Details, datasheet, quote on part number: SW90-0004ATR
PartSW90-0004ATR
CategoryRF & Microwaves => Switches
Description GaAs SP6T Switch, Absorptive, Single Supply, DC - 4 GHZ
CompanyM/A-COM, Inc.
DatasheetDownload SW90-0004ATR datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Features

Operates - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 7 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel are Available

Description

M/A-COM's a SP6T absorptive pHEMT switch with integral TTL driver. This device in an MLP plastic surface mount package. This switch offers excellent broadband performance and repeatability from to 4 GHz, while maintaining low DC power dissipation. The SW90-0004A is ideally suited for wireless infrastructure applications.

Parameter Insertion Loss Isolation VSWR Test Conditions RFC-RF1, On (RFC, RF1-RF6) Logic per Truth Table Off (RF1-RF6) Logic per Truth Table Two-tone inputs to +5 dBm Ton (50% Control to 10% RF) Toff (50% Control to 90% RF) Trise to 90% RF) Tfall to 10% RF) Vcc Logic "0" Logic "1" Icc

Sink Current 20 A max. Source Current 20 A max. Vcc min to max, Logic or "1" For guaranteed start-up Generated from DC-DC Converter with recommended capacitors

1. During turn-on, the device requires an initial start up current (Icc) specified as "Turn-on Current". Once operational, Icc will drop to the specified levels. This is not applicable to dual supply operation. 2. The DC-DC converter is guaranteed to start s as long as the power supplies have the maximum turn-on current available for start-up.

GaAs SP6T Switch, Absorptive, Single Supply, - 4 GHz Pin Configuration

Function GND NC GND RFC GND RF4 GND RF5 GND RF6 GND NC VEE Vcc NC Vcc 7. 8. Parameter Max. Input Power 0.05 GHz - 4.0 GHz Bias Voltages VCC Control Voltage 8 Operating Temperature Storage Temperature

Operation of this device above any one of these parameters may cause permanent damage. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.

= No Connection 4. For single supply operation VEE is internally generated and must remain isolated from external power supplies. Generated noise is typical of switching DC-DC Converters. 5. Connections and external components shown in functional schematic are required. 0.1F Capacitors need to be located near pins & 33.

M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information.

2 n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020

GaAs SP6T Switch, Absorptive, Single Supply, - 4 GHz Functional Schematic

3 n North America: Tel. 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020


 

Related products with the same datasheet
SW90-0004A-TB
Some Part number from the same manufacture M/A-COM, Inc.
SW90-0004TR DC-4 Ghz, GAAS SP6T Switch, Absorptive, Single Supply
SWD-109 Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-109PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-109RTR Single/quad Driver For GAAS Fet Switche And Attenuator
SWD-119
SWD-119PIN Single/quad Drivers For GAAS Fet Switches And Attenuators
SWD-119RTR Single/quad Driver For GAAS Fet Switche And Attenuator
T-1000  Two-Way Power Splitter/Combiner, 10 - 1000MHz
THV-50  Two-Way Power Splitter/Combiner, 2 - 200MHz
TP-101  RF Pulse Transformer, 500 KHZ - 1.5 GHZ
TP-102  RF Pulse Transformer, 1 - 500 MHZ
TP-103  RF Pulse Transformer, 500 KHZ - 1 GHZ
TP-104  RF Pulse Transformer, 750 KHZ - 400 MHZ
TP-105  RF Pulse Transformer
TP-108  RF Transformer, 350 - 1125 MHZ
TP-75  50/75-Ohm Transformer
TP-75N 50/75-ohm Transformer 2 - 200 MHZ
TP-75SMA  50/75-Ohm Transformer
TPX-75-4
TPX-75-4N 50/75-ohm Transformer 10 - 1500 MHZ
TU-50  Two-Way Power Splitter/Combiner, 2 - 200MHz
 
0-C     D-L     M-R     S-Z