Details, datasheet, quote on part number: IDT54FCT16827BTPA
PartIDT54FCT16827BTPA
CategoryLogic => Bus Interface => Bus Oriented Circuits
TitleBus Oriented Circuits
DescriptionFast CMOS 20-bit Buffer
CompanyIntegrated Device Technology, Inc.
DatasheetDownload IDT54FCT16827BTPA datasheet
Quote
Find where to buy
 
  

 

Features, Applications

0.5 MICRON CMOS Technology High-speed, low-power CMOS replacement for ABT functions Typical tSK(o) (Output Skew) < 250ps Low input and output leakage 1A (max.) VCC 5V 10% High drive outputs (32mA IOH, 64mA IOL) Power off disable outputs permit "live insertion" Typical VOLP (Output Ground Bounce) 1.0V at VCC = 25C Available in SSOP and TSSOP packages

The FCT16827T 20-bit buffer is built using advanced dual metal CMOS technology. These 20-bit bus drivers provide high-performance bus interface buffering for wide data/address paths or buses carrying parity. Two pair of NAND-ed output enable controls offer maximum control flexibility and are organized to operate the device as two 10-bit buffers or one 20-bit buffer. Flowthrough organization of signal pins simplifies layout. All inputs are designed with hysteresis for improved noise margin. The FCT16827T is ideally suited for driving high capacitance loads and low impedance backplanes. The output buffers are designed with power off disable capability to allow "live insertion" of boards when used as backplane drivers.

The IDT logo is a registered trademark of Integrated Device Technology, Inc.

Symbol Description Terminal Voltage with Respect to GND Terminal Voltage with Respect to GND Storage Temperature DC Output Current Max to +120 Unit C mA

NOTES: 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. 2. All device terminals except FCT162XXX Output and I/O terminals. 3. Outputs and I/O terminals for FCT162XXX.

Symbol CIN COUT Parameter(1) Input Capacitance Output Capacitance Conditions VIN = 0V VOUT = 0V Typ. 3.5 Max. 6 8 Unit pF

NOTE: 1. This parameter is measured at characterization but not tested.
Pin Names OE x xAx xYx Data Inputs 3-State Outputs Description Output Enable Inputs (Active LOW)
NOTE: H = HIGH voltage level L = LOW voltage level X = Don't care Z = High-Impedance
Following Conditions Apply Unless Otherwise Specified: Industrial: to +85C, VCC 5.0V 10%

Symbol VIH VIL IIH IIL IOZH IOZL VIK IOS VH ICCL ICCH ICCZ Parameter Input HIGH Level Input LOW Level Input HIGH Current (Input pins)(5) Input HIGH Current (I/O pins)(5) Input LOW Current (Input pins)(5) Input LOW Current (I/O pins)(5) High Impedance Output Current (3-State Output pins)(5) Clamp Diode Voltage Short Circuit Current Input Hysteresis Quiescent Power Supply Current VCC = Max VIN = GND or VCC = Min., IIN = 18mA VCC = Max., = GND(3) VCC = Max. VI = GND Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic LOW Level VCC = Max. VI = VCC Min. 80 Typ.(2) Max. mV A Unit V A

Symbol IO VOH Parameter Output Drive Current Output HIGH Voltage VCC = Max., VO = VCC = Min. VIN = VIH or VIL VOL IOFF Output LOW Voltage Input/Output Power Off Leakage(5) VCC = Min. VIN = VIH or VIL VCC = 0V, VIN 1 A

NOTES: 1. For conditions shown as Min. or Max., use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC 5.0V, +25C ambient. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Duration of the condition can not exceed one second. 5. This test limit for this parameter = 55C.


 

Related products with the same datasheet
IDT54FCT16827ATE
IDT54FCT16827ATEB
IDT54FCT16827ATPA
IDT54FCT16827ATPAB
IDT54FCT16827ATPF
IDT54FCT16827ATPFB
IDT54FCT16827ATPV
IDT54FCT16827ATPVB
IDT54FCT16827BT
IDT54FCT16827BTE
IDT54FCT16827BTEB
Some Part number from the same manufacture Integrated Device Technology, Inc.
IDT54FCT16827BTPAB Fast CMOS 20-bit Buffer
IDT54FCT16827ET Fast CMOS 20-bit Buffers
IDT54FCT16827ETE Fast CMOS 20-bit Buffer
IDT54FCT16841 Fast CMOS 20-bit Transparent Latch
IDT54FCT16841AT
IDT54FCT16841ET Fast CMOS 20-bit Transparent Latches
IDT54FCT16841ETE Fast CMOS 20-bit Transparent Latch
IDT54FCT16952AT Fast CMOS 16-bit Registered Transceiver
IDT54FCT16H244ATE Fast CMOS 16-bit Buffer/line Driver

IDT7143SA : Multiport->32K High Speed 2k X 16 Dual-port SRAM

IDT74FCT16823ETPA8 : 18-Bit Register

IDT74FCT2373CTD : CMOS/BiCMOS->FCT/FCT-T Family Fast CMOS Octal Transparent Latch

IDT71V2579YS80BQI : 128K x 36,256k x 18 3.3V Synchronous Srams 2.5V I/o,flow-through Outputs Burst Counter,single Cycle Deselect

IDT7016L12J8 : Multi-Ports 16K X 9 Dual-port RAM

IDT71V421S35TF : 2K X 8 DUAL-PORT SRAM, 25 ns, PQCC52 Specifications: Memory Category: SRAM Chip ; Density: 16 kbits ; Number of Words: 2 k ; Bits per Word: 8 bits ; Package Type: 0.750 X 0.750 INCH, 0.170 INCH HEIGHT, GREEN, PLASTIC, LCC-52 ; Pins: 52 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 25 ns ; Operating Temperature: 0 to 70 C (

IDT72420L10TC : 64 X 8 OTHER FIFO, 6.5 ns, UUC28 Specifications: Memory Category: FIFO ; Density: 1 kbits ; Number of Words: 64 k ; Bits per Word: 8 bits ; Package Type: DIE ; Pins: 28 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 6.5 ns ; Cycle Time: 10 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

54FCT374TLBB : FCT SERIES, 8-BIT DRIVER, TRUE OUTPUT, DIP20 Specifications: Technology: CMOS ; Device Type: Line / Bus Driver ; Supply Voltage: 5V ; Operating Temperature: -55 to 125 C (-67 to 257 F) ; Package Type: CERDIP-20 ; Pins: 20

71V3556SA166BQI : 128K X 36 ZBT SRAM, 5 ns, PBGA119 Specifications: Memory Category: SRAM Chip ; Density: 4719 kbits ; Number of Words: 128 k ; Bits per Word: 36 bits ; Package Type: BGA, 14 X 22 MM, ROHS COMPLIANT, PLASTIC, MS-028AA, BGA-119 ; Pins: 119 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 5 ns ; Operating Temperature: 0 to 70

72V3612L12PFG : 64 X 36 BI-DIRECTIONAL FIFO, 8 ns, PQFP120 Specifications: Memory Category: FIFO ; Density: 2 kbits ; Number of Words: 64 k ; Bits per Word: 36 bits ; Package Type: TQFP, TQFP-120 ; Pins: 120 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 8 ns ; Cycle Time: 12 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

 
0-C     D-L     M-R     S-Z