Details, datasheet, quote on part number: PI5C16210K
PartPI5C16210K
CategoryInterface and Interconnect => Mux/Demux/Switch Digital Bus
TitleBus Oriented Circuits
Description20-Bit Bus Switch
CompanyPericom Semiconductor Corporation
DatasheetDownload PI5C16210K datasheet
Cross ref.Similar parts: QS32X861Q1G8, SN74CBT16210DGVR, SN74CBT16210CDGVR, SN74CBT16244, SN74CBT16244C, SN74CBT16245, SN74CBT16245C, SN74CBT16861, SN74CBTD16210
Quote
Find where to buy
 
  

 

Features, Applications

Near-zero propagation delay 5 Ohm switches connect inputs to outputs Direct bus connection when switches are ON 32X384 function with flow through pinout make board layout easier Ultra-low quiescent power (0.5W typical) ideally suited for notebook applications Industrial operating temperature: to +85C Packages available: 48-pin 150-mil wide plastic BQSOP (B) 48-pin 173-mil wide plastic TVSOP (K) 48-pin 240-mil wide plastic TSSOP (A) 48-pin 300-mil wide plastic SSOP (V)

Pericom Semiconductor's PI5C series of BusSwitch circuits are produced in the Company's advanced sub-micron CMOS technology, achieving industry leading speed. The PI5C16210 is configured 20-bit, 2-port bus switches designed with a low ON resistance (5 Ohm) allowing inputs to be connected directly to outputs. The bus switch creates no additional propagational delay or additional ground bounce noise. The switches are turned ON by the Bus Enable (xOE) input signal.

Pin Name - 2B10 Description Bus Enable Inputs (Active LOW) Bus A Bus B
Note: H = High Voltage Level L = Low Voltage Level Hi-Z = High Impedance

(Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature.................................................................. to +150C Ambient Temperature with Power Applied................................. to +85C Supply Voltage to Ground Potential (Inputs & Vcc Only)........... to +7.0V Supply Voltage to Ground Potential (Outputs & D/O Only)....... +7.0V DC Input Voltage......................................................................... +7.0V DC Output Current................................................................................... 120 mA Power Dissipation......................................................................................... 0.5W Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Parameters Description VIH VIL II Input HIGH Voltage Input LOW Voltage Input Current Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic LOW Level VCC = 5.5V., VIN 5.5V OR GND VCC = 0V, VIN = VCC IOZH VIK V IOS VH RON High Impedance Output Current Clamp Diode Voltage Short Circuit Current(3) Input Hysteresis at Control Pins Switch On Resistance

Parameters(5) CIN COFF Description Input Capacitance A/B Capacitance, Switch Off Test Conditions VIN or 3V VIN or 3V Typ 4.5 5.5 Units pF

Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at Vcc = 25C ambient and maximum loading. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the lower of the voltages on the two (A,B) pins. 5. This parameter is determined by device characterization but is not production tested.

Parameters Description ICC ICCD Quiescent Power Supply Current Supply Current per Input @ TTL HIGH Supply Current per Input per MHz(4) Test Conditions(1) VCC = Max. VCC = Max. VCC = Max., A and B Pins Open Control Input Toggling 50% Duty Cycle VIN = GND or VCC VIN = 3.4V(3) Min. Typ(2) 0.1 Max. 2.5 0.25 Units A mA mA/ MHz

Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device. 2. Typical values are at Vcc 5.0V, +25C ambient. 3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to Icc. 4. This current applies to the control inputs only and represent the current required to switch internal capacitance at the specified frequency. The A and B inputs generate no significant or DC currents as they transition. This parameter is not tested, but is guaranteed by design.

Notes: 1. See test circuit and wave forms. 2. This parameter is guaranteed but not tested on Propagation Delays. 3. The bus switch contributes no propagational delay other than the RC delay of the ON resistance of the switch and the load capacitance. The time constant for the switch alone is of the order 0.25 ns for 50 pF load. Since this time constant is much smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.


 

Related products with the same datasheet
PI5C16210A
PI5C16210B
PI5C16210V
Some Part number from the same manufacture Pericom Semiconductor Corporation
PI5C16210V 20-Bit Bus Switch
PI5C16211 24-Bit Bus Switch
PI5C16212 24-Bit Bus Exchange Switch
PI5C16213 24-bit Bus-exchange Switch
PI5C16214 Pi5c162214 (25ohm)
PI5C16215C 20-Bit Bus Switch W/undershoot Protection
PI5C162209 18-bit Bus Exchange Switch
PI5C162210 20-bit, 2-port Bus Switch
PI5C162212 24-bit Bus Exchange Switch
PI5C162213A
PI5C162213V
PI5C162214 12-bit, 3-to-1 Bus-select Switch
PI5C162215CA 20-bit,hot Insertion,bus Switch With Precharged Outputs & Undershoot Protection
PI5C162215CB
PI5C162244 16-Bit Bus Switch W/25 Ohm Resistor (FCT16244 Pinout)
PI5C162245 16-Bit Bus Switch W/25 Ohm Resistor (FCT16245 Pinout)
PI5C16225C Low Capacitance 12-bit-to-24-bit Mux/demux Bus Switch
PI5C16226C Low Capacitance 12-bit to 24-bit Mux/demux Busswitch
PI5C162292 24-bit Mux/demux Bus Switch
PI5C16233C 32:16 Mux/demux Bus Switch W/undershoot Protection
PI5C16234C Low Capacitance 16-bit to 32-bit Mux/demux Busswitch
 
0-C     D-L     M-R     S-Z