Details, datasheet, quote on part number: AA107-310
CategoryRF & Microwaves => Attenuators => Digital Attenuator
TitleDigital Attenuator
DescriptionGAAS ic 5 Bit Digital Attenuator
CompanySkyworks Solutions, Inc.
DatasheetDownload AA107-310 datasheet
Find where to buy


Features, Applications

GaAs IC 5 Bit Digital Attenuator With Serial-to-Parallel Driver DC­2 GHz

Positive Voltage Operation (+5 V) MLF 5 mm Leadless Package Integrated Silicon Serial-to-Parallel Driver Attenuation 0.5 dB Steps 15.5 dB


The is a GaAs FET IC 5 bit digital attenuator with a serial-to-parallel driver packaged a 32 leadless exposed pad plastic package. It is particularly suited at IF frequencies where high attenuation accuracy, low insertion loss and low intermodulation products are required.Typical applications include base station, wireless and RF data and wireless local loop gain control circuits.

Parameter1 Insertion Loss3 Attenuation Range4, 5 Attenuation 5 DC­1.0 GHz DC­2.0 GHz VSWR (I/O) Switching Characteristics6 Rise, Fall or 90/10% RF) On, Off (50% CTL to 90/10% RF) Video Feedthru 0.50­2.0 GHz 0.05 GHz For Two-tone Input Power +5 dBm VLow 20 µA Max. VHigh 300 µA Max. 0.50­2.0 GHz 0.05 GHz DC­2.0 GHz Condition Frequency2 DC­1.0 GHz DC­2.0 GHz Min. Typ. of Attenuation Setting in dB) of Attenuation Setting in dB) ns mV dBm Max. 1.7 2.2 Unit dB

Input Power for 1 dB Compression Intermodulation Intercept Point (IP3) Control Voltages

Parameter Input Voltage High Input Voltage Low Input Leakage Current Quiescent Current Supply Voltages

1. All measurements made a 50 system, unless otherwise specified. = 300 kHz. 3. Insertion loss changes by 0.003 dB/°C.

4. Attenuation value referenced above insertion loss. 5. Exposed pad must be connected to RF ground to obtain specified attenuation. 6. Video feedthru measured with 1 ns risetime pulse and 500 MHz bandwidth.

Skyworks Solutions, Inc. [781] 376-3000 Fax [781] 376-3100 Email

Input Voltage (VI) Power Dissipation (PD) Storage Temperature (TST) Operating Temperature (TOP)

Function Serial Data Output Ground RF Input/Output Ground RF Input/Output Ground Reset Latch Enable Serial Data Input Serial Clock Input Low Output Voltage Level Ground Charge Pump Capacitor Charge Pump Capacitor Supply Voltage

Parameter LE Setup Time SDA Setup Time SDA Hold Time LE Hold Time Clock Period


Some Part number from the same manufacture Skyworks Solutions, Inc.
AA109-310 GAAS ic 5 Bit Digital Attenuator
AA110-85 GAAS ic 5 Bit Digital Attenuator With...
AA113-310 GAAS ic 6 Bit Digital Attenuator With...
AA115-321 GAAS ic 2 Bit Digital Attenuator
AA116-72 GAAS ic 1 Bit Digital Attenuator 15 DB LS
AA117-85 GAAS ic 5 Bit Digital Attenuator With...
AA210-25 GAAS ic 4 Bit Digital Attenuator 1 DB...
AA220-25 GAAS ic 4 Bit Digital Attenuator 2 DB...
AA226-87 GAAS ic 4 Bit Digital Attenuator 1 DB...
AA230-24 GAAS ic 3 Bit Digital Attenuator 4 DB...
AA260-85 GAAS ic 5 Bit Digital Attenuator 1 DB...
AA264-87 GAAS ic 4 Bit Digital Attenuator 2 DB...
AA280-25 GAAS ic 5 Bit Dig Attenuator 0.5 DB...
AA310-25 GAAS ic 4 Bit Digital Attenuator 1 DB...
AA320-25 GAAS ic 4 Bit Digital Attenuator 2 DB...
AB006M2-11 GAAS ic SPDT Non-reflective Switch...
AB026P2-14 25 28 GHZ Amplifier
AB028H1-14 23 30 GHZ High Gain Amplifier
AB028V1-14 23 30 GHZ Variable Gain Amplifier
AB038H1-14 36 41 GHZ High Gain Amplifier

AS170-92 : GAAS ic SPDT Reflective Switch Positiv...

