Details, datasheet, quote on part number: A72
PartA72
CategoryRF & Microwaves => Amplifiers => Power Amplifiers => LNAs
TitleLNAs
Description 5 to 500 MHZ TO-8 Cascadable Amplifier
CompanyM/A-COM, Inc.
DatasheetDownload A72 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

TO 500 MHz TO-8 CASCADABLE AMPLIFIER LOW POWER DRAIN 31mA (TYP.) HIGH OUTPUT LEVEL +12.5 dBm (TYP.) HIGH IP3 +28 dBm (TYP.) @ Vcc = +8 Vdc

Characteristics Frequency Small Signal Gain (min.) Gain Flatness (max.) Reverse Isolation Noise Figure (max.) Power Output 1 dB comp. (min.) IP3 IP2 Second Order Harmonic IP VSWR Input / Output (max.) DC Current @ 5 Volts (max.) Typical

is a standard A72 installed in a miniature SMA connectorized housing and guaranteed over to 50░C temperature range. Measured a 50-ohm system at +5 Vdc Nominal. Subject to change without notice.

Storage Temperature Max. Case Temperature Max. DC Voltage Max. Continuous RF Input Power Max. Short Term RF Input Power (1 minute max.) Max. Peak Power (3 Ásec max.) "S" Series Burn-in Temperature (Case)

Thermal Resistance jc Transistor Power Dissipation Pd Junction Temperature Rise Above Case Tjc
Package Figure Model BG A72 Surface Mount AA SMA72 SMA Connectorized CE CA72

Specifications subject to change without notice. North America: 1-800-366-2266 Visit www.macom.com for complete contact and product information.


 

Related products with the same datasheet
SMA72
Some Part number from the same manufacture M/A-COM, Inc.
A73  5 to 500 MHZ TO-8 Cascadable Amplifier
A74
A74-1  5 to 250 MHZ TO-8 Cascadable Amplifier
A74-2  5 to 500 MHZ TO-8 Cascadable Amplifier
A75
A75-2  5 to 250 MHZ TO-8 Cascadable Amplifier
A75-3  10 to 500 MHZ TO-8 Cascadable Amplifier
A76  5 to 500 MHZ TO-8 Cascadable Amplifier
A76-1
A77
A77-1  5 to 600 MHZ TO-8 Cascadable Amplifier
A78  5 to 300 MHZ TO-8 Cascadable Amplifier
A79
A80  20 to 500 MHZ TO-8 Cascadable Amplifier
A80-1  10 to 200 MHZ TO-8 Cascadable Amplifier
A81  20 to 250 MHZ TO-8 Cascadable Amplifier
A81-1
A81-2  20 to 500 MHZ TO-8 Cascadable Amplifier
A81-3
A82  20 to 250 MHZ TO-8 Cascadable Amplifier
A82-1
Same catergory

2SC4253 : Bipolar Transistors. Vceo (V) = 25 ;; Ic (mA) = 50 ;; PC (mW) = 100 ;; Cob (pF) = 1.1 ;; Cre (pF) = - ;; .fT(Typ.) (GHz) = 0.6 ;; Package = Usm ;; Application = Pif Amp.

854669 : = Filter - STD Low-loss ;; Frequency (MHz) = 70 ;; Bandwidth (MHz) = 18 ;; Insertion Loss (dB) = 14.5 Max ;; Modes of Operation = se ;; Package (mm) = 13.3 X 6.5.

AT-103 : Frequency 20-1000 Mhz, 5-Bit Digital Attenuator. Attenuation 0.5 dB Steps 15.5 dB CMOS Control Interface Internal Latch on Control Input Hermetic Case Dimensions ( ) are in mm. Unless Otherwise Noted:.xxx = ▒0.010 (.xx = ▒0.02 (.x = ▒0.5) WEIGHT (APPROX.): 0.39 OUNCES 11 GRAMS MIL-STD-883 screening available. All s apply when operated with bias voltage of +15 VDC and a 50 ohm impedance at both RF ports.

BX5149 : Frequency (MHz) = 5 - 150 ;; Gain (Typ/Min) (dB) = 23.5 / 22.5 ;; Noise Figure (Typ/Max) (dB) = 3 / 3.2 ;; P1dB Comp Point (Typ/Min) (dBm) = +18 / +17 ;; 3rd Order Intercept (Typ) (dBm) = +33 ;; 2nd Order Intercept (Typ) (dBm) = +37 ;; DC Power (Typ) (V/mA) = +15 / +35 ;; Package = Package = Package = 4 Pin TO-8 Package = Surface Mount Package = Flatpack.

