Details, datasheet, quote on part number: SW-226PIN
CategoryPower Management => AC-DC Controllers/Converters => High & Low Side Switch
DescriptionGAAS SPDT Switch Dc-4 GHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW-226PIN datasheet
Find where to buy


Features, Applications

Miniature Ceramic Package Terminated (SE-226), High Isolation (SW-227), Low Loss (SW-228) Fast Switching Speed, 6 ns Typical Ultra Low DC Power Consumption

(From to +85C) Frequency Range DC-4 GHz Model Number SW-227 SW-228 Insertion Loss DC-4 GHz 1.0 dB Max DC-2 GHz 0.8 dB Max DC-1 GHz 0.7 dB Max DC-0.5 GHz 0.7 dB Max VSWR DC-4 GHz 2.0:1 1.9:1 Max DC-2 GHz 1.6:1 1.3:1 Max DC-1 GHz 1.4:1 1.2:1 Max DC-0.5 GHz 1.2:1 Max Isolation DC-4 GHz 22 dB Min DC-2 GHz 32 dB Min DC-2 GHz 42 dB Min DC-0.5 GHz 50 dB Min

Bottom of Case is AC Ground. Dimensions ( ) are in mm. Unless Otherwise = 0.010 (.xx = 0.02 (.x = 0.5)

Impedance 50 Ohms Nominal Switching Characteristics Trise, Tfall 3 ns Typ Ton, Toff (50% CTL to 90/10% RF) 6 ns Typ Transients (In-Band) 30 mV Typ Transients (In-Band) 10 mV Typ Input Power for 1 dB Compression Control Voltages (Vdc) 0/-8 0.5-4 GHz +27 +33 dBm Typ 0.05 GHz +21 +26 dBm Typ Intermodulation Intercept Point (for two-tone input power + 13 dBm) Intercept Points - 4 GHz +68 +46 dBm Typ 0.05 GHz +62 +40 dBm Typ Control Voltages (Complementary Logic) VIN Low 20 A Max VIN 110 A Typ 600 A Max VIN 50 A Typ 300 A Max Environmental See Appendix for MIL-STD-883 screening option.

* All specifications apply with 50 ohm impedance connected to all RF por ts with 0 and -5 VDC control voltages. Faster switching speed can be achieved with enhaned driver waveform. For the SW-227 and SW-228 only, when an RF output is `OFF' it is shorted to case ground.

Control Input HI NC Condition of Switch RF Common To Each RF PORT HI ON OFF LO OFF NC ON OFF NC OFF ON


Some Part number from the same manufacture M/A-COM, Inc.
SW-227  GaAs SPDT Switch, DC - 4 GHZ
SW-228  GaAs SPDT Switch, DC - 4 GHZ
SW-229  Connectorized SPDT GAAS Switch, DC - 2 GHZ
SW-231  Matched GAAS SPST Switch, 5 - 4000 MHZ
SW-233  Matched GAAS SPDT Switch, 5 - 2000 MHZ
SW-233PIN Matched GAAS SPDT Switch 5-2000mhz
SW-236  Matched GAAS SPDT Switch, 5 - 2000 MHZ
SW-236PIN Matched GAAS SPDT Switch 5-2000mhz
SW-239  GaAs SPDT Switch
SW-239PIN GAAS SPDT Switch Dc-2.5 GHZ
SW-239RTR  GaAs SPDT Switch
SW-241  Matched GAAS SP3T Switch, 5 - 2000 MHZ
SW-254  Matched GAAS SP4T Switch, 5 - 2000 MHZ
SW-255  GaAs SP4T Switch, 5 - 2000 MHZ
SW-259  GaAs SPST Switch
SW-261  Matched GAAS SP4T Switch, 5 - 2000 MHZ
SW-262  GaAs SP4T Switch, 5 - 2000 MHZ
SW-276 DC-3 Ghz, High Power GAAS SPDT Switch
SW-277  High Power GAAS SPDT Switch

SW90-0004A :  GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ

MA48706B155 : mm WAVE BAND, GALLIUM ARSENIDE, STEP RECOVERY DIODE Specifications: Configuration: Single ; Pin Count: 2 ; Number of Diodes: 1 ; VBR: 25 volts ; CT: 0.1500 to 0.2490 pF

