Details, datasheet, quote on part number: SW10-0312
PartSW10-0312
CategoryRF & Microwaves => Switches
DescriptionDC-3 Ghz, GAAS SPDT Reflective Switch
CompanyM/A-COM, Inc.
DatasheetDownload SW10-0312 datasheet
Quote
Find where to buy
 
  

 

Features, Applications
GaAs SPDT Reflective Switch, - 3 GHz with TTL/CMOS Control Input
Features

n Integral TTL Driver n Low DC Power Consumption n Surface Mount Package n Low Cost/High Performance n 50 Ohm Nominal Impedance

Description

M/A-COM's is a GaAs FET SPDT reflective switch with integral silicon ASIC driver. Packaged a 16-lead ceramic surface mount package, this device offers excellent performance and repeatability from to 3 GHz while maintaining low power consumption. The SW10-0312 is ideally suited for use where fast speed, low power consumption and broadband applications are required.

Parameter Insertion Loss Test Conditions Frequency - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz 0.05 GHz 0.5 GHz to 3 GHz 0.05 GHz 0.5 GHz to 3 GHz 0.05 GHz 0.5 GHz to 3 GHz Units dB Ratio ns mV dBm A Min Typ Max

Trise, Tfall Ton, Toff Transients 1 dB Compression IP2 IP3 Vin Low Vin High

90% 1.3V CTL / 10% In-Band Input Power Two-Tone Input Power to +5 dBm Two-Tone Input Power to +5 dBm to 5.0V

1. All specifications apply when operated with bias voltages of +5V for Vcc and 5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.

GaAs SPDT Reflective Switch, - 3 GHz with TTL/CMOS Control Input Electrical Specifications: = +25C

Parameter Max Input Power 50 MHz - 2000 MHz Supply Voltages Vcc Vee Control Voltage 4 Operating Temperature Storage Temperature Absolute Maximum +27 dBm +34 dBm -0.5V, to Vcc +150C LO HIGH

3. Operation of this device above any one of these parameters may cause permanent damage. 4. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.

Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020

Visit www.macom.com for additional data sheets and product information.
GaAs SPDT Reflective Switch, - 3 GHz with TTL/CMOS Control Input Typical Performance Curves

Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020


 

Some Part number from the same manufacture M/A-COM, Inc.
SW10-0313 DC-3 Ghz, Matched GAAS SPDT Reflective Switch
SW15-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch
SW65-0003 DC-2500 Mhz, GAAS SP8T Reflective Switch
SW65-0014 DC-3 Ghz, GAAS SPST Absorptive Switch With Asic Driver
SW65-0114 DC-3 Ghz, GAAS SPDT Absorptive Switch With Asic Driver
SW65-0214 DC-3 Ghz, GAAS SP3T Absorptive Switch With Asic Driver
SW65-0313 DC-3 Ghz, GAAS SP2T Absorptive Switch With Asic Driver
SW65-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch With Asic Driver
SW65-0440
SW90-0001 DC-4 Ghz, GAAS SPST Switch, Absorptive, Single Supply
SW90-0002 DC-4 Ghz, GAAS SPDT Switch, Absorptive, Single Supply
SW90-0003 DC-4 Ghz, GAAS SP4T Switch, Absorptive, Single Supply
SW90-0004 DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply
SW90-0004A  GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ
SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply
SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-119
SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator
Same catergory

854658 : = Filter - STD Low-loss ;; Frequency (MHz) = 70 ;; Bandwidth (MHz) = 4.0 ;; Insertion Loss (dB) = 7.5 Max ;; Modes of Operation = se ;; Package (mm) = 13.3 X 6.5.

856020 : = Filter - STD 140 High-selectivity ;; Frequency (MHz) = 140 ;; Bandwidth (MHz) = 64 ;; Insertion Loss (dB) = 20.0 Max ;; Modes of Operation = se ;; Package (mm) = 9.0 X 7.0.

