Details, datasheet, quote on part number: STK7561J
PartSTK7561J
Category
DescriptionChopper Type Parallel 2-output Voltage Regulator
CompanySanyo Semiconductor Corporation
DatasheetDownload STK7561J datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Applications
Serial printers, line printers, office automation equipment. Floppy disk units, portable VCRs.
Features

2 outputs for microconputer power supply (5V) and motor drive power supply (12V) and capable of delivering 2 regulated voltage outputs form 1 rectifier. Chopper type permitting high efficiency, and separate excitation type oscillator common to 2 outputs causing no beat trouble. Independent overcurrent protectors for 2 outputs (Foldback characteristics) External signal-used output cutoff function (Output 2). High-precision setting of output voltage eliminating the need to use a variable resistor for adjustment. One input/output GND line making it possible for other negative voltage to be used jointly. A negative voltage regulator (5V, 12V, etc.) can be connected externally. Output voltage, output current constituting a series.

Specifications

Parameter Maximum DC Input Voltage Maximum Output Current Thermal Resistance Operating Case Temperature Junction Temperature Storage Temperature Symbol

Any and all SANYO products described or contained herein do not have specifications that can handle applications that require extremely high levels of reliability, such as life-support systems, aircraft's control systems, or other applications whose failure can be reasonably expected to result in serious physical and/or material damage. Consult with your SANYO representative nearest you before using any SANYO products described or contained herein in such applications. SANYO assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges,or other parameters) listed in products specifications of any and all SANYO products described or contained herein.

TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN

Parameter Output Voltage Ripple Voltage Line Regulation Load Regulation Overcurrent Trip Start Current Efficiency Operating Frequency Cutoff Voltage Temperature Coefficient Condition 1 Condition 1 Condition 2 Condition 3 Condition 4 Condition 5 Condition 1 Condition 1 Condition 0.025 6 Conditions See specified Test Circuit. min 4.9 Output 1 Ratings typ 5.0 max typ at outputs 1, 2 operating mode 35kHz typ at outputs 1, 2 operating mode 3V or more 1V or less OFF 0.01 min 11.8 Output 2 Ratings typ 12.0 max 40 V mV/V mV/A A 20 mVrms Unit

(Note) Condition 5V1A, 12V1A Condition 5V1A, 12V1A Condition 3 Output to 6A Output to 4A Condition : Vin(DC)=25V Condition 5V2.5A, 12V1A

Since pin 12 is grounded to the substrate, noise may be affected when a heat sink is connected to the FG (Frame Ground), GND line, etc. In this case. bring the heat sink to floating state or use an insulating sheet.

* The N.C. pin (pin 18) must not be used as a relay pin for other line, pin. * Pins connected inside the IC must be also connected on the printed circuit board.

Specifications of any and all SANYO products described or contained herein stipulate the performance, characteristics, and functions of the described products in the independent state, and are not guarantees of the performance, characteristics, and functions of the described products as mounted in the customer's products or equipment. To verify symptoms and states that cannot be evaluated in an independent device, the customer should always evaluate and test devices mounted in the customer's products or equipment. SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all semiconductor products fail with some probability. It is possible that these probabilistic failures could give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire, or that could cause damage to other property. When designing equipment, adopt safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective circuits and error prevention circuits for safe design, redundant design, and structural design. In the event that any or all SANYO products(including technical data,services) described or contained herein are controlled under any of applicable local export control laws and regulations, such products must not be expor ted without obtaining the expor t license from the authorities concerned in accordance with the above law. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise, without the prior written permission of SANYO Electric Co., Ltd. Any and all information described or contained herein are subject to change without notice due to product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the SANYO product that you intend to use. Information (including circuit diagrams and circuit parameters) herein is for example only it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties.

This catalog provides information as of November, 1999. Specifications and information herein are subject to change without notice.


