Details, datasheet, quote on part number: STK740-441
CategoryPower Management => Regulators => Linear Voltage Regulators => Fixed
Description3.3V/5A Single Output Separate Excitation Chopper Regulator
CompanySanyo Semiconductor Corporation
DatasheetDownload STK740-441 datasheet
Find where to buy


Features, Applications

3.3V/5A Single Output Separate Excitation Chopper Regulator

The is a separate-excitation step-down chopper regulator hybrid IC for the secondstage circuit and optimal a 3.3V local power supply for use in logic circuit that includes both 5V and 3.3V systems. This IC incorporates in the package all the necessary circuits for a chopper regulator including power switch, error amplifier, soft start, shutdown type output short protection, low-voltage malfunction prevention, on/off, and snubber circuits. Therefore, external components required are input and output capacitors and choke coil only and this allows this to be used to construct a large-current (5A) chopper regulator a 3-pin regulator were used.


3.3V local power supply for the logic circuit where both 5V and 3.3V systems are constructed togeter.


Adoption of Sanyo IMST ; Insulated Metal Substrate Technology, allows the circuit to be operated without using a heat sink (see "No Fin Output Current Derating" chart in the page 6). Slim package reduces mounting space. Typical efficiency DC 5V input, 2.5A output. Fine adjustment of output voltage enable. 50 kHz operating frequency. Low-RON resistance power MOSFET adopted. Low-VF Schottky barrier diode adopted.

Any and all SANYO products described or contained herein do not have specifications that can handle applications that require extremely high levels of reliability, such as life-support systems, aircraft's control systems, or other applications whose failure can be reasonably expected to result in serious physical and/or material damage. Consult with your SANYO representative nearest you before using any SANYO products described or contained herein in such applications. SANYO assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges,or other parameters) listed in products specifications of any and all SANYO products described or contained herein.

TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

This product is listed in a product series due to its property such as output voltage, output current, package, and other similar items. Since some prducts listed in the table below is under development, please refer to your Sanyo sales representative for details.

Type number * : Under planning 10A 5A Input voltage Output voltage Output current 10A 5A Package dimensions (output pins not included) 4.5mm,12pins 8.5mm,12pins


Parameter Operating IC substrate temperature Operating temperature Storage temperature DC input voltage Symbol Tc max Topr Tstg VIN max Pins 6, 11, and 12 Conditions Ratings +115 10 Unit

Parameter Operating IC substrate temperature DC input voltage Load current Symbol Tc VIN Io In the recommended circuit In the recommended circuit Conditions Ratings to 5 Unit V A

Electrical Characteristics 25C, in the specified circuit, VIN = 1A, unless othrwise specified

Parameter Output voltage Load regulation Efficiency Operating frequency Cutoff current On/off circuit Output voltage temperature coefficient Symbol Vo VO fosc ICUT Voff TCVO 6pin, latch mode 5A Io=2.5A Conditions Ratings min 3.2 typ 3.3 max 3.4 50 Unit mV % kHz mA V

SUB Low-voltage malfunction prevention circuit Phase compensation


Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK740-470 5V/5A Single Output Separate Excitation Chopper Regulator,
STK7406 Offline Switching Regulator

DBB04 : Bridge Rectifier Stacks, Package :

FH201 : Vco Oscillator Tr1, Package : MCP6

LA1145 : FM if System For Car Radios, Package : Sip

LA4663 : 16 W Typical, 2-channels, For General- Purpose Audio, ac Muting (RL = 6 Ohm Main), Package : Sip

LA71562M :

STK420 :

STK571C :

STK7406 : Offline Switching Regulator

KR-4400DF7 : Battery Pack Battery Product; BATT PACK 8.4V 4400MAH NICAD Specifications: Battery Cell Size: D ; Number of Cells: 7 ; Voltage - Rated: 8.4V ; Capacity: 4.4Ah @ 880mA ; Structure: Side to Side, 1 Row x 7 Cells ; Rechargeability: Yes ; Termination Style: Solder Tab ; Battery Chemistry: Nickel Cadmium ; Weight: 2.2 lbs (997.9g) ; Lead Free Status: Lead Free ;

109R0824M402 : AXIAL FAN, 80MM, 24VDC, 50mA Specifications: External Height: 80mm ; External Width: 80mm ; External Depth: 25mm ; External Diameter: - ; Current Type: DC ; Supply Voltage: 24VDC ; Current Rating: 50mA ; Flow Rate - Imperial: 29.3CFM ; Flow Rate - Metric: 0.83m/min ; Noise Rating: 23dBA ; Bearing Type: Ball ; Power Connection

Same catergory

ADM809-5L : Microprocessor Supervisory Circuit. Specified Over Temperature Low Power Consumption (17 A) Precision Voltage Monitor: 5 V Options Reset Assertion Down 1 V VCC 30 ms min Power-On Reset Logic Low RESET Output APPLICATIONS Microprocessor Systems Computers Controllers Intelligent Instruments Automotive Systems The ADM809-5S/L supervisory circuits monitor the power supply voltage in microprocessor.

