|
Details, datasheet, quote on part number:MD-169
| |
Datasheet text preview:
Termination Insensitive Mixer, 1 MHz - 3.5 GHz
V 5.00
MD-/MDC-/MDS-169
Features
n Intermodulation Ratio is Insensitive to Port Mismatches n VSWR: <2.0:1 Typical Midband n Isolation: 35 dB Typical Midband n Impedance: 50 Ohms Nominal n Maximum Input Power: 350 mW Max @ 25°C, Derated n n
FP-2 (MD-169)
to 85°C @ 3.2 mW/°C LO Power: +24 dBm Max. MIL-STD-883 Screening Available
Description
The unique design of the termination insensitive mixer (TIM) enables it to apply high reverse voltage to diodes during their "off" phase, in the LO cycle. This allows for higher power level performance with minimum distortion. In addition the TIM has internal loads that provide a good match and also absorb mixer generated LO frequency terms. Combined, these features give the mixer its insensitivity to external mismatches, plus superior VSWR.
C-7 (MDC-169)
SF-1 (MDS-169)
Termination-Insensitive Mixer, 1 MHz - 3.5 GHz
MD-/MDC-/MDS-169
V 5.00
Electrical Specifications1(MD-/MDC-169): TA = -55°C to +85°C
Parameter Frequency Range Conversion Loss Test Conditions RF, LO Ports IF Port Frequency 0.001 - 3.5 5 - 1500 5 - 1000 MHz 2 5 - 3000 MHz 3 1 - 3500 MHz LO to RF LO to IF RF to IF 5 - 1000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 10 - 500 MHz 1 - 3000 MHz 1 - 3500 MHz -- -- -- 10 MHz 500 MHz 3000 MHz -- Units GHz MHz dB dB dB dB dB dB dB dB dB dB dBm dBm -- dB dB dB dB Min -- -- -- -- -- 30 20 30 20 30 20 18 -- -- -- -- -- -- -- Typ -- -- -- -- -- -- -- -- -- -- -- -- +7 +5 -- 55 58 56 3 Max -- -- 7 8 10 -- -- -- -- -- -- -- -- -- -- -- -- -- --
Isolation
RF Input SSB Noise Figure Typical Two-Tone IM Ratio 3rd Order Intermodulation Ratio Degradation
1 dB Compression 1 dB Desensitization Within 1 dB of Conversion Loss Max with a 10 dBm input, each input, 25 MHz and 35 MHz IF @ IF VSWR 3:1
1. All specifications apply when operated at +10 available LO power with 50 Ohm source and load impedance. 2. For IF Frequencies of 5 - 300 MHz and RF of 10 dBm or less. 3. For MDC-169, add 1.0 dB to conversion loss.
Electrical Specifications (MDS-169): TA = -55°C to +85°C, Frequency: RF, LO Ports = 1 - 3500 MHz, IF Port = 5 - 1500 MHz
Parameter Conversion Loss Test Conditions LO @ +10 dBm IF @ 60 MHz LO to RF LO to IF RF to IF Frequency 5 - 1000 MHz 1000 - 3000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 10 - 500 MHz 1 - 3000 MHz 1 - 3500 MHz Units dB dB dB dB dB dB dB dB dB dB Min -- -- -- 30 20 30 20 30 20 18 Typ 6.5 7.5 8.0 35 25 35 25 35 25 23 Max 7.0 9.0 10.0 -- -- -- -- -- -- --
Isolation
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. Visit www.macom.com for additional data sheets and product information.
2 n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
Termination-Insensitive Mixer, 1 MHz - 3.5 GHz
MD-/MDC-/MDS-169
V 5.00
Pin Configuration (MD-169)
Pin No. 1 2 3 4 Function GND GND GND IF Pin No. 5 6 7 8 Function LO GND GND RF
Pin Configuration (MDS-169)
Pin No. 1 2 Function GND IF Pin No. 3 4 Function LO RF
Bottom View of SF-1
6X .050 (+.020/-.000) 4X .099 ± .010
Absolute Maximum Ratings (MDS-169) 4
Parameter Max Input Power 5 Total Power LO Power 350 mW Derated to 85°C @ 3.2 mW/°C +24 dBm Absolute Maximum
4X .016 ± .002 .506
.385 Ref
.220 .165
.381
4. Operation of this device above any one of these parameters may cause permanent damage. 5. Ambient Temperature (TA) = +25°C
.002 .000
.367
.143
.080
.205
.305
.430
Typical Performance Curves
Conversion Loss - LO @ +10 dBm, IF @ 60 MHz
10 60 50
.510 Ref
.000 .002
Isolation - Input +10 dBm
L-R L-I R-I
Conversion Loss (dB)
9
Isolation (dB)
8 7 6 5 4 0 1 3 10 30 100 1000 2000 3000 4000
40 30 20 10 0 0 1 3 10 30 100 1000 2000 3000 4000
Frequency (MHz)
Frequency (MHz)
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. Visit www.macom.com for additional data sheets and product information.
3 n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
|
|
