Details, datasheet, quote on part number: SW-283
PartSW-283
CategoryRF & Microwaves => Switches
Description GaAs Transfer Switch, DC - 3 GHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW-283 datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Features
Small Ceramic Package, 0.250" Sq Fast Switching Speed, 4 ns Typical Ultra Low DC Power Consumption

Frequency Range Insertion Loss DC-3 GHz DC-2 GHz DC-1 GHz DC-0.5 GHz VSWR DC-3 GHz DC-2 GHz DC-1 GHz DC-0.5 GHz Isolation DC-3 GHz DC-2 GHz DC-1 GHz DC-0.5 GHz

Impedance 50 Ohms Nominal Switching Characteristics trise, tfall or 90/10% RF) 2 ns Typ ton, toff (50% control to 90/10% RF) 4 ns Typ Transients (In-Band) 30 mV Typ Input Power for 1 dB Compression Control Voltages (Vdc) 0/-8 0.5-3 GHz +27 +33 dBm Typ 0.05 GHz +21 +26 dBm Typ Intermodulation Intercept Point (for two-tone input power to +5 dBm) Intercept Points IP3 0.5-3 GHz +68 +50 dBm Typ 0.05 GHz +62 +45 dBm Typ Control Voltages (Complementary Logic) VIN Low 5 µA Max VIN 10 µA Typ 200 µA Max Environmental MIL-STD-883 screening available.

Bottom of case is AC ground. Dimensions ( ) are in mm. Unless Otherwise Noted:.xxx = ±0.010 (.xx = ±0.02 (.x = ±0.5)

All specifications apply with 50 ohm impedance connected to all RF ports with 0 and -5 Vdc control voltages. Faster switching speed can be achieved with enhanced driver waveform.


 

Related products with the same datasheet
SW-283PIN
Some Part number from the same manufacture M/A-COM, Inc.
SW-283PIN  GaAs Transfer Switch, DC - 3 GHZ
SW-284  GaAs Matched SP6T Switch, DC - 2 GHZ
SW-289
SW-289PIN GAAS DPDT Switch DC - 2 GHZ
SW-289RTR
SW-289TR
SW-311  Matched GAAS SPST Switch, DC - 3 GHZ With Ttl/cmos Control Input
SW-312 DC-3 Ghz, Match GAAS SPST Switch
SW-313 DC-3 Ghz, Matched GAAS SPDT Switch
SW-314 DC-3 Ghz, GAAS SP4T Absorptive Switch
SW-331 Matched GAAS SPDT Switch DC - 2 GHZ
SW-331PIN
SW-333 DC-2 Ghz, Matched GAAS SPDT RF Switch
SW-333PIN Matched GAAS SPDT Switch DC - 2 GHZ
SW-335 800-2000 Mhz, SPDT Switch With Integral CMOS Driver
SW-337 GAAS SPDT Terminated Switch DC - 2.5 GHZ
SW-337PIN
SW-337RTR
SW-337TR
SW-338 DC-2.5 Ghz, GAAS SPDT Terminated Switch
SW-339
Same catergory

4A1307 : Power Dividers. = Xinger In-phase Power Dividers ;; Size LXWXH = 0.56 X 0.35 X 0.081" ;; Packaging = Surface Mount ;; Frequency MHZ = 3000-3800 ;; Power Handling Watts =.

855915 : = Filter - 3G BTS ;; Frequency (MHz) = 249 ;; Bandwidth (MHz) = 5 ;; Insertion Loss (dB) = 20.0 Max ;; Modes of Operation = se ;; Package (mm) = 9.0 X 7.0.

AM59-0028 :  L-band 250mW pa.

AS004R1-11 : GAAS ic SPST Switch Reflective DC 4 GHZ. s Low DC Power Consumption s Reflective s 8 Lead Hermetic Surface Mount Package s Capable of Meeting MIL-STD Requirements6 The is a GaAs IC FET SPST reflective switch that operates from DC­4 GHz. These devices are useful as modulators and switches in high reliability and commercial applications. Parameter Switching Characteristics Condition Rise, Fall.

AV131-315 : HIP3 Variable Attenuator For Amps. 23 dB Attenuation Range 1.5 dB Insertion Loss, 1.5 SWR 0­12 V Control Voltage 43 dBm IP3 Small Footprint LGA Package Designed for AMPS and GSM Base Stations The is a voltage controlled variable attenuator from Skyworks' series of HIP3TM components. It is specifically designed and specified for use as a wide dynamic range low distortion attenuator for AMPS.

BX6212 : Frequency (MHz) = 10 - 1300 ;; Gain (Typ/Min) (dB) = 10 / 8.5 ;; Noise Figure (Typ/Max) (dB) = 6 / 8.5 ;; P1dB Comp Point (Typ/Min) (dBm) = +22.5 / +19.5 ;; 3rd Order Intercept (Typ) (dBm) = +34 ;; 2nd Order Intercept (Typ) (dBm) = +42 ;; DC Power (Typ) (V/mA) = +15 / +92 ;; Package = Package = Package = 4 Pin TO-8 Package = Surface Mount Package = Flatpack.

