Details, datasheet, quote on part number: IDT54FCT16827ATPAB
PartIDT54FCT16827ATPAB
CategoryLogic => Bus Interface => Bus Oriented Circuits
TitleBus Oriented Circuits
DescriptionFast CMOS 20-bit Buffer
CompanyIntegrated Device Technology, Inc.
DatasheetDownload IDT54FCT16827ATPAB datasheet
Quote
Find where to buy
 
  

 

Features, Applications

0.5 MICRON CMOS Technology High-speed, low-power CMOS replacement for ABT functions Typical tSK(o) (Output Skew) < 250ps Low input and output leakage 1A (max.) VCC 5V 10% High drive outputs (32mA IOH, 64mA IOL) Power off disable outputs permit "live insertion" Typical VOLP (Output Ground Bounce) 1.0V at VCC = 25C Available in SSOP and TSSOP packages

The FCT16827T 20-bit buffer is built using advanced dual metal CMOS technology. These 20-bit bus drivers provide high-performance bus interface buffering for wide data/address paths or buses carrying parity. Two pair of NAND-ed output enable controls offer maximum control flexibility and are organized to operate the device as two 10-bit buffers or one 20-bit buffer. Flowthrough organization of signal pins simplifies layout. All inputs are designed with hysteresis for improved noise margin. The FCT16827T is ideally suited for driving high capacitance loads and low impedance backplanes. The output buffers are designed with power off disable capability to allow "live insertion" of boards when used as backplane drivers.

The IDT logo is a registered trademark of Integrated Device Technology, Inc.

Symbol Description Terminal Voltage with Respect to GND Terminal Voltage with Respect to GND Storage Temperature DC Output Current Max to +120 Unit C mA

NOTES: 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. 2. All device terminals except FCT162XXX Output and I/O terminals. 3. Outputs and I/O terminals for FCT162XXX.

Symbol CIN COUT Parameter(1) Input Capacitance Output Capacitance Conditions VIN = 0V VOUT = 0V Typ. 3.5 Max. 6 8 Unit pF

NOTE: 1. This parameter is measured at characterization but not tested.
Pin Names OE x xAx xYx Data Inputs 3-State Outputs Description Output Enable Inputs (Active LOW)
NOTE: H = HIGH voltage level L = LOW voltage level X = Don't care Z = High-Impedance
Following Conditions Apply Unless Otherwise Specified: Industrial: to +85C, VCC 5.0V 10%

Symbol VIH VIL IIH IIL IOZH IOZL VIK IOS VH ICCL ICCH ICCZ Parameter Input HIGH Level Input LOW Level Input HIGH Current (Input pins)(5) Input HIGH Current (I/O pins)(5) Input LOW Current (Input pins)(5) Input LOW Current (I/O pins)(5) High Impedance Output Current (3-State Output pins)(5) Clamp Diode Voltage Short Circuit Current Input Hysteresis Quiescent Power Supply Current VCC = Max VIN = GND or VCC = Min., IIN = 18mA VCC = Max., = GND(3) VCC = Max. VI = GND Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic LOW Level VCC = Max. VI = VCC Min. 80 Typ.(2) Max. mV A Unit V A

Symbol IO VOH Parameter Output Drive Current Output HIGH Voltage VCC = Max., VO = VCC = Min. VIN = VIH or VIL VOL IOFF Output LOW Voltage Input/Output Power Off Leakage(5) VCC = Min. VIN = VIH or VIL VCC = 0V, VIN 1 A

NOTES: 1. For conditions shown as Min. or Max., use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC 5.0V, +25C ambient. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Duration of the condition can not exceed one second. 5. This test limit for this parameter = 55C.


 

Related products with the same datasheet
IDT54FCT16827ATE
IDT54FCT16827ATEB
IDT54FCT16827ATPA
IDT54FCT16827ATPF
IDT54FCT16827ATPFB
IDT54FCT16827ATPV
IDT54FCT16827ATPVB
IDT54FCT16827BT
IDT54FCT16827BTE
IDT54FCT16827BTEB
IDT54FCT16827BTPA
Some Part number from the same manufacture Integrated Device Technology, Inc.
IDT54FCT16827ATPF Fast CMOS 20-bit Buffer
IDT54FCT16827ET Fast CMOS 20-bit Buffers
IDT54FCT16827ETE Fast CMOS 20-bit Buffer
IDT54FCT16841 Fast CMOS 20-bit Transparent Latch
IDT54FCT16841AT
IDT54FCT16841ET Fast CMOS 20-bit Transparent Latches
IDT54FCT16841ETE Fast CMOS 20-bit Transparent Latch
IDT54FCT16952AT Fast CMOS 16-bit Registered Transceiver

