|Category||RF & Microwaves => Switches|
|Description||DC-2 Ghz, GAAS SP4T Terminated Switch|
|Datasheet||Download SW-419 datasheet
Very Low Power Consumption: 100 ”W Low Insertion Loss: 1 dB High Isolation: to 2 GHz Very High Intercept Point: 46 dBm IP3 Nanosecond Switching Speed Temperature Range: to +85°C Low Cost SOIC24 Plastic Package Tape and Reel Packaging Available1Description
M/A-COM's is a GaAs MMIC SP4T terminated switch in a low cost SOIC 24-lead wide body surface mount plastic package. The SW-419 is ideally suited for use where very low power consumption is required. Typical applications include switch matrices, and filter banks in systems such as: radio and cellular equipment, PCM, GPS, fiber optic modules, and other battery powered radio equipment. The SW-419 is fabricated with a monolithic GaAs MMIC using a mature 1-micron process. The process features full chip passivation for increased performance and reliability.
SOIC 24-Lead Plastic Package Forward Tape & Reel Reverse Tape & Reel Unit dB Min. Typ. Max SW-419 PIN TR SW-419 RTR
0.1 GHz 0.5 GHz 1.0 GHz 2.0 GHz 0.1 GHz 0.5 GHz 1.0 GHz 2.0 GHz On Off to 90% RF, RF 50% Control to 90% RF, 50% Control RF In Band Input Power 0.05 GHz Input Power 2.0 GHz Measured Relative 0.05 GHz to Input Power 2.0 GHz (for two-tone input power to +5 dBm) Measured Relative 0.05 GHz to Input Power 2.0 GHz (for two-tone input power to +5 dBm)VSWR Trise, Tfall Ton, Toff Transients One dB Compression IP2
1. Refer to "Tape and Reel Packaging" Section, or contact factory. 2. All measurements with -5 V control voltages at 1 GHz a 50 system, unless otherwise specified.
Parameter Max. Input Power Below 500 MHz Above 500 MHz Control Voltage Storage Temperature Absolute Maximum +27 dBm +30 dBm to +150°C1.Operation of this device above any one of these parameters may cause permanent damage.
Control Input A4 B4 Condition Of Switch RF Common to Each RF Port RF1 On Off RF2 Off On Off RF3 Off On Off RF4 Off On
|Related products with the same datasheet|
|Some Part number from the same manufacture M/A-COM, Inc.|
|SW-419PIN GAAS Sp4t Terminated Switch DC - 2 GHZ|
|SW-419RTR DC-2 Ghz, GAAS SP4T Terminated Switch|
|SW-425 DC-3 Ghz, 3 Watt Cellular T/r And Antenna Changeover Switch|
|SW-437 DC-3 Ghz, GAAS SPDT Switch|
|SW-437PIN GAAS SPDT Switch DC - 3.0 GHZ|
|SW-437RTR DC-3 Ghz, GAAS SPDT Switch|
|SW-438 GaAs SPDT Switch DC - 3.0 GHZ|
|SW-439 DC-3 Ghz, GAAS High ISOlation Switch|
|SW-439PIN GAAS High ISOlation Switch DC - 3.0 GHZ|
|SW-439PIN DC-3 Ghz, GAAS High ISOlation Switch|
|SW-442 DC-3 Ghz, GAAS SPDT Terminated Switch|
|SW-442PIN GAAS SPDT Terminated Switch DC - 3.0 GHZ|
|SW-442PIN DC-3 Ghz, GAAS SPDT Terminated Switch|
|SW-444 2v Control Triple-band Gsm/dcs/pcs Sp5t Switch 0.5 . 2.0 GHZ|
|SW-456 DC-3 Ghz, GAAS SPDT Switch|
|SW-456TR3000 2v Control Triple-band Gsm/dcs/pcs Sp5t Switch 0.5 . 2.0 GHZ|
|SW-456TR3000 DC-3 Ghz, GAAS SPDT Switch|
|SW-461 800-900 Mhz, 4 X 6 RF Switch Matrix|
|SW-475 0.5-3 Ghz, SPDT High ISOlation Terminated Switch|
AT-210TR : Digital Attenuator, 15 DB, 4-Bit
DS56-0001-TR : E-Glass 6-Way SMT Power Splitter/combiner 824 - 960 MHZ
NJG1518KB2-R1 : E-series 2-way 0 Power Divider 5 - 500 MHZ
