Details, datasheet, quote on part number: SW90-0002TR
PartSW90-0002TR
CategoryRF & Microwaves => Switches
DescriptionDC-4 Ghz, GAAS SPDT Switch, Absorptive, Single Supply
CompanyM/A-COM, Inc.
DatasheetDownload SW90-0002TR datasheet
Quote
Find where to buy
 
  

 

Features, Applications
GaAs SPDT Switch, Absorptive, Single Supply, - 4 GHz
Features

Operates - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 6 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel are Available

Description

M/A-COM's is a SPDT absorptive pHEMT switch with integral TTL driver. This device in an MLP plastic surface mount package. This switch offers excellent broadband performance and repeatability from to 4 GHz, while maintaining low DC power dissipation. The SW90-0002 is ideally suited for wireless infrastructure applications.

Parameter Insertion Loss Isolation VSWR 1 dB Compression Input IP3 Switching Speed Test Conditions RFC--RF1,RF2 (Logic per truth table) RF1--RF2 (All Logic (RFC,RF1, RF2) (Logic per truth table) Off (RF1, RF2) (Logic per truth table) Two-tone inputs to +5 dBm Ton (50% Control to 10% RF) Toff (50% Control to 90% RF) Trise to 90% RF) Tfall to 10% RF) Vcc Logic "0" Logic "1" Icc

Sink Current 20 A max. Source Current 20 A max. Vcc min to max, Logic or "1" For guaranteed start-up Generated from DC-DC Converter with recommended capacitors

1. During turn-on, the device requires an initial start up current (Icc) specified as "Turn-on Current". Once operational, Icc will drop to the specified levels. 2. The DC-DC converter is guaranteed to start s as long as the power supplies have the maximum turn-on current available for start-up.

GaAs SPDT Switch, Absorptive, Single Supply, - 4 GHz Pin Configuration 3,4,5

Parameter Max. Input Power 0.05 GHz - 4.0 GHz Bias Voltages VCC Control Voltage 8 Operating Temperature Storage Temperature Absolute Maximum +27 dBm +34 dBm -0.5V to VCC to +125C

6. Operation of this device above any one of these parameters may cause permanent damage. 7. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. 8. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.

= No Connection 4. VEE is internally generated and must remain isolated from external power supplies. Generated noise is typical of switching DC-DC Converters. 5. Connections and external components shown in functional schematic are required. 0.1 F Capacitors need to be located near pins & 26.

Control Input Condition of the Switch RF Common to each RF Port C1 TTL Low RF1 Off "1" = TTL High RF2 On Off 9. Application Note C2083 is available on line at www.macom.com

M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information.

GaAs SPDT Switch, Absorptive, Single Supply, - 4 GHz Functional Schematic

10.Dual Supply Operation will eliminate the start-up current mentioned in Note 1. It will also eliminate spurious signals caused by the DC-DC converter that are present in single supply operation.



 

Related products with the same datasheet
SW90-0002-TB
Some Part number from the same manufacture M/A-COM, Inc.
SW90-0003 DC-4 Ghz, GAAS SP4T Switch, Absorptive, Single Supply
SW90-0004 DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply
SW90-0004A  GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ
SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply
SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-119
SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator
T-1000  Two-Way Power Splitter/Combiner, 10 - 1000MHz
THV-50  Two-Way Power Splitter/Combiner, 2 - 200MHz
TP-101  RF Pulse Transformer, 500 KHZ - 1.5 GHZ
TP-102  RF Pulse Transformer, 1 - 500 MHZ
TP-103  RF Pulse Transformer, 500 KHZ - 1 GHZ
TP-104  RF Pulse Transformer, 750 KHZ - 400 MHZ
TP-105  RF Pulse Transformer
TP-108  RF Transformer, 350 - 1125 MHZ
TP-75  50/75-Ohm Transformer
TP-75N 50/75-ohm Transformer 2 - 200 MHZ
TP-75SMA  50/75-Ohm Transformer
 
0-C     D-L     M-R     S-Z