Details, datasheet, quote on part number: TC664
PartTC664
CategorySensors => Temperature Sensors => Fan Controllers/Fan Fault Detectors
TitleFan Controllers/Fan Fault Detectors
DescriptionThe TC664 is a Single PWM Mode Fan Speed Controller With Fansense TM Technology For Use With Brush-less DC Motors
CompanyMicrochip Technology, Inc.
DatasheetDownload TC664 datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Features

Temperature Proportional Fan Speed for Reduced Acoustic Noise and Longer Fan Life FanSenseTM Protects against Fan Failure and Eliminates the Need for 3-wire Fans Over Temperature Detection (TC665) Efficient PWM Fan Drive Provides RPM Data 2-Wire SMBusTM-Compatible Interface Supports Any Fan Voltage Software Controlled Shutdown Mode for "Green" Systems Supports Low Cost NTC/PTC Thermistors Space Saving 10-Pin MSOP Package Temperature Range: to +85C

Description

The TC664/TC665 devices are PWM mode fan speed controllers with FanSense technology for use with brushless DC fans. These devices implement temperature proportional fan speed control which lowers acoustic fan noise and increases fan life. The voltage at VIN (Pin 1) represents temperature and is typically provided by an external thermistor or voltage output temperature sensor. The PWM output (VOUT) is adjusted between 30% and 100%, based on the voltage at VIN. The PWM duty cycle can also be programmed via SMBus to allow fan speed control without the need for an external thermistor. IN is not connected, the TC664/TC665 will start driving the fan at a default duty cycle of 39.33%. See Section 4.3, "Fan Startup", for more details). In normal fan operation, a pulse train is present at the SENSE pin (Pin 8). The TC664/TC665 use these pulses to calculate the fan revolutions per minute (RPM). The fan RPM data is used to detect a worn out, stalled, open or unconnected fan. An RPM level below the user-programmable threshold causes the TC665 to assert a logic low alert signal (FAULT). The default threshold value is 500 RPM. Also, if this condition occurs, FF (bit 0<0>) in the Status Register will also be set `1'. An over-temperature condition is indicated when the voltage at VIN exceeds 2.6 V (typical). The TC664/ TC665 devices indicate this by setting OTF(bit 5<X>) in the Status Register a '1'. The TC665 device also pulls the FAULT line low during an over-temperature condition. The TC664/TC665 devices are available a 10-Pin MSOP package and consume 150 A during operation. The devices can also enter a low-power shutdown mode (5 A, typ.) by setting the appropriate bit in the Configuration Register. The operating temperature range for these devices to +85C.

SMBusTM PWM Fan Speed Controllers With Fan Fault Detection
Applications

Personal Computers & Servers LCD Projectors Datacom & Telecom Equipment Fan Trays File Servers Workstations General Purpose Fan Speed Control

Name VIN CF SCLK SDA GND FAULT NC SENSE VOUT VDD Analog Input Analog Output Serial Clock Input Serial Data In/Out (Open Drain) Ground Digital (Open Drain) Output No Connection Analog Input Digital Output Power Supply Input Function

VDD..................................................................................6.5 V Input Voltages.................................... V to (VDD 0.3 V) Output Voltages................................. V to (VDD 0.3 V) Storage to +150C Ambient temp. with power to +125C Maximum Junction Temperature, TJ............................. 150C ESD protection on all pins.................................................. 4 kV *Notice: Stresses above those listed under "Maximum ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability.

Electrical Characteristics: Unless otherwise noted, all limits are specified for VDD V, -40C <TA < +85C. Parameters Supply Voltage Operating Supply Current Shutdown Mode Supply Current VOUT PWM Output VOUT Rise Time VOUT Fall Time Sink Current at VOUT Output Source Current at VOUT Output PWM Frequency VIN Input VIN Input Voltage for 100% PWM duty-cycle VC(MAX) - VC(MIN) VIN Input Resistance VIN Input Leakage Current SENSE Input SENSE Input Threshold Voltage with Respect to GND FAULT Output FAULT Output LOW Voltage FAULT Output Response Time Fan RPM-to-Digital Output Fan RPM ERROR 2-Wire Serial Bus Interface Logic Input High Logic Input Low Logic Output Low Input Capacitance SDA, SCLK I/O Leakage Current SDA Output Low Current VIH VIL VOL CIN ILEAK IOLSDA A mA VOL 0.6 V IOL 3 mA Note 1 Note RPM > 1600 VOL tFAULT 0.3 V sec IOL 2.5 mA VTHSENSE 120 mV IIN V C(MAX) VCRANGE V A VDD tR tF IOL IOH F sec mA Hz IOH = 5 mA, Note 1 IOL = 1 mA, Note 1 VOL 10% of VDD VOH 80% of VDD 1 F Sym VDD IDD IDDSHDN Min 3.0 Typ 150 5 Max 300 10 Units V A Pins 8, 9 Open Pins 8, 9 Open Conditions

Note 1: Not production tested, ensured by design, tested during characterization. 2: For 5.5 V, the limit for 2.2 V.


