|Category||RF & Microwaves => Switches|
|Description||DC-3 Ghz, GAAS SPDT Absorptive Switch With Asic Driver|
|Datasheet||Download SW65-0114 datasheet
|GaAs SPDT Absorptive Switch with ASIC Driver, - 3.0 GHz
Typical Isolation: dB (2,000 MHz) Typical Insertion Loss: dB (2,000 MHz) Integral ASIC TTL/CMOS Driver Plastic, 50 mil Pitch, SOW-24 Lead, Wide Body Low DC Power Consumption 50 Ohm Nominal Impedance Tape and Reel Packaging Available Test Boards AvailableDescription
M/A-COM's is a GaAs MMIC absorptive SPDT switch with an integral silicon ASIC driver. This device a 24-lead plastic package. This switch offers excellent broadband performance and repeatability from to 3 GHz, while maintaining low DC power dissipation. The SW65-0114 is ideally suited for wireless infrastructure applications. Also available in ceramic package with improved performance.
Parameter Insertion Loss Isolation (All arms off) VSWR Trise Tfall Ton Toff Transients 1 dB Compression Input IP3 VCC VEE ICC IEE Logic "0" Logic "1" Test Conditions - 3.0 GHz - 3.0 GHz Units dB Min 33 On Typical 1.8 36 Off 2.1:1 Max 2.21. Decoupling capacitors (.01 µF) are required on the power supply lines.
GaAs SPDT Absorptive Switch with ASIC Driver, - 3.0 GHz
Parameter Max. Input Power 0.05 GHz - 3.0 GHz Bias Voltages VEE VCC Control Voltage 4 Operating Temperature Storage Temperature Absolute Maximum +27 dBm +34 dBm -0.5V to VCC to +125°C
2. Operation of this device above any one of these parameters may cause permanent damage. 3. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. 4. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.
Part Number SW65-0114TR SW65-0114-TB Package Bulk Packaging Tape and Reel (1K Reel) Units Mounted on Test Board
Specifications subject to change without notice. n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020Visit www.macom.com for additional data sheets and product information.
|Related products with the same datasheet|
|Some Part number from the same manufacture M/A-COM, Inc.|
|SW65-0114-TB DC-3 Ghz, GAAS SPDT Absorptive Switch With Asic Driver|
|SW65-0214 DC-3 Ghz, GAAS SP3T Absorptive Switch With Asic Driver|
|SW65-0313 DC-3 Ghz, GAAS SP2T Absorptive Switch With Asic Driver|
|SW65-0314 DC-3 Ghz, GAAS SP4T Absorptive Switch With Asic Driver|
|SW90-0001 DC-4 Ghz, GAAS SPST Switch, Absorptive, Single Supply|
|SW90-0002 DC-4 Ghz, GAAS SPDT Switch, Absorptive, Single Supply|
|SW90-0003 DC-4 Ghz, GAAS SP4T Switch, Absorptive, Single Supply|
|SW90-0004 DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ|
|SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply|
|SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators|
|SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator|
|T-1000 Two-Way Power Splitter/Combiner, 10 - 1000MHz|
|THV-50 Two-Way Power Splitter/Combiner, 2 - 200MHz|
|TP-101 RF Pulse Transformer, 500 KHZ - 1.5 GHZ|
|TP-102 RF Pulse Transformer, 1 - 500 MHZ|
1SV307 : VR (v) = 30 ;; Ir (µA) = 0.1 ;; VF(v) = 1 ;; CT(pF) = 0.5 ;; .rs(Typ.) Ohms = 1 ;; Package = Usc ;; Application = SingleSW, Att.
BX6191 : Frequency (MHz) = 100 - 600 ;; Gain (Typ/Min) (dB) = 23.5 / 22 ;; Noise Figure (Typ/Max) (dB) = 2.5 / 4 ;; P1dB Comp Point (Typ/Min) (dBm) = +21.5 / +20 ;; 3rd Order Intercept (Typ) (dBm) = +36 ;; 2nd Order Intercept (Typ) (dBm) = +52 ;; DC Power (Typ) (V/mA) = +15 / +95 ;; Package = Package = Package = 4 Pin TO-8 Package = Surface Mount Package = Flatpack.
BX6559 : Frequency (MHz) = 5 - 500 ;; Gain (Typ/Min) (dB) = 11.5 / 10 ;; Noise Figure (Typ/Max) (dB) = 5.5 / 7 ;; P1dB Comp Point (Typ/Min) (dBm) = +22 / +20 ;; 3rd Order Intercept (Typ) (dBm) = +36 ;; 2nd Order Intercept (Typ) (dBm) = +46 ;; DC Power (Typ) (V/mA) = +15 / +88 ;; Package = Package = Package = 4 Pin TO-8 Package = Surface Mount Package = Flatpack.
