Details, datasheet, quote on part number: RH-0505D
PartRH-0505D
CategoryPower Management => DC-DC Converters => Unregulated DC/DC
TitleUnregulated DC/DC
DescriptionPower = 1 ;; ISOlation = 3 & 4 ;; Input Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; Output Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; No. Of Outputs = S & D ;; Case = SIP7
CompanyRecom International Power
DatasheetDownload RH-0505D datasheet
Quote
Find where to buy
 
  
Related products with the same datasheet
RH-0509D
RH-051.8D
RH-0512D
RH-0512DH
RH-0515D
RH-0524D
RH-053.3D
RH-0905D
RH-0909D
RH-091.8D
RH-0912D
RH-0915D
Some Part number from the same manufacture Recom International Power
RH-0509D Power = 1 ;; ISOlation = 3 & 4 ;; Input Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; Output Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; No. Of Outputs = S & D ;; Case = SIP7
RI-0505 Power = 2 ;; ISOlation = 1 ;; Input Voltages (VDC) = 5, 9, 12, 15, 24 ;; Output Voltages (VDC) = 3.3, 5, 7, 9, 12, 15, 24 ;; No. Of Outputs = S ;; Case = SIP4
RJ-0505S Power = 1 ;; ISOlation = 3 & 4 ;; Input Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; Output Voltages (VDC) = 1.8, 3.3, 5, 9, 12, 15, 24 ;; No. Of Outputs = S & D ;; Case = DIP14
Same catergory

FAN1581x15 : 5A Fixed 1.5V Low Dropout Voltage Regulator (LDO). Ultra Low dropout voltage, 0.4V typical at 5A Remote sense operation Fast transient response Load regulation: 0.05% typical 0.5% initial accuracy On-chip thermal limiting 5-Pin SPAK and TO-263 packages The FAN1581, FAN1581-1.5, and FAN1581-2.5 are ultra-low dropout regulators with 5A output current capability. These devices have been optimized for low voltage.

HV-2405E : -. The is a single chip off line power supply that converts world wide AC line voltages to a regulated DC voltage. The output voltage is adjustable from to 24VDC with an output current to 50mA. The HV-2405E can operate from input voltages between 15Vrms and 275Vrms as well as input frequencies between to 200Hz (see Table 1 in section titled "Minimum Input.

LP8345 : Positive Voltage->Adjustable. LP8345 - Low Dropout, Low IQ, 500mA CMOS Linear Regulator, Package: to 252, Pin Nb=3.

MAX6316 : Watchdog. 5-Pin P Supervisory Circuits With Watchdog And Manual Reset.

ML4801 : Power Factor Correction (PFC) And PWM Controller Combo. Internally synchronized PFC and PWM in one IC Low start-up current (200µA typ.) Low operating current (5.5mA typ.) Low total harmonic distortion Reduces ripple current in the storage capacitor between the PFC and PWM sections Average current continuous boost leading edge PFC High efficiency trailing edge PWM optimized for current mode operation Current.

MM1134 : System Reset. System Reset(battery Back-up). These ICs protect S-RAM data in back-up mode (CS signal makes R-SAM CE pin low and CE pin high) when power supply voltage goes below a certain set voltage (detection voltage 3.5V, 4.2V typ.). Further, it switches from main power supply to battery back-up when power supply voltage drops. Conversely, when power supply rises, it first switches the S-RAM.

MTRS9080 : Reflective Switch.

PT4498A : Plug-in Power Solutions->Isolated->Single Output. ti PT4498, 20A 'Current Booster' For The PT4484 DC-DC Converter.

PT6362A : Plug-in Power Solutions->Non-Isolated->Single Posi. ti PT6362, 3.3V 10A, 12-V Input Adjustable Step-down Isr.

PT8125A : Plug-in Power Solutions->Non-Isolated->Single Posi. ti PT8125, 4.5V to 7.6V 28A, 12-V Input Multiphase Programmable Isr.

R1121Nxxxx : LDO/TK112 Compatible.

R1280D : Inverting.

SI-3052N : Linear Regulator ic 3-Terminal. Compact full-mold package (equivalent to TO220) Output current: 2.0A Low dropout voltage: VDIF1V (at IO=2.0A) Built-in foldback overcurrent, overvoltage, thermal protection circuits For stabilization of the secondary stage of switching power supplies Electronic equipment Parameter DC Input Voltage DC Output Current Power Dissipation Junction Temperature.

UC1525B : Voltage Mode PWM Controllers. Regulating Pulse Width Modulator. The UC1525B/1527B series of pulse width modulator integrated circuits are designed to offer improved performance and lowered external parts count when 5.1V Buried Zener Reference used in designing all types of switching power supplies. The on-chip +5.1V Trimmed to ±0.75% buried zener reference is trimmed to ±0.75% and the input common-mode range to 500kHz.

UC2825B : Current Mode PWM Controllers. Improved versions of the UC3823/UC3825 PWMs Compatible with Voltage or Current-Mode Topologies Practical Operation at Switching Frequencies 1MHz 50ns Propagation Delay to Output High Current Dual Totem Pole Outputs (2A Peak) Trimmed Oscillator Discharge Current Low 100µA Startup Current Pulse-by-Pulse Current Limiting Comparator Latched Overcurrent.

NMG : Murata Power Solutions Expands Its Range Of High Efficiency DC/DC Converters With Introduction Of 2W Single Output NMG Series Murata Power Solutions has introduced a new range of isolated 2W single output DC/DC Converters that deliver class-leading performance. The eight models in the NMG series are housed in small footprint (19.5mm x 7.5mm x 10.0mm.

ADP190 : Logic Controlled, High-Side Power Switch The ADP190 is a high-side load switch designed for operation from 1.2 V to 3.6 V. This load switch provides power domain isolation for extended power battery life. The device contains a low on-resistance P-channel MOSFET that supports more than 500 mA of continuous current and minimizes power loss. The low 2 ?A (maximum).

FUSB2500 : USB2.0 High-Speed OTG Transceiver With ULPI Interface USB2.0 High-Speed OTG Transceiver with ULPI Interface.

LMZ22008 : 8A SIMPLE SWITCHER® Power Module With 20V Maximum Input Voltage And Current Sharing The LMZ22008 SIMPLE SWITCHER© power module is an easy-to-use step-down DC-DC solution capable of driving up to 8A load. The LMZ22008 is available in an innovative package that enhances thermal performance and allows for hand or machine soldering..

UCC25230 : 12V To 105V Input, 0.2A Output Switching Converter The UCC25230 is a highly integrated PWM converter operating as an isolated forward flyback. It has high-side and low-side power switches integrated and the control circuit with all key converter functions included. The power stage requires only one- or multiple winding coupled inductor and output capacitors.

 
0-C     D-L     M-R     S-Z