Details, datasheet, quote on part number: SW-393
PartSW-393
CategoryRF & Microwaves => Switches
Description0.5-2 Ghz, GAAS SPST High ISOlation Terminated Switch
CompanyM/A-COM, Inc.
DatasheetDownload SW-393 datasheet
Quote
Find where to buy
 
  

 

Features, Applications
GaAs SPST High Isolation Terminated Switch, - 2.0 GHz
Features

! Terminated RF Output ! High Isolation: to 2 GHz ! Single Positive Control ! CMOS Compatible Logic ! Low Cost SOIC 8 Plastic Package

Description

M/A-COM's is a GaAs monolithic SPST terminated switch in a low cost SOIC 8-lead plastic package. The SW-393 is ideally suited for use where low power consumption and high isolation are required. Typical applications include PCS and GSM LO Switching, switch matrices and switched filter banks in systems such as radio and cellular equipment. The SW-393 is fabricated using a mature 1-micron gate length GaAs MESFET process. The process features full chip passivation for increased performance and reliability.

Parameter Insertion Loss Isolation VSWR 1 dB Compression Input Power, +5V Control/Supply Test Conditions Frequency - 2.0 GHz - 1.0 GHz - 2.0 GHz - 1.5 GHz - 2.0 GHz 0.5 GHz 0.9 GHz 1.5 GHz Units dB Ratio dBm mV 0.5 GHz 0.9 GHz 0.5 GHz 0.9 GHz dBm Min 50 40 Typ Max 1.8

Trise, Tfall Ton, Toff Transients Input IP2 Input IP3

to 90% RF, RF 50% Control to 90% RF, Control 10% RF In-Band 2-Tone, 5 MHz spacing, +10 dBm each 2-Tone, 5 MHz spacing, +10 dBm each

1. All measurements taken at 900 MHz a 50 Ohm system unless otherwise specified. Loss varies at 0.003 dB/°C.

GaAs SPST High Isolation Terminated Switch, - 2.0 GHz

Parameter Input Power Operating Voltage (VS, VCTL) Operating Temperature Storage Temperature Absolute Maximum +34 dBm +8.5 Volts to +150°C

2. Operation of this device above any one of these parameters may cause permanent damage.

Blocking capacitors are required on all RF ports. VS can be applied or RF2 using 10K or greater pull-up resistors.

M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information.

GaAs SPST High Isolation Terminated Switch, - 2.0 GHz Typical Performance Curves
Output Insertion Loss Output Isolation Input

Part Number SW-393 PIN SW-393TR SW-393SMB Package SOIC 8-Lead Plastic Package Tape and Reel 3 Sample Board

3. Refer to Application Note M513 for reel size information.

 

Related products with the same datasheet
SW-393PIN
SW-393SMB
SW-393TR
Some Part number from the same manufacture M/A-COM, Inc.
SW-393PIN 0.5-2 Ghz, GAAS SPST High ISOlation Terminated Switch
SW-394
SW-395 DC-2 Ghz, 3 V GAAS SPDT Switch
SW-399
SW-415 DC-2 Ghz, Matched GAAS SP4T Switch
SW-419 DC-2 Ghz, GAAS SP4T Terminated Switch
SW-419PIN GAAS Sp4t Terminated Switch DC - 2 GHZ
SW-419RTR DC-2 Ghz, GAAS SP4T Terminated Switch
SW-425 DC-3 Ghz, 3 Watt Cellular T/r And Antenna Changeover Switch
SW-437 DC-3 Ghz, GAAS SPDT Switch
SW-437PIN GAAS SPDT Switch DC - 3.0 GHZ
SW-437RTR DC-3 Ghz, GAAS SPDT Switch
SW-438  GaAs SPDT Switch DC - 3.0 GHZ
SW-439 DC-3 Ghz, GAAS High ISOlation Switch
SW-439PIN GAAS High ISOlation Switch DC - 3.0 GHZ
SW-439PIN DC-3 Ghz, GAAS High ISOlation Switch
SW-442 DC-3 Ghz, GAAS SPDT Terminated Switch
SW-442PIN GAAS SPDT Terminated Switch DC - 3.0 GHZ
SW-442PIN DC-3 Ghz, GAAS SPDT Terminated Switch
SW-444 2v Control Triple-band Gsm/dcs/pcs Sp5t Switch 0.5 . 2.0 GHZ
SW-444SMB
Same catergory

10616-10 : = Directional Couplers ;; Size LXWXH = 2.44 X 1.25 X 0.43" ;; Packaging = Aluminum Cased ;; Frequency MHZ = 2000-4000 ;; Power Handling Watts = 50.

4J3305 : Power Dividers. = Xinger In-phase Power Dividers ;; Size LXWXH = 0.65 X 0.48 X 0.09" ;; Packaging = Surface Mount ;; Frequency MHZ = 2000-2300 ;; Power Handling Watts =.

AD9901TE/883 : Ultrahigh Speed Phase/frequency Discriminator.

MA4EX950L-1225 : 700-1200 MHZ Low Cost Silicon Double Balanced Hmic Mixer. Low Cost Silicon Double Balanced HMICTM Mixer, - 1200 MHz 6.5 dB Typical Conversion Loss to +7 dBm LO Drive HMIC IC Process Silicon Low Barrier Schottky Barrier Diodes - 400 MHz IF Bandwidth Low Cost Miniature Plastic Package M/A-COM's is a silicon monolithic 700-1200 MHz double balanced mixer in a low-cost miniature surface mount SOT-25 package. The die uses.