D2219UK : Purchase Online = ;; Package = SO8 ;; Impedance Calculator = ;; Operating Voltage (V) = 12.5 ;; Power Output (W) = 2.5 ;; Minimum Efficiency = 40 ;; Gain = 10 ;; Test Frequency (MHz) = 1000 ;; Configuration = Single-ended ;; Application Range = 1-1000MHz ;; Active Fet Configuration = 1 ;; BVDSS (V) = 40.
FLM3135-4F : C-band Internally Matched Fets. High Output Power: = 36.5dBm (Typ.) High Gain: = 12.0dB (Typ.) High PAE: add = 38% (Typ.) Low = 25.5dBm Broad Band: ~ 3.5GHz Impedance Matched Zin/Zout = 50 Hermetically Sealed Package The is a power GaAs FET that is internally matched for standard communication bands to provide optimum power and gain a 50 ohm system. Fujitsu's stringent Quality Assurance.
FTSO5137 : NPN Small Signal General Purpose Amplifiers.
JDV2S14E : VR (v) = 10 ;; Ir (nA) = 3 ;; CT(1) (pF) = 44 to 49.5 ;; CT(2) (pF) = 19 to 26.5 ;; CT(1)/CT(2) = 2.15 TYP ;; .rs(Typ.) Ohms = 0.4 ;; Package = Esc ;; Application = Tcxo / Vco.
JEPS-12-10 : Power Splitter. Power Splitter. Aqueous washable Non-hermetic Denotes 75 Ohm model, for coax connector models 75 Ohm BNC connectors are standard. When only for M range given, applies to entire frequency range. At low range frequency band (fL to 10 fL), linearly derate maximum input power by 13 dB. General Quality Control Procedures, Environmental s, Hi-Rel and MIL are given in section.
MF1082V-2 : For PCS Mobile Telephone, TX. This SAW filter for the transmitting RF circuit of PCS mobile communication equipment operating at 1850 MHz ~ 1910 MHz. 1. SMD package insures small size, lightweight. 2. Adjustment free. 3. Low insertion loss and high stop band attenuation. 4. Wide and sharp passband characteristics. 5. High stability and reliability. 6. Designed for reflow solderings.
MGCR01 : = Dual Band if Receiver For Tdma/amps And Cdma/amps ;; Package Type = Qsop ;; No. Of Pins = 28.
PA1133 : LNAs. 1850-1910 Mhz, 160 W, Linear Power Amplifier.
SD2904 : Power. RF Power Transistors Hf/vhf/uhf N-channel MOSFETs. GOLD METALLIZATION COMMON SOURCE CONFIGURATION - 500 MHz 30 WATTS 28 VOLTS 9.5 dB MIN. AT 400 MHz CLASS OR AB OPERATION EXCELLENT THERMAL STABILITY M113 epoxy sealed ORDER CODE BRANDING SD2904 The is a gold metallized N-Channel MOS field-effect RF power transistor. It is intended for use V DC large signal applications to 500 MHz 1. Drain 2. Source ABSOLUTE.
TMJ9911 : Analog Level Detectors. Frequency Range = 10-2000 MHZ ;; Detected Voltage Typical = -120 MV ;; Input Flatness Typical = 0.7 DBM ;; Tangential Sensitivity (1 MHZ Bandwidth) Typ/max = -32/-30 DBM ;; Max. VSWR In/out = 1.5:1 ;; Power Typical = +15 V/16 ma.
ADL5541 : 50 MHz to 6 GHz RF/IF Gain Blocks The ADL5541 is a broadband 15 dB linear amplifier that operates at frequencies up to 6 GHz. The device can be used in a wide variety of wired and wireless devices including cellular, GSM and WCDMA, and broadband applications. The ADL5541 provides a gain of 15 dB, which is stable over frequency, temperature, power supply,.
HMC619 : GaAs PHEMT MMIC POWER AMPLIFIER, DC - 10 GHz The HMC619 is a GaAs MMIC PHEMT Distributed Power Amplii er die which operates between DC and 1 0 G H z . T h e a m p l i i e r p r o v i d e s 1 2 d B o f g a i n , +37 dBm output IP3 and +28 dBm of output power at 1 dB gain compression while requiring 300 mA from a +12V supply. Gain l atness is excellent.
SKY14151-350LF : High-Power Single Pole Four Throw (SP4T) Switch With Decoder The SKY14151 is a symmetrical single pole four throw (SP4T) switch designed for broad band, high power switching applications which demand high linearity and low insertion loss. The switch is manufactured using the Skyworks state of the art pHEMT process. This is a general purpose switch that.