IDT74FCT162260CTPA : 12-Bit Latched, Bi-directional Tri-port Bus Exchanger

IDT74FCT299C : CMOS/BiCMOS->FCT/FCT-T Family Fast CMOS 8-input Universal Shift Register

MK74CG117AF : Clock/timing - Clock Generators, Plls, Frequency Synthesizer Integrated Circuit (ics) Clock Generator Tube 3.14 V ~ 3.47 V; IC CLK GEN 16OUTPUT 48-SSOP Specifications: Type: Clock Generator ; PLL: Yes ; Input: Clock, Crystal ; Output: Clock ; Frequency - Max: 90MHz ; Number of Circuits: 1 ; Ratio - Input Output: 1 17 ; Differential - Input Output: No/No ; Divider/Multiplier: Yes/Yes ; Voltage - Supply: 3.14 V ~ 3.47 V ; Operating Temperature: 0C ~

ICS83940BYIT : LOW SKEW CLOCK DRIVER, 18 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, 7 X 7 MM, 1.40 MM HEIGHT, MS-026, LQFP-32 ; Supply Voltage: 2.38 to 2.62 volts ; Skew: 100 ps ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features / Standards: RoHS, Lead-Free

IDT7015S35GGB : 8K X 9 DUAL-PORT SRAM, 12 ns, CPGA68 Specifications: Memory Category: SRAM Chip ; Density: 74 kbits ; Number of Words: 8 k ; Bits per Word: 9 bits ; Package Type: 1.18 X 1.18 INCH, 0.16 INCH HEIGHT, GREEN, CERAMIC, PGA-68 ; Pins: 68 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 12 ns ; Operating Temperature: 0 to 70 C (32 to

IDT7016S12JG8 : 16K X 9 DUAL-PORT SRAM, 12 ns, PQCC68 Specifications: Memory Category: SRAM Chip ; Density: 147 kbits ; Number of Words: 16 k ; Bits per Word: 9 bits ; Package Type: PLASTIC, LCC-68 ; Pins: 68 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 12 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

IDT70V3579S5DR : 16K X 36 DUAL-PORT SRAM, 4.2 ns, CBGA256 Specifications: Memory Category: SRAM Chip ; Density: 590 kbits ; Number of Words: 16 k ; Bits per Word: 36 bits ; Package Type: BGA, 17 X 17 MM X 1.4 MM, 1 MM PITCH, GREEN, BGA-256 ; Pins: 256 ; Supply Voltage: 3.3V ; Access Time: 4.2 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

M2006-02A-670.8386 : PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), CQCC36 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, 9 X 9 MM, CERAMIC, LCC-36 ; Supply Voltage: 3.14 to 3.46 volts ; Frequency: 700 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features / Standards: RoHS, Lead-Free

71V3557S80BG8 : IC,SYNC SRAM,128KX36,CMOS,BGA,119PIN,PLASTIC Specifications: Memory Category: SRAM Chip

7201LA30LGB : 512 X 9 OTHER FIFO, 30 ns, CDIP28 Specifications: Memory Category: FIFO ; Density: 5 kbits ; Number of Words: 512 k ; Bits per Word: 9 bits ; Package Type: DIP, 0.600 INCH, CERAMIC, DIP-28 ; Pins: 28 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 30 ns ; Cycle Time: 40 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F

7205L50JG : 8K X 9 OTHER FIFO, 50 ns, PQCC32 Specifications: Memory Category: FIFO ; Density: 74 kbits ; Number of Words: 8 k ; Bits per Word: 9 bits ; Package Type: PLASTIC, LCC-32 ; Pins: 32 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 50 ns ; Cycle Time: 65 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

84321AYILF : 260 MHz, OTHER CLOCK GENERATOR, PQFP32 Specifications: Device Type: Clock Generator ; Package Type: Surface Mount, 7 X 7 MM, 1.40 MM HEIGHT, MS-026BBA, LQFP-32 ; Supply Voltage: 3.14 to 3.46 volts ; Frequency: 40 MHz ; Operating Temperature: -40 to 85 C (-40 to 185 F)

 
0-C     D-L     M-R     S-Z