Details, datasheet, quote on part number: 5962D9569202VEA
Part5962D9569202VEA
CategoryCommunication => DSL (Digital Subscriber Line) => DSL Analog Front Ends
DescriptionRadiation Hardened Single 8/differential 4-channel CMOS Analog Multiplexers
CompanyIntersil Corporation
DatasheetDownload 5962D9569202VEA datasheet
Cross ref.Similar parts: MPC506, MPC508
Quote
Find where to buy
 
  

 

Features, Applications

Radiation Hardened Single 8/Differential 4-Channel CMOS Analog Multiplexers

These radiation hardened monolithic CMOS multiplexers each include an array of eight analog switches, a digital decode circuit for channel selection, a voltage reference for logic thresholds, and an ENABLE input for device selection when several multiplexers are present. The Dielectric Isolation (DI) process used in fabrication of these devices eliminates the problem of latch-up. Also, DI offers much lower substrate leakage and parasitic capacitance than conventional junction-isolated CMOS. Switches are guaranteed to break-before-make, so that two channels are never shorted together. The switching threshold for each digital input is established by an internal +5V reference, providing a guaranteed minimum 2.4V for logic "1" and maximum 0.8 for logic "0". This allows direct interface without pull-up resistors to signals from most logic families: CMOS, TTL, DTL and some PMOS. For protection against transient overvoltage, the digital inputs include a series 200 resistor and a diode clamp to each supply. The is an eight channel single-ended multiplexer, and the is a four channel differential version. If input overvoltage protection is needed, the HS-0548RH and HS-0549RH multiplexers are recommended. Specifications for Rad Hard QML devices are controlled by the Defense Supply Center in Columbus (DSCC). The SMD numbers listed here must be used when ordering. Detailed Electrical Specifications for these devices are contained in SMD 5962-95692. A "hot-link" is provided on our homepage for downloading. http://www.intersil.com/spacedefense/space.htm

Features

Electrically Screened to SMD # 5962-95692 QML Qualified per MIL-PRF-38535 Requirements Gamma Dose. 104RAD(Si) No Latch-Up No Channel Interaction During Overvoltage Low On Resistance. <200 (Typ) 44V Maximum Power Supply Break-Before-Make Switch Analog Signal Range. ±15V Access Time. <300ns (Typ)

Applications
Data Acquisition Systems Control Systems Telemetry

ORDERING NUMBER 5962D9569202VEA 5962D9569202VEC INTERNAL MKT. NUMBER HS1-0509RH-Q HS1B-0509RH-Q TEMP. RANGE (oC) to 125

HS-0508RH GDIP1-T16 (CERDIP) OR CDIP2-T16 (SBDIP) TOP VIEW HS-0509RH GDIP1-T16 (CERDIP) OR CDIP2-T16 (SBDIP) TOP VIEW

CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. http://www.intersil.com 407-727-9207 | Copyright © Intersil Corporation 1999

HS-0509RH TRUTH TABLE A0 EN "ON" CHANNEL PAIR NONE

Q4 D3 LEVEL SHIFTER V+ LEVEL SHIFTED ADDRESS TO DECODE LEVEL SHIFTED ADDRESS TO DECODE R10 TTL REFERENCE CIRCUIT

FIGURE 1. ADDRESS INPUT BUFFER AND LEVEL SHIFTER
ENABLE DELETE OR A3 INPUT FOR HI-507 DELETE OR A3 INPUT FOR HI-508 DELETE OR A2 INPUT FOR HI-509

 

