Details, datasheet, quote on part number: MC3405
PartMC3405
CategoryAnalog & Mixed-Signal Processing => Amplifiers => Operational Amplifiers => General Purpose => Dual
DescriptionDual Operational Amplifier And Dual Comparator
CompanyON Semiconductor
DatasheetDownload MC3405 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The MC3405 contains two differential­input operational amplifiers and two comparators, each set capable of single supply operation. This operational amplifier­comparator circuit fulfills its applications as a general purpose product for automotive and consumer circuits as well as an industrial building block. The MC3405 is specified over the commercial operating temperature range to +70°C. Operational Amplifier Equivalent in Performance to MC3403

DUAL OPERATIONAL AMPLIFIER / DUAL VOLTAGE COMPARATOR

Comparator Similar in Performance to LM339 Single Supply Operation: 36 V Split Supply Operation: ±18 V Low Supply Current Drain Operational Amplifier is Internally Frequency Compensated Comparator TTL and CMOS Compatible

Rating Power Supply Voltage ­ Single Supply Power Supply Voltage ­ Split Supplies Input Differential Voltage Range Input Common Mode Voltage Range Operating Ambient Temperature Range Storage Temperature Range Operating Junction Temperature Range Symbol VCC VCC, VEE VIDR VICR TA Tstg TJ Value +125 150 Unit Vdc °C

ELECTRICAL CHARACTERISTICS (VCC 5.0 V, VEE = Gnd, = 25°C, unless otherwise noted.)

Characteristic Input Offset Voltage Input Offset Current Input Bias Current Large­Signal, Open Loop Voltage Gain (RL 2.0 k) Power Supply Rejection Output Voltage Range (Note 1) (RL 10 k, VCC 5.0 V) (RL 5.0 V VCC 30 V) Power Supply Current (Notes 2 and 3) Channel Separation, = 1.0 kHz to 20 kHz (Input Referenced) Symbol VIO IIO IIB AVOL PSR VOR 3.3 VCC ­ 2.0 ICC VCC mA dB Min Typ Max Unit mV nA V/mV µV/V Vpp

ELECTRICAL CHARACTERISTICS (VCC +15 V, VEE = 25°C, unless otherwise noted.)

Characteristic Input Offset Voltage (TA = Tlow + Thigh) (Note 4) Average Temperature Coefficient of Input Offset Voltage Input Offset Current (TA = Tlow to Thigh) (Note 4) Input Bias Current (TA = Tlow to Thigh) (Note 4) Input Common Mode Voltage Range Large Signal, Open Loop Voltage Gain (VO 2.0 k) (TA = Tlow to Thigh) (Note 4) Common Mode Rejection Power Supply Rejection Ratio Output Voltage (RL 10 k) (RL 2.0 k) (RL TA = Tlow to Thigh) (Note 4) Output Short Circuit Current Power Supply Current (Notes 2 and 3) Phase Margin Small­Signal Bandwidth (AV = 50 mV)

NOTES: 1. Output will swing to ground. 2. Not to exceed maximum package power dissipation. 3. For operational amplifier and comparator. 4. Tlow = 0°C, Thigh = +70°C

ELECTRICAL CHARACTERISTICS (VCC +15 V, VEE = 25°C, unless otherwise noted.)

Characteristic Power Bandwidth (AV = 20 Vpp, THD = 5%) Rise Time/Fall Time Overshoot (AV = 50 mV) Slew Rate Symbol BWp tTLH, tTHL os SR Min Typ Max Unit kHz µs % V/µs

Rating Power Supply Voltage ­ Single Supply Power Supply Voltage ­ Split Supplies Input Differential Voltage Range Input Common Mode Voltage Range Sink Current Operating Ambient Temperature Range Storage Temperature Range Operating Junction Temperature Range Symbol VCC VCC, VEE VIDR VICR ISink TA Tstg TJ Value +125 150 Unit Vdc mA °C

ELECTRICAL CHARACTERISTICS (VCC 5.0 V, VEE = Gnd, = 25°C, unless otherwise noted.)

