|Category||Analog & Mixed-Signal Processing|
|Description||af Power Amplifier (100W + 100W)|
|Company||Sanyo Semiconductor Corporation|
|Datasheet||Download STK4231V datasheet
STK4231V AF Power Amplifier (Split Power Supply) (100W+100W min, THD = 0.08%)
Muting circuit built-in to isolate all types of shock noise Current mirror circuit for low 0.08% total harmonic distortion Pin compatible with the STK4201II series (THD = 0.4%) and the STK4141X series (THD = 0.02%)Specifications
Parameter Maximum supply voltage Thermal resistance Junction temperature Operating substrate temperature Storage temperature Available time for load short-circuit1 Symbol VCC max j-c Tj Tc Tstg ts VCC = 100W Conditions Ratings +125 1 Unit V °C/W °C sParameter Recommended supply voltage Load resistance Symbol VCC RL Conditions Ratings ±51 8 Unit V
SANYO Electric Co., Ltd. Semiconductor Business Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
Parameter Quiescent current Output power Total harmonic distortion Frequency response Input impedance Output noise voltage2 Neutral voltage Muting voltage Symbol ICCO PO THD fL, fH ri VNO VN VM Conditions VCC = ±61.5V THD = 1.0W,
Notes. All tests are measured using a regulated voltage supply unless otherwise specified. 1. Available time for load short-circuit and output noise voltage are measured using the transformer supply specified below. 2. The output noise voltage is the peak value of an average-reading meter with an rms value scale (VTVM). The noise voltage waveform includes no flicker noise.
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or indirectly cause injury, death or property loss. Anyone purchasing any products described or contained herein for an above-mentioned use shall: Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use: Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees, jointly or severally. Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of June, 1997. Specifications and information herein are subject to change without notice.
|Some Part number from the same manufacture Sanyo Semiconductor Corporation|
|STK4241V af Power Amplifier (120W + 120W)|
|STK4273 2 Channel af Power Amp|
|STK4274 Current Amp|
DM2023-0AL7 : 20 Characters X 2 Line Liquid Crystal Dot Matrix Display Module
LA4485 : 5.0 W Typical 2-channel Power Amplifier With Standby Switch And Mute, Package : Sip
STK402-100 : af Power Amplifier , Package : Sip
LA6504H : Monolithic Linear IC DVD System Motor Drives
2SA1641RTP-FA : 8000 mA, 20 V, PNP, Si, SMALL SIGNAL TRANSISTOR Specifications: Polarity: PNP
2SA1356 : Transistor ( Audio Power Amplifier Applications ).
AD8055 : Low Cost, Single, 300 MHZ Voltage Feedback Amplifiers. Low Cost Single (AD8055) and Dual (AD8056) Easy to Use Voltage Feedback Architecture High Speed 300 MHz, 3 dB Bandwidth V/ s Slew Rate 20 ns Settling to 0.1% Low Distortion: 72 dBc @ 10 MHz Low Noise: 6 nV/ Hz Low DC Errors: 5 mV Max VOS, 1.2 A Max IB Small Packaging AD8055 Available SOT-23-5 AD8056 Available in 8-Lead microSOIC Excellent Video s (RL = +2) Gain.
CGY191 : GAAS Mmic ( Dual Mode Power Amplifier For Cdma /tdma Portable Cellular Phones ).
INA117AM : Difference Amplifiers. ti INA117, High Common-mode Voltage Difference Amplifier.
ISL83385E : +/-15kV Esd Protected, +3V to +5.5V, 1microamp, 250kbps, RS-232 Transmitter/receiver.
KM4121 : 0.2mA, 35MHz, Rro Amplifier With Disable. The KM4111 (single) and KM4121 (single with disable) are ultra-low power, low cost, voltage feedback amplifiers. These amplifiers use only 208µA of supply current and are designed to operate or ±2.5V supplies. The input voltage range extends 300mV below the negative rail and 1.2V below the positive rail. The KM4111 offers high bipolar performance at a low CMOS.
KTY82-1 : KTY82-1 Series; Silicon Temperature Sensors. Product Supersedes data of 1996 Dec 05 File under Discrete Semiconductors, SC17 1998 Mar 26 The temperature sensors in the KTY82-1 series have a positive temperature coefficient of resistance and are suitable for use in measurement and control systems. The sensors are encapsulated in the small plastic SMD SOT23 package. Tolerances 0.5% or other special.