MA4GP022 : 50 V, GALLIUM ARSENIDE, PIN DIODE Specifications: Package: CASE 277, 1 PIN ; Number of Diodes: 1 ; PD: 250 milliwatts

ML4629-95 : 200 V, SILICON, PIN DIODE Specifications: Number of Diodes: 1

ML6716-241 : 12000 MHz - 18000 MHz RF/MICROWAVE LIMITER Specifications: Limiter Type: Pin Diode Limiter ; Frequency Band: 12000.0 to 18000.0 MHz ; VSWR: 2.00 1

ML7744H-0021 : 100 MHz - 2000 MHz RF/MICROWAVE LINEAR DETECTOR, 23 dBm INPUT POWER-MAX Specifications: Input Frequency Range: 100 to 2000 MHz ; LO/RF Impedance: 50 ohms

ML8R18L : 14300 MHz - 14500 MHz RF/MICROWAVE ISOLATOR Specifications: Component: Isolator ; Frequency Range : 14300 to 14500 MHz ; Insertion Loss: 0.3000 dB ; VSWR: 1.2 1 ; Operating Temperature: -10 to 60 C (14 to 140 F)

MLA2170-502B2 : 6000 MHz - 18000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER Specifications: Amplifier Type: Power Amplifier ; Applications: RF Microwave ; Frequency Range: 6000 to 18000 MHz ; Minimum Gain: 11 dB ; Input VSWR: 2 1 ; Output VSWR: 2 1 ; Operating Temperature: -55 to 95 C (-67 to 203 F)

MLA2240-502B3 : 2000 MHz - 8000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER Specifications: Amplifier Type: Power Amplifier ; Applications: RF Microwave ; Frequency Range: 2000 to 8000 MHz ; Minimum Gain: 17 dB ; Input VSWR: 2 1 ; Output VSWR: 2 1 ; Operating Temperature: -55 to 95 C (-67 to 203 F)

MLM6518-102D : 500 MHz - 18000 MHz RF/MICROWAVE SGL POLE SGL THROW SWITCH, 2.2 dB INSERTION LOSS Specifications: Frequency Range: 500 to 18000 MHz ; Insertion Loss: 2.2 dB ; VSWR: 1.9 1 ; Type: Single Pole Single Throw ; Operating Temperature: -55 to 85 C (-67 to 185 F)

2677-1001-40 : 500 MHz - 2000 MHz RF/MICROWAVE SGL POLE SIX THROW SWITCH, 2 dB INSERTION LOSS Specifications: Frequency Range: 500 to 2000 MHz ; Insertion Loss: 2 dB ; VSWR: 1.6 1 ; Impedance: 50 ohms ; Type: SGL POLE SIX THROW SWITCH ; Operating Temperature: -55 to 95 C (-67 to 203 F)

7N251-T-A7 : 810 MHz - 826 MHz RF/MICROWAVE ISOLATOR Specifications: Component: Isolator ; Frequency Range : 810 to 826 MHz ; Insertion Loss: 0.2000 dB ; VSWR: 1.2 1 ; Operating Temperature: -10 to 70 C (14 to 158 F)

Same catergory

BQ4013MA-120 : NVSRAM Power Management. ti BQ4013, 128Kx8 Nonvolatile SRAM, 5% Voltage Tolerance.

HS-390RH : broadband power. Radiation Hardened CMOS Dual SPDT Analog Switch. Radiation Hardened CMOS Dual SPDT Analog Switch Intersil's Satellite Applications Flow TM (SAF) devices are fully tested and guaranteed to 100kRAD total dose. This QML Class T device is processed to a standard flow intended to meet the cost and shorter lead-time needs of large volume satellite manufacturers, while maintaining a high level of reliability.

ISL6119 : Usb Dual Port Power Supply Controller. The is a USB dual port power controller, fully independent overcurrent (OC) fault protection IC. Operational over the to +5.5V range, this device internal current monitoring, accurate current limiting, integrated power switches and current limited delay to latch-off for system protection. The ISL6119 current sense and limiting circuitry sets the current.

LM5000 : LM5041 - Cascaded PWM Controller, Package: Tssop, Pin Nb=16. The LM5041 PWM controller contains all of the necessary to implement either current-fed or voltage-fed push-pull or bridge power converters. These "Cascaded" topologies are well suited for multiple output and higher power applications. The LM5041's four control outputs include: the buck stage controls (HD and LD) and the pushpull control outputs (PUSH.