LP3000/LPV3000 : 2w Power Phemt. +33.5 dBm Typical Power at 18 GHz 7 dB Typical Power Gain at 18 GHz +30.5 dBm at 3.3V Battery Voltage Low Intermodulation Distortion 45% Power-Added-Efficiency at 18 GHz DIE SIZE: x 16.5 mils x 420 µm) DIE THICKNESS: 2.6 mils (65 µm typ.) BONDING PADS: x 2.4 mils 60 µm typ.) The is an Aluminum Gallium Arsenide / Indium Gallium Arsenide (AlGaAs/InGaAs).

M6EH :  Double Balanced Mixer. DOUBLE-BALANCED MIXER TO 750 MHz TO 500 MHz TO 500 MHz LO DRIVE: +20 dBm (NOMINAL) HIGH INTERCEPT POINT: +28.5 dBm (TYP.) HIGH ISOLATION 45 dB (TYP.) SSB Conversion Loss & SSB Noise Figure (max.) to 0.1 GHz, to 0.1 GHz, to 0.1 GHz to 0.25 GHz, to 0.25 GHz, to 0.25 GHz to 0.5 GHz,fL to 0.75 GHz, to 0.5 GHz fI = Isolation (min.) to 0.2 GHz to 0.5 GHz to 0.75.

MICRF500 : MICRF500 UHF Transceiver, 700MHz to 1000MHz. The is a single chip UHF transceiver designed for spread spectrum communication (FHSS) intended for ISM (Industrial, Scientific and Medical) and SRD (Short Range Device) frequency bands from to 1100MHz with FSK data rates to 128k baud. The transmitter consists of a PLL frequency synthesizer and a power amplifier. The frequency synthesizer consists of a voltage-controlled.

PWC32 : Fixed TTL Pulse Width Controller.

RMPA0959-108 : MMIC. Type = Cellular Power Amplifier ;; Circuit = 3V Cellular Band Amps, Cdma & CDMA2000 Power Amplifier Module ;; Frequency = 824-849 MHZ.

RMTR13390 : MMIC. Circuit = 13-39 GHZ Tripler Mmic ;; Frequency = 13-39 GHZ ;; Conversion Loss = 5 DBM.

SME1400B-17 : . Product to 2200 MHz to 2200 MHz to 2000 MHz LO Drive: +17 dBm (Other Levels Available) No Internal Solder Connections s Parameter SSB Conversion Loss RF/LO = 10-1300 MHz, = 10-1000 MHz RF/LO = 10-2200 MHz, = 30-1000 MHz RF/LO = 1-2200 MHz, = 1-2000 MHz Port-to-Port Isolation L-R = 10-1500 MHz L-R = 10-2200 MHz L-I = 10-2000 MHz L-I = 10-2200 MHz R-I 3rd Order.

SW90-0004 : DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply. Operates - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 7 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel are Available M/A-COM's a SP6T absorptive pHEMT switch with integral TTL driver. This device in an MLP plastic surface mount package. This switch offers excellent.

TGL8784 : 2 - 20 GHZ Analog Attenuator. to 20 GHz Frequency Range 2-dB Insertion Loss at Midband 10-dB Input/Output Return Loss 13-dB Variable Attenuation Range Single Polarity Power Supply Required x 0.006 in.) The TriQuint is a monolithic variable attenuator which operates from to 20-GHz. This analog attenuator can operate from a single +2.5 volt power supply if used with an external variable.

TH72035 : Transmitter - 868/915MHz, Fsk/ask (10L MLPD 3x3). Fully integrated PLL-stabilized VCO Frequency range from 850 MHz to 930 MHz Single-ended RF output FSK through crystal pulling allows modulation from to 40 kbit/s High FSK deviation possible for wideband data transmission ASK achieved by on/off keying of internal power amplifier to 40 kbit/s Wide power supply range from 5.5 V Very low standby current.

RF-HDT-DVBE-N0 : Texas Instruments’ 13.56MHz Encapsulated Standard Transponder is compliant with the ISO/IEC 15693 and ISO/IEC 18000-3 global open standards. This product offers a user accessible memory of 256 bits, organized in 8 blocks and an optimized command set. Designed for harsh environments such as garment tracking in laundries, each transponder has a 64bit.

ZL60212 : 50 MHz Single-Chip Duplex (880 nm Tx/Rx) The single-chip device operates as both an Emitter and Detector, and transmits data over a single fiber in half-duplex mode; therefore, reducing both fiber and component costs when compared with traditional approache.

BLF573S : HF / VHF Power LDMOS Transistor A 300 W LDMOS RF power transistor for broadcast applications and industrial, scientific and medical applications in the HF to 500 MHz band. CAUTION This device is sensitive to ElectroStatic Discharge (ESD). Therefore care should be taken during transport and handling..

 
0-C     D-L     M-R     S-Z