L6995 : Step Down Controller For High Differential Input-output Conversion. STEP DOWN CONTROLLER FOR HIGH DIFFERENTIAL INPUT-OUTPUT CONVERSION FEATURE s CONSTANT ON TIME TOPOLOGY ALLOWS OPERATION WITH LOWER DUTY THAN PWM TOPOLOGY s VERY FAST LOAD TRANSIENTS s 5V Vcc SUPPLY TO 28V INPUT VOLTAGE RANGE 0.9V ±1% VREF s MINIMUM OUTPUT VOLTAGE AS LOW 0.9V s SELECTABLE SINKING MODE s LOSSLESS CURRENT LIMIT s REMOTE SENSING s OVP,UVP.
LM381 : Low Noise Dual Preamplifier (discontinued). The is a dual preamplifier for the amplification of low level signals in applications requiring optimum noise performance Each of the two amplifiers is completely independent with individual internal power supply decoupler-regulator providing 120 dB supply rejection and 60 dB channel separation Other outstanding include high gain (112 dB) large output.
LMV358 : Low-voltage Rail-to-rail Output op Amp (quad). LMV321 SINGLE, LMV358 DUAL, LMV324 QUAD, LMV324S QUAD WITH SHUTDOWN LOW-VOLTAGE RAIL-TO-RAIL OUTPUT OPERATIONAL AMPLIFIERS 2.7-V and 5-V Performance Low-Power Shutdown Mode (LMV324S) No Crossover Distortion Low Supply Current: 130 µA Typ 210 µA Typ 410 µA Typ 410 µA Typ Rail-to-Rail Output Swing ESD Protection Exceeds JESD 2000-V Human-Body Model.
MAX270CPP : Digitally-programmed, Dual 2nd-order Continuous Lowpass Filters.
NJU7017 : Low-voltage Operation Tiny Single C-mos Operational Amplifier.
OP-420 : Quad Micropower Operational Amplifier.
OPA2137E : Low Cost Fet-input Operational Amplifiers Microamplifier Series. LOW COST FET-INPUT OPERATIONAL AMPLIFIERS MicroAmplifier TM Series FET INPUT: = 5pA LOW OFFSET VOLTAGE: 1.5mV WIDE SUPPLY RANGE: to ±18V LOW QUIESCENT CURRENT: 220µA/channel EXCELLENT SPEED/POWER: 1MHz INPUT TO POSITIVE SUPPLY MicroSIZE PACKAGES: SOT-23-5, MSOP-8 SINGLE, DUAL, AND QUAD OPA137 series FET-input operational amplifiers are designed for low cost.
PACUSB100MST : Usb Upstream Port Filter With Esd Protection.
TLV2762 : . TLV2764, TLV2765 FAMILY 1.8 V MICROPOWER RAIL-TO-RAIL INPUT/OUTPUT OPERATIONAL AMPLIFIERS WITH SHUT DOWN Low Supply Voltage. 3.6 V Very Low Supply Current. 20 µA (per channel) Ultralow Power Shut-Down Mode IDD(SHDN) = 10 nA/Channel CMOS Rail-to-Rail Input/Output Input Common-Mode Voltage Range. V to VDD 0.2 V Input Offset Voltage. 550 µV Wide Bandwidth.
UCC39151 : Power. 15v Programmable Hot Swap Power Manager. D Integrated 0.15- Power MOSFET to 15-V Operation D Digital Programmable Current Limit from 3 A Programmable On-Time Programmable Start Delay Fixed 2% Duty Cycle Thermal Shutdown Fault Output Indicator Power SOIC and TSSOP, Low ThermalResistance Packaging The UCC39151 programmable hot swap power manager provides complete power management, hot swap capability,.
MC13821 : Low Noise Amplifier with Bypass Switch The MC13821 is a high gain LNA with extremely low noise figure, designed for cellular, GPS and ISM band applications. An integrated bypass switch is included to preserve input intercept performance. The input and output match are external to allow maximum design flexibility. The MC13821 is fabricated using Motorola's.
OPA4314 : Quad, 3MHz, Low-Power, Low-Noise, RRI/O, 1.8V CMOS Operational Amplifier ACTIVE) Quad, 3MHz, Low-Power, Low-Noise, RRI/O, 1.8V CMOS Operational Amplifier.