|Category||RF & Microwaves => Switches|
|Description||DC-3 Ghz, Matched GAAS SPDT Reflective Switch|
|Datasheet||Download SW10-0313 datasheet
|Matched GaAs SPDT Switch, - 3 GHz with TTL/CMOS Control Input
n Integral TTL Driver n Low DC Power Consumption n Surface Mount Package n Low Cost/High Performance n 50 Ohm Nominal ImpedanceDescription
M/A-COM's is a GaAs FET SPDT absorptive switch with integral silicon ASIC driver. Packaged a 16-lead ceramic surface mount package, this device offers excellent performance and repeatability from to 3 GHz while maintaining low power consumption. The SW10-0313 is ideally suited for use where fast speed, low power consumption and broadband applications are required.
Parameter Insertion Loss Test Conditions Frequency - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz - 3000 MHz - 2000 MHz - 1000 MHz - 500 MHz 0.05 GHz 0.5 GHz to 3 GHz 0.05 GHz 0.5 GHz to 3 GHz 0.05 GHz 0.5 GHz to 3 GHz Units dB Ratio ns mV dBm µA Min Typ MaxTrise, Tfall Ton, Toff Transients 1 dB Compression IP2 IP3 Vin Low Vin High
90% 1.3V CTL / 10% In-Band Input Power Two-Tone Input Power to +5 dBm Two-Tone Input Power to +5 dBm to 5.0V
1. All specifications apply when operated with bias voltages of +5V for Vcc and 5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.Matched GaAs SPDT Switch, - 3 GHz with TTL/CMOS Control Input Electrical Specifications: = +25°C
Parameter Max Input Power 50 MHz - 2000 MHz Supply Voltages Vcc Vee Control Voltage 4 Operating Temperature Storage Temperature Absolute Maximum +27 dBm +34 dBm -0.5V, to Vcc +150°C LO HIGH
3. Operation of this device above any one of these parameters may cause permanent damage. 4. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.
Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020Visit www.macom.com for additional data sheets and product information.
Matched GaAs SPDT Switch, - 3 GHz with TTL/CMOS Control Input Typical Performance Curves
Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020
|Some Part number from the same manufacture M/A-COM, Inc.|
|SW15-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch|
|SW65-0003 DC-2500 Mhz, GAAS SP8T Reflective Switch|
|SW65-0014 DC-3 Ghz, GAAS SPST Absorptive Switch With Asic Driver|
|SW65-0114 DC-3 Ghz, GAAS SPDT Absorptive Switch With Asic Driver|
|SW65-0214 DC-3 Ghz, GAAS SP3T Absorptive Switch With Asic Driver|
|SW65-0313 DC-3 Ghz, GAAS SP2T Absorptive Switch With Asic Driver|
|SW65-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch With Asic Driver|
|SW90-0001 DC-4 Ghz, GAAS SPST Switch, Absorptive, Single Supply|
|SW90-0002 DC-4 Ghz, GAAS SPDT Switch, Absorptive, Single Supply|
|SW90-0003 DC-4 Ghz, GAAS SP4T Switch, Absorptive, Single Supply|
|SW90-0004 DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ|
|SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|T-1000 Two-Way Power Splitter/Combiner, 10 - 1000MHz|
1SV262 : VR (v) = 34 ;; Ir (nA) = 10 ;; CT(1) (pF) = 33 to 38 ;; CT(2) (pF) = 2.6 to 3 ;; CT(1)/CT(2) = 12 ;; .rs(Typ.) Ohms = 0.6 ;; Package = Usc ;; Application = VHF Tuning (CATV).
2SK1310 : VDSS (V) = 100 ;; Pc(tc = 25 C) (W) = 250 ;; Id (A) = 12 ;; Pout (W) .min = 190 ;; VDD (V) = 50 ;; .f (MHz) = 230 ;; Pin (W) = 10 ;; Applications = Tvvhf.
42020 : Power Dividers. = Power Dividers ;; Size LXWXH = 1.0 X 1.5 X 0.37" ;; Packaging = Aluminum Cased ;; Frequency MHZ = 2000-8000 ;; Power Handling Watts = 10.
