Details, datasheet, quote on part number: A75-3
PartA75-3
CategoryRF & Microwaves => Amplifiers => Power Amplifiers => LNAs
TitleLNAs
Description 10 to 500 MHZ TO-8 Cascadable Amplifier
CompanyM/A-COM, Inc.
DatasheetDownload A75-3 datasheet
Quote
Find where to buy
 
  

 

Features, Applications
TO 500 MHz CASCADABLE AMPLIFIER HIGH GAIN: 20.5 dB (TYP.) LOW NOISE: 1.7 dB (TYP.)

Characteristics Frequency Small Signal Gain (min.) Gain Flatness (max.) Reverse Isolation Noise Figure (max.) Power Output 1 dB comp. (min.) IP3 IP2 Second Order Harmonic IP VSWR Input / Output (max.) DC Current @ 15 Volts (max.) Typical

Measured a 50-ohm system at +15 Vdc Nominal. Subject to change without notice.

Storage Temperature Max. Case Temperature Max. DC Voltage Max. Continuous RF Input Power Max. Short Term RF Input Power (1 minute max.) Max. Peak Power (3 sec max.) "S" Series Burn-in Temperature (Case)

Thermal Resistance jc Transistor Power Dissipation Pd Junction Temperature Rise Above Case Tjc
Package Figure Model BG A75-3 Surface Mount AA SMA75-3 SMA Connectorized CE CA75-3

Specifications subject to change without notice. North America: 1-800-366-2266 Visit www.macom.com for complete contact and product information.


 

Related products with the same datasheet
SMA75-3
Some Part number from the same manufacture M/A-COM, Inc.
A76  5 to 500 MHZ TO-8 Cascadable Amplifier
A76-1
A77
A77-1  5 to 600 MHZ TO-8 Cascadable Amplifier
A78  5 to 300 MHZ TO-8 Cascadable Amplifier
A79
A80  20 to 500 MHZ TO-8 Cascadable Amplifier
A80-1  10 to 200 MHZ TO-8 Cascadable Amplifier
A81  20 to 250 MHZ TO-8 Cascadable Amplifier
A81-1
A81-2  20 to 500 MHZ TO-8 Cascadable Amplifier
A81-3
A82  20 to 250 MHZ TO-8 Cascadable Amplifier
A82-1
A83  10 to 500 MHZ TO-8 Cascadable Amplifier
A83-1  10 to 250 MHZ TO-8 Cascadable Amplifier
A87  10 to 400 MHZ TO-8 Cascadable Amplifier
A87-1
A87-2 10 to 300 MHZ TO-8 Cascadable Amplifier
A88  5 to 500 MHZ TO-8 Cascadable Amplifier
A88-1  5 to 300 MHZ TO-8 Cascadable Amplifier
Same catergory

AE002M6-77 : GAAS ic SP6T Non-reflective Switch. s Single 5 V Supply Voltage s Non-Reflective All Ports s Three Line Control s Capable of Meeting MIL-STD Requirements4 The a SP6T non-reflective MMIC switch. This switch integrates GaAs IC and silicon CMOS devices. It operates with a single fixed 5 V supply voltage and three line logic control. This device is used in high reliability and commercial.

AP137-501 : Quad-band GSM Power Amplifier Module. First Quad-Band InGaP HBT GSM PA Module 3.2 V Nominal Operating Voltage 50 Internally Matched Input and Output High Power Added Efficiency: 55% for GSM and 50% for DCS and PCS Small Size: 1.6 mm MCM Land Grid Array Package Low Current Standby Mode: 30 A Integral Band Select and Analog Power Control GPRS Class 12 Capable The is a high performance power.

AS185-92 : Phemt GAAS ic High Linearity Positive. PHEMT GaAs IC High Linearity Positive Control SPDT Switch DC2 GHz High Linearity (50 dBm @ 0.9 GHz) @3V Low Insertion Loss @ 0.9 GHz) +3 V Operation Ultra Miniature SC-70 6 Lead Package The is a PHEMT GaAs FET IC high linearity SPDT switch SC-70 6 lead plastic package.This switch has been designed for use where extremely high linearity, low insertion.

