Details, datasheet, quote on part number: STK401-270
PartSTK401-270
CategoryAnalog & Mixed-Signal Processing
Description2-channel, (40W+40W) af Power Amplifier (split Power Supply)
CompanySanyo Semiconductor Corporation
DatasheetDownload STK401-270 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

2ch AF Power Amplifier (Split Power Supply) + 40W min, THD = 0.08%)

The a 2-channel audio power amplifier IC that supports 6/3 output load impedances. It is fully pin compatible with the 3-channel output devices (STK400×00 series) and 2-channel output devices (STK401-×00 series). In addition, it supports 6/3 output load impedance.

Features

Pin compatible with the 3-channel output devices (STK400-×00 series) and 2-channel output devices (STK401-×00 series) Output load impedance RL=6/3 supported Pin configuration grouped into individual blocks of inputs, outputs and supply lines to minimize the adverse effects of pattern layout on operating characteristics. Few external components

Any and all SANYO products described or contained herein do not have specifications that can handle applications that require extremely high levels of reliability, such as life-support systems, aircraft's control systems, or other applications whose failure can be reasonably expected to result in serious physical and/or material damage. Consult with your SANYO representative nearest you before using any SANYO products described or contained herein in such applications. SANYO assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges,or other parameters) listed in products specifications of any and all SANYO products described or contained herein.

TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

Parameter Maximum supply voltage Thermal resistance Junction temperature Operating substrate temperature Storage temperature Available time for load short-circuit Symbol VCC max j-c Tj Tc Tstg f=50Hz, PO=40W Per power transistor Conditions Ratings +125 1 Unit V

Parameter Symbol PO1 Output power PO2 Total harmonic distortion Frequency response Input impedance Output noise voltage Quiescent current Neutral voltage THD1 THD2 fL, fH ri VNO ICCO VN Conditions to 50k Ratings min 40 typ 45 0.08 max Unit k 1.2 mVrms mA mV

Note. All tests are measured using a constant-voltage supply unless otherwise specified. Available time for load short-circuit and output noise voltage are measured using the transformer supply specified below. The output noise voltage is the peak value of an average-reading meter with an rms value scale (VTVM). A regulated AC supply (50Hz) should be used to eliminate the effects of AC primary line flicker noise. Specified Transformer Supply (MG-200 or Equivalent)


 

Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK401-290
STK401-290 2-channel, (50W+50W) af Power Amplifier (split Power Supply)
STK401-330 2-channel, (100W+100W) af Power Amplifier (split Power Supply)
STK4017
STK4017C
STK4019
STK4019M
STK402-020 af Power Amplifier , Package : Sip
STK402-030
STK402-040
STK402-050
STK402-060
STK402-070 Two-channel Class ab Audio Power Amplifier ic
STK402-090 af Power Amplifier , Package : Sip
STK402-100
STK402-120
STK402-220
STK402-230
STK402-240
STK402-250
STK402-270

2SD1908 : , Package : to

LA7155M : Audio Switch For Pal 21 Pin Connectors

LA72600M :

LC322260AT-60 :

LC665316A : 4-bit Single-chip Microcontroller With 16 KB of On-chip ROM

LC7367JM : Pulse/tone Switchable Dialer, Package : Sop

LC78855M :

LC9915-RM :

2SK2624FG : N-channel Silicon Mosfet General-purpose Switching Device Applications

CPH6006-TL-E : Rf Transistor (bjt) Discrete Semiconductor Product 300mA 20V 1W NPN; TRANS NPN 20V 300MA CPH6 Specifications: Frequency - Transition: 2.2GHz ; Noise Figure (dB Typ @ f): - ; Current - Collector (Ic) (Max): 300mA ; DC Current Gain (hFE) (Min) @ Ic, Vce: 100 @ 50mA, 5V ; Transistor Type: NPN ; Voltage - Collector Emitter Breakdown (Max): 20V ; Gain: - ; Power - Max: 1W ; Lead Free Status: Lead

Same catergory

EL5481CS : Quad 8ns High-speed Comparators. 8ns Typ. Propagation Delay to 12V Input Supply to +5V Output Supply True-to-ground Input Rail-to-rail Outputs Active Low Latch Single (EL5181C) Available Dual (EL5281C) Available Window Available (EL5283C) Pin-compatible 4ns Family Available & EL5486C) The EL5481C and EL5482C comparators are designed for operation in single supply and dual supply applications.

L272 : Dual Operational Amplifier. Output Current upto 0.7A Operates at Low Voltage (VS(MIN)=4V) Low Saturation Voltage (Ip=0.5A, VO=1.5V) Thermal Shutdown (TSD=160°C) Ground Compatible Inputs Large Common mode & Differential mode Range The is a high-power dual operational amplifier provided a 8-DIP and 16-SOP package. The operational amplifier is designed for low impedance loads and will.