EMRSJ-2LH : 5 MHz - 1000 MHz RF/MICROWAVE DOUBLE BALANCED MIXER, 9.5 dB CONVERSION LOSS-MAX Specifications: RF: 5 to 1000 MHz ; Conversion Loss: 9.5 dB ; Mixer Type: Double Balanced ; Operating Temperature: -55 to 100 C (-67 to 212 F)
EQKR8-160W : 90 MHz - 150 MHz RF/MICROWAVE I/Q MODULATOR, 6 dB CONVERSION LOSS-MAX Specifications: Product Type: I & Q Modulator ; Carrier Frequency: 90 to 150 MHz
MA46483-120 : VHF-KA BAND, 6.8 pF, 22 V, GALLIUM ARSENIDE, HYPERABRUPT VARIABLE CAPACITANCE DIODE Specifications: Diode Type: VARIABLE CAPACITANCE DIODE
ML4519-118 : 30 V, GALLIUM ARSENIDE, ABRUPT VARIABLE CAPACITANCE DIODE Specifications: Diode Type: VARIABLE CAPACITANCE DIODE
ML48709B-168 : mm WAVE BAND, 25 V, GALLIUM ARSENIDE, ABRUPT VARIABLE CAPACITANCE DIODE Specifications: Diode Type: VARIABLE CAPACITANCE DIODE
ML6713-112 : 500 MHz - 2000 MHz RF/MICROWAVE LIMITER Specifications: Limiter Type: Pin Diode Limiter ; Frequency Band: 500.0 to 2000.0 MHz ; VSWR: 1.40 1
2-22-400-41 : RF/MICROWAVE ISOLATOR Specifications: Component: Isolator ; Insertion Loss: 0.4000 dB ; VSWR: 1.2 1 ; Operating Temperature: -30 to 70 C (-22 to 158 F)
2674-1004-40 : 500 MHz - 2000 MHz RF/MICROWAVE SGL POLE FIVE THROW SWITCH, 1.3 dB INSERTION LOSS Specifications: Frequency Range: 500 to 2000 MHz ; Insertion Loss: 1.3 dB ; VSWR: 1.5 1 ; Type: SGL POLE FIVE THROW SWITCH ; Operating Temperature: -55 to 95 C (-67 to 203 F)
1GT-10 : Digital Attenuators. = Attenuator, Pin Diode ;; Freq. Range = 0.25-18 GHZ.
40279 : Power Dividers. = Power Dividers ;; Size LXWXH = 2.5 X 2.0 X 0.37" ;; Packaging = Aluminum Cased ;; Frequency MHZ = 12400-18000 ;; Power Handling Watts = 17.
4A1280 : Power Dividers. = Power Dividers ;; Size LXWXH = 2.8 X 2.4 X 0.37" ;; Packaging = Aluminum Cased ;; Frequency MHZ = 3700-4200 ;; Power Handling Watts = 17.
AA104-73 : Digital Attenuator. GAAS ic 1 Bit Digital Attenuator 32 DB. 1 Bit Attenuation dB DC1 GHz, dB 12 GHz, 22.5 dB Combine with or AA101-80 for dB 6 Bit Solution Tune with One Capacitor and/or Resistor to Desired Operating Frequency and Attenuation Ideal for Both IF and RF Applications Including Cable, GSM, PCS, EDGE, 3G and ISM The a 1 bit, GaAs IC FET digital attenuator in a low cost SOT-6 package. This attenuator.
CHT3091a-99F : Operational Frequency = DC-40GHz ;; Amplitude Control = 20dB ;; Minimum Attenuation = 3dB ;; Maximum Attenuation = 23dB ;; P-1dB = 15dBm ;; Case = Die.
D2018UK : Purchase Online = ;; Package = Flangeless DP ;; Impedance Calculator = ;; Operating Voltage (V) = 28 ;; Power Output (W) = 10 ;; Minimum Efficiency = 40 ;; Gain = 13 ;; Test Frequency (MHz) = 1000 ;; Configuration = Single-ended ;; Application Range = 1-1000MHz ;; Active Fet Configuration = 4 ;; BVDSS (V) = 65.
DS-323 : Flatpack Three-way Power Divider, 25 - 1000 MHZ. Insertion Loss: 0.4 dB Typical Midband Isolation: 35 dB Typical Midband Input VSWR: 1.2:1 Typical Impedance: 50 Ohms Nominal Maximum Power Rating or Input Power: 1 Watt Max. Internal Load Dissipation: 0.05 Watts Max. MIL-STD-202 Screening Available A Power Divider is ideally a loss less reciprocal device which can also perform vector summation of two or more.
