Details, datasheet, quote on part number: SL12.TC
PartSL12.TC
Category
DescriptionLow Capacitance TVS Diode For High Speed Data Interfaces
CompanySemtech Corporation
DatasheetDownload SL12.TC datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Low Capacitance TVS Diode For High Speed Data Interfaces

The SL series of TVS arrays are designed to protect sensitive electronics from damage or latch-up due to ESD, lightning, and other voltage-induced transient events. They are available with operating voltages 12V, 15V and 24V. TVS diodes are solid-state devices designed specifically for transient suppression. They offer desirable characteristics for board level protection including fast response time, low operating and clamping voltage, and no device degradation. The SL series devices feature a low capacitance, fast switching compensation diode in series with a standard TVS diode. This effectively reduces the overall capacitance of the device to less than 5pF making it an integrated, low capacitance solution for use on high-speed interfaces. The SL series devices may be used to meet the immunity requirements of IEC 61000-4-2, level 4.

Features

IEC 61000-4-2 (ESD) ±15kV (air), ±8kV (contact) IEC 61000-4-4 (EFT) 40A (5/50ns) IEC 61000-4-5 (Lightning) 12A (8/20µs) Small package for use in portable electronics Two devices will protect one line Low capacitance for high-speed data lines Working voltages: 12V, 15V and 24V Solid-state silicon avalanche technology

JEDEC SOT23 package Molding compound flammability rating: UL 94V-0 Marking : Marking Code Packaging : Tape and Reel per EIA 481

Applications

High-Speed data lines Cellular handsets AND accessories Universal Serial Bus (USB) port protection Portable instrumentation LAN/WAN equipment Peripherals

R ating Peak Pulse Power (tp = 8/20µs) ESD Voltage (HBM p er IEC 61000-4-2) Lead Soldering Temp erature Op erating Temp erature Storage Temp erature Symbol Pp k VESD TL TJ TSTG Value sec.) to +150 Units Watts kV °C

SL05 Parameter Reverse Stand-Off Voltage Reverse Breakdown Voltage Reverse Leakage Current Clamp ing Voltage Clamp ing Voltage Peak Pulse Current Junction Cap acitance Symbol VRWM = 1mA VRWM 5V, T=25°C IPP = 8/20µs IPP = 1MHz Conditions Minimum Typical Maximum 5 Units A pF

SL12 Parameter Reverse Stand-Off Voltage Reverse Breakdown Voltage Reverse Leakage Current Clamping Voltage Clamping Voltage Peak Pulse Current Junction Capacitance Symbol VRWM = 1mA VRWM 12V, T=25°C IPP = 8/20µs IPP = 1MHz

SL15 Parameter Reverse Stand-Off Voltage Reverse Breakdown Voltage Reverse Leakage Current Clamping Voltage Clamping Voltage Peak Pulse Current Junction Capacitance Symbol VRWM = 1mA VRWM 15V, T=25°C IPP = 8/20µs IPP = 1MHz Conditions Minimum Typical Maximum 15 Units A pF

SL24 Parameter Reverse Stand-Off Voltage Reverse Breakdown Voltage Reverse Leakage Current Clamp ing Voltage Clamp ing Voltage Peak Pulse Current Junction Cap acitance Symbol VRWM = 1mA VRWM 24V, T=25°C IPP = 8/20µs IPP = 1MHz Conditions Minimum Typical Maximum 24 Units A pF


 

Related products with the same datasheet
SL12.TCT
Some Part number from the same manufacture Semtech Corporation
SL12.TCT Low Capacitance TVS Diode For High Speed Data Interfaces
SC338IMSTR Ultra Low Output Voltage Dual Linear FET Controller
BZT10 Silicon Planar Zener Diodes
ZJ3V6 Silicon Epitaxial Planer Zener Diodes
STZ8068 Silicon Planar Zener Diodes
4V3HSC
BZX55T9V1 Silicon Epitaxial Planar Zener Diodes
MBR1650CT Schottky Barrier Rectifier
6V2BSB Silicon Planar Zener Diodes
MPSA94U PNP Silicon Epitaxial Planar Transistor
SC412AMLTRT Synchronous Buck Controller
3FF10 Rectifier, up to 150v, 3.1a, 30ns
SC1104XEVB Simple, Synchronous Voltage Mode PWM Controller
MM5Z10 Silicon Planar Zener Diodes
SC471_08 Synchronous Buck Controller with Multi-level VOUT Transition Support
P20FB2 Zener Diodes
SB160M-40 Silicon Epitaxial Planer Schottky Barrier Diode
UZ-10B Standard Zener Diodes
MMDT5P333 PNP Silicon Epitaxial Planar Transistor
MTZJ8V2A Zener Diodes
P15FB1
Same catergory

DMS-20PC-4-DCM : Segment Displays. Self-Powered, LED, Negative Input, DC Voltage Monitors DATEL's DMS-20PC-DCM Series of self-powered, negative-reading, dc voltage monitors are great replacements for older, hard-to-read, analog meters. Simply connect a negative voltage across the rear terminals and the meters are fully operational! Negative-input DCM's can be easily combined with positivereading.

HPY1010-1 : PKG Type = 10 ;; Emitted Color = Yellow ;; Lens Type = Clear ;; Peak Wavelength λ P (nm) = 570 ;; Luminous Intensity iv (mcd) Min = 500.0 ;; Luminous Intensity iv (mcd) TYP = 1000.0 ;; Luminous Intensity iv (mcd) Max = 20 ;; Viewing Angle (2 θ 1/2) = 10.

