Details, datasheet, quote on part number: 6GBUSeries
Part6GBUSeries
CategoryPower Management => AC-DC Controllers/Converters => Bridge Rectifiers
Description6.0 Amp Single Phase Full Wave Bridge Rectifier
CompanyInternational Rectifier Corp.
DatasheetDownload 6GBUSeries datasheet
  

 

Features, Applications

Features

Diode chips are glass passivated Suitable for Universal hole mounting Easy to assemble & install on P.C.B. High Surge Current Capability High Isolation between terminals and molded case (1500 VRMS) Lead free terminals solderable as per MIL-STD-750 Method 2026 Terminals suitable for high temperature soldering at 260C for 8-10 secs UL E160375 approved

Description

These GBU Series of Single Phase Bridges consist of four glass passivated silicon junction connected as a Full Wave Bridge. These four junctions are encapsulated by plastic molding technique. These Bridges are mainly used in Switch Mode power supply and in industrial and consumer equipment.

Type number Voltage Code VRRM , max repetitive peak rev. voltage = TJ max. V VRMS , max RMS voltage = TJ max. V IRRM max. @ rated VRRM 25C A IRRM max. @ rated VRRM 150C A

IO IFSM Maximum DC output current Maximum peak, one-cycle non-repetitive surge current, following any rated load condition and with rated VRRM reapplied I2t VFM IRM VRRM Maximum 2 t for fusing, initial = TJ max Maximum peak forward voltage per diode Typical peak reverse leakage curren t per diode Maximum repetitive peak reverse voltage range = 25 oC, IFM = 25 oC, 100% VRRM = 150 oC, 100% VRRM = 150C

TJ Tstg RthJC RthJA W T Operating and storage temperature range Max. thermal resistance junction to case Thermal resistance, junction to ambient Approximate weight Mounting Torque C/ W C/ W g (oz) Nm Lb.in Bridge to Heatsink DC rated current through bridge (1) DC rated current through bridge (1)

Note (1): Bridge mounted on Aluminum heat sink of dim x 1.5mm, use silicon thermal compound heat transfer and bolt down using 3mm screw

Bridge current Basic Part Number Voltage Code: code 100 = VRRM

 

Some Part number from the same manufacture International Rectifier Corp.
6TQ Schottky Rectifier 6 Amp
6TQ035 35V 6A Schottky Discrete Diode in a TO-220AC Package
6TQTQ035 Schottky Rectifier 6 Amp
70/300UR Standard Recovery Diodes
70300U Standard Recovery Diodes Stud Version
70CRU02 200V 35A Ultra-fast Doubler Diode in a TO-218 Package
70CRU04 400V 70A Ultra-fast Doubler Diode in a TO-218 Package
70EPF02 200V Fast Recovery Diode in a Powirtab Package
70EPF08 800V Fast Recovery Diode in a Powirtab Package
70EPS Input Rectifier Diode
70EPS08 800V 70A Std. Recovery Diode in a Powirtab (Short) Package
70HA100 Standard Recovery Diodes
70HA120
70HA140
70HA160
70HA40
70HA60
70HA80
70HF
70HF10 100V 70A Std. Recovery Diode in a DO-203AB (DO-5)package
70HFL100S05 1000V Fast Recovery Diode in a DO-203AB (DO-5) Package

IRLML2502PBF : 20V Single N-channel Lead Free HexFET Power MOSFET in a Micro3 Package

P405KW : 400V 40A 2 SCR Traverse Bridge in a Pace-pak Package

AFL5006SX : 28V Input, Single Output Hybrid-high Reliability Dc/dc Converter

IRKL57/04AS90 : Thyristor/ Diode and Thyristor/ Thyristor

IR2110STRPBF : Pmic - Mosfet, Bridge Driver - External Switch Integrated Circuit (ics) Non-Inverting Digi-Reel 2.5A 10 V ~ 20 V; IC DRIVER HIGH/LOW SIDE 16SOIC Specifications: Configuration: High and Low Side, Independent ; Voltage - Supply: 10 V ~ 20 V ; Current - Peak: 2.5A ; Delay Time: 120ns ; Package / Case: 16-SOIC (0.295", 7.50mm Width) ; Packaging: Digi-Reel ; Number of Outputs: 2 ; Input Type: Non-Inverting ; Number of Configurations: 1 ; Operati

IRFIZ24N-030PBF : 14 A, 60 V, 0.1 ohm, N-CHANNEL, Si, POWER, MOSFET Specifications: Polarity: N-Channel ; MOSFET Operating Mode: Enhancement ; V(BR)DSS: 60 volts ; rDS(on): 0.1000 ohms ; Number of units in IC: 1

IRG4RC10KDTRRPBF : 9 A, 600 V, N-CHANNEL IGBT, TO-252AA Specifications: Polarity: N-Channel ; Package Type: LEAD FREE, DPAK-3 ; Number of units in IC: 1

