|Category||RF & Microwaves => Switches|
|Description||DC-3 Ghz, GAAS SP4T Absorptive Switch|
|Datasheet||Download SW15-0314 datasheet
n Integral TTL Driver n Isolation: 50 dB Typ. At 1 GHz n Low DC Power Consumption n Surface Mount Package n Low Cost/High Performance n 50 Ohm Nominal ImpedanceDescription
M/A-COM's is a GaAs MMIC SP4T absorptive switch with an integral silicon ASIC driver. This device a 24-lead ceramic surface mount package. These switches exhibit excellent performance from to 3 GHz, with very low DC power dissipation. The SW15-0314 is ideally suited for wireless infrastructure applications. Available with enhanced performance as fully hermetic version. Environmentally screenable as SW-314.
Parameter Insertion Loss Test Conditions Frequency - 0.5 GHz - 1.0 GHz - 2.0 GHz - 3.0 GHz - 0.5 GHz - 1.0 GHz - 2.0 GHz - 3.0 GHz - 0.5 GHz - 1.0 GHz - 2.0 GHz - 3.0 GHz - 0.5 GHz - 1.0 GHz - 2.0 GHz - 3.0 GHz 0.05 GHz 0.5 GHz to 3 GHz Units dB Ratio ns mV dBm Min Typ MaxTrise, Tfall Ton, Toff Transients 1 dB Compression
1. All specifications apply when operated with bias voltages of +5V for Vcc and 5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.
Parameter IP2 3 Vcc Vee Icc Iee Test Conditions Two-Tone Input Power to +5 dBm Two-Tone Input Power to +5 dBm Vcc 5.5 V Vctl 0.8V, or Vcc 2.1V to Vcc Vee to -8.0V Frequency 0.05 GHz 0.5 GHz to 3 GHz 0.05 GHz 0.5 GHz to 3 GHz Units dBm V mA Min 4.5 -8.0 Typ MaxParameter Max Input Power 0.05 GHz - 3.0 GHz 4 Bias Voltages Vcc Vee Control Voltage
3. Operation of this device above any one of these parameters may cause permanent damage. 4. When the input power is applied to the terminated port, the absolute maximum is +30 dBm. 5. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.
TTL Control Inputs Condition of Switch RF Common to Each RF Port RF1 On Off RF2 Off On Off RF3 Off On Off RF4 Off On
Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020Visit www.macom.com for additional data sheets and product information.
GaAs SP4T Absorptive Switch, - 3 GHz Typical Performance Curves
Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020
|Some Part number from the same manufacture M/A-COM, Inc.|
|SW65-0003 DC-2500 Mhz, GAAS SP8T Reflective Switch|
|SW65-0014 DC-3 Ghz, GAAS SPST Absorptive Switch With Asic Driver|
|SW65-0114 DC-3 Ghz, GAAS SPDT Absorptive Switch With Asic Driver|
|SW65-0214 DC-3 Ghz, GAAS SP3T Absorptive Switch With Asic Driver|
|SW65-0313 DC-3 Ghz, GAAS SP2T Absorptive Switch With Asic Driver|
|SW65-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch With Asic Driver|
|SW90-0001 DC-4 Ghz, GAAS SPST Switch, Absorptive, Single Supply|
|SW90-0002 DC-4 Ghz, GAAS SPDT Switch, Absorptive, Single Supply|
|SW90-0003 DC-4 Ghz, GAAS SP4T Switch, Absorptive, Single Supply|
|SW90-0004 DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ|
|SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|T-1000 Two-Way Power Splitter/Combiner, 10 - 1000MHz|
|THV-50 Two-Way Power Splitter/Combiner, 2 - 200MHz|
1A1306-3 : = Xinger Hybrid Couplers ;; Size LXWXH = 0.56 X 0.35 X 0.076" ;; Packaging = Surface Mount ;; Frequency MHZ = 1800-2700 ;; Power Handling Watts = 60.
856187 : = Filter - Wireless Data ;; Frequency (MHz) = 374 ;; Bandwidth (MHz) = 17 ;; Insertion Loss (dB) = 5.0 Max ;; Modes of Operation = SE, Bal ;; Package (mm) = 3.8 X 3.8.
CV211-3 : . High dynamic range downconverter with integrated LO and IF amplifiers The is a dual-channel high-linearity downconverter designed to meet the demanding performance, functionality, and cost goals of current and next generation mobile infrastructure basestations. It provides high dynamic range performance in a low profile surface-mount leadless package.