LB1205M : . The is a four-channel, high withstand voltage (65V), large-current (1.5A) Darlington driver array with input low active configuration and sync output. 4-channel, high withstand voltage design (65V), large-current (1.5A) Darlington driver. PNP input type (low active) Built-in spark killer diode Built-in input protection diode Direct drive capable with.

LF13508 : Multiplexers. 8-channel Analog Multiplexer (obsolete). The an 8-channel analog multiplexer which connects the output 1 of the 8 analog inputs depending on the state a 3-bit binary address An enable control allows disconnecting the output thereby providing a package select function This device is fabricated with National's BI-FET technology which provides ion-implanted JFETs for the analog switch on the same.

LM107 : High-performance op Amps. Low Input Currents No Frequency Compensation Required Low Input Offset Parameters Short-Circuit Protection No Latch-Up Wide Common-Mode and Differential Voltage Ranges The LM107, LM207, and LM307 are high-performance operational amplifiers featuring very low input bias current and input offset voltage and current to improve the accuracy of high-impedance.

LMC6064 : LMC6064 - Precision CMOS Quad Micropower Operational Amplifier, Package: Soic Narrow, Pin Nb=14.

LMX2240 : Intermediate Frequency Receiver (obsolete). The is a monolithic integrated intermediate frequency receiver suitable for use in Digital European Cordless Telecommunications (DECT) systems as well as other mobile telephony and wireless communications applications It is fabricated using National's ABiCTM IV BiCMOS process (fT e 15 GHz) The LMX2240 consists of a high gain limiting amplifier a frequency.

MAX440C/D : High-speed Video Multiplixer/amplifier.

MC-4516DA727 : 16m-word BY 72-bit Synchronous Dynamic RAM Module Registered Type. The a 16,777,216 words by 72 bits synchronous dynamic RAM module on which 9 pieces of 128M SDRAM: µPD45128841 are assembled. These modules provide high density and large quantities of memory in a small space without utilizing the surfacemounting technology on the printed circuit board. Decoupling capacitors are mounted on power supply line for noise.

MC03AX1456RT : Adsl Line Driver. The MC03AX1456 ADSL Line Driver provides a single chip analog front end to interface the ADSL Transceiver to the line transformer. The MC03AX1456CO is designed to fulfill the central office requirements. The MC03AX1456RT is optimized for use at the remote terminal (i.e. consumer premises). The ADSL Line Driver provides three differential ports: a transmit.

ML2111 : Universal Dual High Frequency Filter. The ML2111 consists of two independent switched capacitor filters that operate to 150kHz and perform second order filter functions such as lowpass, bandpass, highpass, notch and allpass. All filter configurations, including Butterworth, Bessel, Cauer, and Chebyshev can be formed. The center frequency of these filters is tuned by an external clock or the external.

SN54LS685 : 8-bit Magnitude/identity Comparators.

TA75071P : Single Opertional Amplifier.

TL322CDR : ti TL322, Dual Low-power Operational Amplifier. Wide Range of Supply Voltages Single Supply. 30 V Dual Supplies. 15 V Class AB Output Stage True Differential Input Stage Low Input Bias Current Internal Frequency Compensation Short-Circuit Protection The TL322C and the TL322I are dual operational amplifiers similar in performance to the uA741 but with several distinct advantages. They are designed.

TLC04 : Butterworth Fourth-order Low-pass Switched-capacitor Filters. Low Clock-to-Cutoff-Frequency Ratio Error ± 1% Filter Cutoff Frequency Dependent Only on External-Clock Frequency Stability Minimum Filter Response Deviation Due to External Component Variations Over Time and Temperature Cutoff Frequency Range From to 30 kHz, VCC to 12-V Operation Self Clocking or TTL-Compatible and CMOS-Compatible Clock Inputs Low Supply-Voltage.

TPA152D : ti TPA152, Hi-Fi, Stereo Headphone Audio Amplifier. High-Fidelity Line-Out/HP Driver 75-mW Stereo Output PC Power Supply Compatible Pop Reduction Circuitry Internal Mid-Rail Generation Thermal and Short-Circuit Protection Surface-Mount Packaging Pin Compatible With TPA302 The is a stereo audio power amplifier capable of less than 0.1% THD+N at 1 kHz when delivering 75 mW per channel into a 32- load.

LTC6401IUD-26#TR : 1.3GHz Low Noise, Low Distortion Differential ADC Driver For 140MHz IF The LTC6401-20 is a high-speed differential amplifier targeted at processing signals from DC to 140MHz. The part has been specifically designed to drive 12-, 14- and 16-bit ADCs with low noise and low distortion, but can also be used as a general-purpose broadband gain block. The LTC6401-20.

 
0-C     D-L     M-R     S-Z