 

Some Part number from the same manufacture Sanyo Semiconductor Corporation
STK7562J
STK7563A Chopper Type Parallel 2-output Voltage Regulator
STK7563F
STK7563G
STK7563G2
STK7573A
STK7573B
STK759-051
STK759-061
STK759-071
STK759-081
STK759-091
STK760
STK760-220 PFC Active Converter ic Developed
STK761
STK762
STK7677
STK770
STK77014E
STK7702
STK77024E
Same catergory

BCR12UM-12 : . IT (RMS). 12A VDRM.400V/600V IFGT I RGT IRGT 15mA Viso 1500V APPLICATION Light dimmer Symbol VDRM VDSM Parameter Repetitive peak off-state voltage V1 Non-repetitive peak off-state voltage V1 Voltage class Unit V Symbol IT (RMS) ITSM I2t PGM PG (AV) VGM IGM Tj Tstg Viso Parameter RMS on-state current Surge on-state current I2t for fusing Conditions.

DIM800DDM17 : 800a 1700v Dual Switch Igbt Module. 10s Short Circuit Withstand High Thermal Cycling Capability Non Punch Through Silicon Isolated MMC Base with AlN Substrates KEY PARAMETERS VCES (typ) VCE(sat) * (max) IC (max) IC(PK) APPLICATIONS High Reliability Inverters Motor Controllers Traction Drives The Powerline range of high power modules includes half bridge, chopper, dual, single and bi-directional.

HMS87C1102 : 8-bit Single-chip Microcontrollers. VERSION 1.03 (SEP. 2004) This book The company name, Hynix Semiconductor Inc. changed to MagnaChip Semiconductor Ltd. VERSION 1.02 (MAR. 2004) Correct the external RC oscillation characteristics Fixed some errata. VERSION 1.01 (MAY. 2003) Fixed some errata. Version 1.03 Published by MCU Application Team 2004 MagnaChip Semiconductor Ltd. All right reserved.

TEP4532 : Audio Matching Transformer. TEP4532 is line matching transformer with the following . Low profile. Small volume. Conforming to FCC part 68 and Canadian CS 03. Split secondary windings to enable center tapped current feed. Applications: Interfacing equipment to telephone line when small size and high insulation voltage is required. Insertion Loss Frequency Response Longitudinal.

MAS9280 : IC FOR 18.00 - 40.00 MHz Vctcxo. This is preliminary information on a new product under development. Micro Analog Systems Oy reserves the right to make any changes without notice. Min. Supply Voltage 2.4 V Max. Frequency 40 MHz True Sine Wave Output Frequency Stability 1.5 ppm Suitable Also for Low Pull Crystals Very Low Phase Noise The is an integrated circuit well suited to build.

WB15L-DA : Environmentally Sealed Pushbuttons. Single unit construction of the bushing and case gives added protection from environmental elements. Specially designed contact mechanism for breaking light welds. Minimal contact bounce is achieved with specially designed interlocked switching mechanism. Outer housing of heat resistant resin meets UL 94V-0 flammability standard and provides high arc and tracking.

SAW5670 : Dual Color LED Lamp. Milky diffusion lens type 5mm(T-13/4) all plastic mold type Radiation color (Amber, White) Low power consumption PIN Connections 1. Anode (White) 2. Common Cathode 3. Anode (Amber) 1 Power dissipation Forward current * Peak forward current Reverse voltage Operating temperature range Storage temperature range * Soldering temperature Tsol 260 for 10 seconds.

RF220T0050 : RF Connectors. INTRODUCTION: Adam Tech's RFC series RF connectors are a comprehensive assortment of Radio Frequency signal connectors in standard, miniature, sub-miniature, micro miniature and surface mount style. Included are our BNC, TNC, FME, FMA, SMA, SMB, N, F, PAL, UHF, Mini-UHF, MCX, MMCX and 1.6/5.6 coupling versions. Each has standard interfaces and are of a strong.

