Details, datasheet, quote on part number: DSA10
PartDSA10
Category
DescriptionGeneral-purpose Rectifiers, Package : DO-41
CompanySanyo Semiconductor Corporation
DatasheetDownload DSA10 datasheet
  

 

Features, Applications

Features
Plastic molded type. Peak Reverse Voltage to 1000V Average Rectified Current : IO=1A.
Specifications

Parameter Peak Reverse Voltage Average Rectified Current Surge Forward Current Junction Temperature Storage Temperature Symbol VRM IO IFSM Tj Tstg Conditions DSA10J 800

Parameter Forward Voltage Reverse Current Symbol IR IF=1.0A VR:At each VRM Conditions Ratings min typ max 1.2 10 Unit V µA

SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE, Tokyo Bldg., 1-10 , Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or indirectly cause injury, death or property loss. Anyone purchasing any products described or contained herein for an above-mentioned use shall: Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use: Not impose any responsibilty for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally. Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties. This catalog provides information as of May, 1998. Specifications and information herein are subject to change without notice.


 

Related products with the same datasheet
DSA10G
DSA10L
Some Part number from the same manufacture Sanyo Semiconductor Corporation
DSA10G General-purpose Rectifiers, Package : DO-41
DSA12T
DSA12T General-purpose Rectifiers, Package : DO-15
DSA14
DSA14 General-purpose Rectifiers, Package : Surface Mount (LHP)
DSA14C
DSA14G
DSA17
DSA17 General-purpose Rectifiers, Package : DO-15L
DSA17B 1.7a Power Rectifier
DSA17C General-purpose Rectifiers, Package : DO-15L
DSA17E
DSA20T 2.0a Power Rectifier
DSA26
DSA26 General-purpose Rectifiers, Package : DO-201AD
DSA26B 2.6a Power Rectifier
DSA26C General-purpose Rectifiers, Package : DO-201AD
DSA26C
DSA26E
DSA26G General-purpose Rectifiers, Package : DO-201AD
DSA26G
Same catergory

CY7C419-10AC : 5V Async Fifo. Asynchronous first-in first-out (FIFO) buffer memories 9 (CY7C433) Dual-ported RAM cell High-speed 50.0-MHz read/write independent of depth/width Low operating power: ICC 35 mA Empty and Full flags (Half Full flag in standalone) TTL compatible Retransmit in standalone Expandable in width PLCC, 7x7 TQFP, SOJ, 300-mil and 600-mil DIP Pin compatible and functionally.

IT8706R : Gpio ic. If you have any marketing or sales questions, please contact: Lawrence Liu, at ITE Taiwan: E-mail: lawrence.liu@ite.com.tw, Tel: 886-2-26579896 X6071, Fax: 886-2-26578561 David Lin, at ITE U.S.A: E-mail: david.lin@iteusa.com, Tel: 530-8860 X238, Fax: (408) 530-8861 Don Gardenhire , at ITE Eastern USA Office: E-mail: don.gardenhire@iteusa.com, Tel: (512).

6657S-1-102 : Precision Potentiometer. Bushing mount Shaft supported by front sleeve bearing Non-standard and s available Standard Resistance 100 K ohms Total Resistance Tolerance±10 % Independent Linearity.±1 % Effective Electrical ±3 ° End Voltage.0.5 % maximum Output Smoothness0.1 % Dielectric Withstanding Voltage (MIL-STD-202, Method 301) Sea Level.750 VAC minimum Power Rating (Voltage.

ILB03N60 : Lightmos Power Transistor. New high voltage technology designed for ZVS-switching in lamp ballasts IGBT with integrated reverse diode 4A current rating for reverse diode to 10 times lower gate capacitance than MOSFET Avalanche rated 150°C operating temperature FullPak isolates AC (1 min.) Symbol VCE 100°C IC ICpuls IF IFpuls EAS VGE dv/dt Ptot Tstg Ts Pulsed collector current,.

CMP-605 : Mixers Triple-balanced. FREQUENCY RANGE (MHz) CONVERSION LOSS (dB) 1. 1dB Compression Point = +14 dBm (Typ) 2. IP3 (Input) = +26 dBm (Typ) As IF frequency decrease below LF towards DC, conversion loss increases 8 dB higher than maximum. 4. Maximum Input Power without damage 500 mW ave. cw XMB= to HF/2 FULL BAND to HF LB= to HF/2 UB= to HF * Pins must be connected together.

