Details, datasheet, quote on part number: SW-225PIN
PartSW-225PIN
CategoryPower Management => AC-DC Controllers/Converters => High & Low Side Switch
DescriptionGAAS SPDT Switch Dc-2 GHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW-225PIN datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Features
Low Insertion Loss, 0.5 dB Typical Integral TTL Driver Low DC Power Consumption

Bottom of Case is AC Ground. Dimensions ( ) are in mm. Unless Otherwise Noted:.xxx 0.010 (.xx 0.02 (.x 0.5) WEIGHT (APPROX.): 0.025 OUNCES 0.7 GRAMS

Impedance 50 Ohms Nominal Switching Characteristics Trise, Tfall 10 ns Typ Ton, Toff (50% CTL to 90/10% RF) 150 ns Typ Transients (In-Band) 15 mV Typ Input Power for 1 dB Compression 0.5-2 GHz +27 dBm Typ 0.05 GHz +21 dBm Typ Intermodulation Intercept Point (for two-tone input power to +13 dBm) Intercept Points IP3 0.5-2 GHz 0.05 GHz Bias Power +62 +46 dBm Typ +40 dBm Typ +5 VDC 1 mA Max -5 VDC 1 mA Max

* All specifications apply when operated with bias voltages of +5 VDC

TTL Control Input "1" = TTL Logic High 1 0 Condition of Switch RF Common To Each RF Port RF2 ON OFF ON



 

Some Part number from the same manufacture M/A-COM, Inc.
SW-226  GaAs SPDT Switch, DC - 4 GHZ
SW-226PIN GAAS SPDT Switch Dc-4 GHZ
SW-227  GaAs SPDT Switch, DC - 4 GHZ
SW-227PIN GAAS SPDT Switch Dc-4 GHZ
SW-228  GaAs SPDT Switch, DC - 4 GHZ
SW-228PIN GAAS SPDT Switch Dc-4 GHZ
SW-229  Connectorized SPDT GAAS Switch, DC - 2 GHZ
SW-231  Matched GAAS SPST Switch, 5 - 4000 MHZ
SW-233  Matched GAAS SPDT Switch, 5 - 2000 MHZ
SW-233PIN Matched GAAS SPDT Switch 5-2000mhz
SW-236  Matched GAAS SPDT Switch, 5 - 2000 MHZ
SW-236PIN Matched GAAS SPDT Switch 5-2000mhz
SW-239  GaAs SPDT Switch
SW-239PIN GAAS SPDT Switch Dc-2.5 GHZ
SW-239RTR  GaAs SPDT Switch
SW-241  Matched GAAS SP3T Switch, 5 - 2000 MHZ
SW-254  Matched GAAS SP4T Switch, 5 - 2000 MHZ
SW-255  GaAs SP4T Switch, 5 - 2000 MHZ
SW-259  GaAs SPST Switch
SW-261  Matched GAAS SP4T Switch, 5 - 2000 MHZ
SW-262  GaAs SP4T Switch, 5 - 2000 MHZ
Same catergory

8284 : Two Output LNB Supply And Control Voltage Regulator. Intended for analog and digital satellite receivers, the low noise block converter regulator (LNBR) is a monolithic linear and switching voltage regulator designed to provide power and interface signals to the LNB downconverter via the coaxial cable. Because most satellite receivers have two antenna ports, the output voltage of the regulator is available.

AKBPC608 : 6 Amp Controlled Avalanche Silicon Bridge Rectifier.

CLM2805 : Micropower Sot-23, 120ma Low-dropout Voltage Regulator On/off Switch. Micropower SOT-23, 120mA Low-Dropout Voltage Regulator ON/OFF Switch Smallest Possible Size 3V, 2.5V Fixed Output Guaranteed Output Current in Excess of 120mA Available in Adjustable Output With ON/OFF Switch Internal Thermal Overload Protection Voltage Dropout is Less Than at 50mA Output Reverse Battery Protection Short Circuit Protection Low Cost.

LD1086 : 1.5a Low Drop Fixed And Adjustable Positive Voltage Regulators. 1.5A LOW DROP POSITIVE VOLTAGE REGULATOR ADJUSTABLE AND FIXED TYPICAL DROPOUT AT 1.5A THREE TERMINAL ADJUSTABLE OR FIXED OUTPUT VOLTAGE 9V, 12V. GUARANTEED OUTPUT CURRENT TO 1.5A OUPUT TOLERANCE AT 25C AND 2% IN FULL TEMPERATURE RANGE INTERNAL POWER AND THERMAL LIMIT WIDE OPERATING TEMPERATURE RANGE TO 125C PACKAGE AVAILABLE D2PAK, D2PAK/A, DPAK.

