Details, datasheet, quote on part number: STK402-220
PartSTK402-220
Category
Descriptionaf Power Amplifier , Package : Sip
CompanySanyo Semiconductor Corporation
DatasheetDownload STK402-220 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The STK402-200 series products are audio power amplifier hybrid ICs that consist of optimally-designed discrete component power amplifier circuits that have been miniaturized using SANYO's unique insulated metal substrate technology (IMST). SANYO has adopted a new low thermal resistance substrate in these products to reduce the package size by about 60% as compared to the earlier SANYO STK408-000 series.

Features

Series of pin compatible power amplifiers ranging from 3 channels 3 channels (10%/1 kHz) devices. The same printed circuit board can be used depending on the output power grade. The pin arrangement is compatible with that of the 2channel STK402-000 series. This means that 3-channel printed circuit boards can also be used for 2-channel products. Miniature packages 15 W/ch to 40 W/ch (THD to 20 kHz); mm * Not including the pins. Output load impedance: 6 Allowable load shorted time: 0.3 seconds Supports the use of standby, muting, and load shorting protection circuits.

Any and all SANYO products described or contained herein do not have specifications that can handle applications that require extremely high levels of reliability, such as life-support systems, aircraft's control systems, or other applications whose failure can be reasonably expected to result in serious physical and/or material damage. Consult with your SANYO representative nearest you before using any SANYO products described or contained herein in such applications. SANYO assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all SANYO products described or contained herein.

TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

STK402-220 Series Organization These products are organized as a series based on their output capacity.

Specifications

Parameter Maximum supply voltage (No signal) Maximum supply voltage Thermal resistance Junction temperature Operating IC substrate temperature Storage temperature Allowable load shorted time *2 Symbol VCC max(1) VCC max(2) RL j-c Tj max Tc max Tstg ts VCC = 50 Hz, W, 1ch drive Per power transistor Both the Tj max and the Tc max conditions must be met. Conditions Ratings +125 0.3 Unit V C/W C s

Parameter Symbol PO (1) Output power PO (3) Total harmonic distortion Frequency characteristics Input impedance Output noise voltage *3 Quiescent current Neutral voltage THD (1) THD (2) fL, fH ri VNO ICCO VN Conditions*1 VCC (V) 1k f (Hz) k PO (W) THD at 8 min Hz k mVrms mV W Ratings typ max Unit

Notes: 1. Unless otherwise noted, use a constant-voltage supply for the power supply used during inspection. 2. Use the transformer power supply circuit stipulated in the figure below for allowable load shorted time measurement and output noise voltage measurement. 4700 F +VCC 500

3. The output noise voltage values shown are peak values read with a VTVM. However, an AC stabilized (50 Hz) power supply should be used to minimize the influence of AC primary side flicker noise on the reading.


 

Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK402-230 af Power Amplifier , Package : Sip
STK402-240
STK402-250
STK402-270
STK402-320 af Power Amplifier
STK402-330
STK402-340
STK402-350
STK402-920
STK402-920 af Power Amplifier , Package : Sip
STK402-930 af Power Amplifier
STK402-930 af Power Amplifier , Package : Sip
STK402-940 af Power Amplifier
STK402-940 af Power Amplifier , Package : Sip
STK402-950 af Power Amplifier
STK402-950 af Power Amplifier , Package : Sip
STK4024
STK4024II af Power (20W) Amplifier
STK4024MK2
STK4024MK5
STK4024V af Power Amplifier (20W)

1SS358 : High-frequency Schottky Barrier Diodes, Package : CP

2SC4864 : NPN Epitaxial Planar Silicon Transistor, VHF to UHF Wide-band Low-noise Amp Application

2SJ468 :

LA4905 : 17W, 2-channel BTL af High-efficiency Power Amplifier For Car Stereo System

LA71750M :

LB1690 : 3-phase DD Motor Driver For DC Fan, Package : Dip

LC877280B :

STK412-000 : af Power Amplifier , Package : Sip

Same catergory

HFBR1424C : Low Cost, Miniature Fiber Optic Components With St, Sma, SC And FC Ports.

LC72343G : Low-voltage Single-chip Microcontroller With On-chip PLL And LCD Driver Circuit.

OPA2634 : . HIGH BANDWIDTH: TO +10V OPERATION INPUT RANGE INCLUDES GROUND 4.8V OUTPUT SWING ON +5V SUPPLY HIGH OUTPUT CURRENT: 80mA HIGH SLEW RATE: 250V/s LOW INPUT VOLTAGE NOISE: 5.6nV/HZ The is a dual, low-power, voltage-feedback, high-speed operational amplifier designed to operate or +5V single-supply voltage. Operation or +10V supplies is also supported.

STK350-040 : 2-channel, (100 to 120W/channel Supported) af Voltage Amplifier. The is a voltage amplifier for use in audio power output stages. It comprises a 2-channel amplifier integrated in a small package, making possible audio set miniaturization and design simplification. Split power supply for wide bandwidth to 20kHz). Member of a family of devices with power capacities from to 150W. Compact package. High withstand voltage.

MTB50HE : Full-size (7.3mm or 4.7mm Height). Industry Standard Package or 3.3 Volt HCMOS, Sinewave, Clipped Sine to 1.000GHz Stability Down to 1ppm H Option = HCMOS Output Frequency Range Frequency Stability Load Supply Current Output Frequency Range Frequency Stability Load Supply Current Output Sinewave Output Frequency Stability Load Supply Current Output to 160.000MHz Down 1ppm 10K Ohms.