H124I : Ultra-miniature Minidip 1W, High Isolation Dc/dc Converters. Ultra-Miniature MiniDIP 1W, High Isolation DC/DC Converters s typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. s subject to change without notice. 1W Output Power Miniature MiniDIP Case 3,000 VDC Isolation Complies to RFI Standards >2 MHour MTBF 18 Standard Models Industry Standard Pin-Out Parameter Input Voltage.

MHR68TAJ : 9x14 mm, 5.0 Volt, Hcmos/ttl, Clock Oscillator. NOTE: A capacitor of value µF or greater between Vdd and Ground is recommended. MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your.

IN4937 : 1.0 Amp FAST Recovery Plastic Rectifiers. n FAST SWITCHING FOR HIGH EFFICIENCY n HIGH SURGE CAPABILITY n 1.0 AMP OPERATION = 55°C, WITH NO THERMAL RUNAWAY n MEETS UL 94V-0 1N4933. 37 Series Maximum Ratings Peak Repetitive Reverse VoltageVRRM RMS Reverse VoltageVR(rms) DC Blocking VoltageVDC Average Forward Rectified CurrentIF(av) = 55°C Non-Repetitive Peak Forward Surge CurrentIFSM @ Rated.

0405-1000M : UHF: 400-450 MHz, Class C, Common Emitter-Pulsed UHF: 400-450 MHz, Class C, Common Emitter-Pulsed.

1PS70SB10,115 : Schottky Diode. s: Diode Type: Schottky ; Repetitive Reverse Voltage Vrrm Max: 30V ; Forward Current If(AV): 100mA ; Forward Voltage VF Max: 800mV ; Reverse Recovery Time trr Max: - ; Forward Surge Current Ifsm Max: 600mA ; Operating Temperature Range: -65°C to +125°C ; Diode Case Style: SOT-323 ; No. of Pins: 3 ; MSL: -.

ST7S014V4BR800 : Surface Mount, Right Angle Memory - Pc Card - Connector Connectors, Interconnect Combo - microSD™, SIM; CONN MICRO SD/SIM CARD COMBO. s: Card Type: Combo - microSD™, SIM ; Number of Positions: 18 (14 + 4) ; Connector Type: Connector and Ejector ; Height Above Board: 0.126" (3.20mm) ; Insertion, Removal Method: Push In, Push Out ; Ejector Side: - ; Mounting.

TNPW1210715KBEEA : 715K Ohm 0.333W, 1/3W Chip Resistor - Surface Mount; RES 715K OHM 1/3W 0.1% 1210. s: Resistance (Ohms): 715K ; Power (Watts): 0.333W, 1/3W ; Tolerance: ±0.1% ; Packaging: Tape & Reel (TR) ; Composition: Thin Film ; Temperature Coefficient: ±25ppm/°C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

MK23-90-B-1 : Magnetic - Position, Proximity, Speed (Modules) SENSOR REED SPDT-CHANGE SMD -; SENSOR REED SPDT-CHANGE SMD. s: Type: Reed Switch ; Output Type: SPDT ; Voltage - Supply: 175V ; Package / Case: Glass ; Frequency: - ; Termination Style: Surface Mount ; Actuator Material: Magnet ; Must Operate: 10 ~ 30AT ; Must Release: - ; Function: Switch ; Lead Free.

MX7578K/D-T : 1-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, UUC22. s: Package Type: DIE-22 ; Screening Level: Commercial ; Pins: 22 ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Input Voltage: 0.0 to 5 volts.

1TH1CA5685MCS6L011 : CAPACITOR, ALUMINUM ELECTROLYTIC, NON SOLID, POLARIZED, 16 V, 6.8 uF, THROUGH HOLE MOUNT. s: Configuration / Form Factor: Leaded Capacitor ; RoHS Compliant: Yes ; : Polarized ; Capacitance Range: 6.8 microF ; Capacitance Tolerance: 20 (+/- %) ; WVDC: 16 volts ; Leakage Current: 4.09 microamps ; Mounting Style: Through Hole ; Operating Temperature: -40 to 85 C (-40.

 
0-C     D-L     M-R     S-Z