Details, datasheet, quote on part number: PI5C16234C
CategoryLogic => Bus Interface
DescriptionLow Capacitance 16-bit to 32-bit Mux/demux Busswitch
CompanyPericom Semiconductor Corporation
DatasheetDownload PI5C16234C datasheet


Features, Applications

RON is 8 Typical Pulldown on B Ports Low Power: 1mW Industrial Operation to 85C Near Zero Propagation Delay Switching Speed: 4.5ns max. Channel on capacitance: 9pF (typ.) VCC Operating Range: +5.5V >100 MHz Bandwidth Packages Available: - 56-pin plastic TSSOP (A)

Pericom Semiconductor's PI5C series of logic circuits are produced using the Company's advanced submicron CMOS technology. The to 32-bit mux/demux switch. Industry leading advantages include almost zero propagation delay of 500ps because of the 8 channel resistance and low I/O capacitance. A1 port demultiplexes to either port or B2. The switch is bidirectional.


(Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature..................................................... to +150C Ambient Temperature with Power Applied.................... to +85C Supply Voltage Range..................................................... +4.6V DC Input Voltage............................................................ +4.6V DC Output Current....................................................................... 120mA Power Dissipation............................................................................. 0.5W Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Parameters Description VIH VIL IIH IIL IOZ RON Input HIGH Voltage Input LOW Voltage Input HIGH Current Input LOW Current High Impedance Output Current Switch On Resistance(4) Test Conditions(1) Guaranteed Logic HIGH Level Guaranteed Logic HIGH Level VCC = Max., VIN = VCC = Max., VIN = GND B = VCC Min., VCC =Min. VCC = Min., VIN = 0.0V, ION = 12mA VCC = Min., VIN = 2.4V, ION = 8mA Min. Typ(1) Max. mA V Units

Parameters(5) CIN CON Description Input Capacitance A/B Capacitance, Switch On Test Conditions VIN = 0V VIN = 0V Typ. 3 9 Max. 11 Units pF

Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC = 25C ambient and maximum loading. 3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 4. Measured by the voltage drop between A and B pins at indicated current through the switch. ON resistance is determined by the lower of the voltages on the two & B) pins. 5. This parameter is determined by device characterization but is not production tested.

PI5C16234C Low Capacitance to 32-Bit Mux/Demux BusSwitch 12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012 Power Supply Characteristics

Parameters Description ICC ICCD Quiescent Power Supply Current Supply Current per Input @ TTL HIGH Supply Current per Input per MHz(4) Test Conditions(1) VCC = Max. VCC = Max. VCC = Max., A and B Pins Open Control Input Toggling 50% Duty Cycle VIN = GND or VCC VIN = 3.4V(3) other pin = VCC or GND Min. Typ(2) Max. 2.5 0.25 Units A mA mA/ MHz

Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device. 2. Typical values are at VCC 5.0V, +25C ambient. 3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to ICC. 4. This current applies to the control inputs only and represent the current required to switch internal capacitance at the specified frequency. The A and B inputs generate no significant or DC currents as they transition. This parameter is not tested, but is guaranteed by design. 5. Values for these conditions are examples of the ICC formula. These limits are guaranteed but not tested.

Description Propagation to B Bus Enable Time SEL TO A,B Bus Disable Time SEL to A,B

Notes: 1. See test circuit and waveforms. 2. This parameter is guaranteed but not tested on Propagation Delays. 3. The bus switch contributes no propagational delay other than the RC delay of the ON resistance of the switch and the load capacitance. The time constant for the switch alone is of the order of 0.25ns for 25pF load. Since this time constant is much smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.

Pericom Semiconductor Corporation 2380 Bering Drive San Jose, 95131 1-800-435-2336 Fax (408) 435-1100


Related products with the same datasheet
Some Part number from the same manufacture Pericom Semiconductor Corporation
PI5C16234CA Low Capacitance 16-bit to 32-bit Mux/demux Busswitch
PI5C16244 16-Bit Bus Switch W/25 Ohm Resistor (FCT16244 Pinout)
PI5C16245 16-Bit Bus Switch W/25 Ohm Resistor (FCT16245 Pinout)
PI5C162861 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C162861C 20-bit, 2-port Bus Switch
PI5C162861V 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C162862CA 20-bit,2-port Bus Switch With Undershoot Protection
PI5C16292 24:12-Bit, Mux/demux Bus Switch W/500 Ohm Pull-down
PI5C16861 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C16861C 20-bit, 2-port Bus Switch
PI5C16861V 20-Bit Flow-through Bus Switch (2 Enables) W/25 Ohm Resistor
PI5C16862C 20-Bit Flow-through Bus Switch W/undershoot Protection (4 Enables)
PI5C3125 4-Bit Bus Switch W/individual Low Enables
PI5C3125C 4-Bit Bus Switch W/individual Low Enables, 2V Undershoot Protection
PI5C3125L 4-Bit Bus Switch W/individual Low Enables
PI5C3126C 4-Bit Bus Switch W/individual Low Enables, 2V Undershoot Protection
PI5C3126L 4-Bit Bus Switch W/individual Low Enables
PI5C32160C 32:16 Mux/demux Bus Switch (PCI Hot Plug)
PI5C32161C 32:16 Mux/demux Bus Switch (PCI Hot Plug) W/slow Enable Time
PI5C32200 32-Bit 56 Ohm GTL Terminator Bus Switch
Same catergory