MAMUCT0021 : CATV Amplifier Splitter Module 50 - 860 MHz. Low Noise Figure Low Distortion Multifunction Integration Single Positive Supply 75 ohm Impedance Lead-Free Surface Mount Package Electroless Nickel Imersion Gold (ENIG) Finish 260C Reflow Compatible RoHS* Compliant Version of MAMUSS0007 M/A-COM's is an integrated module consisting of an amplifier and two equal split power dividers. The push-pull,.

UA9665 : High Current/voltage Darlington Drivers.

TS7808ICI : 3-terminal Fixed Positive Voltage Regulator. Pin assignment: 1. Input 2. Ground 3. Output (Heatsink surface connected to Pin 2) These voltage regulators are monolithic integrated circuits designed as fixed-voltage regulators for a wide variety of applications including local, on-card regulation. These regulators employ internal current limiting, thermal shutdown, and safe-area compensation. With.

IP1201PBF : Dual Output Full Function 2 Phase Synchronous Buck Power Block Integrated Power Semiconductors, PWM Control & Passives.

MIKROE-496 : Development Boards & Kits - Wireless WIFI PROTO (ZG2100M) PROTO ADAPTER BOARD. s: Manufacturer: mikroElektronika ; RoHS:  Details ; Tool Type: Wireless Development Board ; Processor To Be Evaluated: Multiple ; Core: Multiple ; Interface Type: SPI, UART ; Operating Supply Voltage: 3.3 V ; Core Architecture: Multiple ; Data Bus Width: 8 bit, 16 bit,.

GBC30DRTS : Gold Through Hole Card Edge, Edgeboard Connector Connectors, Interconnect Non Specified - Dual Edge; CONN EDGECARD 60POS DIP .100 SLD. s: Card Thickness: 0.062" (1.57mm) ; Card Type: Non Specified - Dual Edge ; Contact Finish: Gold ; Mounting Type: Through Hole ; : - ; Number of Positions: 60 ; Number of Rows: 2 ; Pitch: 0.100" (2.54mm) ; Packaging:.

ESC36DRTI : Gold Through Hole Card Edge, Edgeboard Connector Connectors, Interconnect Non Specified - Dual Edge; CONN EDGECARD 72POS DIP .100 SLD. s: Card Thickness: 0.062" (1.57mm) ; Card Type: Non Specified - Dual Edge ; Contact Finish: Gold ; Mounting Type: Through Hole ; : - ; Number of Positions: 72 ; Number of Rows: 2 ; Pitch: 0.100" (2.54mm) ; Packaging:.

D38999/24WJ7AN : Aluminum, Olive Drab Cadmium Plated Panel Mount, Bulkhead - Front Side Nut Circular - Housing Connectors, Interconnect Receptacle for Male Contacts; CONN HSG RCPT 99POS JAM NUT PINS. s: : - ; Packaging: Bulk ; Connector Type: Receptacle for Male Contacts ; Mounting Type: Panel Mount, Bulkhead - Front Side Nut ; Shell Size - Insert: 25-7 ; Contact Type:.

3471-0000 : Gold Free Hanging (In-Line) Rectangular - Free Hanging, Panel Mount Connectors, Interconnect Receptacle; CONN SOCKET 34POS BACK PLANE. s: Color: Gray ; Connector Type: Receptacle ; Contact Finish: Gold ; : Feed Through ; Mounting Type: Free Hanging (In-Line) ; Number of Rows: 2 ; Pitch: 0.100" (2.54mm) ; Row Spacing: 0.200" (5.08mm) ; Packaging: Bulk.

RNF14FTC10R5 : 10.5 Ohm 0.25W, 1/4W Through Hole Resistors; RES 10.5 OHM 1/4W 1% AXIAL. s: Resistance (Ohms): 10.5 ; Power (Watts): 0.25W, 1/4W ; Tolerance: 1% ; Packaging: Tape & Reel (TR) ; Composition: Metal Film ; Temperature Coefficient: 50ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

DF07M4B : 7 CONTACT(S), MALE, POWER CONNECTOR, SOLDER. s: Connector Type: POWER CONNECTOR ; Gender: Male ; Termination Types: SOLDER ; Number of Contacts: 7.

LX5510BLQ : 2400 MHz - 2500 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER. s: Amplifier Type: Power Amplifier ; Applications: RF Microwave ; RoHS Compliant: RoHS ; Frequency Range: 2400 to 2500 MHz ; Minimum Gain: 19 dB ; Package Type: 3 X 3 MM, ROHS COMPLIANT, PLASTIC, MLPQ-16 ; Operating Temperature: 0 to 70 C (32 to 158 F).

AB-RTCMC-32.768KHZ-EOZ9-S3-D-B-T : IC RTC CLK/CALENDAR I2C 10-VDFN. Abracon Corporation introduces its ultra-low power, real-time-clock integrated circuits in 3 x 3 mm QFN package. The AB08XX and AB18XX series of RTC ICs are targeted for ultra-low power, timekeeping applications where power consumption is of critical importance. Customers who seek sub 60 nA total power consumption with.

 
0-C     D-L     M-R     S-Z