Details, datasheet, quote on part number: SW-216PIN
PartSW-216PIN
CategoryPower Management => AC-DC Controllers/Converters => High & Low Side Switch
DescriptionMatched GAAS SPST Switch 5 - 3000 MHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW-216PIN datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Features

Low Insertion Loss, 1.0 dB Typical Fast Switching Speed, 20 ns Typical Ultra Low DC Power Consumption, 0.07mA Typical Integral TTL (SW-215) or CMOS (SW-216) Driver

Impedance Switching Characteristics 50 Ohms Nominal SW 216 (CMOS) 20 ns Typ 40 ns Typ 35 mV Typ SW-215 (TTL) tRISE, tFALL 7 ns Typ tON, tOFF (50% CTL to 90/10% RF) 20ns Typ Transients (In-Band) 70 mV Typ +33 +26 dBm Typ dBm Typ

Dimensions ( ) are in mm. Unless Otherwise Noted:.xxx = 0.010 (.xx = 0.02 (.x = 0.5) WEIGHT (APPROX): 0.14 OUNCES 4 GRAMS

Control Input "1" = Logic High TTL (SW-215) CMOS 1 0 Condition of Switch 2 ON OFF

Intermodulation Intercept Pt. (for two-tone input power to +13 dBm) Intercept Points 500-4000 MHz 50 MHz Bias Power +46 +40 dBm Typ dBm Typ

+ VDC NC GROUND RF1 GROUND CONTROL INPUT GROUND 50 GROUND RF2

Environmental MIL-STD-883 screening available. * All specifications apply when operated with bias voltages of +5 VDC or +8 VDC (SW 216) and 50 ohm impedance at all RF ports.

Model No. SW-215 PIN SW-216 PIN Package Dual Inline Dual Inline
Matched GaAs SPST Switch Typical Performance

 

Some Part number from the same manufacture M/A-COM, Inc.
SW-217  GaAs SPDT Switch, 5 - 2000 MHZ
SW-219  GaAs SPDT RF Switch, DC - 3 GHZ
SW-221 GAAS SPST Switch Dc-4 GHZ
SW-221PIN
SW-222
SW-222PIN GAAS SPST Switch Dc-4 GHZ
SW-223PIN
SW-224  GaAs SPDT Switch, DC - 2 GHZ
SW-224PIN GAAS SPDT Switch Dc-2 GHZ
SW-225  GaAs SPDT Switch, DC - 2 GHZ
SW-225PIN GAAS SPDT Switch Dc-2 GHZ
SW-226  GaAs SPDT Switch, DC - 4 GHZ
SW-226PIN GAAS SPDT Switch Dc-4 GHZ
SW-227  GaAs SPDT Switch, DC - 4 GHZ
SW-227PIN GAAS SPDT Switch Dc-4 GHZ
SW-228  GaAs SPDT Switch, DC - 4 GHZ
SW-228PIN GAAS SPDT Switch Dc-4 GHZ
SW-229  Connectorized SPDT GAAS Switch, DC - 2 GHZ
SW-231  Matched GAAS SPST Switch, 5 - 4000 MHZ
SW-233  Matched GAAS SPDT Switch, 5 - 2000 MHZ
SW-233PIN Matched GAAS SPDT Switch 5-2000mhz
Same catergory

FAN8200MP : Low Voltage/low Saturation Stepping Motor Driver. 3.3V and 5V MPU interface Dual H-bridge drivers for bipolar stepping motor drives Built-in vertical-PNP power transistors Wide supply voltage range (VCC ~ 7.0V) Low saturation voltage (0.4V@ 0.4A) Built-in chip enable function for each bridge Built-in shoot-through current protection Built-in thermal shutdown(TSD) function The is a monolithic intergrated.

HA13563V : Three-phase Brushless Motor Driver. The HA13563/V are 3-phase brushless motor driver ICs with digital speed control. It is designed for use as a PPC or LBP drum motor driver and provides the functions and listed below. Three-phase brushless motor driver Direct PWM drive Digital discriminator plus PLL speed control Speed monitor Stuck rotor protection Current limiter Thermal protection.