SMV2019-000 : Silicon Hyperabrupt Varactor...

SKY77161 : Power Amplifier Module for Cdma2000 (450-460 MHz)

CX74061 : Rx ASIC for Cdma, Amps, PCS, and GPS Mobile Handset Applications

SKY74693 : Receiver for Cdma, Amps, PCS, and GPS Mobile Handset Applications

SKY65049-360LF : Rf Amplifier Rf/if And Rfid; IC AMP 1.7-2.4GHZ LN 8QFN Specifications: Package / Case: 8-VFDFN Exposed Pad ; Voltage - Supply: 4.75 V ~ 5.25 V ; Current - Supply: 65mA ; Gain: 17.5dB ; Frequency: 1.7GHz ~ 2.4GHz ; RF Type: CDMA, GSM, WCDMA ; Packaging: Tape & Reel (TR) ; Noise Figure: 0.7dB ; P1dB: 17.5dBm (56.2mW) ; Test Frequency: 2GHz ; Lead Free

AAT2782IRN-AAE-T1 : SWITCHING REGULATOR Specifications: Life Cycle Stage: ACTIVE



Same catergory

1F1305-3 : = Xinger Hybrid Couplers ;; Size LXWXH = 0.56 X 0.35 X 0.076" ;; Packaging = Surface Mount ;; Frequency MHZ = 1930-1990 ;; Power Handling Watts = 100.

2SK881 : Single Gate FETs. Vgdo VGDS (VGDO) (V) = -18 ;; Id (IC)(mA) = 10 ;; PD (mW) = 100 ;; Idss (mA) = 1 to 10 ;; YFS (Typ.) @1kHz (mS) = 9 ;; GRS(GCS)/NF(NFCS)(Typ.) (dB/dB) = 18/2.5 ;; Package = Usm ;; Application = FM RF.

AS004L2-11 : GAAS ic SPDT Low Loss Switch Reflect. s Low DC Power Consumption s Low Loss, Reflective, Short s 8 Lead Hermetic Surface Mount Package s Capable of Meeting MIL-STD Requirements6 The AS004L2-11 SPDT low loss reflective switch operates from DC­4 GHz. The chip has a single series FET in each arm for low loss performance. This switch should be used when requirements call for low insertion loss.

BGA2011 : Linear Amplifiers. BGA2011; 900 MHZ High Linear Low Noise Amplifier;; Package: SOT363 (UMT6).

FL05-0001-G : Filters/Diplexers.  E-Glass SMT High Pass Filter 800 - 3000 MHZ. Small Size and Low Profile Industry Standard SOIC-8 SMT Plastic Package Superior Repeatability Typical Insertion Loss 0.5 dB Typical Rejection 20dB 2 Watt Power Handling M/A-COM's is an IC-based monolithic high pass filter in a low cost SOIC-8 plastic package. This filter is ideally suited for applications where small size, low cost and low loss are required.

HFA3983 : 2.4GHz Power Amplifier And Detector. The a 2.4GHz monolithic SiGe Power Amplifier designed to operate in the ISM Band. It two low voltage single supply stages. Cascaded, they deliver a 18dBm (Typ.) of an output power for the typical DSSS signal (ACPR, 1st Side Lobe -30dBc, 2nd Side Lobe -50dBc). In addition, the device includes a 2.4GHz detector which is accurate over 15dB of dynamic range.

JDV2S10S : VR (v) = 10 ;; Ir (nA) = 3 ;; CT(1) (pF) = 7.3 to 8.4 ;; CT(2) (pF) = 2.75 to 3.4 ;; CT(1)/CT(2) = 2.5 ;; .rs(Typ.) Ohms = 0.35 ;; Package = Sesc ;; Application = UHF Vco.

M74M74C : Double-balanced Mixer. DOUBLE-BALANCED MIXER TO 18 GHz TO 18 GHz TO 3 GHz LO DRIVE +10 dBm (nominal) VERY SMALL PACKAGE SSB Conversion Loss & SSB Noise Figure (max.) to 16 GHz, to 17 GHz, to 1 GHz to 16 GHz, to 18 GHz, to 2 GHz to 16 GHz, to 16 GHz, to 3 GHz to 18 GHz, to 18 GHz, to 3 GHz Isolation (min.) to 14 GHz to 18 GHz to 18 GHz to 8 GHz 1 dB Conversion Compression.