Related products with the same datasheet
5962D9569202VEC
Some Part number from the same manufacture Intersil Corporation
5962D9569202VEC Radiation Hardened Single 8/differential 4-channel CMOS Analog Multiplexers
5962D9569301V9A Radiation Hardened Single 16/differential 8 Channel CMOS Analog Multiplexers With Active Overvoltage Protection
5962D9569302V9A
5962D9569401VEA Radiation Hardened Single 8/differential 4 Channel CMOS Analog Multiplexers With Active Overvoltage Protection
5962D9569402VEA
5962F0152101QXC Radiation Hardened 9a, Non-inverting Power MOSFET Drivers
5962F0250301QXC Radiation Hardened Negative Low Dropout Adjustable Voltage Regulator
5962F0254201QXC Single-event Hardened, Single Supply, Quad Operational Amplifier
5962F0324801QXC Radiation Hardened, 9a, Non-inverting Power MOSFET Driver
5962F9467602VPA Radiation Hardened, Ultra High Speed Current Feedback Amplifier
5962F9563002QXC Rad-hard 16 Channel CMOS Analog Multiplexer With High-z Analog Input Protection
5962F9563201QEC Radiation Hardened Quad Differential Line Driver
5962F9563501QXC Radiation Hardened Real Time Express Microcontroller
5962F9565101V9A Radiation Hardened Quad 2-input And Gate
5962F9568701QGA Radiation Hardened Programmable Low Power op Amp
5962F9666301QEC Radiation Hardened Quad Differential Line Driver
5962F9669601QXC Radiation Hardened CMOS 8-bit Flash Analog-to-digital Converter
5962F9670301VCC Radiation Hardened Quad 2-input NAND Gate With Open Drain
5962F9670401VEC Radiation Hardened Dual J-k Flip-flop
5962F9670501VCC Radiation Hardened Quad Buffer, Three-state
5962F9670601VEC Radiation Hardened 4-bit Synchronous Counter
Same catergory

AD8390 : Low Power, DSL co Driver Amplifier. One Technology Way P.O. Box 9106 Norwood, MA 02062-9106 Tel: 781/329-4700 Fax: 781/326-8703 www.analog.com INTRODUCTION The EVAL-PRAOPAMP evaluation board accommodates single op amps in many packages. It is meant to provide the user with multiple choices and extensive flexibility for different applications circuits and configurations. For evaluation.

CS6707 : 200Mbps Fiber Optic Led Driver. GENERAL The is a high-speed fiber optic LED driver ideally suited for applications to 200Mbps. The CS6707 accepts differential PECL inputs which can be shaped, if desired, by pins PWAI (Pulse Width Adjust Increase) or PWAD (Pulse Width Adjust Decrease). Simply leave these two pins unconnected if no adjustment is needed, then default mark/space ratio.

EL1517 : XDSL Differential Line Driver. The is a dual operational amplifier designed for VDSL and ADSL line driving in DMT based solutions. This device a high drive capability of 250mA while consuming only 7mA of supply current per amplifier and operating from a single to 12V supply. This driver achieves a typical distortion at 150kHz into a 25 load. The EL1517 is available in the industry-standard.

HC55171 : PCM Line Card->Line Interface. 5 Ren Ringing Slic For Isdn Modem/ta And WLL.

HFBR-5103 : Fast Ethernet. 125 MBD Atm And Fast Ethernet Transceiver in Low Cost 1x9 Package: SC Receptacle.

HT9302 : 1-memory/2-memory Tone/pulse Dialer. Universal Operating voltage: 2.0V~5.5V Low standby current Low memory retention current: 0.1mA (typ.) Tone/pulse switchable Interface with LCD driver 32 digits for redialing 32 digits for SA memory dialing One-key redialing Pause and P®T key for PBX 4´4 keyboard matrix 3.58MHz crystal or ceramic resonator Hand-free control Hold-line control Pause, P®T can be saved.

M-88L70 : 3v DTMF Receiver. Operates between 2.7 and 3.6 volts Low power consumption Power-down mode Inhibit mode Central office quality and performance Inexpensive 3.58 MHz time base Adjustable acquisition and release times Dial tone suppression Functionally compatible with Clare's M-8870 Applications Telephone switch equipment Mobile radio Remote control Paging systems PCMCIA.