LT1940 : Step-Down. LT1940, Dual 1.1MHz, Monolithic 1.4A, Step-down Switching Regulator.

RC1587x33 : 3A Fixed 3.3V Low Dropout Voltage Regulator (LDO). Fast transient response Low dropout voltage to 3A Load regulation: 0.05% typical Trimmed current limit On-chip thermal limiting Standard TO-263, TO-263 center cut, and TO-252 packages The RC1587, RC1587-1.5, and RC1587-3.3 are low dropout three-terminal regulators with 3A output current capability. These devices have been optimized for low voltage applications.

TEN10-1210 : 10-40 Watt. Input Voltage Ranges (VDC) = 9-18 18-36 36-72 ;; Available Output Voltages (VDC) = 3.3 5 12 15 24 5 12 15 ;; Output Current Max. (mA) = 2400 2000 830 650 410 1000 410 330 ;; Package Dimension (mm) = 50 X 25 X 10 (2" X 1" X 0,4") ;; = Full Smd-design Efficiency up to 83% I/O- ISOlation 1500 VDC Integrated Emi-filter to Meet.

VUO52-08NO1 : Three Phase Rectifier Bridge. Test Conditions = 90C, module = 45C (RthKA = 0.5 K/W), module TVJ = 0 TVJ = TVJM ms (50 Hz), sine ms (60 Hz), sine ms (50 Hz), sine ms (60 Hz), sine ms (50 Hz), sine ms (60 Hz), sine ms (50 Hz), sine ms (60 Hz), sine Package with DCB ceramic base plate Isolation voltage 3600 V~ Planar passivated chips Blocking voltage 1800 V Low forward voltage drop.

DRA480 : AC - DC DIN RAIL MOUNTABLE 480W INDUSTRIAL CONTROL EQUIPMENT. COMPACT DESIGN HIGH EFFICIENCY TO 90% ACTIVE PFC FUNCTION PARALLEL FUNCTION AVAILABLE (SWITCH) UNIVERSAL INPUT VOLTAGE OUTPUT WATTAGE VOLTAGE Single Output Models All s Typical At Nominal Line, Full Load, 25 C Unless Otherwise Noticed Isolation voltage Isolation resistance Ambient temperature Derating Storage temperature Relative humidity Dimension.

AAT1265 : Low Voltage 2MHz Step-Up DC/DC Converter The AAT1265 is a member of AnalogicTech's Total Power Management ICTM (TPMICTM) product family and is designed for single-cell or dual-cell alkaline, NiMH, or NiCd battery-powered applications. It is a high frequency, synchronous, fixed frequency step-up converter with true output disconnect during shutdown (.

SSM3K104TU : The ever-increasing functionality of portable devices like cell phone, DSC and portable audio device is increasing their battery loading. In order to realize longer set operation, we are trying to decrease the system power consumption by lowering the internal operating voltage. Especially, lowering the voltage of the power supply and decreasing the internal.

VND810P-E : High Side Switches Double channel high-side driver. ECOPACK: lead free and RoHS compliant Automotive Grade: compliance with AEC Guidelines Very low standby current CMOS compatible input On-state open-load detection Off-state open-load detection Thermal shutdown protection and diagnosis Undervoltage shutdown Overvoltage clamp Output stuck to VCC detection Load current limitation Reverse battery protection.

NSI45090JD : 45 V, 90 MA 15%, 2.7 W Package, Adjustable Constant Current Regulator & LED Driver, DPAK The adjustable constant current regulator (CCR) is a simple, economical and robust device designed to provide a cost effective solution for regulating current in LEDs. The CCR is based on patent-pending Self-Biased Transistor (SBT) technology and regulates current.

NCV8769 : Ultra Low Iq 150 MA LDO Linear Voltage Regulator With Reset And Early Warning The NCV8769 is 150 mA LDO regulator with integrated reset and early warning functions dedicated for microprocessor applications. Its robustness allows NCV8769 to be used in severe automotive environments. Ultra low quiescent current as low as 25 A typical for NCV8769 makes.

0-C     D-L     M-R     S-Z