Details, datasheet, quote on part number: STK402-050
PartSTK402-050
Category
Descriptionaf Power Amplifier , Package : Sip
CompanySanyo Semiconductor Corporation
DatasheetDownload STK402-050 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The STK402-000 series products are audio power amplifier hybrid ICs that consist of optimally-designed discrete component power amplifier circuits that have been miniaturized using SANYO's unique insulated metal substrate technology (IMST). SANYO has adopted a new low thermal resistance substrate in these products to reduce the package size by about 60% as compared to the earlier SANYO STK407-000 series.

Features

Series of pin compatible power amplifiers ranging from 2 channels 2 channels (10%/1 kHz) devices. The same printed circuit board can be used depending on the output power grade. The pin arrangement is compatible with that of the 3channel STK402-200 series. This means that 3-channel printed circuit boards can also be used for 2-channel products. Miniature packages 15 W/ch to 40 W/ch (THD to 20 kHz); * 50 W/ch to 80 W/ch (THD to 20 kHz); mm * Not including the pins. Output load impedance: 6 Allowable load shorted time: 0.3 seconds Supports the use of standby, muting, and load shorting protection circuits.

Any and all SANYO products described or contained herein do not have specifications that can handle applications that require extremely high levels of reliability, such as life-support systems, aircraft's control systems, or other applications whose failure can be reasonably expected to result in serious physical and/or material damage. Consult with your SANYO representative nearest you before using any SANYO products described or contained herein in such applications. SANYO assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all SANYO products described or contained herein.

TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

STK402-050 Series Organization These products are organized as a series based on their output capacity.

Output to 20 kHz) 15 W Maximum supply voltage (No signal) Maximum supply voltage (6 ) Recommended supply voltage (6 ) Package 19 V

Specifications

Parameter Maximum supply voltage (No signal) Maximum supply voltage Thermal resistance Junction temperature Operating IC substrate temperature Storage temperature Allowable load shorted time *2 Symbol VCC max(0) VCC = 6 j-c Tj max Tc max Tstg ts VCC RL 50 Hz, 30 W Per power transistor Both the Tj max and the Tc max conditions must be met. Conditions Ratings +125 0.3 Unit V C/W C s

Parameter Output power (continuous output) Total harmonic distortion Frequency characteristics Input impedance Output noise voltage *3 Quiescent current Neutral voltage Symbol PO (2) THD (1) THD (2) fL, fH ri VNO ICCO VN Conditions*1 VCC (V) 1k f (Hz) k PO (W) THD 0.4 10 min 27 Ratings typ 45 0.4 max Unit

Notes: 1. Unless otherwise noted, use a constant-voltage supply for the power supply used during inspection. 2. Use the transformer power supply circuit stipulated in the figure below for allowable load shorted time measurement and output noise voltage measurement.. 4700 F +VCC 500

3. The output noise voltage values shown are peak values read with a VTVM. However, an AC stabilized (50 Hz) power supply should be used to minimize the influence of AC primary side flicker noise on the reading.


 

Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK402-060
STK402-070 Two-channel Class ab Audio Power Amplifier ic
STK402-090 af Power Amplifier , Package : Sip
STK402-100
STK402-120
STK402-220
STK402-230
STK402-240
STK402-250
STK402-270
STK402-320 af Power Amplifier
STK402-330
STK402-340
STK402-350
STK402-920
STK402-920 af Power Amplifier , Package : Sip
STK402-930 af Power Amplifier
STK402-930 af Power Amplifier , Package : Sip
STK402-940 af Power Amplifier
STK402-940 af Power Amplifier , Package : Sip
STK402-950 af Power Amplifier

2SC4598 : NPN Triple Diffused Planar Silicon Transistor, Switching Regulator Application

2SJ274 :

30A02MH : Low-frequency Audio Amplifier, Package : MCPH3

LC6522C : 4 / 8 Bit Sirial i /O, Package : Dip

LC74784 : On-screen Display Controller Lsi For VCR Product

LC75842M : 1/2 Duty LCD Display Driver , Package : Sop

SB160-18 : Large Signal(twin Type) , Package : TO-3PB

SLP-4118B-51 :

STK402-940 : af Power Amplifier , Package : Sip

Same catergory

8031AH : CISC->8051/80C51 Family->8031/8051. MCS 51 8-bit Control-oriented Microcontrollers.

GS3T5-52 : 3 W DC-DC Converter For Ecl. The a 3.12W DC-DC converter designed to provide an isolated 5.2V/600mA power source. The module operates from a 5V input source and continuous short-circuit protection. ELECTRICAL CHARACTERISTICS (Tamb.= 25 C unless otherwise specified) Symbol Vi Iir Vo Vor Vorn VOL VOO Io Iosc Vis fs Top Tstg Parameter Input Voltage Reflected Input Current Output.

NDL7503P : Ingaasp Strained MQW Dc-pbh Pulsed Laser Diode Module 1310nm Otdr Application.

NCP1580 : Low Voltage Synchronous Buck Controller The NCP1580 is a voltage mode PWM controller designed to operate from a 5.0V or 12V supply and produce an output voltage as low as 0.8V. This 8-pin device provides an optimal level of integration to reduce size and cost of the power supply. The NCP1580 has a fixed 350 kHz oscillator and soft-start function. The NCP1580.

TEW5315 : Cept/t1 In/output Transformer. TEW5315 is designed to be used either as a transmit or a receive transformer in the ISDN primary access network, interfacing the SIEMENS or 120 ohm line. When in transmit mode, connect the two primary windings in parallel, pin to 4 and pin to 5. When in receive mode, connect the two primary windings in series, pin 6 to pin 4, thus forming a center tap at pin 6/4.