D1012UK : Purchase Online = ;; Package = DH ;; Impedance Calculator = ;; Operating Voltage (V) = 28 ;; Power Output (W) = 100 ;; Minimum Efficiency = 50 ;; Gain = 10 ;; Test Frequency (MHz) = 500 ;; Configuration = Push-pull ;; Application Range = 1-500MHz ;; Active Fet Configuration = 3+3 ;; BVDSS (V) = 70.

DS0950 : 5-400MHz Schottky Diode SPST.

HMJ4 : . The is a high dynamic range, GaAs FET mixer. This active FET mixer realizes a typical third order intercept point of +36 dBm an LO drive level of +17 dBm. The HMJ4 comes in a low cost, J-lead package. Typical applications include frequency up/down conversion, modulation and demodulation for receivers and transmitters used in communications systems.

KGA4121 : 10Gbps Transimpedance Amplifier ic. Oki's 10 Gbps transimpedance amplifier is fabricated 0.1m gate length P-HEMTs for high-speed optical communication. The IC has a large transimpedance, high sensitivity and a wide dynamic range. High Transimpedance Ultra-Broadband Amplifier Single -5V Power Supply : >8 GHz Wide Dynamic Range Ultra-Low Noise Current : <10pA/Hz(T.B.D) Parameters.

NJG1312PC1 : GaAs MMICs->Amplifiers. SPDT Switch Driver Amplifier GAAS Mmic. NJG1312PC1 SPDT SWITCH DRIVER AMPLIFIER GaAs MMIC nGENERAL is a GaAs MMIC mainly designed for CDMA 800MHz band cellular phone handsets. This Ic low current consumption and variable gain. An ultra small & thin FFP package is adopted. nPACKAGE OUTLINE NJG1312PC1 n lLow supply voltage operation lLow current consumption lHigh gain lPout at 1dB Gain Compression.

TPM2323-30 : L, S-Band Power GaAs FETs. Frequency Band (GHz) = 2.3 ;; P1dB (dBm) = 44.5 ;; G1dB (dB) = 11.5 ;; P.A.E. (%) Typ. = 35 ;; VDS (V) = 10 ;; Ids (A) Typ. = 7.5 ;; RTH ( C/W) Typ. = 1.1.

UPC2745TB : 3 v, Super Minimold Silicon Mmic Wideband Amplifier. 3 V, SUPER MINIMOLD UPC2745TB SILICON MMIC WIDEBAND AMPLIFIER UPC2746TB HIGH DENSITY SURFACE MOUNTING: 6 pin super minimold or SOT-363 package LOW SUPPLY VOLTAGE: VCC 3.3 V WIDEBAND RESPONSE: = 2.7 GHz TYP = 1.5 GHz TYP HIGH ISOLATION: UPC2745TB: ISOL 38 dB TYP UPC2746TB: ISOL 45 dB TYP The UPC2745TB and UPC2746TB are Silicon MMIC Wideband Amplifiers.

MAX19995 : Dual, SiGe, High-Linearity, 1700MHz To 2200MHz Downconversion Mixer With LO Buffer/Switch The MAX19995 dual-channel downconverter provides up to 9dB of conversion gain, +24.8dBm input IP3, +13.3dBm 1dB input compression point, and a noise figure as low as 9dB for 1700MHz to 2200MHz diversity receiver applications. With an optimized LO frequency range.

TQM613029 : CDMA PA-Duplexer Module; SE Input W/Coupler CDMA PA-Duplexer Module; SE Input w/Coupler.

HMC903LP3E : Low Noise Amplifier SMT, 6 - 17 GHz The HMC903LP3E is a self-biased GaAs MMIC Low Noise Amplifier housed in a leadless 3x3 mm plastic surface mount package. The amplifier operates between 6 and 17 GHz, providing 18 dB of small signal gain, 1.7 dB noise figure, and output IP3 of +25 dBm, while requiring only 80 mA from a +3.5 V supply. The P1dB output.

 
0-C     D-L     M-R     S-Z