Details, datasheet, quote on part number: SW-339TR
PartSW-339TR
CategoryPower Management
DescriptionGAAS SPDT Terminated Switch DC - 2.5 GHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW-339TR datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Features

Very Low Power Consumption: 75 W Low Insertion Loss: 0.5 dB High Isolation: to 2 GHz to 2 GHz (SW-339) Very High Intercept Point: 46 dBm IP3 Nanosecond Switching Speed Temperature Range: to +85C Low Cost SOIC8 Plastic Package Tape and Reel Packaging Available1

Description

M/A-COM's SW-337, SW-338 and SW-339 are GaAs MMIC SPDT terminated switches in a low cost SOIC 8-lead surface mount plastic package. They are ideally suited for use where very low power consumption is required. Typical applications include transmit/receive switching, switch matrices, and filter banks in systems such as: radio and cellular equipment, PCM, GPS, fiber optic modules, and other battery powered radio equipment. The difference between the switches is in the pin configuration. The SW-337, SW-338 and SW-339 are fabricated with monolithic GaAs MMICs using a mature 1-micron process. The process features full chip passivation for increased performance and reliability.

8-Lead SOP outline dimensions Narrow body.150 (All dimensions per JEDEC No. MS-012-AA, Issue C) Dimensions ( ) are in mm. Unless otherwise noted:.xxx = 0.010 (.xx = 0.02 (.x = 0.5)

Part Number SW-337 PIN TR SW-337 RTR SW-338 PIN TR SW-338 RTR SW-339 PIN TR SW-339 RTR Package SOIC 8 Lead Forward Tape & Reel Reverse Tape & Reel SOIC 8 Lead Forward Tape & Reel Reverse Tape & Reel SOIC 8 Lead Forward Tape & Reel Reverse Tape & Reel

0.1 GHz 0.5 GHz 1.0 GHz 2.0 GHz Isolation 0.1 GHz 0.5 GHz 1.0 GHz 2.0 GHz VSWR 2.0 GHz Off 2.0 GHz Trise, Tfall to 90% RF, 10% RF Ton, Toff 50% Control to 90% RF, 50% Control 10% RF Transients In Band One dB Input Power 0.05 GHz Compression Point Input Power 2.0 GHz 2nd Order Measured Relative 0.05 GHz Intercept to Input Power 2.0 GHz (for two-tone input power to +5 dBm) 3rd Order Measured Relative 0.05 GHz Intercept to Input Power 2.0 GHz (for two-tone input power to +5 dBm) 1. Refer to "Tape and Reel Packaging" Section, or contact factory.

2. All measurements with 0, -5 control voltages at 1 GHz a 50 system, unless otherwise specified.
GaAs SPDT Terminated Switch Absolute Maximum Ratings

Parameter Max. Input Power 0.05 GHz 2.0 GHz Control Voltage Operating Temperature Storage Temperature +27 dBm +34 dBm to +150C

1. Operation of this device above any one of these parameters may cause permanent damage.


 

Some Part number from the same manufacture M/A-COM, Inc.
SW-349
SW-369 0.02-2 Ghz, GAAS Matched SP4T Switch
SW-392
SW-393 0.5-2 Ghz, GAAS SPST High ISOlation Terminated Switch
SW-394
SW-395 DC-2 Ghz, 3 V GAAS SPDT Switch
SW-399
SW-415 DC-2 Ghz, Matched GAAS SP4T Switch
SW-419 DC-2 Ghz, GAAS SP4T Terminated Switch
SW-419PIN GAAS Sp4t Terminated Switch DC - 2 GHZ
SW-419RTR DC-2 Ghz, GAAS SP4T Terminated Switch
SW-425 DC-3 Ghz, 3 Watt Cellular T/r And Antenna Changeover Switch
SW-437 DC-3 Ghz, GAAS SPDT Switch
SW-437PIN GAAS SPDT Switch DC - 3.0 GHZ
SW-437RTR DC-3 Ghz, GAAS SPDT Switch
SW-438  GaAs SPDT Switch DC - 3.0 GHZ
SW-439 DC-3 Ghz, GAAS High ISOlation Switch
SW-439PIN GAAS High ISOlation Switch DC - 3.0 GHZ
SW-439PIN DC-3 Ghz, GAAS High ISOlation Switch
SW-442 DC-3 Ghz, GAAS SPDT Terminated Switch
SW-442PIN GAAS SPDT Terminated Switch DC - 3.0 GHZ
Same catergory

AN7700F : Low-dropout Three-pin Voltage Regulator 1.2-a Type. The AN7700, AN7700F, and AN7700SP series are stabilized constant-voltage power supplies with small difference between I/O voltages (0.5 V typ.). They are suitable for low-voltage, battery-driven equipment, and home appliances and industrial equipment with great fluctuation of the supply voltage. The output voltage ranges: For 20 V, and 24 V For 12 V, and V AN7700.

AP2002 : Synchronous PWM With VFC Controller.

BD6660FV : 3-phase Motor Driver For Cd-roms. The BD6660FV is low power consumption CD-ROM spindle driver that uses MOS transistor in the output. To meet the requirements for notebook computers, the thin power package SSOP-B28 is used and a PWM drive with a MOS processor output stage achieves an extremely low power consumption. FApplications Portable CD-ROMs, DVDs F 1) Direct PWM drive. 2) Built-in.