CS9202 : Micropower 3.3v, 100ma Low Dropout Linear Regulator With Nocap(tm). CS9202 Micropower 100 mA Low Dropout Linear Regulator with NOCAPTM The is a precision 100 mA voltage regulator with low quiescent current (450 A typ. 100 A load). The 3.3 V output is accurate within 2% and supplies mA of load current. The regulator is protected against reverse battery, short circuit, over voltage, and over temperature conditions.

EZ55Z3L-S3.3 : 0.25 Amp Positive Voltage Regulators. The EZ55Z3L voltage regulators are monolithic integrated circuits designed for use in applications requiring a well regulated positive output voltage with low input-tooutput differential voltage requirements. Outstanding include full power usage 250mA of load current, internal current limiting and thermal shutdown. Safe area protection on the die is also.

IRFK2F450 : ISOlated Base Power Hex Pak(tm) Assembly- Half Bridge Configuration.

LM333 : Adjustable. LM333 - 3-Ampere Adjustable Negative Regulator, Package: TO-3, Pin Nb=3.

MAX1793EUE-15 : Low-dropout, Low Iq, 1a Linear Regulator. The MAX1793 low-dropout linear regulator (LDO) operates from to +5.5V and delivers a guaranteed 1A load current with a low 210mV dropout. The high-accuracy (1%) output voltage is preset at an internally trimmed voltage (see Ordering Information) or can be adjusted from to 5.0V with an external resistordivider. An internal PMOS pass transistor allows.

MAX5074 : Power ic With Integrated MOSFETs For ISOlated Ieee 802.3af PD And Telecom Power-supply Applications The MAX5074 ISOlated PWM Power ic Integrated Switching Power MOSFETs Connected in a Voltageclamped, Two-transistor, Power-circuit Configuration. This Device CAN be Used in Both Forward And Flyback Configurations With a Wide Input Voltage Range From 11V to 76V And up to 15W of Output.

SP6660 : iq = 400µA ;; Vin Min. = 1.5V ;; Vin Max. = 4.25V ;; Output Current = 200mA ;; Output Range = -1.5V to -4.25V or +3V to 8.5V ;; Freq. (kHz) = 10/80 ;; Efficiency = 93% ;; Package = 8 Pin Msoic 8 Pin Nsoic 8 Pin Pdip.

UC3527AJ : Voltage Mode. ti UC3527A, Regulating Pulse Width Modulators. to 35V Operation 5.1V Reference Trimmed to 500kHz Oscillator Range Separate Oscillator Sync Terminal Adjustable Deadtime Control Internal Soft-Start Pulse-by-Pulse Shutdown Input Undervoltage Lockout with Hysteresis Latching PWM to Prevent Multiple Pulses Dual Source/Sink Output Drivers The UC1525A/1527A series of pulse width modulator integrated circuits.

UCC2813-3 : Current Mode PWM Controllers. 100A Typical Starting Supply Current 500A Typical Operating Supply Current Operation to 1MHz Internal Soft Start Internal Fault Soft Start Internal Leading-Edge Blanking of the Current Sense Signal 1 Amp Totem-Pole Output 70ns Typical Response from Current-Sense to Gate Drive Output 1.5% Tolerance Voltage Reference Same Pinout UCC3802, UC3842, and UC3842A.

ISL9012 : Dual LDO with Low Noise, Low IQ, and High PSRR ISL9012 is a high performance dual LDO capable of sourcing 150mA current from channel 1 and 300mA from channel 2. The device has a low standby current and high- PSRR and is stable with output capacitance of 1F to 10F with ESR of up to 200m. The device integrates a Power-On-Reset (POR) function for the VO2 output.

LM2748 : Synchronous Buck Controller with Pre-bias Startup, and Optional Clock Synchronization The LM2745/8 are high-speed synchronous buck regulator controllers with an accurate feedback voltage accuracy of 1.5%. It can provide simple down conversion to output voltages as low as 0.6V. Though the control sections of the IC are rated for 3 to 6V, the driver.

LTC3225 : 150mA Supercapacitor Charger The LTC3225 is a programmable supercapacitor charger designed to charge two supercapacitors in series to a ??xed output voltage (4.8V/5.3V selectable) from a 2.8V/3V to 5.5V input supply. Automatic cell balancing prevents overvoltage damage to either supercapacitor. No balancing resistors are required..

NJM2857 : Low Dropout Voltage Regulator The NJM2857 is a low dropout voltage regulator.This product has Reverse Current Protection without external SBD Advanced Bipolar technology achieves low noise, high ripple rejection and high supply voltage.1.5A output current capacity, 4.7F small decoupling capacitor,built-in noise bypass capacitor make the NJM2857 suitable.

0-C     D-L     M-R     S-Z