54ACQ373 : Military/Aerospace->FACT ACQ. 54ACQ373 - Quiet Series Octal Transparent Latch With Tri-state Outputs, Package: Lcc, Pin Nb=20.

5962-8994601EA : ti CD54HC190, High Speed CMOS Logic Presettable Synchronous 4-Bit BCD Decade Up/down Counter.

74ALVCH16244 : 3.3V CMOS 16-BIT Buffer/driver With 3-STATE Outputs And Bus-hold. 0.5 MICRON CMOS Technology Typical tSK(o) (Output Skew) < 250ps ESD > 2000V per MIL-STD-883, Method > 200V using machine model = 0) VCC 0.3V, Normal Range VCC to 3.6V, Extended Range VCC 0.2V CMOS power levels (0.4 W typ. static) Rail-to-Rail output swing for increased noise margin Available in SSOP, TSSOP, and TVSOP packages High Output.

74LVCH32245A : 74LVC32245A; 74LVCH32245A; 32-bit Bus Transceiver With Direction Pin; 5 V Tolerant; 3-state;; Package: SOT536-1 (LFBGA96).

DM5403J : Quad 2-input NAND Gates With Open-collector Outputs. DM5403 DM7403 Quad 2-Input NAND Gates with Open-Collector Outputs This device contains four independent gates each of which performs the logic NAND function The open-collector outputs require external pull-up resistors for proper logical operation VCC (Max) b VOL RMIN e IOL b N3 (IIL) Where N1 (IOH) e total maximum output high current for all outputs.

HEF4070B : HEF4070B Gates; Quadruple Exclusive-OR GATE;; Package: SOT108-1 (SO14), SOT27-1 (DIP14).

IW4541BD : Programmable Timer14. The IW4541 programmable timer consists a 16-stage binary counter, an oscillator that is controlled by external R-C components (2 resistors and a capacitor), an automatic power-on reset circuit, and output control logic. The counter increments on positive-edge clock transitons and can also be reset via the MASTER RESET input. The output from this timer.

M54HCT258F1R : Hct257 Quad 2 Channel Multiplexer 3-state Hct258 Quad 2 Channel Multiplexer 3-state, Inverting.

MC100EL05 : Bipolar->ECL 100 Family. 2-input Differential And/nand. The a 2-input differential AND/NAND gate. The device is functionally equivalent to the E404 device with higher performance capabilities. With propagation delays and output transition times significantly faster than the E404, the EL05 is ideally suited for those applications which require the ultimate in AC performance. Because a negative 2-input NAND.

NL27WZU04 : . The is a high performance dual unbuffered inverter operating from 5.5 V supply. These devices are well suited for use as oscillators, pulse shapers, and in many other applications requiring a highinput impedance amplifier. For digital applications, the NL27WZ04 is recommended. Designed for 5.5 V VCC Operation Unbuffered for Crystal Oscillator and Analog.

SN74ABT16640DGGR : Standard Transceivers. ti SN74ABT16640, 16-Bit Bus Transceivers With 3-State Outputs.

SN74AS760 : Bus Oriented Circuits. Octal Buffer/line Driver With Open Collector Outputs.

SN74AUC16244DGGR : Non-Inverting Buffers and Drivers. ti SN74AUC16244, 16-Bit Buffer/driver With 3-State Outputs.

SN74S181J : Arithmetic Logic Units. ti SN74S181, Arithmetic Logic Units/function Generators.

XC6VHX380T-1FF1154E : FPGA. s: Device Type: FPGA. Virtex-6 FPGAs are available -2, -1, and -1L speed grades, with -3 having the highest performance. Virtex-6 FPGA DC and AC characteristics are specified in commercial, extended, industrial, and military temperature ranges. Unless noted, the Virtex-6Q FPGA DC and AC characteristics are equivalent to the commercial s. Except for the operating temperature.

74HC02U : HC/UH SERIES, QUAD 2-INPUT NOR GATE, UUC. s: Gate Type: NOR ; Supply Voltage: 5V ; Logic Family: CMOS ; Inputs: 2 ; Propagation Delay: 135 ns ; Operating Temperature: -40 to 125 C (-40 to 257 F) ; IC Package Type: Other, DIE.

0-C     D-L     M-R     S-Z