ESH685M063AC3AA : 6.8F Aluminum Capacitor Radial 63V; CAP ALUM 6.8UF 63V 20% RADIAL. s: Capacitance: 6.8F ; ESR (Equivalent Series Resistance): - ; : General Purpose ; Lifetime @ Temp.: 2000 Hrs @ 105C ; Size / Dimension: 0.197" Dia (5.00mm) ; Lead Spacing: 0.079" (2.00mm) ; Surface Mount Land Size: - ; Mounting Type: Through Hole ; Package / Case: Radial ; Packaging:.

0907-4-15-20-75-14-11-0 : Surface Mount Contacts, Spring Loaded And Pressure Connectors, Interconnect Surface Mount; CONN PIN SPRING-LOAD .335 20GOLD. s: Mounting Type: Surface Mount ; Material: Copper Alloy ; Plating: Gold ; Plating - Thickness: 20in (0.51m) ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

MCP6XXXDM-FLTR : Eval And Demo Board And Kit Programmers, Development System; KIT DEMO BOARD ACTIVE FILTER. s: Main Purpose: Filters, Active - Bandpass, Highpass, Lowpass ; Primary Attributes: Cascadable PCBs, Single Supply ; Secondary Attributes: Bessel, Butterworth, and Chebyshev, with Order 1 ~ 8 ; Supplied Contents: 5 Boards, Accessory Bag, CD ; Utilized IC / Part:.

PCK946BD,128 : Clock/timing - Clock Buffers, Driver Integrated Circuit (ics) Fanout Buffer (Distribution), Divider, Multiplexer Tape & Reel (TR) 3 V ~ 3.6 V; IC CLK DRVR CMOS 2:10 32LQFP. s: Type: Fanout Buffer (Distribution), Divider, Multiplexer ; Frequency - Max: 150MHz ; Input: LVCMOS, LVTTL ; Output: CMOS ; Voltage - Supply: 3 V ~ 3.6 V ; Package / Case:.

ML-63-4-5 : Knob Hardware, Fasteners, Accessory Metal Smooth 6-32 Set Screw; KNOB BLK/MATTE.625"DIA.250"SHAFT. s: Color: Black Matte ; Diameter: 0.625" (15.88mm) ; Height: 0.625" (15.88mm) ; Indicator: Dot on Top ; Material: Metal ; Shaft Size: 0.250" (6.35mm) ; Style: Cylindrical ; Type: Smooth ; : 6-32 Set Screw ; Lead Free Status: Lead Free ; RoHS Status: RoHS.

66741-2 : Contact - Multi Purpose Connectors, Interconnect Power, Stamped; CONN SOCKET 10AWG SILVER CRIMP. s: Wire Gauge: 10 AWG ; Material: Copper ; Packaging: Bulk ; Pin or Socket: Socket ; Plating: Silver ; Type: Power, Stamped ; Plating - Thickness: 100in (2.54m) ; Contact Termination: Crimp ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

1612630000 : Through Hole Terminal Block - Headers, Plug And Socket Connectors, Interconnect Header, Female Sockets; CONN TERM BLK 7MM 90 9POS. s: Terminal Block Type: Header, Female Sockets ; Positions Per Level: 9 ; Pitch: 0.276" (7.00mm) ; Number of Levels: 1 ; Header Orientation: 90, Right Angle ; Plug Wire Entry: - ; Termination: Solder ; Wire Gauge: - ; Current:.

SI5110-F-BC : Interface - Drivers, Receivers, Transceiver Integrated Circuit (ics) Transceiver Tube 1.71 V ~ 1.89 V; IC TXRX SERIAL/DESERIAL 99CBGA. s: Number of Drivers/Receivers: 1/1 ; Type: Transceiver ; Voltage - Supply: 1.71 V ~ 1.89 V ; Package / Case: 99-BCBGA ; Packaging: Tube ; Protocol: SONET/SDH ; Lead Free Status: Contains Lead ; RoHS Status: RoHS Non-Compliant.

SS6102 : UNIDIRECTIONAL, SILICON, TVS DIODE. s: Configuration: Single ; Direction: Unidirectional ; Package: AXIAL PACKAGE-2 ; Pin Count: 2 ; Number of Diodes: 1.

 
0-C     D-L     M-R     S-Z