Details, datasheet, quote on part number: NJM2734V
PartNJM2734V
CategoryAnalog & Mixed-Signal Processing => Amplifiers => Operational Amplifiers => General Purpose => Quad
DescriptionFull-Swing Input and Output type Quad Operational Amplifier
NJM2734 is single supply quad operational amplifier with full swing
input and output, operates from 1.8V.
Input and Output Full Swing provides wide dynamic range, is from
ground to power supply level. In addition to ground sensing
applications, NJM2734 enable to be applied to Hi-side sensing
applications.
The features are low noise and low operating voltage for battery
management, portable audio applications, and others.
■ FEATURES
●Operating Voltage :1.8 to 6.0V
●Input Full-Swing :VICM= 0 to 5.0V, at V+=5V
●Output Full-Swing :VOH≥4.9V/ VOL≤0.1V, at V+=5V, RL=20kΩ
●Load Drivability :VOH≥4.75V/ VOL≤0.25V, at V+=5V, RL=2kΩ
●Offset Voltage :5mV max.
●Slew Rate :0.4V/µs typ.
●Low Input Voltage Noise :10nV/√Hz typ.
●Adequate phase margin :ΦM=75deg. typ., at RL=2kΩ
●Bipolar Technology
●Package Outline :DIP14, DMP14, EMP14, SSOP14
CompanyNJR Corporation
DatasheetDownload NJM2734V datasheet
Cross ref.Similar parts: TSV324IPT, TS1854IPT, TSV324AIYPT, TSV324IYPT
Quote
Find where to buy
 
  

 

Features, Applications
Full-Swing Input and Output type Quad Operational Amplifier

GENERAL DESCRIPTION NJM2734 is single supply quad operational amplifier with full swing input and output, operates from 1.8V. Input and Output Full Swing provides wide dynamic range, is from ground to power supply level. In addition to ground sensing applications, NJM2734 enable to be applied to Hi-side sensing applications. The features are low noise and low operating voltage for battery management, portable audio applications, and others. PACKAGE OUTLINE

FEATURES Operating Voltage Input Full-Swing Output Full-Swing Load Drivability Offset Voltage Slew Rate Low Input Voltage Noise Adequate phase margin Bipolar Technology Package Outline

PIN FUNCTION 1. A OUTPUT 2. A -INPUT 3. A +INPUT 5. B +INPUT 6. B ­INPUT 7. B OUTPUT
8. C OUTPUT 9. C -INPUT 10. A +INPUT 11. GND 12. D +INPUT 13. D ­INPUT 14. D OUTPUT

PARAMETER Supply Voltage Differential Input Voltage Range Common Mode Input Voltage Range Power Dissipation Operating Temperature Range Storage Temperature Range SYMBOL + V VID VIC PD Topr Tstg RATINGS -40~+85 -40~+125 UNIT mW °C

(Note1) For supply voltage less than 7V, the absolute maximum input voltage is equal to the supply voltage. (Note2) On the PCB " EIA/JEDEC (76.2×114.3×1.6mm, two layers, FR-4) "

PARAMETER Supply Voltage SYMBOL + V RATING to 6.0 UNIT V

PARAMETER Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio Supply Voltage Rejection Ratio Maximum Output Voltage 1 Maximum Output Voltage 2 Input Common Mode Voltage Range (Note3) SYMBOL ICC VIO IB IIO AV CMR SVR VOH2 VOL2 VICM TEST CONDITION No signal applied MIN. TYP.

CMR is represented by either CMR+ or CMR- has lower value. CMR+ is measured with 2.5VVCM5.0 and CMR- is measured with 0VVCM2.5V.

PARAMETER Unity Gain Bandwidth Phase Margin Equivalent Input Noise Voltage Amp to Amp Separation SYMBOL GB M VNI CS TEST CONDITION 2.5V, Vo=1.2Vrms MIN. TYP. 75 10 TBD

PARAMETER Slew Rate SYMBOL SR TEST CONDITION to 2.5V MIN. TYP. 0.4

PARAMETER Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio Supply Voltage Rejection Ratio Maximum Output Voltage 1 Maximum Output Voltage 2 Input Common Mode Voltage Range (Note4) SYMBOL ICC VIO IB IIO AV CMR SVR VOH2 VOL2 VICM TEST CONDITION No signal applied MIN. TYP.

CMR is represented by either CMR+ or CMR-has lower value. CMR+ is measured with 1.5VVCM3.0 and CMR- is measured with 0VVCM1.5V.

PARAMETER Unity Gain Bandwidth Phase Margin Equivalent Input Noise Voltage Amp to Amp Separation SYMBOL GB M VNI CS TEST CONDITION 1.5V, Vo=0.7Vrms MIN. TYP. 75 10 TBD

PARAMETER Slew Rate SYMBOL SR TEST CONDITION to 1.5V MIN. TYP. 0.35

 