AM-138 : LNAs. High Performance Amplifier, 25 DB Gain, 10 - 200 MHZ. +49 dBm Typical Midband Third Order Intercept +25 dBm Typical Midband 1 dB Compression 5.3 dB Typical Midband Noise Figure M/A-COM's is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges.
AM42-0007-DIE : VSAT Mmic Power Amplifier, 2W 14.0 - 14.5 GHZ.
JX510 : = Xinger Directional Couplers ;; Size LXWXH = 0.56 X 0.2 X 0.071" ;; Packaging = Surface Mount ;; Frequency MHZ = 2000-2300 ;; Power Handling Watts = 60.
LZY-1 : Amplifier. wide bandwidth, 0.5-1000 MHz instrument model, with built-in power supply,110/220V operation high power output, (at 3.5 dB compression) 2. NF above 400 MHz. At low frequency, NF Increases 16 dB Typ. Prices and s subject to change without notice. For Quality Control Procedures see Table of Contents, Section 0, see "Mini-Circuits Guarantees Quality" article.
M85 : Double-balanced Mixer. DOUBLE-BALANCED MIXER TO 18 GHz TO 18 GHz TO 1000 MHz LO DRIVE: +7 dBm (NOMINAL) DC COUPLED I-PORT WIDE BANDWIDTH SSB Conversion Loss & SSB Noise Figure (max.) to 14 GHz, to 15 GHz, to 1 GHz to 3 GHz, to 3 GHz, to 1 GHz to 18 GHz, to 18 GHz, to 1 GHz fI = Isolation (min.) to 18 GHz to 18 GHz to 18 GHz 1 dB Conversion Compression @ +7 dBm fL @ Input.
MSC82100 : General Purpose Linear Transistors. General Purpose Linear Applications RF & Microwave Transistors.
P124 : Power. Pout W = 4 ;; Freq MHZ = 850 ;; Gain DB = 10 ;; Theta JC = 10 ;; GM Mho = 0.4 ;; Idsat a = 4.6 ;; Ciss PF = 15 ;; CRSS PF = 2.4 ;; Coss PF = 16 ;; Die = 2 ;; Style = Single Ended ;; PKG = SO8.
RFP-250375-4Z50-2 : = Terminations ;; Size LXWXH = 0.25 X 0.375 X 0.04" ;; Packaging = Surface Mount ;; Frequency MHZ = 0-2000 ;; Power Handling Watts = 25.
ZL20200 : = Dual Band IS136/AMPS Transceiver ;; Package Type = MLP ;; No. Of Pins = 56.
HMC656 : WIDEBAND FIXED ATTENUATOR FAMILY, DC - 50 GHz The HMC650 / 651 / 652 / 653 / 654 / 655 / 656 / 657 / 658 are a line of wideband i xed value 50 Ohm matched attenuator chips which offer relative attenuation levels of 0, 2, 3, 4, 6, 10, 15 and 20 dB. These passive though- lines and attenuators are ideal for microstrip, hybrid, and multi-chip module applications.
PE43502 : 50-ohm, 5-bit RF Digital Attenuator The PE43502 is a HaRP?-enhanced, high linearity, 5-bit RF Digital Step Attenuator (DSA) covering a 15.5 dB attenuation range in 0.5 dB steps. This Peregrine 50? RF DSA provides both a serial and parallel CMOS control interface. It maintains high attenuation accuracy over frequency and temperature and exhibits very.
RF1604 : Broadband High Power SP4T Switch The RF1604 is a single-pole four-throw (SP4T) switch designed for general purpose switching applications which require very low insertion loss and high power handling capability with minimal DC power consumption. The excellent linearity performance achieved by the RF1604 make it ideal for use in multi-mode GSM/EDGE/WCDMA,.
SKY13369-365LF : 0.25–2.15 GHz 4x2 Switch Matrix With Tone/Voltage Detector The SKY13369-365LF is a four-input to two-output switch matrix intended for Direct Broadcast Satellite (DBS) switching and cable TV/modem applications. The SKY13369-365LF enables any of the four inputs to either of the two outputs. Switch states can be selected using tone and voltage signals.