MHW1253LA : MHW1253LA 5-200 Mhz, 25.5 DB, 10-Channel Catv Low Current Amplifier Module.

RMPA1751-102 : MMIC. Type = PCS ;; Circuit = 3V PCS Cdma Power Amplifier Module ;; Frequency = 1720-1780 MHZ.

SD1729 : HF Transistors. HF SSB Applications RF & Microwave Transistors. OPTIMIZED FOR SSB 30 MHz 28 VOLTS IMD 30 dB COMMON EMITTER GOLD METALLIZATION POUT 130 W PEP WITH 12 dB GAIN The is a Class 28 V epitaxial silicon NPN planar transistor designed primarily for SSB communications. This device utilizes emitter ballasting to achieve extreme ruggedness under severe operating conditions. ABSOLUTE MAXIMUM RATINGS (T case ° C) Collector-Base.

TGA8810 : GaAs. 2-10 GHZ Gain Block Amplifier. to 10-GHz Frequency Range Operates from Single 5-V Supply Unconditionally Stable 17-dB Typical Gain Typical ± 0.6-dB Gain Flatness x 0.006 in.) The TriQuint is a self-biased general purpose amplifier. Two gain stages employ shunt feedback to produce flat gain to 10-GHz. Output power at 1-dB gain compression is typically 17-dBm and noise figure is 6-dB.

ONET4201PA : 1 Gbps to 4.25 Gbps Limiting Amplifier With LOS and RSSI The ONET4201PA is a versatile high-speed, 3.3-V limiting amplifier for multiple fiber optic applications with data rates up to 4.25 Gbps. This device provides a gain of about 50 dB, which ensures a fully differential output swing for input signals as low as 3 mVp-p. The high input signal dynamic.

MHW9186AN : 870 MHz 18.5 dB Gain 132–Channel GaAs CATV Amplifier Module * 24 Vdc Supply, 40 to 870 MHz, CATV GaAs Forward Amplifier * Replaced MHW9186A. There are no form, fit or function changes with this part replacement. * RoHS Compliant Applications * CATV Systems Operating in the 40 to 870 MHz Frequency Range * Input Stage Amplifier in Optical Nodes, Line.

RF3166D : The RF3166 is a high-power, high-efficiency power amplifier module with integrated power control that provides over 50dB of control range. The device is a self-contained 6mmx6mm module with 50 Ohm input and output terminals. The device is designed for use as the final RF amplifier in EGSM900 and DCS handheld digital cellular equipment and other applications.

RF5328 : The RF5328 is a linear, medium-power, high-efficiency power amplifier IC designed specifically for battery-powered WLAN applications such as PC cards, mini PCI, and compact flash applications. It is also designed to meet IEEE802.11a, IEEE802.11n, IEEE802.16e (4.9 GHz to 5.850 GHz only) WiMax, FCC, and ETSI requirements for operation in the 4.9 GHz to 5.850.

MC44CC373CA : CMOS Audio/Video RF Modulators The MC44CC373 / MC44CC374 CMOS family of RF modulators is the latest generation of the legacy MC44BS373/4 family of devices. The MC44CC373/MC44CC374 RF modulators are designed for use in VCRs, set-top boxes, and similar devices.They support multiple standards, and can be programmed to support PAL, SECAM, or NTSC formats.

VBF-1575+ : Coaxial Bandpass Filters Coaxial Bandpass Filters. Low Insertion Loss (2.0 dB typical) Good close-in rejection Versatile small size, coaxial, 1.43" length The VBF-1575+ Band Pass Filter is constructed using internal LTCC Band Pass Filter structure to achieve repeatable performance. Covering 1575 MHz ± 45 MHz, these units offer low insertion loss and good rejection at the band reject edges. Built using.

HMC1048LC3B : Double Balanced Mixer SMT, 2 - 18 GHz The HMC1048LC3B is a general purpose double balanced mixer that can be used as a downconverter with DC to 4 GHz at the IF port and 2 to 18 GHz at the RF port. This mixer requires no external components or matching circuitry. The HMC1048LC3B provides excellent LO/RF, LO/IF and RF/IF isolation The mixer operates with.

0-C     D-L     M-R     S-Z