LF398 : Precision Sample And Hold Amplifier.

SN74194N : ti SN74194, Bidirectional Universal Shift Registers.

UC5603 : 9-line Scsi Active Terminator. Standards 6-pF Channel Capacitance during Disconnect 100-µA Supply Current in Disconnect Mode Meets SCSI Hot Plugging ­400-mA Sourcing Current for Termination +400-mA Sinking Current for Active Negation Drivers Termination Lines Trimmed Termination Current to 3% Trimmed Impedance to 3% Negative Clamping on all Signal Lines Current Limit and Thermal.

SNC12030 : One Channel Speech Controller. INTRODUCTION3 .3 PIN ASSIGNMENT3 BLOCK DIAGRAM.4 FUNCTION ROM.4 RAM.5 POWER DOWN MODE.5 SAMPLING RATE COUNTER.5 I/O PORTS.5 PUSH-PULL OUTPUT6 WATCH DOG IR FUNCTION.6 Version Ver 1.3 Ver 1.4 Ver 1.5 Date January 14, 2005 March 17,2005 May 25, 2005 First issue Modify Standby & operation current Remove APPLICATION CIRCUIT RST pin capacitance Add IR is a one-channel.

A80-A75XSMD : 2-electrode-arrester. DC spark-over voltage 1) 2) Impulse spark-over voltage at 100 V/µs - for % of measured values - typical values of distribution at 1 kV/µs - for % of measured values - typical values of distribution Nominal impulse discharge current (wave 8/20 µs) Single impulse discharge current (wave 8/20 µs) Nominal alternating discharge current (50 Hz, 1 s) Insulation.

264UBC/C470/F45-85 : 3.0mm Round Type LED Lamps. Technical Data Sheet 3.0mm Round Type LED Lamps ”“High efficiency and low cost ”“Good control and free combinations on the colors of LED lamps ”“Good lock and easy to assembly ”“Stackable and easy to assembly ”“Stackable vertically and easy to assembly ”“Versatile mounting on P.C board or panel ”“Stackable horizontally and easy to assembly s : ”“ARRAY=Plastic.

PTH03010 : Dc-dc Converters. VTT bus termination output (output the system VREF) 15 A output current or 12 Vdc input voltage DDR and QDR compatible ON/OFF inhibit (for VTT standby) Under-voltage lockout Operating temperature range: to +85 °C Efficiencies to 91% Output overcurrent protection (non-latching, auto-reset) Point-of-Load-Alliance (POLA) compatible Available RoHS compliant.

N3433-5003RB : Gold Through Hole, Right Angle Rectangular - Headers, Male Pin Connectors, Interconnect Header, Shrouded; CONN HEADER 50POS R/A NO LATC. s: Color: Black ; Connector Type: Header, Shrouded ; Contact Finish: Gold ; Contact Mating Length: 0.240" (6.10mm) ; : - ; Mounting Type: Through Hole, Right Angle ; Number of Positions Loaded: All ; Number of Rows:.

ELJ-FB680JF : Fixed Inductors, Coils, Choke 68µH 115mA 1812 (4532 Metric) -; INDUCTOR 68 UH 5% 1812 SMD. s: Inductance: 68µH ; Tolerance: ±5% ; Package / Case: 1812 (4532 Metric) ; Packaging: Cut Tape (CT) ; Type: - ; Current: 115mA ; Mounting Type: Surface Mount ; Q @ Freq: 40 @ 2.52MHz ; Frequency - Self Resonant: 8.2MHz ; DC Resistance (DCR): 5.3 Ohm Max ; Shielding:.

102985-4 : Rectangular - Accessory Connectors, Interconnect Ferrule; SHLD FERRULE PLTD LF. s: Accessory Type: Ferrule ; Number of Positions: - ; For Use With/Related Products: AMPMODU® MT Series ; : - ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

A210331 : 30 A, BARRIER STRIP TERMINAL BLOCK, 1 ROW, 1 DECK. s: Mounting Options: Universal Mounting Foot ; # of Contacts: 31 ; North American: 12 AWG ; Voltage Rating: 300 volts ; Current Rating: 30 amps ; Termination Options: Screw Clamp ; Approvals: CE Conformity Marks, CSA Mark (US, NRTL/C), UL Listing Mark, IEC.

B04-040-0464A : 40 CONTACT(S), MALE, POWER CONNECTOR, SOLDER. s: Connector Type: POWER CONNECTOR ; Gender: Male ; Termination Types: SOLDER ; Number of Contacts: 40.

2N2712LEADFREE : 18 V, NPN, Si, SMALL SIGNAL TRANSISTOR, TO-92. s: Polarity: NPN ; Package Type: TO-92, TO-92, 3 PIN.

6URD73TTF1800 : VERY FAST BLOW ELECTRIC FUSE, 1800A, 600VAC, 100000A (IR), INLINE/HOLDER. s: Mounting: Replaceable ; Rated Voltage: 600 volts ; Rated Current: 1800 amps ; Rated Breaking Capacity: 100000 amps ; : Fast Acting.

CA761KS07984 : DC Power Cords Sld DC PWR Cbl Assy 0.100" Cen Pin STRT. Switchcraft Harsh Environment DC Power Cables are molded cables available for immediate shipment, saving time and cost of field installation or a custom cable. The cables feature Switchcraft IP68 sealed and 11A power plugs with strip and tin on the opposite end for maximum flexibility with both.

 
0-C     D-L     M-R     S-Z