HMC264LM3 : Sub Harmonic. Integrated LO Amplifier: -4 dBm Input Sub-Harmonically Pumped (x2) LO High 2LO/RF Isolation: dB LM3 SMT Package Typical Applications The HMC264LM3 is ideal for: 20 and 30 GHz Microwave Radios Up and Down Converter for Point to Point Radios LMDS and SATCOM The - 30 GHz surface mount sub-harmonically pumped (x2) MMIC mixer with an integrated LO amplifier.

IC1003 : Frequency =   ;; = RF Uart ic. Provides RF Uart Functions, 12 Bit Symbols to Serial TX And Serial to 12 bit Symbols with Start Symbol Detection Supports data rates from to 1Mbps Allows unsquelched receiver operation for improved sensitiviy Compatible with RFM's TR-Series ASH transceivers The IC1003 RF Uart IC detects a start-of-data pulse sequence and then provides clocking pulses.

NJG1522KB2 : GaAs MMICs. SPDT Switch GAAS Mmic. nGENERAL is a GaAs SPDT switch suited for RF receiving circuit of cellular phone handsets. This switch very low loss, high isolation and exhibits wide operating frequency range from 3.0GHz at low voltage of 2.5V. The ultra small & ultra thin FLP6 package is applied. Reversed logic version of this device is NJG1532KB2. n lSingle low voltage control lLow.

P7Z9AAA900W : Phase Control Modules ( 345-800 Amperes/400-3000 Volts ). Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania (724) 925-7272 OUTLINE DRAWING MARKING: DEVICE AND DIRECTION ACCORDING TO CIRCUIT CONFIGURATION CHART C G TAPPED HOLE x 0.50 DEEP TYP. 3 PLACES MARKING: K1 AI/K2 (ANODE)/(CATHODE), AND A2 (ANODE) AS SHOWN D B F A MARKING: STYLE NO. WITH DATE CODE & MFG. LOCATION CODE (CUSTOMER PART NO. OPTIONAL).

PE3511 : Product = Divide-by-2 ;; Input Operating Freq. Range (MHz) = DC - 1000 ;; Divide Ratio = 2 ;; Total Icc MA@3V = 8 ;; VCC Range (V) = 2.85 - 3.15 ;; Package Types = 6L SC70.

RFP-40-50TT : = Terminations ;; Size LXWXH = 0.8 X 0.225 X 0.125" ;; Packaging = Flanged ;; Frequency MHZ = 0-3000 ;; Power Handling Watts = 40.

TGA8061-SCC : = Low Noise Amp, SB ;; Freq(GHz) = 0.1 - 3.5 ;; Power(dBm) = 15 ;; Gain(dB) = 18 ;; Nf/pae = 2.4 DB ;; +V = 12 ;; IQ(mA) = 112 ;; Status = Standard.

CV221-2A : 1.9-2.4 GHz Dual-Branch Downconverter. High dynamic range downconverter with integrated LO and IF amplifiers The is a dual-channel high-linearity downconverter designed to meet the demanding performance, functionality, and cost goals of current and next generation mobile infrastructure basestations and repeaters. It provides high dynamic range performance in a low profile RoHS-compliant/lead-free.

HMC636ST89 : High IP3 SMT Amplifier, 0.2 - 4.0 GHz The HMC636ST89(E) is a GaAs PHEMT, High Linearity, Low Noise, Wideband Gain Block Amplifier covering 0.2 to 4.0 GHz. Packaged in an industry standard SOT89, the amplifier can be used as either a cascadable 50 Ohm gain stage, a PA Pre-Driver, a Low Noise Amplifier, or a Gain Block with up to +23 dBm output power.

TDA18250HN : Cable Silicon Tuner The TDA18250HN is a Silicon Tuner IC designed specifically for high definition cable Set Top Boxes (STB) supporting single streaming. Used in conjunction with the TDA10024HN (digital channel demodulator), the TDA18250HN covers all worldwide digital cable standards. * The TDA18250HN ensures a low system cost as: o Costly components.

 
0-C     D-L     M-R     S-Z