MAAPGM0038-DIE :  1.2W X/ku-band Amplifier. 7.5-13.5 GHz Operation 1.2 Watt Saturated Output Power Level Variable Drain Voltage (4-10V) Operation Self-Aligned MSAG® MESFET Process The 1.2 W power amplifier with on-chip bias networks. This product is fully matched to 50 ohms on both the input and output. It can be used as a power amplifier stage as a driver stage in high power applications. Each.

NJG1553F : GaAs MMICs. 1.5GHz/1.9GHz Band Mixer GAAS Mmic. is a mixer GaAs MMIC featured low distortion, high conversion gain and low noise figure. This mixer includes a local amplifier, and ideally suitable for 1.5/1.9Hz band digital mobile phone and PHS handsets. The very small MTP package is adopted. NJG1553F nPACKAGE OUTLINE lLow voltage operation lHigh conversion gain lHigh Input +2.7V 9dB typ. @fRF= 1489.0MHz,.

PI5A4626 : Sotiny 1 Ohm, Low-Voltage, Single-supply SPST Switch. SOTINYTM Low-Voltage, Single-Supply, 1-Ohm SPST CMOS Analog Switches 1-Ohm max. ON-Resistance 0.15-Ohm max. ON-Resistance Flatness at +25°C Fast Switching tON = 50ns max. tOFF = 50ns max. to +5.5V Single-Supply Operation TTL/CMOS-Logic Compatible ­57dB Off-Isolation 1MHz 4nA max. Off-Leakage at +25°C Package: 5-Pin SOT-23 PI5A4626/PI5A4629, single-pole/single-throw.

RF2484 : Modulators/Demodulators. Direct Quadrature Modulator. Typical Applications Dual-Band CDMA Base Stations TDMA/TDMA-EDGE Base Stations GSM-EDGE/EGSM Base Stations Product The is a monolithic integrated quadrature modulator IC capable of universal direct modulation for highfrequency AM, PM, or compound carriers. This low-cost IC excellent linearity, noise floor, and over-temperature carrier suppression performance.

RFP-100-50TW : = Terminations ;; Size LXWXH = 0.8 X 0.225 X 0.16" ;; Packaging = Flanged ;; Frequency MHZ = 0-6000 ;; Power Handling Watts = 100.

SD57030 : Power. RF Power Transistors The Ldmost Family. EXCELLENT THERMAL STABILITY COMMON SOURCE CONFIGURATION POUT 30 W WITH 13 dB gain @ 945 MHz BeO FREE PACKAGE The is a common source N-Channel enhancement-mode lateral Field-Effect RF power transistor designed for broadband commercial and industrial applications at frequencies to 1.0 GHz. The SD57030 is designed for high gain and broadband performance.

SQ202 : Power. Pout W = 10 ;; Freq MHZ = 1000 ;; Gain DB = 10 ;; Theta JC = 3.4 ;; GM Mho = 0.6 ;; Idsat a = 2.8 ;; Ciss PF = 20 ;; CRSS PF = 1.2 ;; Coss PF = 12 ;; Die = 2+2 ;; Style = Push - Pull ;; PKG = aq ;; = P ;; = a ;; = S.

HMC-C034 : The HMC-C034 is a x2 active broadband frequency multiplier utilizing GaAs PHEMT technology in a miniature hermetic module. When driven by a 3 dBm signal, the multiplier provides +13 dBm typical output power from 32 to 46 GHz. The Fo isolation is >30 dBc with respect to output signal level. This frequency multiplier DC blocked I/O’s, and is ideal.

MSWSSB-020-30 : Medium / High Power Switches Unlike standard MMIC switches that can’t handle high power, Aeroflex / Metelics’ new no-driver switch family provides medium to high power levels from 20 to 40 W max. with low harmonic distortion. If higher RF power is required, we can support up to 100W maximum Need specified information? Contact our application engineers.

HMC932LP4E : 390° Analog Phase Shifter SMT, 12 - 18 GHz The HMC932LP4E is an Analog Phase Shifter which is controlled via an analog control voltage from 0 to +13V. The HMC932LP4E provides a continuously variable phase shift of 0 to 390 degrees from 12 to 18 GHz, with extremely consistent low insertion loss versus phase shift and frequency. The high accuracy HMC932LP4E.

RF6505 : 3.3 V, 2.4 GHz Front-End Module The RF6505 integrates a complete solution in a single Front End Module (FEM) for WiFi and ZigBee® applications in the 2.4GHz to 2.5GHz band. This FEM integrates the PA plus harmonic filter in the transmit path and the LNA with bypass mode in the receive side. It provides a single balanced TDD access for Rx and Tx paths.

HMC897 : Filter - Tunable, Band Pass Chip, 9 - 19 GHz The HMC897 is a MMIC band pass filter which a user selectable passband frequency. The 3 dB filter bandwidth is approximately 18%. The 20 dB filter bandwidth is approximately 35%. The center frequency can be varied between 9 and 19 GHz by applying an analog tune voltage between 0 and 14V. This tunable filter.

 
0-C     D-L     M-R     S-Z