Details, datasheet, quote on part number: LSI20160L
CategoryInterface and Interconnect => SCSI => SCSI driver development
TitleSCSI driver development
DescriptionPci to Single Channel Ultra160 Scsi Low Profile Host Adapter User's Guide V1.0 2/01
CompanyLSI Logic Corporation
DatasheetDownload LSI20160L datasheet


Features, Applications

LSI20160L PCI to Single Channel Ultra160 SCSI Low Profile Host Adapter

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Shielded cables for SCSI connection external to the cabinet are used in the compliance testing of this Product. LSI Logic is not responsible for any radio or television interference caused by unauthorized modification of this equipment or the substitution or attachment of connecting cables and equipment other than those specified by LSI Logic. The correction of interferences caused by such unauthorized modification, substitution, or attachment will be the responsibility of the user. The LSI Logic LSI20160L is tested to comply with FCC standards for home or office use.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

LSI Logic Corporation North American Headquarters Milpitas, CA 408.433.8000

This document contains proprietary information of LSI Logic Corporation. The information contained herein is not to be used by or disclosed to third parties without the express written permission of an officer of LSI Logic Corporation. LSI Logic products are not intended for use in life-support appliances, devices, or systems. Use of any LSI Logic product in such applications without written consent of the appropriate LSI Logic officer is prohibited. Document DB15-000154-00, First Edition (February 2001) This document describes the LSI Logic LSI20160L PCI to Single Channel Ultra160 SCSI Low Profile PCI Host Adapter and will remain the official reference source for all revisions/releases of this product until rescinded by an update. To receive product literature, visit us at LSI Logic Corporation reserves the right to make changes to any products herein at any time without notice. LSI Logic does not assume any responsibility or liability arising out of the application or use of any product described herein, except as expressly agreed to in writing by LSI Logic; nor does the purchase or use of a product from LSI Logic convey a license under any patent rights, copyrights, trademark rights, or any other of the intellectual property rights of LSI Logic or third parties. Copyright 2001 by LSI Logic Corporation. All rights reserved. TRADEMARK ACKNOWLEDGMENT The LSI Logic logo design, TolerANT, SDMS, LVDlink, SCRIPTS, Nextreme, and SureLINK are registered trademarks or trademarks of LSI Logic Corporation. All other brand and product names may be trademarks of their respective companies. MH


Some Part number from the same manufacture LSI Logic Corporation
LSI20860 Pci to Ultra Scsi Host Adapter User's Guide V1.1 1/01
LSI21002 Pci to Dual Channel Scsi Host Adapter User's Guide V1.1 11/00
LSI21003 Pci to Dual Channel Scsi Host Adapter User's Guide V1.0 10/00
LSI21040 Pci to Dual Channel Ultra 160 Scsi Host Adapter User's Guide V1.1 11/00
LSI22902 Host Adapter to Intel ISP1100 Internet Server Quick Installation Guide V1.1 11/00
LSI22910 Pci to Dual Channel Pci to Ultra2 Scsi Host Adapter User's Guide V1.1 12/00
LSI22915A Pci to Dual Channel Ultra160 Scsi Host Adapter User's Guide V1.2 4/01
LSI401Z Digital Signal Processor
LSI402ZX Detailedoverview of Features, Specifications, Functional Waveforms,signal Descriptions, Functional Descriptions, Instruction Setsummary And Block Diagram
LSI40909G-S Pci to Fibre Channel Host Adapter For Sun Solaris User's Guide Erratum-E1 V1.0 4/01
LSI53C040 Enclosure Services Processor Programming Guide V1.1 12/00
LSI53C1000 Pci to Ultra160 Scsi Controller Technical Manual V2.1 2/01
LSI53C1000R Pci to Ultra160 Scsi Controller Technical Manual V2.1 5/01
LSI53C1010-33 Pci to Dual Channel Ultra160 Scsi Multifunction Controller Technical Manual V3.2 2/01
LSI53C1010-66 Pci to Dual Channel Ultra160 Scsi Multifunction Controller Technical Manual V2.1 2/01

80C200 : Full Duplex CMOS Ethernet 10/100 Mega Bit/sec Data Link Controller

DQ8020 : MCC Manchester Code Converter Manual

L84221 :

LSI8751SPE : SCSI driver development Pci to Ultra Scsi Host Adapter User's Guide V1.1 11/00

SAS1064 : Serial Attached Scsi (SAS) Dual-port And 3 Gb/s Transfer Rates Using The World S First 2.5-inch Enterprise Disc Drives And Lsi Logic SAS1064 Controller Ics.