MV363VCN : 5x7 mm, 3.3 or 5.0 Volt, Hcmos, VCXO. General purpose VCXO with good performance at an affordable price MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your application.

SMB5342 : 5 W Surface Mount Silicon Zener Diodes. Mechanical Data Case: SMB (DO-214AA) molded plastic Epoxy: UL 94V-0 rate flame retardant Terminals: Solder plated solderable per MIL-STD-750 method 2025 Polarity: color band denotes cathode end Mounting position: Any Maximum Ratings and Electrical Characteristics Ratings 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive.

EUROPLUS BASIC 12/6 : BOX, ASSORTMENT, 6 COMPARTMENTS. s: Box Type: - ; Box Material: Plastic ; Box Color: - ; External Height - Imperial: 1.73" ; External Height - Metric: 44mm ; External Width - Imperial: 4.76" ; External Width - Metric: 121mm ; External Depth - Imperial: 8.15" ; External Depth - Metric: 207mm.

GRM1886P1H9R7DZ01D : 9.7pF Ceramic Capacitor 0603 (1608 Metric) 50V; CAP CER 9.7PF 50V P2H 0603. s: Capacitance: 9.7pF ; Voltage - Rated: 50V ; Tolerance: 0.5pF ; Package / Case: 0603 (1608 Metric) ; Temperature Coefficient: P2H ; Packaging: Tape & Reel (TR) ; : - ; Lead Spacing: - ; Operating Temperature: -55C ~ 125C ; Mounting Type: Surface Mount, MLCC ; Lead Free.

41191 : Safety Sign. s: Height: - ; External Height: 254mm ; External Width: 355.6mm ; Sign Color: - ; Sign Type: - ; Sign Legend: Notice Safety Glasses Required Beyond This Point ; Sign Material: -.

CLT-139-01-L-D : Gold Through Hole Rectangular - Headers, Receptacles, Female Socket Connectors, Interconnect Receptacle; CONN RCPT 78POS DUAL 2MM T/H. s: Color: Black ; Connector Type: Receptacle ; Contact Finish: Gold ; : - ; Mounting Type: Through Hole ; Number of Positions Loaded: All ; Number of Rows: 2 ; Pitch: 0.079" (2.00mm) ; Row Spacing: 0.079" (2.00mm) ; Packaging:.

1676915-5 : 6.98K Ohm 0.25W, 1/4W Through Hole Resistors; RES 6.98K OHM 1/4W 0.1% AXIAL. s: Resistance (Ohms): 6.98K ; Power (Watts): 0.25W, 1/4W ; Tolerance: 0.1% ; Packaging: Tape & Box (TB) ; Composition: Metal Film ; Temperature Coefficient: 15ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

ERJ-6GEYJ394V : 390K Ohm 0.125W, 1/8W Chip Resistor - Surface Mount; RES 390K OHM 1/8W 5% 0805 SMD. s: Resistance (Ohms): 390K ; Power (Watts): 0.125W, 1/8W ; Tolerance: 5% ; Packaging: Cut Tape (CT) ; Composition: Thick Film ; Temperature Coefficient: 200ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

BZX79C36_T50A : Diode - Zener - Single Discrete Semiconductor Product 50nA @ 25.2V 36V 500mW Through Hole; DIODE ZENER 36V 500MW DO-35. s: Voltage - Zener (Nom) (Vz): 36V ; Power - Max: 500mW ; Impedance (Max) (Zzt): 90 Ohm ; Voltage - Forward (Vf) (Max) @ If: 1.5V @ 100mA ; Current - Reverse Leakage @ Vr: 50nA @ 25.2V ; Tolerance: 5.56% ; Mounting Type: Through Hole.

DBMMG9H4PJK87 : Gold Panel Mount; Through Hole, Right Angle D-sub Connectors, Interconnect Plug, Male Pins; DSUB 9H4 M PCR/A BRAC G50 HP T. s: Connector Type: Plug, Male Pins ; Contact Finish: Gold ; : Board Lock, Grounding Indents, Shielded ; Flange Feature: Mating Side; Female Screwlock (4-40) ; Mounting Type: Panel Mount; Through Hole, Right Angle ; Number of Positions:.

ATS-59004-C1-R0 : Heat Sinks MAXIGRIP HTSNK 43 X 55 X 12 (MM). Advanced Thermal Solutions (ATS) Freescale BGA Heatsinks are designed for Freescale flip-chip ICs.ATS Freescale BGA heatsinks offer MaxiGRIP& 8482; attachment which applies steady, even pressure to the component and does not require holes in the PCB. The heatsink comes pre-assembled with high performance.

B39491B5217H310 : 1 FUNCTIONS, 491.52 MHz, SAW FILTER. s: Filter Design: Saw Filter ; Insertion Loss: 8 dB ; Package Type: Surface Mount ; Operating Temperature: -40 to 185 F (233 to 358 K).

ROS-43-119+ : VCO, 43 MHz. s: Package / Form Factor: Surface Mount ; Phase Noise: -105 dBc/Hz ; Output Power: 2 dBm ; Operating Temperature: -55 to 85 C (-67 to 185 F) ; Supply Voltage: 5.0 Volts.

2SPT6341SD : 25 A, 125 V, NPN, Si, POWER TRANSISTOR. s: Polarity: NPN ; Package Type: 0.170 X 0.180 INCH, DIE-2.

 
0-C     D-L     M-R     S-Z