Details, datasheet, quote on part number: IDT54FCT16240ETEB
PartIDT54FCT16240ETEB
CategoryLogic => Bus Interface => Bus Oriented Circuits
TitleBus Oriented Circuits
DescriptionFast CMOS 16-bit Buffer/line Driver
CompanyIntegrated Device Technology, Inc.
DatasheetDownload IDT54FCT16240ETEB datasheet
Quote
Find where to buy
 
  

 

Features, Applications

0.5 MICRON CMOS Technology High-speed, low-power CMOS replacement for ABT functions Typical tSK(o) (Output Skew) < 250ps Low input and output leakage 1A (max.) VCC 5V 10% High drive outputs (32mA IOH, 64mA IOL) Power off disable outputs permit "live insertion" Typical VOLP (Output Ground Bounce) 1.0V at VCC = 25C Available in SSOP and TSSOP packages

The FCT16240T 16-bit buffer/line driver is built using advanced dual metal CMOS technology. These high-speed, low-power devices offer bus/backplane interface capability with improved packing density. The flow-through organization of signal pins simplifies layout. The three-state controls are designed to operate these devices in a Quad-Nibble, Dual-Byte or single 16-bit word mode. All inputs are designed with hysteresis for improved noise margin. The FCT16240T is ideally suited for driving high capacitance loads and lowimpedance backplanes. The output buffers are designed with power off disable capability to allow "live insertion" of boards when used as backplane drivers.

The IDT logo is a registered trademark of Integrated Device Technology, Inc.

Symbol Description Terminal Voltage with Respect to GND Storage Temperature DC Output Current Max to +120 Unit C mA

NOTES: 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. 2. All device terminals except FCT162XXX Output and I/O terminals 3. Output and I/O terminals for FCT162XXX.

Symbol CIN COUT Parameter(1) Input Capacitance Output Capacitance Conditions VIN = 0V VOUT = 0V Typ. 3.5 Max. 6 8 Unit pF

NOTE: 1. This parameter is measured at characterization but not tested.

Pin Names x OE xAx xYx Data Inputs 3-State Outputs Description 3-State Output Enable Inputs (Active LOW)

NOTE: H = HIGH Voltage Level L = LOW Voltage Level X = Don't Care Z = High-Impedance
Following Conditions Apply Unless Otherwise Specified: Industrial: to +85C, VCC 5.0V 10%

Symbol VIH VIL IIH Parameter Input HIGH Level Input LOW Level Input HIGH Current (Input pins)(5) Input HIGH Current (I/O pins)(5) IIL Input LOW Current (Input pins)(5) Input LOW Current (I/O pins)(5) IOZH IOZL VIK IOS VH ICCL ICCH ICCZ High Impedance Output Current (3-State Output pins)(5) Clamp Diode Voltage Short Circuit Current Input Hysteresis Quiescent Power Supply Current VCC = Max. VIN = GND or VCC = Min., IIN = 18mA VCC = Max., = GND(3) VCC = Max. VI = GND Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic LOW Level VCC = Max. VI = VCC Typ.(2)

Symbol IO VOH Parameter Output DriveCurrent Output HIGH Voltage Test Conditions(1) VCC = Max., = 2.5V(3) VCC = Min. VIN = VIH or VIL IOH = 3mA IOH = 15mA IOH = 32mA(4) VOL IOFF Output LOW Voltage Input/Output Power Off Leakage(5) VCC = Min. VIN = VIH or VIL VCC = 0V, VIN 1 A

NOTES: 1. For conditions shown as Min. or Max., use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC 5.0V, +25C ambient. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Duration of the condition can not exceed one second 5. The test limit for this parameter = 55C.


 

Related products with the same datasheet
IDT54FCT16240ATE
IDT54FCT16240ATEB
IDT54FCT16240ATPA
IDT54FCT16240ATPAB
IDT54FCT16240ATPF
IDT54FCT16240ATPFB
IDT54FCT16240ATPV
IDT54FCT16240ATPVB
IDT54FCT16240CT
IDT54FCT16240CTE
IDT54FCT16240CTEB
IDT54FCT16240CTPA
Some Part number from the same manufacture Integrated Device Technology, Inc.
IDT54FCT16240ETPA Fast CMOS 16-bit Buffer/line Driver
IDT54FCT16240T
IDT54FCT16244
IDT54FCT16244AT
IDT54FCT16244ET
IDT54FCT16244ETE
IDT54FCT16244T
IDT54FCT16245 Fast CMOS 16-bit Bidirectional Transceiver
IDT54FCT16245AT Fast CMOS 16-bit Bi-directional Transceiver
IDT54FCT162500 Fast CMOS 18-bit Registered Transceiver

IDT72T51556L6BBI : 32Q X36 2M Multi-Queue, 2.5V

IDT74FCT138CTEB : CMOS/BiCMOS->FCT/FCT-T Family Fast CMOS 1-of-8 Decoder With Enable

ICS843252AGLFT : Clock/timing - Clock Generators, Plls, Frequency Synthesizer Integrated Circuit (ics) Clock/Frequency Synthesizer, Clock Generator, Multiplexer Tube 3.135 V ~ 3.465 V; IC CLK GENERATOR LVPECL 16-TSSOP Specifications: Type: Clock/Frequency Synthesizer, Clock Generator, Multiplexer ; PLL: Yes with Bypass ; Input: LVCMOS, LVTTL, Crystal ; Output: LVPECL ; Frequency - Max: 187.5MHz ; Number of Circuits: 1 ; Ratio - Input Output: 2 2 ; Differential - Input Output: No/Yes ; Divider/Multiplier: Yes/No ;

ICS950908YFLF-T : 200.4 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56 Specifications: Device Type: Clock Generator ; Package Type: Surface Mount, SSOP, 0.300 INCH, MO-118, SSOP-56 ; Supply Voltage: 3.14 to 3.46 volts ; Frequency: 14.32 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features / Standards: RoHS, Lead-Free

IDT70V9269L12PRFGI8 : 16K X 16 DUAL-PORT SRAM, 25 ns, PQFP128 Specifications: Memory Category: SRAM Chip ; Density: 262 kbits ; Number of Words: 16 k ; Bits per Word: 16 bits ; Package Type: TQFP, 14 X 20 MM, 1.40 MM HEIGHT, TQFP-128 ; Pins: 128 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 25 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

IDT7140SA20L48G : 1K X 8 DUAL-PORT SRAM, 100 ns, CDIP48 Specifications: Memory Category: SRAM Chip ; Density: 8 kbits ; Number of Words: 1 k ; Bits per Word: 8 bits ; Package Type: DIP, SIDE BRAZED, DIP-48 ; Pins: 48 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 100 ns ; Operating Temperature: -40 to 85 C (-40 to 185 F)

IDT72T55248L6-7BBG : 32K X 18 OTHER FIFO, PBGA256 Specifications: Memory Category: FIFO ; Density: 590 kbits ; Number of Words: 32 k ; Bits per Word: 18 bits ; Package Type: BGA, 17 X 17 MM, 1 MM PITCH, PLASTIC, BGA-256 ; Pins: 256 ; Logic Family: CMOS ; Supply Voltage: 2.5V ; Cycle Time: 7.5 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

M2006-02A-672.1600 : PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), CQCC36 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, 9 X 9 MM, CERAMIC, LCC-36 ; Supply Voltage: 3.14 to 3.46 volts ; Frequency: 700 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features / Standards: RoHS, Lead-Free

 
0-C     D-L     M-R     S-Z