SYM20811 : SCSI driver development Pci to Fast Scsi Host Adapter User's Guide

SYM65C02 :

SYM92C03-M :


DMN-8633 : DoMiNo® 8633 HDTV DVD Recorder Processor Highly integrated, single-chip processor for ATSC regions The DMN-8633 is part of the third generation family of DVD recorder system processors based on the DoMiNo® architecture. Addressing the worldwide transition from analog to digital, and specifically

Same catergory

AM26LS31 : Quad Rs422a Differential Line Driver: 4 Drivers. Meets or Exceeds the Requirements of ANSI TIA/EIA-422-B and ITU Recommendation V.11 Operates From a Single 5-V Supply TTL Compatible Complementary Outputs High Output Impedance in Power-Off Conditions Complementary Output-Enable Inputs The is a quadruple complementary-output line driver designed to meet the requirements of ANSI TIA/EIA-422-B and ITU (formerly.

AS2701 : Actuator Sensor Interface (up to 31 Slaves). Simple two-wire bus (ASI line) Transmission of both power and signal on the ASI line Decoupling of power and signal by the IC without additional external devices Transmitting protocol for using the IC and the ASI master in the transmit/receive modes Switching of max. 31 ASI slave ICs on one bus possible Power supply of peripheral devices from the ASI slave.

BT16543DGG : 16-bit Latched Transceivers With Dual Enable 3-state. Product Supersedes data of 1995 Aug 17 IC23 Data Handbook 1998 Feb 27 Two 8-bit octal transceivers with D-type latch Live insertion/extraction permitted Power-up 3-State Power-up reset Multiple VCC and GND pins minimize switching noise Back-to-back registers for storage Separate controls for data flow in each direction 74ABTH16543 incorporates bus-hold.

DS21S07A : Scsi Terminator. Fully compliant with SCSI­1, Fast SCSI and Ultra Backward compatible to the DS2107 and DS2107A Provides active termination for nine signal lines Laser­trimmed 110 ohm termination resistors have Low dropout voltage regulator Power­down mode isolates termination resistors DS21S07AS 16­PIN SOIC (300 MIL) TERMPWR1 HS­GND R4 R5 HS­GND VREF1 GND PD VREF2.

LB1817W : . The is a spindle motor driver for low-profile floppy disk drives. Three-phase full-wave linear drive (with external PNP transistor) Low saturation voltage Built-in digital speed control Start/stop circuit (Low active) Switchable rotation speed Current limiter circuit Built-in index processing circuit Index timing adjustable by VR AGC circuit Thermal.

LTC1322C : Rs232/eia562/rs485 Transceivers. 2-EIA562/RS232 Transceivers/2-RS485 Transceivers 4-EIA562/RS232 Transceivers/2-RS485 Transceivers 4-EIA562 Transceivers/2-RS485 Transceivers with OE LTC1321/LTC1322 Have the Same Pinout SP301/SP302 LTC1335 Receiver Three-State Outputs Low Supply Current: 1mA Typical 15µA Supply Current in Shutdown or RS232 Mode in RS485/RS422 Mode Self-Testing Capability.

LX5115A : Terminator. Ultra 9-channel Scsi Terminator. The LX5115A SCSI terminator is part of Linfinity's UltraMAX family of high-performance, adaptive, non-linear mode SCSI products, which are designed to deliver true UltraSCSI performance in SCSI applications. The low voltage BiCMOS architecture employed in its design offers superior performance to older linear passive and active techniques. Linfinity's.