HDD50-12D05-X : DC-DC Converter 60Watt. TO 60W DC/DC CONVERTER 2:1 INPUT RANGE, Pi INPUT FILTER ISOLATION INPUT AND OUTPUT HIGH PERFORMANCE TO 86% SHORT CIRCUIT PROTECTION 2 YEARS WARRANTY OUTPUT WATTAGE VOLTAGE Single Output Models 48D512-X 9~18 VDC 9~18 VDC 9~18 VDC 9~18 VDC 18~36 VDC 18~36 VDC 18~36 VDC 18~36 VDC 36~72 VDC 36~72 VDC 36~72 VDC 36~72 VDC 50 WATTS 60 WATTS 60 WATTS 55 WATTS.

HT0440 : Switch/Translator. Level Translator. HT0440 Dual High Voltage Isolated MOSFET Driver Input to Output Isolation Voltage 400V Package Option 8-Pin Narrow Body SOIC HT0440LG 400V input to output isolation 700V isolation between outputs No external voltage supply required Dual isolated output drivers Option of internal or external clock The Supertex is a dual high voltage isolated driver.

LT1963-2.5 : Fixed. 1.5A, Low Noise, Fast Transient Response LDO Regulators. LT1963 Series 1.5A, Low Noise, Fast Transient Response LDO Regulators Optimized for Fast Transient Response Output Current: 1.5A Dropout Voltage: 340mV Low Noise: 100kHz) 1mA Quiescent Current No Protection Diodes Needed Controlled Quiescent Current in Dropout Fixed Output Voltages: 2.5V, 3.3V Adjustable Output from < 1A Quiescent Current in Shutdown.

SL431BM : Programmable Voltage Reference. Programmable output voltage to 36 volts Sink current capability to 100mA Low dynamic impedance 0.15 typical Temperature compensated for operation over full rated operating temperature Equivalent full-range temperature coefficient of 50ppm/C (Typical) Low output Noise voltage Voltage reference tolerance 1.0% (Ta=25) (Operating ambient temperature range.

TPS6735 : Fixed Negative 5v 200-ma Inverting DC/DC Converter. Negative 5-V 200-mA Output (VCC to 6.2-V Input Operating Range 78% Typical Efficiency 160-kHz Fixed-Frequency Current-Mode PWM Controller EN Input Inhibits Operation and Reduces Supply Current 1 A Soft Start 8-Pin SOIC and DIP Packages to 85C Free-Air Temperature Range Pin-for-Pin Compatible with MAX735 The is a fixed negative 5-V output inverting.

UCC3882DW-1 : Switching DC/DC Controllers. ti UCC3882-1, Average Current Mode Synchronous Buck Controller With 5-Bit DAC.

UTCBA9741A : = Two-channel Swiching Regulator Controller ;; Package = DIP-16, SOP-16, TSSOP-16 ;;.

NCP1588 : Single Phase Buck Controller The NCP1588 is a low cost PWM controller designed to operate from a 5V or 12V supply. This device is capable of producing an output voltage as low as 0.8V. It is also capable of converting voltage from as low as 2.5V. This 10 pin device provides an optimal level of integration to reduce size and cost of the power supply.

MAX17112 : High-Performance, Step-Up, DC-DC Converter The MAX17112 is a high-performance, step-up, DC-DC converter that provides a regulated supply voltage for active-matrix thin-film transistor (TFT) liquid-crystal displays (LCDs). The MAX17112 incorporates current-mode, fixed-frequency (1MHz), pulse-width modulation (PWM) circuitry with a built-in, n-channel.

LTC6803 : Multicell Battery Stack Monitor The LTC6803 is a 2nd generation, complete battery monitoring IC that includes a 12-bit ADC, a precision voltage reference, a high voltage input multiplexer and a serial interface. Each LTC6803 can measure up to 12 series-connected battery cells or supercapacitors. Using a unique level shifting serial interface, multiple.

PT7M7809LT : P Supervisor Circuits The PT7M7xxx family microprocessor (P) supervisory circuits are targeted to improve reliability and accuracy of power-supply circuitry in P systems. These devices reduce the complexity and number of components required to monitor power-supply and battery functions..

CM2830AGMIM23 : 300mA CMOS LDO The CM2830/CM2830A family is a positive voltage linear regulator developed utilizing CMOS technology featured low quiescent current (30 ÂA typ.), low dropout voltage, and high output voltage accuracy. Built-in low on-resistance transistor provides low dropout voltage and large output current. A 2.2 ÂF or greater can be used as an output.

 
0-C     D-L     M-R     S-Z