 

Related products with the same datasheet
TC664E
TC664EUN
TC664EUNTR
TC665
TC665E
TC665EUN
TC665EUNTR
Some Part number from the same manufacture Microchip Technology, Inc.
TC664E The TC664 is a Single PWM Mode Fan Speed Controller With Fansense TM Technology For Use With Brush-less DC Motors
TC670 The TC670 is an Integrated Fan Speed Sensor That Predicts And/or Detects Fan Failure, Preventing Thermal Damage to Systems With Cooling Fans
TC682
TC7106 The TC7106A And TC7107A 3-1/2 Digit Direct-display Drive Analog-to-digital Converters Allow Existing 7106/7107 Based Systems to be Upgraded
TC7109 The TC7109A is a 12-bit Plus Sign,cmos Low-power Analog-to-digital Converter (ADC)
TC7116 The TC7116A/TC7117A Are 3-1/2 Digit CMOS Analog-to-digital Converters (ADCs)containing All The Active Components Necessary to Construct a 0
TC7126 The TC7126A is a 3-1/2 Digit CMOS Analog-to-digital Converter (ADC)containing All The Active Components Necessary to Construct a 0
TC7129 4-1/2 Digit Analog-to-digital Converters With On-chip LCD Drivers<<<>>>the TC7129 is a 4-1/2 Digit Analog-to-digital Converter<<<>>>(ADC) That Directly Drives a Multiplexed Liquid Crystal<<<>>>display
TC7129 The TC7129 is a 4-1/2 Digit Analog-to-digital Converter (ADC)that Directly Drives a Multiplexed Liquid Crystal Display (LCD)
TC7129CKW 4-1/2 Digit Analog-to-digital Converters With On-chip LCD Drivers<<<>>>the TC7129 is a 4-1/2 Digit Analog-to-digital Converter<<<>>>(ADC) That Directly Drives a Multiplexed Liquid Crystal<<<>>>display
TC7129CKW The TC7129 is a 4-1/2 Digit Analog-to-digital Converter (ADC)that Directly Drives a Multiplexed Liquid Crystal Display (LCD)
TC7129CLP -
TC7129CLW 4-1/2 Digit Analog-to-digital Converters With On-chip LCD Drivers<<<>>>the TC7129 is a 4-1/2 Digit Analog-to-digital Converter<<<>>>(ADC) That Directly Drives a Multiplexed Liquid Crystal<<<>>>display
TC7129CLW The TC7129 is a 4-1/2 Digit Analog-to-digital Converter (ADC)that Directly Drives a Multiplexed Liquid Crystal Display (LCD)
TC7129CPL 4-1/2 Digit Analog-to-digital Converters With On-chip LCD Drivers<<<>>>the TC7129 is a 4-1/2 Digit Analog-to-digital Converter<<<>>>(ADC) That Directly Drives a Multiplexed Liquid Crystal<<<>>>display
TC7129CPL The TC7129 is a 4-1/2 Digit Analog-to-digital Converter (ADC)that Directly Drives a Multiplexed Liquid Crystal Display (LCD)
TC7135 The TC7135 4-1/2 Digit Analog-to-digital Converter (ADC) Offers 50 PPM (1 Part in 20,000)resolution With a Maximum Nonlinearity Error of 1 Count
TC7136 The TC7136 And TC7136A Are Low-power,3-1/2 Digit With Liquid Crystal Display (LCD)drivers With Analog-to-digital Converters
TC7136A
Same catergory

ADS7845E : Controllers. ti ADS7845, Touch Screen Controller. q 5-WIRE TOUCH SCREEN INTERFACE q RATIOMETRIC CONVERSION q SINGLE SUPPLY: TO 125kHz CONVERSION RATE q SERIAL INTERFACE q PROGRAMMABLE OR 12-BIT RESOLUTION q AUXILIARY ANALOG INPUTS q FULL POWER-DOWN CONTROL The a 12-bit sampling analog-to-digital converter (ADC) with a synchronous serial interface and low on-resistance switches for driving touch screens.

FM20 : Low-voltage Temp Sensor. Analog Output, -11.77mV/C Range, to 130C Accuracy, at 25C Supply Current, 9A typical Output Drive, 1A Self-heating < 0.021C Operating Voltage: to +6V As a precision CMOS temperature sensor, the FM20 is cost-effective for accurate low-power temperature monitoring applications. Output voltage versus temperature is extremely linear. With no load,.

ICX432DQF : Diagonal 6.67mm(Type 1/2.7) Frame Readout Ccdimage Sensor With a Square Pixel For Color Cameras.

