistor: Rmax. 20 m, Imax. 7.0 A Notes These resistors do not feature a limited lifetime when operated within the permissible limits. However, resistance value drift increasing over operating time may result in exceeding a limit acceptable to the specific application, thereby establishing a functional lifetime. Marking: See data sheet "Surface Mount Resistor Marking" (document number 20020). Power rating depends on the max. temperature at the solder point, the component placement density and the substrate material.
This datasheet is subject to change without notice. THE PRODUCT DESCRIBED HEREIN AND THIS DATASHEET ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
PARAMETER Rated dissipation P70 (1) Limiting element voltage Umax. AC/DC Insulation voltage Uins (1 min) Insulation resistance Category temperature range Failure rate Weight D12/ D25/ UNIT W V
Note (1) The power dissipation on the resistor generates a temperature rise against the local ambient, depending on the heat flow support of the printed-circuit board (thermal resistance). The rated dissipation applies only if the permitted film temperature °C is not exceeded.
Product Description: e3 D11/CRCW0603 MODEL CRCW2512 100 TCR ± 200 ppm/K ± 100 ppm/K 562R RESISTANCE VALUE 0R0 = Jumper 1% TOLERANCE ±1% ET6 PACKAGING ET9 e3 LEAD (Pb)-FREE e3 = Pure tin termination finish
MODEL UNIT 180 mm/7" PAPER TAPE ON REEL ACC. TO IEC 60286-3, TYPE I BLISTER TAPE ON REEL ACC. TO IEC 60286-3, TYPE II
QUANTITY PART NUMBER PRODUCT DESC. QUANTITY PART NUMBER PRODUCT DESC. E67 E82