DB-915-12W : Demo Boards->Power. 12W / 12V / 875-915 MHZ pa Using 1X PD55015S. N-CHANNEL ENHANCEMENT-MODE LATERAL MOSFETs EXCELLENT THERMAL STABILITY COMMON SOURCE CONFIGURATION POUT 12 W min. with 12 dB gain over - 915 MHz 10:1 LOAD VSWR CAPABILITY BeO FREE AMPLIFIER. The is a common source N-Channel enhancement-mode lateral Field-Effect RF power amplifier designed as booster for GSM-R applications. The DB-915-12W is designed.
HMC306MS10 : GaAs. 5- Bit Digital Attenuator 0.7- 4 GHZ. 0.5 dB LSB Steps 15.5 dB Single Positive Control Per Bit 0.3 dB Typical Bit Error Miniature 15 mm2 Package: MSOP10 Typical Applications Cellular, PCS, & 3G ISM, MMDS Wireless Local Loop The is a broadband 5-bit positive control GaAs IC digital attenuator a 10 lead MSOP surface mount plastic package. Covering to 3.8 GHz, the insertion loss is typically.
LET21008 : Power. RF Power Transistors Ldmos Enhanced Technology in Plastic Package.
MA02305AK : LNAs. 3.0V 100mW RF Power Amplifier ic For Bluetooth. n Single 3.0V positive supply operates over a wide 1.75 mm body size Output power easily controllable via VDD1 45% Power Added Efficiency 100% Duty Cycle to 2900 MHz Operation Self-Aligned MSAG®-Lite MESFET Process The an RF power amplifier based on M/ACOM's Self-Aligned MSAG® MESFET Process. This product is designed for use in 2.4 GHz ISM products.
MF1193V-1.0 : SAW (Surface Acoustic Wave) Devices. This SAW filter for the receiving RF circuit of K-PCS mobile communication equipment operating at 1840 MHz ~ 1870 MHz. 1. SMD package insures small size, lightweight. 2. Adjustment free. 3. Low insertion loss. 4. Wide and sharp passband characteristics. 5. High stability and reliability. 6. Designed for reflow solderings APPLICATION Mobile Cellular.
MHW1353LA : MHW1353LA 5-150 Mhz, 35.2 DB, 10-Channel Catv Low Current Amplifier Module.
TGS8422 : Sp4t Fet Switch. DC to18 GHz Frequency Range 2.5 dB Insertion Loss at Midband 37 dB Isolation at Midband Typical Input Power of 19 dBm 1 dB Gain Compression Typical SWR 0.081x 0.006 in.) The TriQuint is a GaAs MMIC SP4T FET switch which operates from to 18 GHz. RF Output arm selection is made through 8 control lines. Control bias voltages are 0 V and -5 V. Typical insertion.
UPB1007K : 3V Dual Downconverter And PLL Frequency Synthesizer(537). INTEGRATED RF BLOCK: LNA, & IF Downconverter + PLL frequency synthesizer STATE OF THE ART 25 GHz fT UHS0 BIPOLAR PROCESS DOUBLE-CONVERSION: = 61.380 MHz = 4.092 MHz ADJUSTABLE GAIN: 20 dB range MIN FIXED DIVISION PRESCALER LOW POWER CONSUMPTION: 3 V SMALL 36 PIN QFN PACKAGE Flat lead style for better performance TAPE AND REEL PACKAGING AVAILABLE NEC's.
UPC8182TB : 3V, 2.9 GHZ Silicon Mmic Medium Output Power Amplifier For Mobile Communications(515).
ATR2820 : Low IF WDCT 5.8 GHz Transceiver.
SD2931-10 : Transistors, Radio Frequency RF power transistors HF/VHF/UHF N-channel MOSFETs.
LA6H0912-500 : LDMOS Avionics Radar Power Transistor 500 W LDMOS power transistor intended for avionics transmitter applications in the 960 MHz to 1215 MHz range such as Mode-S, TCAS, JTIDS, DME and TACAN. CAUTION This device is sensitive to ElectroStatic Discharge (ESD). Therefore care should be taken during transport and handling..
MAX2042 : SiGe High-Linearity, 2000MHz To 3000MHz Upconversion/Downconversion Mixer With LO Buffer The MAX2042 single, high-linearity upconversion/downconversion mixer provides +36dBm IIP3, 7.3dB noise figure, and 7.2dB conversion loss for 2000MHz to 3000MHz WCS, LTE, WiMAX™, and MMDS wireless infrastructure applications. With a wide LO frequency range of 1800MHz.