K6R4008V1D-JTCI08/10 : 1mx4 Bit High Speed Static RAM ( 5.0v Operating ) . Operated at Commercial And Industrial Temperature Ranges..

KMI20 : Speed Sensors. Digital current output signal Digital offset compensation Extended air gap Zero speed capability Wide temperature range High tolerance to vibration EMC resistant Tolerant to positioning. The is a sensitive rotational speed sensor for the application with ferrous gear wheels(1). The sensor consists of a magnetoresistive sensor element, a driver IC in BIMOS.

MAX6653 : MAX6653, MAX6663, MAX6664 Temperature Monitors And PWM Fan Controllers.

MLX10801 : Driver Actuators. Power Led Driver. IC Power LED driver for automotive applications Power saving low side coil driver Electronic fuse General Minimum number of cheap external components Auto shut off in case of over temperature with internal or external temperature sensor Small package allows compact module design with minimised wire runs and short connections, what allows to achieve.

MW39962AE : BroadcastIndustrial use. Package = WDIP032-G-0750A. The type-2/3 2.2M-pixel frame interline transfer (FIT-CCD) solid state image sensor. This device uses photodiodes in the opto-electric conversion section and CCDs for signal read-out. The electronic shutter function allows for an exposure time 1/10 000 seconds. Further, it high sensitivity, low noise, broad dynamic range and low smear level. The device.

QT114-D : Single Channel Charge-transfer Touch & Proximity Sensor. Limit sensing of almost any fluid or powder 2-Tier level sensor Hi / Low limits with one probe Only one external part required a 5 capacitor Uses internal probes or external electrodes Active high or active low outputs Slosh filter averages response of moving fluids LED drive capable on both outputs 5V 20A single supply operation HeartBeatTM health.

TCD1304AP : CCD Linear Image Sensor.

QST104 : Touch Sensors Capacitive touch sensor device 4 keys with individual key state outputs or I2C interface.

ADIS16060 : ADIS16060 Wide Bandwidth Yaw Rate Gyroscope With SPI The ADIS16060 is a yaw rate gyroscope with an integrated serial peripheral interface (SPI). It an externally selectable bandwidth response and scalable dynamic range. The SPI port provides access to the rate sensor, an internal temperature sensor, and two external analog signals (using internal ADC).

MAX11359A : 16-Bit, Data-Acquisition System With ADC, DAC, UPIOs, RTC, Voltage Monitors, And Temp Sensor The MAX11359A smart data-acquisition system (DAS) is based on a 16-bit, sigma-delta analog-to-digital converter (ADC) and system-support functionality for a microprocessor (P)-based system. The device integrates an ADC, DAC, operational amplifiers, internal.

A1324 : Low Noise, Linear Hall Effect Sensor ICs With Analog Output New applications for linear output Hall-effect devices, such as displacement, angular position, and current measurement, require high accuracy in conjunction with small package size. The Allegro A1324, A1325, and A1326 linear Hall-effect sensor ICs are designed specifically to achieve both.

MMA2206EGR2 : Surface Mount Micromachined Accelerometer The MMA series of silicon capacitive, micromachined accelerometers feature signal conditioning, a 4-pole low pass filter and temperature compensation. Zero-g offset full scale span and filter cut-off are factory set and require no external devices. A full system self-test capability verifies system functionality..

26PCCFJ6D : Board Mount Pressure Sensors +/-15psi 10V WET-WET DIFF/Gage/Vac Gage. » » » Pressure / Force Sensors Pressure / Force Sensors A pressure sensor transducer generates an electronic signal as a function of the pressure imposed. Pressure sensors are used for control and monitoring in thousands of everyday applications. s: Manufacturer:.

MMS-1A-V2 0 : Proximity Sensors MicroMachined Sensor Raw die version. » » » Proximity Sensors Proximity Sensors A photoelectric sensor, or photoeye, is a device used to detect the distance, absence, or presence of an object by using a light transmitter (often infrared) and a photoelectric receiver. They are used extensively in industrial manufacturing.

30080 : Vibration & Tilt Sensors Say it Module. » » » Vibration & Tilt Sensors Vibration & Tilt SensorsA position sensor is any device that permits position measurement. It can either be an absolute position sensor or a relative one. Position sensors can be either linear or angular. Positioning Sensors are finding their way into more handheld,.

PPG501C1 : Industrial Temperature Sensors Resistance Temperature Detector, 500 ohm RTD Sensor. US Sensor Thin Film Platinum Resistance Temperature Detectors (RTDs) are highly accurate and reliable over a very wide temperature range. Platinum RTD sensors operate as low as 50C and as high as +500C which makes them especially suitable for applications in extreme.

 
0-C     D-L     M-R     S-Z