Details, datasheet, quote on part number: STK4191V
CategoryAnalog & Mixed-Signal Processing
CompanySanyo Semiconductor Corporation
DatasheetDownload STK4191V datasheet
Find where to buy


Features, Applications

STK4191V AF Power Amplifier (Split Power Supply) + 50W min, THD = 0.08%)

Built-in muting circuit to cut off various kinds of pop noise. Greatly reduced heat sink due to substrate temperature 125C guaranteed. Distortion 0.08% due to current mirror circuit. Pin-compatible with the STK4101II series. The STK4101V series use the same package and are available for output to 50W. Excellent cost performance.


Parameter Maximum supply voltage Thermal resistance Junction temperature Operating substrate temperature Storage temperature Available time for load short-circuit Symbol VCC max j-c Tjmax Tc Tstg ts VCC = 50W Conditions Ratings +125 2 Unit V C/W C s

Parameter Recommended supply voltage Load resistance Symbol VCC RL Conditions Ratings 35.5 8 Unit V

SANYO Electric Co., Ltd. Semiconductor Business Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
otherwise specified, at specified test circuit (based on sample application circuit)

Parameter Quiescent current Symbol ICCO PO (1) Output power PO (2) Total harmonic distortion Frequency response Input impedance Output noise voltage Neutral voltage Muting voltage THD fL, fH ri VNO VN VM Conditions VCC to 20kHz, THD = 0.08% VCC = 1kHz, THD = 1W VCC = 10k VCC to 50k min typ 40 max 100 Unit Hz k mVrms mV V

For Power supply at the time of test, use a constant-voltage power supply unless otherwise specified. * For measurement of the available time for load short-circuit and output noise voltage, use the specified transformer power supply shown right. The output noise voltage is represented by the peak value on rms scale (VTVM) of average value indicating type. For AC power supply, use an AC stabilized power supply (50Hz) to eliminate the effect of flicker noise in AC primary line.

Sample Application Circuit : 50W min AF Power Amplifier (2 channels)


Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK4191X 2ch./1packge, +- Power Supply Built-in Muting Circuit 25w/ch. ~ 70w/ch. Thd=0.02%
STK4192II -
STK4200MK2 2ch./1packge, +- Power Supply 6w/ch. ~ 100w/ch. Thd=0.4%
STK4200MK5 2ch./1packge, +- Power Supply 6w/ch. ~ 100w/ch. Thd=0.08%
STK4201II -
STK4201V af Power Amplifier (60W + 60W)
STK4201X 2ch./1packge, +- Power Supply Built-in Muting Circuit 25w/ch. ~ 70w/ch. Thd=0.02%
Same catergory

CA0239E : Quad Voltage Comparators For Industrial, Commercial And Military Applications.

LA7840 : Vertical Deflection Output Circuit. The is a vertical deflection output IC for TVs and CRT displays with excellent image quality that use a BUS control system signal processing IC. This IC can drive the direct (even including a DC component) deflection yoke with the sawtooth wave output from the BUS control system signal processing IC. When used in conjunction with Sanyo's LA7615 series.

LM339 : Amplifiers, General. These comparators are designed for use in level detection, lowlevel sensing and memory applications in consumer automotive and industrial electronic applications. 14 DIP LM339CD Single or dual supplies Low Input Bias Current - 25nA(Typ) Low Input Offset Voltage - +1.0mV(Typ) Low Input Offset Current - +5.0nA(Typ) Input common-mode voltage range to GND Output.

LT1490A : LT1490A, Dual Micropower Rail-to-rail Input And Output op Amp. LT1490A/LT1491A Dual/Quad Over-The-Top Micropower Rail-to-Rail Input and Output Op Amps Low Input Offset Voltage: 500V Max Output Swings to 10mV Max from V Rail-to-Rail Input and Output Micropower: 50A/Amplifier Max Tiny 0.8mm DFN Package Over-The-Top Input Common Mode Range Extends 44V Above V Independent V + Specified 3V, 5V and 15V Supplies.

TA75559P : Dual Operational Amplifier.

TC1027 : The TC1027 is a Mixed-function Device Combining Four General Purpose Comparators And a Voltage Reference in a Single 16-pin Package.

TC9331F : Audio Digital Signal Processor.

TDA4504B : Small Signal Combination For Multistandard Colour TV. Product File under Integrated Circuits, IC02 February 1992 Gain controlled vision IF amplifier Synchronous demodulator for negative and positive demodulation AGC detector operating on peak sync amplitude for negative demodulation and on peak white level for positive demodulation Tuner AGC AFC circuit with two control polarities and on/off-switch Video.

TL3474CD : ti TL3474, Quad, High Slew Rate, Single-Supply, op Amp. Low Offset. 3 mV (Max) for A-Grade Wide Gain-Bandwidth Product. 4 MHz High Slew Rate. 13 V/s Fast Settling Time. to 0.1% Wide-Range Single-Supply Operation. 36 V Wide Input Common-Mode Range Includes Ground (VCC) Low Total Harmonic Distortion. 0.02% Large-Capacitance Drive Capability. 10,000 pF Output Short-Circuit Protection Alternative to MC33074/A.

TLC25M2 : . A-Suffix Versions Offer 5-mV VIO B-Suffix Versions Offer 2-mV VIO Wide Range of Supply Voltages 16 V True Single-Supply Operation Common-Mode Input Voltage Includes the Negative Rail Low Noise. 30 nV/Hz Typ = 1 kHz (High-Bias Versions) The TLC252, TLC25L2, and TLC25M2 are OUT IN low-cost, low-power dual operational amplifiers designed to operate with.

TLV2450CD : ti TLV2450, Single Micropower Rail-to-rail Input/output op Amp W/shutdown.

TLV2462AQDREP : ti TLV2462A-EP, Military Enhanced Plastic Dual Low-Power, Rail-to-rail Input/output Operational Amplifier.

TLV2462AQDRQ1 : ti TLV2462A-Q1, Automotive Catalog Low-power Rail-to-rail Input/output Operational Amp W/shutdown.

V53C8129H35 : Ultra-high Performance, 128k X 8edo Page Mode CMOS Dynamic RAM.

0-C     D-L     M-R     S-Z