Characteristic Input Offset Voltage (TA = Tlow to Thigh) (Notes 1 and 2) Average Temperature Coefficient of Input Offset Voltage Input Offset Current (TA = Tlow to Thigh) (Note 1) Input Bias Current (TA = Tlow to Thigh) (Note 1) Input Common Mode Voltage Range (TA = Tlow to Thigh) (Note 1) Input Differential Voltage (All Vin 0 Vdc) Large­Signal, Open Loop Voltage Gain (RL 15 k) Output Sink Current (­Vin 1.0 Vdc, +Vin= 1.5 V) Low Level Output Voltage (+Vin= 0 V, ­Vin= 1.0 V, ISink = 4.0 mA) (TA = Tlow to Thigh) (Note 1) Output Leakage Current (+Vin 1.0 Vdc, ­Vin= = 5.0 Vdc) (TA = Tlow to Thigh) (Note 1) Large­Signal Response Time (Note 3) (VRL = 5.0 Vdc, 5.1 k) Symbol VIO VIO/T IIO IIB VICR VID AVOL ISink VOL ­ IOL µs µA Min Typ VCC ­1.5 VCC Max VCC ­1.7 VCC Unit mV µV/°C nA Vpp V V/mV mA µA

NOTES: 1. Tlow = 0°C, Thigh = 0 with VCC from 5.0 Vdc to 30 Vdc, and over the input common mode range 0 to VCC V. 3. The response time specified is for 100 mV input step with 5.0 mV overdrive. For larger signals ns is typical.


 

Related products with the same datasheet
MC3405P
Some Part number from the same manufacture ON Semiconductor
MC3405P Dual Operational Amplifier And Dual Comparator
MC34060A Precision Switchmode Pulse Width Modulator Control Circuit
MC34060AD Up-to-200kHz Multi-topology PWM Voltage-mode Controller, Package: Soic, Pins=14
MC34060AP Fixed Frequency, Pwm, Voltage Mode Single Ended Controller , Package: Pdip, Pins=14
MC34063A Dc-to-dc Converter Control Circuit
MC34063AD Up-to-100kHz Multi-topology Burst-mode Voltage-mode Controller With 40V / 1.5A Switch, Package: Soic, Pins=8
MC34063AP1 1.5A, Step-up/down/inverting Switching Regulator , Package: Pdip, Pins=8
MC34063AP2 -
MC34063BD Up-to-100kHz Multi-topology Burst-mode Voltage-mode Controller With 40V / 1.5A Switch, Package: Soic, Pins=8
MC34064 Undervoltage Sensing Circuit
MC34064D-005 4.59V Voltage Detector With Active Low Open Collector Output For 5V Systems, Package: Soic, Pins=8
MC34064P-005 Undervoltage Sensing Circuit , Package: TO-92 (TO-226), Pins=3
MC34064P-5RP 4.59V Voltage Detector With Active Low Open Collector Output For 5V Systems, Package: Soic, Pins=8
MC34064SN-5T1 Undervoltage Sensing Circuit , Package: TO-92 (TO-226), Pins=3
MC34065 High Performance Dual Channel Current Mode Controller
MC34065-H High Performance Dual Channel Current Mode Controllers
MC34065DW High Performance Dual Channel Current Mode Controller
MC34065DW-H High Performance Dual Channel Current Mode Controllers , Package: Soic, Pins=16
MC34065DW-L Up-to-500kHz Dual Flyback PWM Current-mode Controller With Lower Under-voltage Lockout, Package: Soic, Pins=16
MC34065DWH High Performance Dual Channel Current Mode Controllers
MC34065P High Performance Dual Channel Current Mode Controller
Same catergory

5962-9469204Q2A : ti TLC2264A, Advanced LinCMOS(TM) Rail-to-rail Quad Operational Amplifier.

