Details, datasheet, quote on part number: PI5C162209V
PartPI5C162209V
CategoryLogic => Bus Interface => Bus Oriented Circuits
TitleBus Oriented Circuits
Description18-bit Bus Exchange Switch
CompanyPericom Semiconductor Corporation
DatasheetDownload PI5C162209V datasheet
Cross ref.Similar parts: SN74CBT16209A, FST16209, FST16209MEA
  

 

Features, Applications

Near-zero propagation delay 5W switches connect inputs to outputs Direct bus connection when switches are ON Ultra-low quiescent power (0.2A typical) Ideally suited for notebook applications Industrial operating temperature: to +85C Available Packages: 48-pin 240-mil wide thin plastic TSSOP (A) 48-pin 300-mil wide plastic SSOP (V)

Pericom Semiconductors PI5C series of logic circuits are produced using the Companys advanced 0.8 micron CMOS technology. The PI5C16209 and PI5C162209 are 18-bit bus exchange switches designed with a low ON resistance (5) allowing inputs to be connected directly to outputs. This device operates a 18-bit bus switch a 9-bit exchanger, which provides data exchanging between the four signal ports via the data select pins (S0-S2). The PI5C162209 device has a built-in 25-ohm series resistor to reduce noise because of reflections, thus eliminating the need for an external terminating resistor.

H = High Voltage Level L = Low Voltage Level Z = High Impedance

(Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature............................................................ to +150C Ambient Temperature with Power Applied............................ to +85C Supply Voltage to Ground Potential (Inputs & Vcc Only)....... to +7.0V Supply Voltage to Ground Potential (Outputs & D/O Only).... +7.0V DC Input Voltage................................................................... +7.0V DC Output Current.............................................................................. 120mA Power Dissipation................................................................................... 0.5W Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Parameters Description VIH VIL IIH IIL IOZH VIK IOS VH RON Input HIGH Voltage Input LOW Voltage Input HIGH Current Input LOW Current High Impedance Output Current Clamp Diode Voltage Short Circuit Current

Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic LOW Level VCC = Max., VIN = VCC = Max., VIN = GND A, B VCC = Min., IIN 18mA A (B) 0V, B (A) = VCC = Min., VIN = 0.0V, ION = 48mA VCC = Min., VIN = 2.4V, ION = 15mA

Input Hysteresis at Control Pins Switch On Resistance

Parameters(5) CIN COFF CON Description Input Capacitance A/B Capacitance, Switch Off A/B Capacitance, Switch On Test Conditions VIN = 0V VIN = 0V VIN = 0V Typ Max. 6 8 Units pF

Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at Vcc = 25C ambient and maximum loading. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the lower of the voltages on the two (A,B) pins. 5. This parameter is determined by device characterization but is not production tested.

Parameters Description ICC ICCD Quiescent Power Supply Current Supply Current per Input @ TTL HIGH Supply Current per Input per MHz(4) Test Conditions(1) VCC = Max. VCC = Max. VCC = Max., A and B Pins Open Sn = GND Control Input Toggling 50% Duty Cycle VIN = GND or VCC VIN = 3.4V(3) Min. Typ(2) 0.1 Max. 2.5 0.25 Units A mA mA/ MHz

Notes: 1. For conditions shown as Max. or Min., use appropriate value specified under Electrical Characteristics for the applicable device. 2. Typical values are at Vcc 5.0V, +25C ambient. 3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to Icc. 4. This current applies to the control inputs only and represent the current required to switch internal capacitance at the specified frequency. The A and B inputs generate no significant or DC currents as they transition. This parameter is not tested, but is guaranteed by design.

PI5C16209 Com. Parameters tPLH tPHL tPZH tPZL tPHZ tPLZ Description Propagation Delay xAx to xBx, xBx to xAx Bus Enable Time S to xAx or xBx Bus Disable Time S to xAx or xBx

PI5C162209 Com. Parameters tPLH tPHL tPZH tPZL tPHZ tPLZ Description Propagation Delay xAx to xBx, xBx to xAx Bus Enable Time S to xAx or xBx Bus Disable Time S to xAx or xBx

Notes: 1. See test circuit and waveforms. 2. This parameter is guaranteed but not tested on Propagation Delays. 3. The bus switch contributes no propagational delay other than the RC delay of the ON resistance of the switch and the load capacitance. The time constant for the switch alone is of the order of 0.25ns for 50pF load. Since this time constant is much smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side. Pericom Semiconductor Corporation 2380 Bering Drive San Jose, 95131 1-800-435-2336 Fax (408) 435-1100 http://www.pericom.com


 

Related products with the same datasheet
PI5C162209A
Some Part number from the same manufacture Pericom Semiconductor Corporation
PI5C162210 20-bit, 2-port Bus Switch
PI5C162212 24-bit Bus Exchange Switch
PI5C162213A
PI5C162213V
PI5C162214 12-bit, 3-to-1 Bus-select Switch
PI5C162215CA 20-bit,hot Insertion,bus Switch With Precharged Outputs & Undershoot Protection
PI5C162215CB
PI5C162244 16-Bit Bus Switch W/25 Ohm Resistor (FCT16244 Pinout)
PI5C162245 16-Bit Bus Switch W/25 Ohm Resistor (FCT16245 Pinout)
PI5C16225C Low Capacitance 12-bit-to-24-bit Mux/demux Bus Switch
PI5C16226C Low Capacitance 12-bit to 24-bit Mux/demux Busswitch
PI5C162292 24-bit Mux/demux Bus Switch
PI5C16233C 32:16 Mux/demux Bus Switch W/undershoot Protection
PI5C16234C Low Capacitance 16-bit to 32-bit Mux/demux Busswitch
PI5C16244 16-Bit Bus Switch W/25 Ohm Resistor (FCT16244 Pinout)
PI5C16245 16-Bit Bus Switch W/25 Ohm Resistor (FCT16245 Pinout)
PI5C162861 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C162861C 20-bit, 2-port Bus Switch
PI5C162861V 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C162862CA 20-bit,2-port Bus Switch With Undershoot Protection
PI5C162862CB
 
0-C     D-L     M-R     S-Z