M54685L : 2-phase Motor Driver With Governor. The is a semiconductor integrated circuit that is capable of directly driving a smallsize bi-directional motor rotating in both forward and reverse directions. Output 1 FF speed control O1 FSC RSC O2 GND Speed control R input L input Standby input Power supply PSC R L STB VCC q Wide range of operating voltage (VCC 14V) q Possible direct driving with.

MSM7652 : Ntsc/pal Digital Video Encoder. The is a digital NTSC/PAL encoder. By inputting digital image data conforming to ITU Rec. 656 or ITURBT 601, it outputs selected analog composite video signals, analog S video signals or Y, R-Y, B-Y signals. For the scanning system, interlaced or noninterlaced mode can be selected. Since the MSM7652 is provided with pins dedicated to overlay function,.

MT8930CE : 4 Wire Digital Subscriber Line Interfaces. = 4 Wire Full-duplex 2B+D (192Kb/s) Data Format Isdn S And T Subscriber Network Interface Circuit With Controllerless Mode ;; Package Type = Pdip ;; No. Of Pins = 28.

PCF8574ADGVR : I2C Functions. ti PCF8574A, Remote 8-Bit I/o Expander For I2C-Bus. Low Standby-Current Consumption 10 µA Maximum I2C to Parallel-Port Expander Open-Drain Interrupt Output Compatible With Most Microcontrollers Latched Outputs With High-Current Drive Capability for Directly Driving LEDs Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II This 8-bit I/O expander for the two-line bidirectional bus (I2C) is designed.

SN65C1154 : . Meet or Exceed the Requirements of TIA/EIA-232-F and ITU Recommendation V.28 Very Low Power Consumption. 5 mW Typ Wide Driver Supply Voltage. ±15 V Driver Output Slew Rate Limited to 30 V/µs Max Receiver Input Hysteresis. 1000 mV Typ Push-Pull Receiver Outputs On-Chip Receiver 1-µs Noise Filter The SN65C1164 and SN75C1154 are low-power BiMOS devices.

SN65LBC176AQDREP : ti SN65LBC176A-EP, Military Enhanced Plastic Differential Bus Transceivers.

SN75512CDW : ti SN75512, Vacuum Fluorescent Display Drivers. Each Device Drives 12 Lines 60-V Output Voltage Swing Capability 25-mA Output Source Current Capability High-Speed Serially-Shifted Data Input TTL-Compatible Inputs Latches on All Driver Outputs The SN65512C and SN75512C are monolithic BIDFET integrated circuits designed to drive a dot matrix or segmented vacuum fluorescent display. All device inputs.

TSB12LV23APZT : Link Layer Controllers. ti TSB12LV23A, Ieee 1394-1995, 1394a Serial Link Layer Controller.

TUSB3200A : . IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the latest relevant information before placing orders.

SCAN12100 : The SCAN12100 is a 1228.8 and 614.4 Mbps serializer/deseralizer (SerDes) for high-speed bidirectional serial data transmission over FR-4 printed circuit board backplanes, balanced cables, and optical fiber. The SCAN12100 integrates precision delay calibration measurement (DCM) circuitry that measures link delay components to better than ± 800 ps accuracy.

1.5 Gbps 2X2 LVDS Crosspoint Switch from the Power : 1.5 Gbps 2X2 LVDS Crosspoint Switch From The PowerWise?? Family The DS10CP152 is a 1.5 Gbps 2x2 LVDS crosspoint switch optimized for high-speed signal routing and switching over lossy FR-4 printed circuit board backplanes and balanced cables. Fully differential signal paths ensure exceptional signal integrity and noise immunity. The non-blocking architecture.

ADUM6402 : Quad-Channel Isolators With Integrated DC-to-DC Converter The ADuM640x1 devices are quad-channel digital isolators with isoPower®, an integrated, isolated dc-to-dc converter. Based on the Analog Devices, Inc., iCoupler® technology, the dc-to-dc converter provides up to 500 mW of regulated, isolated power at either 5.0 V or 3.3 V from a 5.0 V input supply,.

0-C     D-L     M-R     S-Z