AN6152 : Speech Network Circuit. The is an integrated circuit designed for telephone speech network. It has the basic function which is necessary to apply a sound signal onto the line and excellent in branch performance. Wide operating voltage range to 11.5V Built-in amplifiers for "Dial Tone" and "DTMF" Amplifier Each amplifier gain automaticaly changeable depending on line current.

CAT5419 : 64-Tap Dual Dpp, 2-wire Interface With 2-wire Interface And. Dual Digitally Programmable Potentiometers (DPPTM) with 64 Taps and 2-wire Interface s 64 resistor taps per potentiometer s End to end resistance 100k s Potentiometer control and memory access via to 6.0 volt operation s Standby current less than s 1,000,000 nonvolatile WRITE cycles s 100 year nonvolatile memory data retention s 24-lead SOIC, 24-lead.

LTC2054 : Single/dual Micropower Zero-drift Operational Amplifierslow Power, Low Noise Single/ Dual Zero-drift Operational Amplifiers Available in The SOT-23 (ThinSOT ) And MS8 Packages. For Space Limited Applications, The LTC2055 is Also Available in a 3mm X 3mm X 0.8mm Dual Fine Pitch Leadless Package (DFN). They Operate From a Single 2.7V Minimum Supply And Support.

MAX4503 : Low-Voltage, Dual-Supply, Spst, CMOS Analog Switches. Low-Voltage, Dual-Supply, SPST, CMOS Analog Switches The MAX4503/MAX4504 are low-voltage, dual-supply, single-pole/single-throw (SPST), CMOS analog switches. The MAX4503 is normally open (NO). The MAX4504 is normally closed (NC). These CMOS switches can operate continuously with dual supplies between ±1.V and ±6V. Each switch can handle rail-to-rail.

MAX4561 : 15kV ESD-Protected, Low-Voltage, SPDT/SPST, CMOS Analog Switches. ±15kV ESD-Protected, Low-Voltage, SPDT/SPST, CMOS Analog Switches The MAX4561/MAX4568/MAX4569 are low-voltage, ESD-protected analog switches. The normally open (NO) and normally closed (NC) inputs are protected against ±15kV electrostatic discharge (ESD) without latchup or damage, and the COM input is protected against 2.5kV ESD. These switches operate.

MSK103 : Ultra High Voltage Dual Operational Amplifier. ULTRA HIGH VOLTAGE DUAL OPERATIONAL AMPLIFIER Low Cost Dual Amplifier Monolithic MOS Technology High Voltage Operation : 350V Low Quiescent Current : 2mA Max Per Amplifier High Output Current: 60mA Minimum Per Amplifier No Secondary Breakdown High Speed : 40V/µS Typ MSK103 The MSK is an ultra high voltage monolithic MOSFET operational amplifier ideally.

OP07CCSA : Low Offset Voltage Operational Amplifier.

OPA237NA/250 : ti OPA237, Single-supply Operational Amplifiers MicroAmplifier(TM) Series.

P103 : Power. Power Supply.

TA7358P : FM Front-end.

TD62783 : 8ch Darlington Sink Driver.

TDA8779 : 10-bit Converter Interface (adc/dac) For Quadrature Transceiver. Product Supersedes data of 1999 Jan 18 File under Integrated Circuits, IC02 1999 Sep 16 Two 10-bit ADCs with multiplexed outputs Two 10-bit DACs with multiplexed inputs Sampling rate for the ADCs and DACs to 20 MHz Digital outputs (for the ADC) and inputs (for the DAC) are TTL/CMOS compatible Internal reference voltage regulator Power dissipation 520 mW Standby.

AD8271 : Programmable Gain Precision Difference Amplifier The AD8271 is a low distortion, precision difference amplifier with internal gain setting resistors. With no external components, it can be configured as a high performance difference amplifier with gains of ˝, 1, or 2. It can also be configured in over 40 single-ended configurations, with gains ranging.

 
0-C     D-L     M-R     S-Z