BQ4013YMA-120 : NVSRAM Power Management. ti BQ4013Y, 128Kx8 Nonvolatile SRAM, 10% Voltage Tolerance.

FSDM07652R : SMPS Power Switch For LCD Monitors Flyback, (Green)The FSDM07652R is an Integrated Pulse Width Modulator (PWM) And Sense Fet Specifically Designed For High Performance Offline Switch Mode Power Supplies (SMPS) With Minimal External Components. This Device is an Integrated High Voltage Power Switching Regulator Which Combine an Avalanche Rugged Sense.

GS-R400/2 : Switching Voltage Regulators->Modules. Small Size Step-down Switching Regulator Family.

HIP6008CB : Buck Pulse-width Modulator ( PWM ) Controller And Output Voltage Monitor.

PBD35171SO : Stepper Motor Drive Circuit. PBD is a bipolar, monolithic, integrated circuit, intended to drive a stepper motor in a unipolar, bilevel way. One PBD 3517/1 and a minimum of external components form a complete control and drive unit for LS-TTL- or microprocessor-controlled stepper motor system for currents to 500mA. The driver is suited for applications requiring least-posssible.

SW-228PIN : GAAS SPDT Switch Dc-4 GHZ. Miniature Ceramic Package Terminated (SE-226), High Isolation (SW-227), Low Loss (SW-228) Fast Switching Speed, 6 ns Typical Ultra Low DC Power Consumption (From to +85C) Frequency Range DC-4 GHz Model Number SW-227 SW-228 Insertion Loss DC-4 GHz 1.0 dB Max DC-2 GHz 0.8 dB Max DC-1 GHz 0.7 dB Max DC-0.5 GHz 0.7 dB Max VSWR DC-4 GHz 2.0:1 1.9:1 Max DC-2.

TLV2402CP : Family of 900-na/ch Rail-to-rail Input/output Operational Amplifiers With Reverse Battery Protection.

TPS2226DB : PCMCIA/Cardbus Switch Matrix. ti TPS2226, 1A Dual-slot PC Card Power Switch W/serial Interface, 30-Pin Package.

UCC3580D-3 : Soft Switching. ti UCC3580-3, Single-ended Active Clamp/reset PWM. Provides Auxiliary Switch Activation Complementary to Main Power Switch Drive Programmable deadtime (Turn-on Delay) Between Activation of Each Switch Voltage Mode Control with Feedforward Operation Programmable Limits for Both Transformer Volt- Second Product and PWM Duty Cycle High Current Gate Driver for Both Main and Auxiliary Outputs Multiple Protection.

SiP42101 : dual MOSFET drivers. Half-Bridge N-Channel MOSFET Driver for Motor Control 5-V Gate Drive Pb-free Undervoltage Lockout Available Internal Bootstrap Diode Adaptive Shoot-Through Protection Motor Braking Shutdown Control Matched Rising and Falling Propagation Delays Drive MOSFETs to 50-V Systems APPLICATIONS The is a high-speed half-bridge MOSFET driver with adaptive shoot-through.

AAT1275 : The AAT1275 SwitchReg is a 2MHz, 500mA synchronous boost converter with an integrated current-limiting load switch controlled output. The AAT1275 operates from a single-cell Lithium-ion/ polymer battery source and provides a regulated 5V, current limit controlled output to support USB port VBUS applications in portable consumer electronic products.

SP6340 : Quad microPower Supervisory Circuits with Manual Reset and Watchdog * Low operating voltage of 1.6V * Low operating current of 20uA typical * Monitors up to four supplies simultaneously * Adjustable inputs monitor down to 0.5V * Reset asserted down to 0.9V * 2% accuracy over temperature range * Open Drain (OD) RSTB * 4 Reset Timeout Periods: 50ms, 100ms,.

FSQ0765R : SMPS Power Switch(QRC), 5A, 650V, TO220F (Green) A Quasi-Resonant Converter (QRC) generally shows lower EMI and higher power conversion efficiency than a conventional hard-switched converter with a fixed switching frequency. The FSQ-series is an integrated Pulse-Width Modulation (PWM) controller and SenseFET specifically designed for quasi-resonant.

SPDCPOE12 : DC-DC Modules Datasheet Power over ethernet 10 W modulee. Input voltage range: 10 W output Based on ST devices integrating standard PoE interface and current mode PVM controller IEEE 802.3af compliant (PoE standard) Class 0 (zero), 0-12.96 W input Output voltage 12 V Output current 0.8 A Output voltage 5 % Ripple 1 % rms Transient response 5 load to full load Operating temperature range 70 C Input transient.

PTD08A210W : Single 10A Output, 4.5V To 14V Input, Non-Isolated, Digital PowerTrain Module The PTD08A210W is a high-performance single 10-A output, non-isolated digital PowerTrain module. This module is the power conversion section of a digital power system which incorporates TIs UCD7242 MOSFET/driver IC. The PTD08A210W must be used in conjunction with a digital.

PT7M7825MTA : P Supervisor Circuits The PT7M7xxx family microprocessor (P) supervisory circuits are targeted to improve reliability and accuracy of power-supply circuitry in P systems. These devices reduce the complexity and number of components required to monitor power-supply and battery functions..

 
0-C     D-L     M-R     S-Z