EKIN2-155WD : Modulators/Demodulators. 135-176 Mhz,i/q Demodulator. Excellent Phase and Amplitude Balance LO Power +10 dBm Typical Surface Mount M/A-COM's is a broadband, passive, surface mount I/Q demodulator. Ideally suited for IF demodulation in Cellular Base Stations. Typical system applications include GSM, DCS1800, W-CDMA and PCS. Parameter Frequency Range - 176 I/Q - 5 Units MHz dB Degrees LO to I/Q dB dBm RF Port.
FMM1103VJ : MMICs->GaAs MMICs. Prescalers. Operation to 12.0 GHz Input Frequency divide by 8, OUT and OUT (or+5V) DC Single Power Supply External 50 ohm Load Driving Capability Small 10 pin Hermetic SMT-10 Package (VJ) Tape and Reel available The is a GaAs Microwave Static Frequency Divider designed for dividing an input signal by 8 over a frequency range from to 12.0 GHz. This part is designed.
HMC347C8 : Spdt, hi ISOlation. GaAs MMIC SMT HIGH ISOLATION SPDT SWITCH, - 8.0 GHz Isolation: @ 2.5 GHz @ 8.0 GHz Insertion Loss: 2.0 dB Typical Non-Reflective Design Surface Mount Ceramic Package Typical Applications The HMC347C8 is ideal for: Telecom Infrastructure Microwave Radio & VSAT Military Radios, Radar & ECM Test Instrumentation The is a broadband high isolation non-reflective.
MAMXES0040 : E-Series SMT Schottky Mixer 125 - 208 MHZ. M/A-COM's is a Low Cost,Broadband,high Performance Double Balanced Mixer designed for use in high volume wireless applications. The device has been optimised by careful selection of the Schottky Diode and Balun Transformer for excellent performance. MAMXES0040 is available an SM-89 surface mount package and reflows using standard soldering reflow profiles.
MGS-801 : Surface Mount GAAS Schottky Diodes. SURFACE MOUNT GaAs SCHOTTKY FOR MIXERS AND DOUBLERS Surface mount Package in a Chip Low Capacitance 0.07/0.04 pF typical Anti-parallel/single Low Rs 4 ohms typical Single and Anti-Parallel configurations Oxide/Nitride/Polyimide Passivation for High Reliability MAXIMUM RATING Total Power Dissipation: @ +25șC Derate linearly at +150șC Operation Temperature:.
MHW1254L : MHW1254L 50 Mhz, 25 DB, 4-Channel Catv Low Current Amplifier Module. Specified for 4Channel Loading Superior Gain, Return Loss and DC Current Stability over Temperature Capable of Handling Multiple Channels in the Return Path with Good Distortion Performance Silicon Bipolar Transistor Technology Unconditionally Stable Under All Load Conditions Applications CATV Systems Operating in the to 50 MHz Frequency Range Specified.
MHW6342T : MHW6342T 550 Mhz, 35.2 DB, 77-Channel Catv Amplifier Module. Specified for 77Channel Loading Excellent Distortion Performance Superior Gain, Return Loss and DC Current Stability over Temperature Silicon Bipolar Transistor Technology Unconditionally Stable Under All Load Conditions Applications CATV Systems Operating in the to 550 MHz Frequency Range Single Module High Gain Line Amplifier in Cable TV Distribution.
MSC80185 : General Purpose Linear Transistors. General Purpose Linear Applications RF & Microwave Transistors.
PD4W09-59 : Four-way 0 Power Splitter Combiner . s Low Cost s Low Profile s Available in Small MSOP-8 Package s Tape & Reel The is a monolithic four-way in-phase hybrid junction tuned for the 0.810.96 GHz band. It offers low loss, high isolation, good input/output matching and exceptional phase/amplitude balance. It is available in the MSOP-8 leaded surface mount package. Parameter Frequency Insertion.
AG602-89 : InGaP HBT Gain Block InGaP HBT Gain Block. 3500 MHz +18.5 dBm at 900 MHz +33 dBm at 900 MHz 14 dB Gain at 900 MHz Single Voltage Supply Lead-free / RoHS-compliant / Green SOT-89 package Internally matched to 50 The is a general-purpose buffer amplifier that offers high dynamic range in a low-cost surface-mount package. At 900 MHz, the AG602-89 typically provides dB of gain, +33 dBm OIP3, and +18.5.
PMA-5453+ : Ultra Low Noise MMIC Amp 0.05 To 6 GHz; 3V, 60mA Ultra Low Noise MMIC Amp 0.05 to 6 GHz; 3V, 60mA.