Details, datasheet, quote on part number: TC74A7-50VCT
CategoryAutomotive => Sensor Interface
DescriptionTiny Serial Digital Thermal Sensor
CompanyMicrochip Technology, Inc.
DatasheetDownload TC74A7-50VCT datasheet
Find where to buy


Features, Applications

Digital Temperature Sensing in SOT-23-5 Package Outputs Temperature an 8-Bit Digital Word Simple Serial Port Interface Solid-State Temperature Sensing: - 2C Accuracy from - 3C Accuracy from +125C 3.0 and 5.5V Operating Range Low Power: - 200A Operating - 5A Standby Mode

The is a serially accessible digital temperature sensor particularly suited for low cost and small formfactor applications. Temperature data is converted from the onboard thermal sensing element and made available an 8-bit digital word. Communication with the TC74 is accomplished via 2wire SMBus/I2CTM compatible serial port. This bus also can be used to implement multi-drop/multi-zone monitoring. The SHDN bit in the CONFIG register can be used to activate the low power Standby mode. Temperature resolution is 1C. Conversion rate is a nominal 8 samples/sec. Power consumption is only 200A typ, (5A Standby, typ). Small size, low installed cost, and ease of use make the TC74 an ideal choice for implementing thermal management in a variety of systems.


Thermal Protection for Hard Disk Drives and other PC Peripherals PC Card Devices for Notebook Computers Low Cost Thermostat Controls Power Supplies Thermistor Replacement

*Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions above those indicated in the operation sections of the specifications is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability.

Supply Voltage (V DD)............................................ +6V Voltage On Any Pin....... (GND 0.3V) to (VDD + 0.3V) Current On Any Pin.......................................... 50 mA Operating Temperature (TA)........................ See Below Storage Temperature (TSTG).............. to +150C

Electrical Characteristics: VDD or 5.0V (Note TA 125C, unless otherwise noted. Symbol Power Supply VPOR IDD IDD-STANDBY Power-on Reset Threshold Operating Current Standby Supply Current V A VDD Falling Edge or Rising Edge VDD = 5.5V Serial Port Inactive (Note 1) VDD = 3.3V Serial Port Inactive (Note 1) +25C <TA < 0C (Note 2) Parameter Min Typ. Max Unit Test Conditions

Temperature to Bits Converter TERR Temperature Accuracy TC74A x VDD x VDD 1 C

Conversion Rate Logic Input High Logic Input Low SDA Output Low Input Capacitance SDA, SCL I/O Leakage

Operating current is an average value integrated over multiple conversion cycles. Transient current may exceed this specification. Maximum ensured conversion time after Power-on Reset (POR to DATA_RDY) is 250 msec. Output current should be minimized for best temperature accuracy. Power dissipation within the TC74 will cause self-heating and temperature drift error. SDA and SCLK must be connected to VDD or GND. VDD = 3.3V for TC74X -3.3VCT. VDD = 5.0V for TC74X -5.0VCT. All part types of the TC74 will operate properly over the wider power supply range to 5.5V. Each part type is tested and specified for rated accuracy at its nominal supply voltage. As VDD varies from the nominal value, accuracy will degrade 1C/V of VDD change.


Related products with the same datasheet
Some Part number from the same manufacture Microchip Technology, Inc.
TC7650 The TC7650 CMOS Chopper-stabilized Operational Amplifier Practically Removes Offset Voltage Error Terms From System Error Calculations
TC7652 The TC7652 is a Lower Noise Version of The TC7650, Sacrificing Some Input Specifications (bias Current And Bandwidth)to Achieve a 10x Reduction in Noise
TC7660 The TC7660 is a Pin-compatible Replacement For The Industry Standard TC7660 Charge Pump Voltage Converter
TC7660EV Charge Pump Dc-to-dc Voltage Converter
TC7660H The TC7660H is a Pin-compatible,high Frequency Up-grade to The Industry Standard TC7660 Charge Pump Voltage Converter
TC7660IJA The TC7660 is a Pin-compatible Replacement For The Industry Standard TC7660 Charge Pump Voltage Converter
TC7660S The TC7660S is a Pin-compatible Upgrade to The Industry Standard TC7660 Charge Pump Voltage Converter
TC7662A The TC7662A is a Pin-compatible Upgrade to The Industry Standard TC7660 Charge Pump Voltage Converter
TC7662B The TC7662B is a Pin-compatible Upgrade to The Industry Standard TC7660 Charge Pump Voltage Converter
TC77 The TC77 is a Serially Accessible Digital Temperature Sensor Particularly Suited For Low Cost And Small Form-factor Applications
TC811 The TC811 is a Low Power, 3-1/2 Digit, LCD Display Analog-to-digital Converter
TC815 The TC815 is a 3 1/2 Digit Integrating Analog-to-digital Converter With Triplex LCD Display Drive And Automatic Ranging
TC818A The TC818A is an Integrating Analog-to-digital Converter (ADC)with a 3-1/2 Digit Numeric LCD Driver,automatic Ranging,and Single 9V Battery Operation
TC820 The TC820 is a 3-3/4 Digit,multi-measurement System Especially Suited For Use in Portable Instruments
TC826 in Many Applications a Graphical Display is Preferred Over a Digital Display
TC835 TC835CBU 64-Pin PQFP 0 °C to +70 °C TC835CKW 44-Pin PQFP 0 °C to +70 °C The TC835 is a Low-power,4-1/2 Digit (0
TC850 The TC850 is a Monolithic CMOS Analog-to-digital Converter (ADC)with Resolution of 15-bits Plus Sign
TC901 The TC901 is a Monolithic, Auto-zeroed Operational Amplifier
TC911A The TC911 CMOS Auto-zeroed Operational Amplifier is The First Complete Monolithic Chopper-stabilized Ampli-fier
TC911B Monolithic Auto-zeroed Operational Amplifers
TC911BCPA Monolithic Auto-zeroed Operational Amplifers, Maximum Offset Voltage 30uV
0-C     D-L     M-R     S-Z