IRLI530G-030 : 9.7 A, 100 V, 0.16 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB Specifications: Polarity: N-Channel ; MOSFET Operating Mode: Enhancement ; V(BR)DSS: 100 volts ; rDS(on): 0.1600 ohms ; Package Type: TO-220, TO-220, 3 PIN ; Number of units in IC: 1

RP1000-5CJ-Z-R : 3-OUTPUT 1000 W AC-DC PWR FACTOR CORR MODULE Specifications: Package Type: Other, LOW PROFILE MODULE ; Output Voltage: 3 to 5.75 volts ; Input Voltage: 85 to 265 volts ; Output Power: 1000 watts (1.34 HP) ; Operating Temperature: 0.0 to 70 C (32 to 158 F)

Same catergory

IR3086 : Xphase Phase ic With Ovp With Fault Overtemp Detect. The IR3086 Phase ic Combined With an IR Xphase TM Control ic Provides a Full Featured And Flexible Way to Implement Power Solutions For The Latest High Performance Cpus And Asics..

LTC1703 : Step-Down. LTC1703, Dual 550kHz Synchronous 2-Phase Switching Regulator Controller With Vid.

MAX709L : Power Supply Monitor With 4.65V Reset Threshold. The MAX709 provides a system reset during power-up, power-down, and brownout conditions. When VCC falls below the reset threshold, RESET goes low and holds the P in reset for 140ms min after VCC rises above the threshold. The RESET output is guaranteed be in the correct state with V CC down to 1V. The MAX709 provides excellent circuit reliability and low cost.

SPX385-1.2 : Vref = 1.235 ;; Vin (MAX) = N/a ;; Operating Current = 10µA-20mA ;; Acc = 1.3%, 2.4% ;; Temp. (ppm/°C) = 30 ;; Ref = N/a ;; Package = 3 Pin TO-92 3 Pin SOT-89 8 Pin Soic.

TPDV625--1225 : Alternistors. High commutation: 88A/ms (400Hz) Insulating voltage = 2500V(RMS) (UL Recognized: EB81734) High voltage capability: VDRM = 1200V The TPDV625 TPDV1225 use a high performance passivated glass alternistor technology. Featuring very high commutation levels and high surge current capability, this family is well adapted to power control on inductive load (motor,.

TPS70358PWP : ti TPS70358, Dual-output Low-dropout (LDO) Voltage Regulators. TPS70358, TPS70302 DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS Applications Selectable Power Up Sequencing for DSP Applications (See TPS704xx for Independent Enabling of Each Output) Output Current Range A on Regulator 1 and A on Regulator 2 Fast Transient Response Voltage Options Are 3.3-V/1.5-V,.

UC3824 : Current Mode PWM Controllers. High Speed PWM Controller. Complementary Outputs Practical Operation Switching Frequencies 1MHz 50ns Propagation Delay to Output High Current Dual Totem Pole Outputs (1.5A Peak) Wide Bandwidth Error Amplifier Fully Latched Logic with Double Pulse Suppression Pulse-by-Pulse Current Limiting Soft Start / Max. Duty Cycle Control Under-Voltage Lockout with Hysteresis Low Start Up Current.

UCC28051 : PFC Controller For Low to Medium Power Applications Requiring Compliance With Iec 1000-3-2.

UCC3958 : Monitor/Supervisory. Single Cell Lithium-ion Battery Protection Circuit.

X4645 : Cpu Supervisor With 64K EePROM. Selectable watchdog timer Low VCC detection and reset assertion --Four standard reset threshold voltages --Adjust low VCC reset threshold voltage using special programming sequence --Reset signal valid to VCC = 1V Low power CMOS --<20A max standby current, watchdog on --<1A standby current, watchdog off --3mA active current 64Kbits of EEPROM.

SP6132H : Dual Supply Synchronous Buck Controller * 3V to 28V Step Down Achieved Using Dual Input * On-Board 1.5Ω sink (2Ω source) NFET Drivers * Up to 30A Output Capability * Highly Integrated Design, Minimal Components * UVLO Detects Both VCC and VIN * Short Circuit Protection with Auto-Restart * Wide BW Amp Allows Type II or III Compensation * Programmable.

CM2830GEIM23 : 300mA CMOS LDO The CM2830/CM2830A family is a positive voltage linear regulator developed utilizing CMOS technology featured low quiescent current (30 ÂA typ.), low dropout voltage, and high output voltage accuracy. Built-in low on-resistance transistor provides low dropout voltage and large output current. A 2.2 ÂF or greater can be used as an output.

MAX8971 : Industry\'s Smallest 1.55A 1-Cell Li+ DC-DC Charger The MAX8971 is a compact, high-frequency, high-efficiency switch-mode charger for a one-cell lithium-ion (Li+) battery. It delivers up to 1.55A of current to the battery from inputs up to 7.5V and withstands transient inputs up to 22V. The 4MHz switch-mode charger is ideally suited for small portable.

 
0-C     D-L     M-R     S-Z