Details, datasheet, quote on part number: AK100-25
PartAK100-25
CategoryRF & Microwaves => Attenuators => Digital Attenuator
TitleDigital Attenuator
DescriptionGAAS ic 4 Bit Dig Atten With Driver...
CompanySkyworks Solutions, Inc.
DatasheetDownload AK100-25 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Attenuation 2 dB Steps 30 dB Low DC Current Consumption 10 mA Total Integral Driver 5 V Supply Voltages Low Cost SOIC-16 Plastic Package

Description

The an IC FET digital attenuator consisting of four monolithic attenuators with an LSB 2 dB and a total attenuation 30 dB with all attenuators connected. The device has integral drivers for each bit requiring less than 3 mA per bit. DC supply voltages 5 V are required. The attenuator is packaged a 16 lead plastic SOIC.

Parameter1 Insertion Frequency2 DC0.5 GHz DC1.0 GHz DC2.0 GHz DC2.0 GHz DC2.0 GHz Min. Typ. 3% of Attenuation Setting) 1.4:1 1.6:1 Max. 2.5 3.5 Unit dB

Parameter Switching Characteristics5 Condition Rise, Fall or 90/10% RF) On, Off (50% CTL to 90/10% RF) Video Feedthru 0.502.0 GHz 0.05 GHz For Two-tone Input Power +13 dBm VLow VHigh 3 mA Typ. 10 mA Typ. 0.502.0 GHz 0.05 GHz Frequency Min. Typ. Max. Unit ns mV dBm

Input Power for 1 dB Compression Intermodulation Intercept Point (IP3) Control Voltages Supply Voltages6,7

1. All measurements made a 50 system, unless otherwise specified. = 300 kHz. 3. Insertion loss changes by 0.003 dB/C. 4. Attenuation referenced to insertion loss. 5. Video feedthru measured with 1 ns risetime pulse and 500 MHz bandwidth. 6. Supply voltage and ground must be connected before control voltage is applied. Use of toggle switches or other similar components may produce voltage spikes which can cause irreversible damage to the device. 7. Current drain 5 mA Typ. 14 mA Typ. -5 V.

Skyworks Solutions, Inc. [978] 241-7000 Fax [978] 241-7906 Email sales@skyworksinc.com www.skyworksinc.com

Characteristic RF Input Power Supply Voltage Control Voltage Operating Temperature Storage Temperature JC Value > 500 MHz @ 50 MHz +150C 30C/W


 

Some Part number from the same manufacture Skyworks Solutions, Inc.
AK115-61 GAAS ic SP4T Non-ref Switch With...
AK802D4-24 GAAS ic 4 Bit Dig Atten With Driver...
AL106-84 GAAS ic 900 MHZ High Dynamic Range Amp...
AL107-84 GAAS ic 1800 Mhzhigh Dynamic Range Amp...
AL108-338 GAAS Phemt Switchable Gain Lna
AM026H1-00 24.5 32 GHZ GAAS Mmic Sub-Harmonic...
AM026S1-00 23 33 GHZ GAAS Mmic Fundamental...
AM028D1-00 26 33 GHZ GAAS Mmic Double Balanced...
AM028D1-A2 26 33 GHZ Surface Mount Double...
AM028S1-00 26 33 GHZ GAAS Mmic Single Balanced...
AM028S1-A2 26 33 GHZ Surface Mount Single...
AM028S2-A2
AM038D1-00 33 43 GHZ GAAS Mmic Double Balanced...
AM038S1-00 33 43 GHZ GAAS Mmic Single Balanced...
AM100-73 DC/DC Converter
AM101-73
AM107 Dual-band GAAS ic Antenna Switch Module
AM108-603 Triple-band GAAS ic Antenna Switch...
AM109-502 Cdma Split Band Switch Module Adv...
AM110 Dual-band Wlan Filter 2.4 2.5 GHZ And...
AM113 Dual-band Wlan Dual Diplexer
Same catergory

1R0260-3 : = ;; Size LXWXH = 1.62 X 0.56 X 0.11" ;; Packaging = Caseless ;; Frequency MHZ = 225-400 ;; Power Handling Watts = 250.

856184 : = Filter - Broadband Access ;; Frequency (MHz) = 1220 ;; Bandwidth (MHz) = 8 ;; Insertion Loss (dB) = 5.0 Max ;; Modes of Operation = Bal ;; Package (mm) = 3.8 X 3.8.

AM-140 : LNAs.  High Performance Amplifier, 29 DB Gain, 10 - 200 MHZ. +47 dBm Typical Midband Third Order Intercept +28 dBm Typical Midband 1 dB Compression 5.4 dB Typical Midband Noise Figure M/A-COM's is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges.