MAX1673 : Regulated, 125mA Output, Charge Pump DC-DC Inverter. The MAX1673 charge-pump inverter provides a lowcost, compact means of generating a regulated negative output from a positive input 125mA. It requires only three small capacitors, and only two resistors to set its output voltage. The input range to 5.5V. The regulated output can be set from 0V to -VIN in Skip regulation mode -1.5V to -VIN in Linear (LIN).

MAX665 : 8V CMOS Switched-capacitor Voltage Converter.

NJU7333 : Single-phase DC Brnshless Motor Driver ic. s GENERAL s PACKAGE OUTLINE The is a single-phase DC brushless motor driver IC for small fan-motor and high power applications. It MOS-FET driver circuit for better saturation characteristics. Slew late of amplifiers and feedback resistors are optimized to achieve low-noise motor operation. Maximum output current is 500mA. The NJU7333 includes. frequency.

PT4225 : . 10W Output Power Input Voltage: to 75V Output Voltages: 13.2V 1500 VDC Isolation Temp Range: to +85C Remote On/Off Control Undervoltage Lockout Output Current Limit Short-Circuit Protection Low-Profile Package (8mm) Space Saving Package Solderable Copper Case Safety Agency Approvals: UL 60950 CSA 22.2 60950 The PT4220 power modules are a series of DC/DC.

QB104M3 : Qbar(r) Normally-closed Switch. QBAR ICs provide a 3-terminal semiconductor switch that functions as: a solid-state normally-closed switch a non-inverting digital transistor a solid-state replacement for a normally-closed, non-isolating relay. QBAR ICs do not require a separate power supply lead. This makes possible: simplified control wiring replacement of normally-closed D.C. relays.

RC1616x25 : 0.5A Fixed 2.5V Low Dropout Voltage Regulator (LDO). Low dropout voltage Load regulation: 0.05% typical Current limit On-chip thermal limiting Standard SOT-223 and TO-252 packages Three-terminal adjustable or fixed or 5V The RC1616 and RC1616-2.5, -3.3 and -5 are low dropout three-terminal regulators with 0.5A output current capability. These devices have been optimized for low voltage where transient.

RE5VTxxxx : Low Voltage Type.

TPS3823-50QDBVRQ1 : ti TPS3823-50-Q1, Automotive Catalog Supply Voltage Supervisor W/watchdog Input And Manual Reset.

UC3572 : Negative Output Flyback Pulse Width Modulator. Negative Output Flyback Pulse Width Modulator Simple Single Inductor Flyback PWM for Negative Voltage Generation Drives External PMOS Switch Contains UVLO Circuit Includes Pulse-by-Pulse Current Limit Low 50A Sleep Mode Current The is a negative output flyback pulse width modulator which converts a positive input voltage to a regulated negative output.

UCC39412D : Switching DC/DC Converters, Integrated Switch. ti UCC39412, Low Power Synchronous Boost Converter.

VRE310 : Output (V) = +10.0 ;; Initial Error (mV) = 1.0, 1.6, 2.0 ;; Temp Error (ppm/oC) = 0.6, 1.0, 2.0 ;; Noise (µVpp) = 6 ;; Package = DIP8, SMT8 ;; Feature = Low Cost.

FAN2011 : High-efficiency step-down DC/DC converter The FAN2011/FAN2012 is a high-efficiency, low-noise synchronous PWM current mode DC-DC converter, designed for low voltage applications. It provides up to 1.5A continuous load current from the 4.5V to 5.5V input. The output voltage is adjustable over a wide range of 0.8V to VIN by means of an external voltage.

LM5032 : High Voltage Dual Interleaved Current Mode Controllers The LM5032 dual current mode PWM controller contains all the needed to control either two independent forward dc/dc converters or a single high current converter comprised of two interleaved power stages. The two controller channels operate 180 out of phase thereby reducing input ripple current.

LX6503IPW : CCFL Backlight Controller IC CCFL Backlight Controller IC. Mask Rev: Mold Cmpd: V1R3 G770H Package: Pkg Suppl: Burn-in Ckt: 0841A PW-16 (CS,CM) BI6503 4 Device: Die Attach: Lead Finish: Lot Number: Date Code: 1 This device has the same package as LX1691A. Only 1 lot is needed for package qualification. Digitally signed by Henry Yeghyayan DN: cn=Henry Yeghyayan, o=Microsemi, ou, email=hyeghyayan@microsemi. com,.

 
0-C     D-L     M-R     S-Z