|Category||Analog & Mixed-Signal Processing => Amplifiers => Operational Amplifiers => Precision => Single|
|Description||Precision Operational Amplifier|
|Company||Linear Technology Corporation|
|Datasheet||Download RH37C datasheet
The RH37C combines very low noise with excellent precision and high speed specifications. The low 1/f noise corner frequency of 2.7Hz combined with 3.5nVHz 10Hz noise and low offset voltage make the RH37C an excellent choice for low frequency military instrumentation applications. The wafer lots are processed to LTC's in-house Class S flow to yield circuits usable in stringent military applications. For complete electrical specifications and performance curves see the OP-27/OP-37 data sheet.
Supply Voltage..................................................... ± 22V Internal Power Dissipation................................ 500mW Input Voltage........................... Equal to Supply Voltage Output Short-Circuit Duration......................... Indefinite Differential Input Current (Note ± 25mA Operating Temperature Range............. to 125°C Junction Temperature Range............... to 150°C Storage Temperature Range................ to 150°C Lead Temperature (Soldering, 10 sec)................. 300°C
SYMBOL PARAMETER VOS Temp VOS Time IOS IB Input Offset Voltage Average Offset Drift Long-Term Input Offset Voltage Stability Input Offset Current Input Bias Current CONDITIONS NOTES MINSUBGROUP TA 125°C MIN TYP MAX SUBGROUP UNITS µVP-P nV/Hz pV/Hz V dB V/mV V V/µs MHz mW
Input Noise Current Density Input Resistance Common Mode Input Voltage Range
Common Mode Rejection Ratio Power Supply Rejection Ratio Large-Signal Voltage Gain
Maximum Output Voltage Swing Slew Rate Gain-Bandwidth Product
SYMBOL PARAMETER VOS IOS IB Input Offset Voltage Input Offset Current Input Bias Current Input Resistance Common Mode Input Voltage Range CMRR PSRR AVOL VOUT ZO PD Common Mode Rejection Ratio Power Supply Rejection Ratio Large-Signal Voltage Gain Maximum Output Voltage Swing Slew Rate Power Dissipation VCM 2k 4 CONDITIONS NOTES (Typ) 170
Note 1: Input offset voltage measurements are performed by automatic test equipment approximately 0.5 seconds after application of power. Note 2: Long-term input offset voltage stability refers to the average trend line of offset voltage vs time over the first 30 days of operation. Excluding the initial hour of operation, changes in VOS during the first 30 days are typically 2.5µV. Refer to the typical performance curves. Note 3: Sample tested to an LTPD 15 on every lot. Contact factory for 100% testing of 10Hz voltage density noise. Note 4: Parameter is guaranteed by design, characterization, or correlation to other tested parameters. Note 5: See test circuit and frequency response curve for to 10Hz tester on OP-27/OP-37 data sheet. Note 6: See test circuit for current noise measurement on OP-27/OP-37 data sheet. Note 7: The average input offset drift performance is within the specifications unnulled or when nulled with a pot having a range to 20k. Note 8: The RH37C's inputs are protected by back-to-back diodes. Current limiting resistors are not used in order to achieve low noise. If differential input voltage exceeds ± 0.7V, the input current should be limited to 25mA. Note ± 15V, VCM = 0V unless otherwise noted. Note ± 15V, VCM = 0V, unless otherwise noted.
Information furnished by Linear Technology Corporation is believed to be accurate and reliable. However, no responsibility is assumed for its use. Linear Technology Corporation makes no representation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
|Some Part number from the same manufacture Linear Technology Corporation|
|SG1524 Regulating Pulse Width Modulator|
|SL30495 Zero Drift Rail-to-rail In/out Precision in Amp For Use With LTC1923 in Tec Apps|
|T1070HV 5a And 2.5a High Efficiency Switching Regulators|
|T1074HV Step-down Switching Regulator|
|LTC4063 Standalone Linear Li-Ion Charger with Micropower Low Dropout Linear RegulatorThe LTC®4063 is a standalone linear charger for single cell lithium-ion batteries with an adjustable low dropout linear regulator|
|LT3483 Inverting Micropower DC/DC Converter with Schottky in ThinSOT PackageThe LT®3483 is a micropower inverting DC/DC converter with integrated Schottky and one resistor feedback. The small package size,|
|LT5525 High Linearity, Low Power Downconverting MixerThe LT®5525 is a low power broadband mixer optimized for high linearity applications such as point-to-point data transmission, high performance radios and wireless|
|LTC3406B-1.2 1.5MHz, 600mA Synchronous Step-Down Regulator in ThinSOTThe LTC®3406B-1.2 is a high efficiency monolithic synchronous buck regulator using a constant frequency, current mode architecture. Supply current|
|LTC3803-5 Constant Frequency Current Mode Flyback DC/DC Controller in ThinSOTVIN and VOUT Limited Only by External Components 4.8V Undervoltage Lockout Threshold Operating Junction Temperature from –40°C to 150°C|
|LT3434 High Voltage 3A, 200kHz Step-Down Switching Regulator with 100µA Quiescent CurrentWide Input Range: 3.3V to 60V 3A Peak Switch Current Burst Mode® Operation: 100µA Quiescent Current** Low Shutdown|
|LTC2924 Quad Power Supply SequencerThe LTC®2924 is a power supply sequencer designed for use with external N-channel MOSFETs or power supplies with shutdown pins. Four power supplies can be fully sequenced by a single|
2SC4682 : NPN Epitaxial Type ( Strobe Flash, Medium Power Amplifier Applications ).