FD93H : Frequency Modulators.  Frequency Doubler. INPUT: TO 9 GHz OUTPUT: TO 18 GHz INPUT DRIVE LEVEL: +19 dBm (NOMINAL) HERMETICALLY-SEALED PACKAGE Characteristics Conversion Loss (max.) Fin to 4 GHz Fin to 9 MHz Typical 12.0 dB Guaranteed *Measured a 50-ohm system at +25C with nominal input drive level. Typical values are measured at +25C and are not guaranteed. Operating Temperature Storage Temperature.

HMC203 : GAAS Mmic Double-balanced Mixer 14 - 23 GHZ. Conversion Loss: / RF Isolation: 38 dB Passive: No DC Bias Required Small Size: 1.48 mm Typical Applications The HMC203 is ideal for: 18 GHz TVRO 23 GHz Telecom Radios Military Systems The HMC203 chip is a miniature double-balanced mixer which can be used as an upconverter or downconverter. Excellent isolations are provided by on-chip baluns, which.

HMC445LP4 : active. X16 Active. Output Power: +7 dBm Sub-Harmonic Suppression: >25 dBc SSB Phase Noise: -130 dBc/Hz Single Supply: 16 mm2 Leadless SMT Package SMT GaAs HBT MMIC x16 ACTIVE FREQUENCY MULTIPLIER, - 11.0 GHz OUTPUT Typical Applications Active Multiplier for X Band Applications: Fiber Optic to Pt Radios Military Radar The is an active miniature x16 frequency multiplier.

NJG1106KB2-C1 : 800mhz Band Lna GAAS Mmic. n GENERAL is a low noise amplifier GaAs MMIC designed for 800MHz band cellular phone handsets. This amplifier provides low noise figure of 1.3dB and low current consumption 3mA at low supply voltage 2.7V. NJG1106KB2 includes internal self-bias circuit and input DC blocking capacitor in a ultra small and ultra thin package FLP6-B2. n lLow voltage operation.

S10B888N2 : = RF Power Directional Couplers ;; Size LXWXH = 1.0 X 0.50 X 0.12" ;; Packaging = Surface Mount ;; Frequency MHZ = 815-960 ;; Power Handling Watts = 200.

SD4590 : 800/900 MHz Transistors. 800-960 MHZ Cellular Base Station RF Power Transistors.

UPC8179TB : Silicon Rfic Low Current Amplifier For Mobile Communications(533). SILICON RFIC LOW CURRENT AMPLIFIER UPC8179TB FOR MOBILE COMMUNICATIONS HIGH DENSITY SURFACE MOUNTING: 6 Pin Super Minimold Package x 0.9 mm) SUPPLY VOLTAGE: VCC 3.3 V HIGH EFFICIENCY: = +3.0 dBm TYP = 1.0 GHz = +1.5 dBm TYP = 1.9 GHz = +1.0 dBm TYP = 2.4 GHz POWER GAIN: 13.5 dB TYP = 1.0 GHz 15.5 dB TYP = 1.9 GHz 15.5 dB TYP = 2.4 GHz EXCELLENT ISOLATION:.

WMF-R07 : Data Receiving Module. 1. Light weight and thin type. 2. 5V supply voltage. 3. Low current consumption 6mA (typ.). 4. Transmission rate 1200 BPS. 5. A set of MITSUMI's transmitting module (AFWJ23 model) is also available. 6. Parts have been reduced to a large extent by using original IC. 7. Applicable over a wide temperature range (-30~+80C) with high sensitivity. S s Item.

CSPEMI202A : The CSPEMI202A is a dual low-pass filter array integrating two pi-style filters (C-R-C) that reduce EMI/RFI emissions while at the same time providing ESD protection. This part is custom-designed to interface with a microphone port on a cellular telephone or similar device. Each high quality filter provides more than 35dB attenuation in the 800-2700.

MRF7S19100N : RF Power Field Effect Transistors N-Channel Enhancement-Mode Lateral MOSFETs Designed for CDMA base station applications with frequencies from 1930 to 1990 MHz. Suitable for CDMA and multicarrier amplifier applications. To be used in Class AB and Class C for PCN - PCS/cel lular radi o and WLL applications. Typical Single- Carrier W-CDMA Performance:.

CC2510F8 : 2.4 GHz Radio Transceiver, 8051 MCU and 8 kB Flash memory The CC2510Fx/CC2511Fx is a true low-cost 2.4 GHz system-on-chip (SoC) designed for lowpower wireless applications. The CC2510Fx/CC2511Fx combines the excellent performance of the state-of-the-art RF transceiver CC2500 with an industry-standard enhanced 8051 MCU, up to 32 kB of in-system programmable.

HMC795LP5E : SiGe Wideband Direct Quadrature Modulator SMT, W/VGA, 50 - 2800 MHz The HMC795LP5E is a variable gain, direct quadrature modulator ideal for digital modulation applications from 50 - 2800 MHz including: Cellular/3G, Broadband Wireless Access and ISM circuits. Housed in a compact 5x5mm (LP5) SMT QFN package, the modulator offers a high level of integration,.

 
0-C     D-L     M-R     S-Z