MC54HC4053AJ : Analog Multiplexers/demultiplexers. The MC54/74HC4051A, MC74HC4052A and MC54/74HC4053A utilize silicon­gate CMOS technology to achieve fast propagation delays, low ON resistances, and low OFF leakage currents. These analog multiplexers/ demultiplexers control analog voltages that may vary across the complete power supply range (from VCC to VEE). The HC4051A, HC4052A and HC4053A are identical.

MF0032M-11ATXX : 8/16-bit Data Bus Flash Ata PC Card. Mitsubishi's Flash ATA cards provide large memory capacities on a device approximately the size of a credit card or 5mm(T)). The cards use an 8/16 bit data bus. Available - 512MB capacities, Mitsubishi's Flash ATA cards conform to the JEIDA/PCMCIA standard. In default mode, the ATA card operates in PC Card compliant sockets. It conforms to PCMCIA 2.1,JEIDA.

ML6622 : High-speed Data Quantizer. The ML6622 high-speed data quantizer (post-amplifier) is a low noise, wide-band, BiCMOS monolithic IC designed for high-speed signal recovery applications, such as FDDI, Fast Ethernet, and ATM. An internal DC restoration feedback loop nulls any offset voltage produced in the input stage. The limiting amplifier contributes to a high level of sensitivity.

N74F182D : Look-ahead Carry Generator. Provides carry look-ahead across a group of four ALUs Multi-level look-ahead for high speed arithmetic operation over The is a high speed carry look-ahead generator. It accepts up to four pairs of active-Low Carry Propagate P2, P3) and Carry Generate G2, G3) signals and an active-High Carry input (Cn) and provides anticipated active-High carries (Cn+x,.

NJG1521PE1 : Tdma Antenna Switch GAAS Mmic. n GENERAL is an antenna switch IC for a digital cellular phone of 800MHz and 1.5GHz band. The parallel control signals of three bits connect T/R circuits to internal two antennas or external two antennas. The termination ports with external matching circuits make low interference between diversity antennas. The Ultra small & thin FFP24-E1 package is applied.

PC87108AVHG : Advanced Uart And Infrared Controller. The is a serial communications device with infrared capability. It supports 6 modes of operation and is backward compatible with the 16550 and 16450. The operational modes are: UART, Sharp-IR, IrDA 1.0 SIR, IrDA 1.1 MIR and FIR, and Consumer Electronics IR (also referred as TV Remote or Consumer Remote Control). The device provides two methods to allow.

SK70704 : Broadband & Access. Networking & Communications - Broadband & Access Products - DSL Components - SK70704/ 70706 HDSL Data Pump Chipset.

SL74HC4053 : Analog Multiplexer/demultiplexer. The SL74HC4053 utilize silicon-gate CMOS technology to achieve fast propagation delays, low ON resistances, and low OFF leakage currents. These analog multiplexers/demultiplexers control analog voltages that may vary across the complete power supply range (from VCC to VEE). The Channel-Select inputs determine which one of the Analog Inputs/Outputs to be connected,.

TC9162AN : High Voltage Analog Function Switch Array.

TC9172AP : High Speed PLL With Built-in Prescaler.

U9280M-H : RF Identification. 4-bit Microcontroller Plus Transponder Front End For Combination of Remote Control And Immobilizer Function..

UPF01002 : 10 Gigabit/s Ethernet Transceiver With Oc-192c Framer And Xaui Interface.

WS82C55A-5C : CMOS Programmable Peripheral Interface. Pin Compatible with NMOS 8255A 24 Programmable I/O Pins Fully TTL Compatible High Speed, No "Wait State" Operation with 5MHz 80C86 and 8MHz 80C88 Direct Bit Set/Reset Capability Enhanced Control Word Read Capability L7 Process 2.5mA Drive Capability on All I/O Ports Low Standby Power (ICCSB).10µA The is a high performance CMOS version of the industry.

 
0-C     D-L     M-R     S-Z