Related products with the same datasheet
NJM2734D
NJM2734M
Some Part number from the same manufacture NJR Corporation
NJW1156A Two channel electronic volume with 5 input selector.NJW1156A is a two channel electronic volume with 5input selector. It’s suitable for Input signal trimmer ofaudio equipments such as DVD / HDD recorder
NJM2567 Low Voltage Video Amplifier with Y/C MIX and Filter NJM2567 is a low voltage operating video amplifier included LPF,BPFIn Y and C system.Output with 75ohm driver optimize the TV monitor system.The
NJU7747 Low dropout voltage regulator with ON/OFF controlNJU7747/48 is a low dropout voltage regulator with ON/OFFcontrol.Advanced CMOS technology achieves ultra low quiescent current.SC-82AB package and 0.1µF
NJU7751 Low dropout voltage regulator with ON/OFF control and Output shunt switch.NJU7751/54 is a low dropout voltage regulator withON/OFF control and Output shunt switch.Advanced CMOS technology achieves
NJM2845 low dropout voltage regulator. Advanced Bipolar technology achieves low noise, high ripple rejection and low quiescent current.The NJM2845 is low dropout voltage regulator. AdvancedBipolar technology
NJU7380 Stepper Motor ControllerNJU7380 is a controller with transrator which convertfrom input step and direction pulse to driver's phase signalfor full and half step.NJU7380 translates from pulse input
NJM2626 PWM Type 3-Phase DC Brushless Motor ControlThe NJM2626 is a 3-phase DC brush less motor controlpre-driver IC with PWM control.It takes hall IC inputs and generates motor drivingwaveform.Output
NJU26902 Digital Audio DelayThe NJU26902 is a digital audio delay. The NJU26902 provides delay-timeadjustment function and digital audio interface.! FEATURES• 2-Channel Audio Delay (24 bits data width).Delay
NJU7757 Low dropout voltage regulator with ON/OFF control.NJU7757/58 is a low dropout voltage regulator with ON/OFFcontrol.Advanced CMOS technology achieves low quiescent current.SC-82AB package and 0.1uF
NJU7044 Input/Output Full-Swing High Output Current Quad C-MOS Operational AmplifierThe NJU7044 is a quad C-MOS operational amplifier permitting afull-swing input and output in full-swing under high load.Based
NJW4100 Lithium-ion Battery Charger Controller ICThe NJW4100 is a Lithium-ion Battery Charger ControllerIC with over charger timer.Charger current and voltage can individually be set by theexternal resistors.
NJU7630 PWM control Step-Down Switching regulator ICNJU7630 is a high speed low voltage operation switchingregulator control IC. It features a totem pole driver that can directlydrive an external MOS-FET.Internal
NJM2527 Color TFT Signal ProcessorThe NJM2527 is a color TFT signal processor.It contains all function, like as Y/C separator circuit, color signalde-modulator, synchronous separate circuit, RGB interface,
NJW1142A Audio processorThe NJW1142A is a sound processor includes all of thefunctions required to process the audio signal for TV, suchas tone control, balance, volume, mute, and AGC functions.Also the NJW1142A
NJW1146A Audio Processor with BBENJW1146A is an audio processor with BBE, which also includes Mastervolume, Balance, Tone Control, eala(NJRC surround), Mute, and Outputfilter amplifier. All of internal status
NJW1149A Audio Processor with Sound Enhancement and TruSurround 5.1ch VirtualizerThe NJW1149A is an audio processor with BBE sound enhancementand SRS Labs' TruSurround 5.1 channel virtualizer. It includes all offunctions
NJW1154 2-Channel Electronic Volume With Input SelectorNJW1154 is a two channel electronic volume with6 in 1 out selector IC. It’s suitable for Input signaltrimmer of audio equipments such as DVD recorderand
NJW1166 Audio Processor With Subwoofer OutputThe NJW1166 is a sound processor with subwooferoutput includes all of functions processing audio signal forTV, such as tone control, balance, volume, mute, and AGCfunctions.Also
NJW1176 Audio Processor With Subwoofer OutputThe NJW1176 is a sound processor with subwoofer outputincludes all of functions processing audio signal for TV, suchas tone control, balance, volume, mute, and AGC functions.Also
NJW1191 4-channel Electronic Volume with Input SelectorNJW1191 is 4-channel Electronic Volume with inputselector. It includes main volume, balance and fader trim, 4inputs selector, loudness and tone control.NJW1191
NJM2160B Dual Boost AmplifierThe NJM2160B is a dual boost amplifier designed for caraudio system. It expands the frequency characteristics byhigh slew rate.It can swing 14V peak-to-peak output voltage at 9V. Itconsists

NJM2891PB1 : 2ch Low Dropout Voltage Regulator

NJU6333CE : Quartz Crystal Oscillator Quartz Crystal Oscillator

NJU6392PC : Quartz Crystal Oscillator Quartz Crystal Oscillator

NJU7042 : Input/output Full-swing Tiny Single C-mos Operational Amplifier

NJU7709F15 : Voltage Detector With Delay Function

NJU7780 : Low Dropout Voltage Regulator With On/offthe NJU7780/81 is a Low Dropout Voltage Regulator With On/offcontrol.advanced CMOS Technology Achieves Low Quiescent Current.it is Suitable For Cellular Phone And Other Portable Items.when The On/off Control is Used, NJU7781 Has

NJW1144GK1 : Audio Processor

NJG1122 : W-CDMA DUAL LNA GaAs MMIC The NJG1122PB4 is a Dual band LNA IC designed for W-CDMA cellular phone of 2.1GHz and 800MHz band. This IC has a LNA pass-through function to select high gain mode or low gain mode. An ultra small and ultra thin package of FFP12–B4 is adopted. [FEATURES] · L

NJM2870F21-TE1 : Pmic - Voltage Regulator - Linear Integrated Circuit (ics); IC LDO REG LOW-VOLT 2.1V SOT23-5 Specifications: Lead Free Status: Contains Lead ; RoHS Status: RoHS Non-Compliant

NJM2855DL1-05-TE1 : Pmic - Voltage Regulator - Linear Integrated Circuit (ics); IC REG LDO 5.0V 1.3A TO-252-3 Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

NJM2856DL3-05-TE1 : Pmic - Voltage Regulator - Linear (ldo) Integrated Circuit (ics); IC REG LDO 5.0V 1.3A TO-252-5 Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

 
0-C     D-L     M-R     S-Z