AC2626 : General Purpose Temperature Probe.
AD5533 : 32-Channel Infinite Sample-and-hold. Infinite Sample-and-Hold Capability to 0.018% Accuracy High Integration: 32-Channel SHA 12 mm2 LFBGA Per Channel Acquisition Time 16 s max Adjustable Voltage Output Range Output Voltage Span 10 V Output Impedance 0.5 Readback Capability DSP-/Microcontroller-Compatible Serial Interface Parallel Interface Temperature Range to +85C APPLICATIONS Level Setting.
LA4471 : Btl-ocl 20W Power Amplifier For Car Stereo Use.
LF153 : Wide Bandwidth Dual J-FET Operational Amplifiers. WIDE BANDWIDTH DUAL J-FET OPERATIONAL AMPLIFIERS s LOW INPUT BIAS AND OFFSET CURRENT s OUTPUT SHORT-CIRCUIT PROTECTION s HIGH INPUT IMPEDANCE JFET INPUT s INTERNAL FREQUENCY COMPENSATION s LATCH UP FREE OPERATION s HIGH SLEW RATE : 16V/µs (typ) ORDER CODE The LF353 are high speed JFET input dual operational amplifiers incorporating well matched, high.
LM710 : Voltage Comparator (discontinued). The LM710 series are high-speed voltage comparators intended for use as an accurate, low-level digital level sensor as a replacement for operational amplifiers in comparator applications where speed is of prime importance. The circuit has a differential input and a single-ended output, with saturated output levels compatible with practically all types.
LMC6041 : LMC6041 - CMOS Single Micropower Operational Amplifier, Package: Soic Narrow, Pin Nb=8.
LV1150 : . The is a virtual surround system Bi-CMOS IC for video soundtracks and audio. The main feature of this IC is the ability to create an audio ambience equivalent to that of a multichannel system by adding a signal to which virtual surround processing has been applied to the left and right channel input signals. It furthermore allows modification of this.
MSM56V16160DH : 2-bank X 524,288-word X 16-bit Synchronous Dynamic RAM. The ¥ 16-bit synchronous dynamic RAM, fabricated in Oki's CMOS silicon-gate process technology. The device operates 3.3 V. The inputs and outputs are LVTTL compatible. Silicon gate, quadruple polysilicon CMOS, 1-transistor memory cell ¥ 16-bit configuration 3.3 V power supply, 0.3 V tolerance Input : LVTTL compatible Output : LVTTL compatible Refresh.
NJU7091A : Low-power And Low-offset-voltage Tiny Single C-mos Operational Amplifier.
PF08103A : MOSFET Power Amplifier Module For E-gsm900 And Dcs1800 Dual Band Handy Phone.
TLV2464AID : ti TLV2464A, Quad Low Power, Rail-to-rail Input/output Operational Amplifier.
TS461 : Output Rail to Rail Op-amps. s HIGH DYNAMIC s LARGE OUTPUT SWING The TS46x is operational amplifiers able to operate with voltages as low as ±1.35V and to reach a minimum ±2Vpp of output swing when supplied with ±2.5V. This device is well suited for every kind of portable and battery-supplied equipment where low noise and low distortion are key. The TS461/2/4 are a cost-attractive.
OPA379 : 1.8V, 2.9uA, 90kHz Rail-to-Rail I/O Operational Amplifier The OPA379 family of micropower, low-voltage operational amplifiers is designed for battery-powered applications. These amplifiers operate on a supply voltage as low as 1.8V. High-performance, single-supply operation with rail-to-rail capability makes the OPA379 family useful for a wide range.
ADA4941-1 : Single-Supply Differential 18-Bit ADC Driver The ADA4941-1 is a low power, differential driver for 16- to 18-bit ADCs. Configured in an easy-to-use, single-ended-to-differential G = +2 configuration, the ADA4941-1 requires no external components to drive ADCs with differential inputs provided that the IN- pin is tied to the OUT+ pin. A resistive network.
INA213 : Voltage Output, High/Low-Side Measurement, Bi-Directional Zero-Drift Series Current Shunt Monitor The INA210, INA211, INA212, INA213, and INA214 are voltage output current shunt monitors that can sense drops across shunts at common-mode voltages from –0.3V to 26V, independent of the supply voltage. Five fixed gains are available: 50V/V, 100V/V, 200V/V,.