AA038N3-00 : 37 40 GHZ GAAS Mmic Low Noise Amplifier. Single Bias Supply Operation 3.5 dB Typical Noise Figure at 38 GHz 13 dB Typical Small Signal Gain 0.25 m Ti/Pd/Au Gates 100% On-Wafer RF, DC and Noise Figure Testing 100% Visual Inspection MT 2010 Skyworks' three-stage reactively-matched 3740 GHz MMIC low noise amplifier has typical small signal gain 13 dB with a typical noise figure at 38 GHz. The chip.

AT001D4-25 : Digital Attenuator. GAAS ic 4 Bit Digital Attenuator. s Designed for Cellular Radio Applications s Low Cost Plastic Package s For Extended Frequency Performance to 2 GHz Use the AD320-25 s Low DC Power Consumption The an IC FET digital attenuator consisting of four monolithic attenuators with LSB 2 dB and a total attenuation 30 dB with all attenuators connected. The attenuator is packaged in the plastic.

BX9333 : Frequency (MHz) = 5 - 1000 ;; Gain (Typ/Min) (dB) = 11.5 / 10 ;; Noise Figure (Typ/Max) (dB) = 5 / 6.5 ;; P1dB Comp Point (Typ/Min) (dBm) = +16 / +14 ;; 3rd Order Intercept (Typ) (dBm) = +30 ;; 2nd Order Intercept (Typ) (dBm) = +44 ;; DC Power (Typ) (V/mA) = +15 / +48 ;; Package = Package = Package = 4 Pin TO-8 Package = Surface Mount Package = Flatpack.

D2014UK : Purchase Online = ;; Package = SOT171 ;; Impedance Calculator = ;; Operating Voltage (V) = 28 ;; Power Output (W) = 2.5 ;; Minimum Efficiency = 40 ;; Gain = 13 ;; Test Frequency (MHz) = 500 ;; Configuration = Single-ended ;; Application Range = 1-1000MHz ;; Active Fet Configuration = 1 ;; BVDSS (V) = 65.

JH-141 :  High-Frequency Quadrature Hybrid, 1-2 GHZ. Octave Bandwidth Low VSWR: 1.25:1 Typical Miniature Size: x 3/8" Flatpack Impedance: 50 Ohms Nominal Input Power: 25 Watts Max @ +25C, Derated to 1 Watt n MIL-STD-202 Screening Available 3 dB Hybrids are ideal for dividing a signal into two signals of equal amplitude and a constant or 180 phase differential and for Quadrature combining or performing.

MAR-8ASM : Amplifier. exact footprint substitute** MAR-8SM and MSA-0886 high gain, at 100 MHz, reduces component count high power output, +12.5 dBm typ. low noise improved stability protection against power supply transients patent pending Applications MODEL NO. FREQ. (MHz) GAIN, dB Typical @MHz MAXIMUM DYNAMIC POWER, dBm RANGE Output (1 dB Input Comp.) (no Typ. dmg.) NF dB Typ.

MRF21125 : Power. MRF21125, MRF21125S, MRF21125SR3 2170 Mhz, 125 W, 28 V Lateral N-channel RF Power MOSFETs.

TWH5017 : Frequency Range (MHz) = 10 - 3000 ;; Insertion Loss (Typ) (dB) = 1 ;; ISOlation (Typ) (dB) = 70 ;; Switching Speed (Typ) (ns) = 2000 ;; P1dB Comp Point (Typ) (dBm) = 25 ;; VSWR (Typ) = 1.2 ;; Termination = 50 Ohms ;; Driver = TTL.

HMC637 : 1 Watt Power Amplifier Chip, DC - 6 GHz The HMC637 is a GaAs MMIC PHEMT Distributed Power Amplifier die which operates between DC and 6 GHz. The amplifier provides 14 dB of gain, +41 dBm output IP3 and +29 dBm of output power at 1 dB gain compression while requiring 400 mA from a +12V supply. Gain flatness is excellent at 0.5 dB from DC to 6 GHz making.

RF5501 : 11B/G WLAN SP3T Switch The RF5501 is a front end solution for high-performance WLAN applications in the 2.4GHz to 2.5GHz ISM band. The RF5501 addresses the need for size reduction for a typical IEEE802.11b/g front end design and reduces the number of components outside of the core chipset. The RF5501 has an integrated SP3T Switch and a Low Noise Amplifier.

 
0-C     D-L     M-R     S-Z